• 전기학회논문지P
• /
• 제60권2호
• /
• pp.94-98
• /
• 2011

Electrolytic power capacitors today form essential components for virtually any power electronic system such as DC/DC converter or UPS. Frequently, electrolytic capacitors for DC link voltage smoothing are the key components which determine the life cycle of the whole unit and often are responsible for converter breakdown failures. In this paper, ethernet-based remote diagnosis system for DC voltage smoothing capacitor using DSP control board is developed. To estimate the status of the capacitor, the equivalent series resistor(ESR) of the component has to be determined. The ESR detection scheme is based on the determination of the capacitor ripple power losses calculated from DC link voltage/current measurement. Experimental results show the veridity and reliability of the proposed ethernet-based remote on-line capacitor diagnosis system.

• Journal of Electrical Engineering and Technology
• /
• 제3권1호
• /
• pp.94-100
• /
• 2008

This paper presents a new control method of single-phase active power filter (APF) for the compensation of harmonic current components in nonlinear loads. To facilitate the possibility of complex calculation for harmonic current detection of the single phase, a single-phase system that has two phases was constructed by including an imaginary second-phase giving time delay to the load current. The imaginary phase, which lagged the load current T/4 (Here T is the fundamental cycle) is used in the conventional method. But in this proposed method, the new signal as the second phase is delayed by the filter. Because this control method is applied to a single-phase system, an instantaneous calculation was developed by using the rotating reference frames synchronized to source-frequency rather than by applying instantaneous reactive power theory that uses the conventional fixed reference frames. The control scheme of single-phase APF for the current source with R-L loads is applied to a laboratory prototype to verify the proposed control method.

• 한국정보과학회:학술대회논문집
• /
• 한국정보과학회 2012년도 한국컴퓨터종합학술대회논문집 Vol.39 No.1(D)
• /
• pp.19-20
• /
• 2012

소셜 네트웍을 통한 다양한 서비스들은 새로운 비즈니스 모델의 형성이라는 긍정적인 측면이 있는 반면에, 개인정보 누출이나 스팸과 같이 부정적인 측면도 등장하고 있다. 현재 스팸을 차단하기 위해 스팸방지 가이드라인, 스팸 단어 검색에 의한 스팸 메시지 차단 등 많은 방법 및 연구들이 논의되어 왔다. 하지만, 기존의 차수를 활용한 방법은 스팸이 아닌 정점 또한 스팸으로 간주하는 문제점을 가지고 있어 부정확하다는 단점이 있다. 본 연구에서는 이를 해결하고자 다른 구조적 특성인 순환을 분석하여 스팸들을 차단하는 방법을 제안하고 그 효과를 입증하였다.

• 대한전자공학회논문지
• /
• 제27권5호
• /
• pp.699-708
• /
• 1990

This paper proposes two test procedures for detecting functional faults in semiconductor random access memories (RAM's) and a new testimg scheme to execute the proposed test procedures. The first test procedure detects stuck-at faults, coupling faults and decoder faults, and requires 19N operations, which is an improvement over conventional procedures. The second detects restricted patternsensitive faults and requires 69N operations. The proposed scheme uses Built-In Self Testing (BIST) techniques. The scheme can write into more memory cells than I/O pins can in a write cycle in test mode. By using the scheme, the number of write operations is reduced and then much testing time is saved.

• 한국정보통신설비학회:학술대회논문집
• /
• 한국정보통신설비학회 2009년도 정보통신설비 학술대회
• /
• pp.19-22
• /
• 2009

This thesis offers forecast & warning algorithm about the accessing networks though statistical sampling methods to prevent computer terrors. These networks are occurred among U-city network groups. The main characteristic of current computer attacks is avoiding well-known detection patterns by successive changes in spreading speeds and attacking codes. The improvement of attacking stills leads to a problem causing the defense-time delay and creates vicious cycle that tries to fix networks after damage. Proposed algorithm notices and warns the potential attacking areas through defecting previous attacking signs, analysing attaching results ed tracing attaching sources at the beginning of the attack.

• 대한전기학회논문지:전력기술부문A
• /
• 제49권8호
• /
• pp.405-411
• /
• 2000

When faults occur in transmission lines, the classification of faults is very important. If the fault is HIF(High Impedance Fault), it cannot be detected or removed by conventional overcurrent relays (OCRs), and results in fire hazards and causes damages in electrical equipment or personal threat. The fast discrimination of fault needs to effective protection and treatment and is important problem for power system protection. This paper propolsed the fault detection and discrimination algorithm for LIFs(Low Impedance Faults) and HIFs(High Impedance Faults). This algorithm uses artificial neural networks and variation of 3-phase maximum currents per period while faults. A double lines-to-ground and line-to-line faults can be detected using Neural Network. Also, the other faults can be detected using the value of variation of maximum current. Test results show that the proposed algorithms discriminate LIFs and HIFs accurately within a half cycle.

• 대한산업공학회지
• /
• 제34권3호
• /
• pp.308-317
• /
• 2008

This research investigates economic characteristics of 2 of 2 runs rules under the Shewhart $\bar{X}$ control chart scheme. A Markov chain approach is employed in order to calculate the in-control average run length (ARL) and the average length of analysis cycle. States of the process are defined according to the process conditions at sampling time and transition probabilities are derived from the state definitions. A steady state cost function is constructed based on the Lorezen and Vance(1986) model. Numerical examples show that 2 of 2 runs rules are economically superior to the Shewhart $\bar{X}$ chart in many cases.

• 대한전기학회논문지:전기기기및에너지변환시스템부문B
• /
• 제48권2호
• /
• pp.63-68
• /
• 1999

This pper describes a digital sensorless drive of permanent magnet brushless DC motors. In order to detect in real time the rotor positions of which Emf becomes zero, terminal voltages are sampled during PWM duty cycle. This method generates detection error in indirect sensed position, which is the harmonic component of PWM frequency. In this paper, the drive adopted Butterworth low pass filter for rejection of the sensing error and for accurate estimation of commutation time. Analytical design process of the digital filter is proposed and the experimental results show that the performance of the proposed sensorless drive is superior to that of the sensorless drives without filterint.

• Journal of Biosystems Engineering
• /
• 제30권2호
• /
• pp.114-120
• /
• 2005

In this study, a biological reaction and measurement control system was developed to rapidly measure the insecticide imidacloprid residues in agricultural products. The biological reaction part of the system was designed to include micro-pumps and valves for fluid transport, and a polystyrene covet as a reaction chamber. The measurement control part of the system consisted of a photodiode with a light-emitting diode for optical density measurement, and a control microcomputer to implement assay. Signal output was read as the rate of change in optical density at 645 nm. The sensitivity of the system was 2.2 ng/mL ($IC_50$). The system could execute a measurement cycle in about 19 minutes. Research will be continued to develop an automatic sampler fur imidacloprid residues from agricultural products.

• Journal of the Optical Society of Korea
• /
• 제10권1호
• /
• pp.42-47
• /
• 2006

M-mode imaging of the in vivo murine myocardium using optical coherence tomography (OCT) is described. Application of conventional techniques (e.g. MRI, Ultrasound imaging) for imaging the murine myocardium is problematic because the wall thickness is less than 1.5 mm (20 g mouse), and the heart rate can be as high as six hundred beats per minute. To acquire a real-time image of the murine myocardium, OCT can provide sufficient spatial resolution ($10{\mu}m$) and imaging speed (1000 A-scans/s). Strong light scattering by blood in the heart causes significant light attenuation, which makes delineation of the endocardium-chamber boundary problematic. To measure the thickness change of the myocardium during one heart beat cycle, a myocardium edge detection algorithm is developed and demonstrated.