• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.29 no.6C
• /
• pp.277-285
• /
• 2009

A series of undrained cyclic triaxial tests were carried out to investigate the cyclic shear stress strength characteristics of sands with respect to the silt content. Silty sand was collected around the basin of Nak-Dong River and remolded in laboratory with the range of silt content 0~50% in sand located. As results, with the change of silt content cyclic shear stress ratio (CSR) at N=10 showed the maximum value at 5% and the minimum at 20% in all relative density. The development tendency of the pore water pressure analyzed by the relationship cyclic ratio and pore water pressure ratio is unrelated the change of CSR varying silt content. Comparing the results of the void ratio and skeleton void ratio after consolidation, CSR varying silt content was much affected by skeleton void ratio which is known to affect shear behavior of silty sand.

• The Korean Journal of Physiology
• /
• v.29 no.1
• /
• pp.39-50
• /
• 1995

This study was designed to clarify the action of cyclic nucleotides, cyclic AMP and cyclic GMP, on phorbol 12,13-dibutyrate (PDBu)-induced contraction in rings isolated from rabbit carotid artery. Arterial rings, 2 mm in width, were myographied isometrically in an isolated organ bath. PDBu produced slowly developing, sustained contraction in rabbit carotid artery, in a dose dependent manner, which was independent of extracellular $Ca^{2+}$ PDBu-induced contraction was relaxed by staurosporine, which suggests that PDBu-induced contraction is mediated by protein kinase C (PKC). $^{45}Ca^{2+}$ uptake by rabbit carotid artery was increased by PDBu during depolarization, but not in control. Isoproterenol and sodium nitroprusside (SNP) relaxed phenylephrine-induced contraction. However, SNP but not isoproterenol relaxed the contraction induced by PDBu. Acetylcholine relaxed PDBu-induced contraction in the presence of the endothelium. 8-bromo-cyclic AMP, a permeable analogue of cyclic AMP, suppressed phenylephrine-induced contraction but not PDBu-induced contraction. 8-bromo cyclic GMP relaxed both of them with dose dependency. A large dose of forskolin relaxed PDBu-induced contraction. PDBu increased cyclic AMP without considerable change in the level of cyclic GMP. Based on these findings, PDBu-induced contraction of rabbit carotid artery was relaxed by cyclic GMP more effectively than cyclic AMP, and the action of cyclic AMP could be mediated by cyclic GMP dependent protein kinase. Therefore it is suggested that the antagonistic action between protein kinase C and cyclic GMP-dependent protein kinase plays a major role in the regulation of vascular tone.

• Journal of the Korean Crystal Growth and Crystal Technology
• /
• v.21 no.3
• /
• pp.119-123
• /
• 2011

Carbon nanotilaments (CNFs) could be synthesized on nickel catalyst layer-deposited silicon oxide substrate using $C_2H_2$ and$H_2$ as source gases under thermal chemical vapor deposition system. By the incorporation of $SF_6$ as a cyclic modulation manner, the geometries of carbon coils-related materials, such as nano-sized coil and wave-like nano-sized coil could be observed on the substrate. The characteristics (formation density and morphology) of as-grown CNFs with or without $SF_6$ incorporation were investigated. Diameter size reduction for the individual CNFs-related shape and the enhancement of the formation density of CNFs-related material could be achieved by the incorporation of $SF_6$ as a cyclic modulation manner. The cause for these results was discussed in association with the slightly increased etching ability by $SF_6$ addition and the sulfur role in SF 6 for the geometry change.

• Journal of The Korean Society of Agricultural Engineers
• /
• v.48 no.5
• /
• pp.63-71
• /
• 2006

In the present study, the dynamic deformation characteristics of clay, including the effect of loading rate in large strain ranges, were examined by performing undrained cyclic triaxial test. The test results showed that the loading rate to failure decreased with increasing loading amplitude and decreasing loading frequency. While the stress-strain relationships was not affected by loading frequency, excess pore pressure was affected significantly with the change in loading frequency. The change for 0.1 Hz was larger for than that of 0.01 Hz, resulting in inclined effective stress paths. Furthermore, the lower the frequency was, the higher the excess pore pressure was in the first loading.

• Nuclear Engineering and Technology
• /
• v.30 no.5
• /
• pp.387-395
• /
• 1998

In general, the laminated rubber bearing (LRB), a composite structure laminated with the elastic rubber and steel plates, has a complex hysteretic nonlinear characteristics in relationships between the restoring force and shear deflection. The representative nonlinear characteristics of LRB include the change of hysteresis loop with cyclic shear deflections and the hardening effects at large shear deflection regions. Changes of the hysteresis loop of LRB with cyclic shear deflections affect the horizontal stiffness and the damping characteristics. The hardening behavior of LRB in large shear deflection region results in an increased horizontal stiffness and therefore, has a great impacton the seismic responses. In this paper, the seismic response analysis is carried out using the modified hysteretic bi-linear model of LRB, which takes into account the hysteresis loop change and the hardening behavior with cyclic shear deflection. The results on seismic responses are compared with those obtained using the widely used hysteretic hi-linear model. The new model is found to reveal the greater amount of peak acceleration response.

• Geomechanics and Engineering
• /
• v.34 no.5
• /
• pp.481-489
• /
• 2023

Drained cyclic triaxial tests were conducted on a saturated sand to examine its deformation characteristics under either axial or lateral cyclic loading condition. To apply lateral cyclic loading, the cell pressure was cycled while maintaining a constant vertical stress. The strain accumulations and flow direction in the soil were presented and discussed considering various initial stress ratios (η₀), cyclic stress amplitudes and cyclic stress paths. The results indicate that axial strain accumulation shows an exponential increase with the maximum stress ratio (η^max). The initial deviatoric stress has comparable effects with lateral cyclic stress amplitude on the accumulated axial strain. In contrast, the accumulated volumetric strain is directly proportional to the lateral cyclic stress amplitude but not much affected by η₀ values. Due to the anisotropy of the soil, the accumulated axial and lateral bulging strains are greater in lateral cyclic loading when compared to axial cyclic loading even though η^max is the same. It is also found that η^max affects soil's lateral deformation and increasing the ratio could change the lateral deformation from contraction to bulging. The flow direction depends on η^max in the sand under lateral cyclic loading, regardless of η₀ values and the cyclic stress amplitudes, and a large η^max could lead to great deviatoric strain but a little volumetric strain accumulation.

• Journal of the Korean Statistical Society
• /
• v.25 no.1
• /
• pp.123-131
• /
• 1996

The problerm of testing for a constant mean is considered. A Kolmogorov-Smirnov type test using the sample Fourier coefficients is suggested and its asymptotic distribution is derived. A simulation study shows that the proposed test is more powerful than the cusum type test when there is more than one change-point or there is a cyclic change.

• Journal of the korean Society of Automotive Engineers
• /
• v.14 no.3
• /
• pp.90-101
• /
• 1992

An experimental study was carried out to investigate the characteristics of cyclic variability of combustion in a single cylinder spark ignition engine. Cylinder pressure of 240 consecutive cycles were measured for various engine operating conditions. From these data, a thermody-n amic analysis was performed for the typical cases in order to identify the cause and effect re -lation of the cyclic variation. In determining the number of cycles required for estimating the coefficient of variation of IMEP and so on, the oprating conditions must be cosidered to fit the objective of the analysis. It is thought that the variation in early flame stage is amplified through the flame propagation and results in the phase change between pressure and volume, which can be the major reason of cyclic variation of IMEP in case of lean operation.

• Geomechanics and Engineering
• /
• v.4 no.4
• /
• pp.243-249
• /
• 2012

In the companion paper, the nonlinear consolidation of soft clays subjected to cyclic loading was analytically investigated. This paper reports the results of an experimental program conducted to verify some critical assumptions made in the analytical study. It, also, includes a numerical study carried out to examine the capability of the proposed theory to determine the consolidation characteristics of soft clays subjected to cyclic loading. Results show that the permeability of the soft clays does not significantly change during the cyclic loading. It is also shown that, compared to the Terzaghi's solution for a linear clay, the inherit nonlinearity of the clay tends to decrease the degree of consolidation due to the smaller rate of dissipation in the excess pore water pressure.

• Journal of the Korean institute of surface engineering
• /
• v.20 no.2
• /
• pp.60-73
• /
• 1987

For the purpose of improving the cyclic oxidation resistance of Ni-base superalloy, Inconel 600, aluminide coating methods are studied. The formation rate of aluminide coating layers is measured as a function of time and pack composition to find out the optimum coating condition. The evaluation of cyclic oxidation is established by the change in weight, the microphotography and EPMA of cross sectional area during $200^{\circ}C\;{\leftrightarrow}\;950^{\circ}C\;and\;200^{\circ}C\;{\leftrightarrow}\;1100^{\circ}C$, respectively. The thickness of coating layer and weight gains are parabolic behavior in propotion to time and Al contents. In pack of low aluminum contents, 2 wt%, however, weight gain is decreased when activator, $NH_4Cl$ is higher than 2 wt%. The cyclic oxidation resistance of the coating carried out at 1100$^{\circ}C$ are superior to those of the coating diffusion-treated after pack cementation at 800$^{\circ}C$. Aluminide oxide, which is formed in external scale, is barrier to the cyclic oxidation.