• The Korean Journal of Pesticide Science
• /
• v.6 no.3
• /
• pp.175-182
• /
• 2002

This experiment was conducted to investigate the effects of acid rain in spraying copper hydroxide 77% wettable power(WP) on leaf surface morphology and crop injury of the garlic(Allium sativum L.). Leaf chlorosis, hooked leaves, wrinkled epidermal cells and increased stomata open of garlic were induced by foliar application of simulated acid rain(SAR). It was become to be severe in application of copper hydroxide solution after application of SAR, but those yield of garlic was not significantly different from the untreated control. Leaf chlorosis was sharply increased above 100 ppm of copper ions. Amount of solved copper ions in copper hydroxide solution was remarkably increased below pH 5.5 and the residue in garlic leaves was significantly increased by application of copper hydroxide solution after spraying SAR compared with application of copper hydroxide solution only. When calcium carbonate was applied together with copper hydroxide leaf chlorosis was less than copper hydroxide only.

• International Journal of Industrial Entomology and Biomaterials
• /
• v.35 no.2
• /
• pp.77-82
• /
• 2017

We studied on improvement method of rutin content using mulberry leaf powder. Mulberry leaves were collected and then hot-air dried and powdered for experiment. As a result, we have developed a pre-treatment method that extracts mulberry leaf powder with water or fermented alcohol with reflux extractor and then increases the rutin content by improving the process. Citric acid (0.1 ~ 1%) and 1000 ml fermented alcohol (50 ~ 95%) or water (10 ~ 50 times) was extracted with 100 g of mulberry leaf powder using a reflux extraction device ($80{\sim}90^{\circ}C$, 1 hour, twice). The extracts were collected, filtered and concentrated. For the recrystallization, the concentrate was dissolved by adding distilled water and allowed to stand at a low temperature. Then, the supernatant was discarded by centrifugation, and only the residue was lyophilized to prepare a final powder. As a result, regardless of the concentration of citric acid added, the content of rutin was higher in 90% fermented alcohol extract. Whereas, in the case of extracting with water, citric acid 0.5% was added to water 25 times as much as the weight of mulberry leaf powder, and 2274.4 (mg / 100g) of rutin content was highest in the case of refluxing twice at $80^{\circ}C$ for 1 hour. The powder with increased rutin content is expected to be applicable to various foods as a food additive. In addition, it can contribute to the improvement of the farm income by promoting consumption of mulberry leaf while satisfying the consumers' desire for functional food intake.

• Korean Journal of Environmental Agriculture
• /
• v.40 no.2
• /
• pp.127-133
• /
• 2021

BACKGROUND: Dithiocarbamte fungicides have been used in crop cultivation for diseases protection and treatment. And cultivated agricultrual products were used as feedstuff, and residual pesticides are likely to be absorbed and transferred to livestock. But the maximum residue limits (MRLs) were not established for dithiocarbate fungicides in livestock products, and thus an analysis method was developed and validated for dithiocarbamate fungicides to establish MRLs. METHODS AND RESULTS: Samples were prepared using CS₂ trap method and detected with UV/VIS spectrophotometer. Calibration line (0.1 ~ 10 ㎍/mL) was linear with r² > 0.99. For validation, the recovery tests were carried out at three fortification levels (MLOQ, 10 MLOQ and 50 MLOQ) from livestock samples (egg, milk, beef, pork, and chicken). The results for mancozeb, propineb, and thiram ranged between 76.8 to 109.6%, 79.4 to 108.8%, and 80.2 to 107.8%, respectively and % RSD (relative standard deviation) values were below 9.5%. Furthermore, inter-laboratory analysis was performed to validate the method. CONCLUSION: All values were corresponded with the criteria ranges requested by both the CODEX (CAC/GL 40-1993, 2003) and MFDS guidelines (2016). This might be used as an official analytical method for determination of dithiocarbamate fungicides at established MRLs and monitoring.

• Journal of Applied Biological Chemistry
• /
• v.63 no.4
• /
• pp.401-406
• /
• 2020

The plant uptake of endosulfan, a new persistent organic pollutants from soil environment was investigated on ginseng through the field survey in Korea. The endosulfan residues in soil for this survey were ranged on 0.013-0.136 mg kg-1. The plant uptake factor (PUF) for endosulfan in ginseng was 0.243-1.708 and the highest PUF was found on 3-year-old ginseng. The PUF for endosulfan decreased in the longer cultivation period and it might be caused by the dilution effect of ginseng growth. In addition, the soil organic matter (SOM) content affected on the PUF negatively and Pearson correlation coefficient (r) between SOM and PUF was -0.7812 (p <0.05). Thus, higher SOM would positively affect to reduce the endosulfan residue in ginseng root.

• Korean Journal of Environmental Agriculture
• /
• v.42 no.3
• /
• pp.220-230
• /
• 2023

Imidacloprid is a neonicotinoid insecticide widely used for insect control in a variety of crops. The evaluation of imidacloprid total residues in animal feeds derived from crop by-products is required to ensure the safety of livestock products. We performed simultaneous LC/MS/MS analyses of imidacloprid and its metabolites in five different livestock products including beef, pork, chicken, milk and egg from domestic markets. The methods for sample preparation and instrumental analysis were established by modifying QuEChERS method to meet the Codex guidelines. The methods generated 0.0035 mg/kg of the limit of determination (LOD), 0.01 mg/kg of the limit of quantitation (LOQ) and standard calibration linearity with >0.983 of the coefficients of determination (R²). The methods exhibited the recovery values of imidacloprid and its metabolites ranging from 65.66 to 119.27% without any interference between matrices. Imidacloprid total residues in the livestock products were found as values lower than the LOQ and maximum residue limits (MRLs). This study suggests that the methods are successfully applicable for the safety evaluation of imidacloprid total residues in livestock products from domestic markets.

• Journal of Food Hygiene and Safety
• /
• v.33 no.4
• /
• pp.296-305
• /
• 2018

Spiroxamine, one of fungicides, is used to control powdery mildew in various crops and black yellow sigatoka in bananas. The major strength of spiroxamine is to control powdery mildew in various crops and bananas yellow sigatoka in bananas. The compound has shown a high level of activity, good persistence and crop tolerance. Besides powdery mildew, good control of rust, net blotch and Rhynchosporium diseases been indicated in cereals, together with a complementary activity against Septoria diseases. In 2017, the maximum residue limit (MRL) of spiroxamine established in Korea. According to Ministry of ood and rug afety) regulations, spiroxamine residues defined only parent compound. Thus, a analytical method is needed to estimate the residue level of the parent compound. The objective of this study was to develop and validate analytical method for spiroxamine in representative agricultural commodities. Samples were extracted with acetonitrile and partitioned with dichloromethane to remove the interfering substances. The analyte were quantified and confirmed liquid chromatograph-tandem mass spectrometer (LC-MS/MS) in positive-ion mode using multiple reaction monitoring (MRM). Matrix matched calibration curves were linear over the calibration ranges ($0.0005{\sim}0.1{\mu}g/mL$) for the analyte in blank extract with coefficient of determination ($r^2$) > 0.99. For validation purposes, recovery studies will be carried out at three different concentration levels (LOQ, 10LOQ, and 50LOQ) performing five replicates at each level. The recoveries 70.6~104.6% with relative standard deviations (RSDs) less than 10%. All values were consistent with the criteria ranges in the Codex guidelines (CAC/GL40, 2003) and MFDS guidelines. proposed analytical method be used as an official analytical method in the Republic of Korea.

• Korean Journal of Environmental Agriculture
• /
• v.33 no.4
• /
• pp.388-394
• /
• 2014

BACKGROUND: Aclonifen is used as a systemic and selective herbicide to control a wide spectrum broad-leaf weeds by inhibition carotenoid biosynthesis, and then its MRLs(Maximum Residue Limits) will be determined in onion and garlic. In this study, a new official method was developed for aclonifen determination in agricultural products to routinely inspect the violation of MRL as well as to evaluate the terminal residue level. METHODS AND RESULTS: Aclonifen was extracted from crop samples with acetone and the extract was partitioned with dichloromethane and then purified by silica solid phase extraction(SPE) cartridge. The purified samples were detected GC using an ECD detector. Limits of detection(LOD) was 0.001 mg/kg and quantification(LOQ) was 0.005 mg/kg, respectively. For validation purposes, recovery studies were carried out at three different concentration levels (LOQ, $10{\times}LOQ$, $50{\times}LOQ$, n=5). The recoveries were ranged from 74.3 to 95.0% with relative standard deviations(RSDs) of less than 8%. All values were consistent with the criteria ranges requested in the Codex guidelines(CAC/GL 40). CONCLUSION: The proposed analytical method was accurate, effective and sensitive for aclonifen determination and it will be used to as an official method in Korea.

• Korean Journal of Environmental Agriculture
• /
• v.36 no.3
• /
• pp.211-216
• /
• 2017

BACKGROUND:This study was conducted to investigate residual organochlorine pesticides (ROCPs) in agricultural soils and crops. Agricultural soil samples and crop samples were collected from 93 cities and counties. METHODS AND RESULTS: Extraction and clean-up for the quantitative analysis of ROCPs were conducted by the modified quick, easy, cheap, effective, rugged, and safe (QuEChERS) method. Recovery and limit of detection (LOD) of ROCPs in agriculturalsoils and crops were 76.5-103.0 and 75.2-93.2%, 0.01-0.08 and $0.10-0.15{\mu}g/kg$, respectively. Detected ROCPs in agricultural soils were ${\alpha}$-endosulfan, ${\beta}$-endosulfan, and endosulfan sulfate, the residue were 2.0-12.0, 1.2-53.1, and $2.2-329.8{\mu}g/kg$, respectively. But these pesticides in all green perilla leaf and green pepper samples were not detected. CONCLUSION: These results showed that ROCPs residues in agricultural soils were not as high as crop safety threatening.

• Korean Journal of Weed Science
• /
• v.14 no.1
• /
• pp.34-41
• /
• 1994

To better understand the allelopathic effect of sorghum(Sorghum vulgare L.), the inhibitory activities of water extracts of the stem, leaf and root, and of residues of the stem to major crops and weeds associated with them were evaluated. The allelopathic activity of sorghum plants was species specific, and depended on source and concentration. Germination, and shoot and root length of all test species were inhibited by the different concentrations of the stem extract. Among the crop species, radish showed the most inhibition, followed by wheat and rice. Maize was the least sensitive species. Of the weed species, Ipomoea triloba was most inhibited, followed by Echinochloa colona and Rottboellia cochinchinensis. The water extracts of leaves, stems, and roots significantly inhibited germination and seedling growth in E. colona and radish. The stem extract gave the greatest inhibitory effect on E. colona while all three extracts produced similar response in radish. In the greenhouse trial, sorghum stem residue placed on the soil surface as mulch significantly inhibited seedling growth in E. colona and radish, but not that in rice.

• Korean Journal of Environmental Agriculture
• /
• v.40 no.4
• /
• pp.335-344
• /
• 2021

BACKGROUND: Cyantraniliprole is a systemic diamide insecticide that has been used to control lepidopteran pests in agriculture. Cyantraniliprole has become an issue due to its potentiality of unexpectable contamination in rotational crop cultivation. Thus, studies on the evaluation of cyantraniliprole translocated from soil into rotational crops are required. METHODS AND RESULTS: Cyantraniliprole was treated at a yearly maximum application level onto bare soil under greenhouse conditions in two geographically different regions. Lettuce was transplanted and spinach and radish were sown onto the soil 30 and 60 days-plant back intervals (PBIs) after cyantraniliprole treatment. The QuEChERS method was modified and coupled with LC/MS/MS analysis to determine the residues of cyantraniliprole in soil and plant samples. The methods for sample preparation and instrumental conditions were validated to meet the criteria of Codex guidelines and were successful to determine cyantraniliprole quantitatively and qualitatively in the samples. Cyantraniliprole residues in lettuce samples were 0.01 mg/kg for PBI 60 and 0.02 mg/kg for PBI 30, respectively. The residues in spinach samples were 0.01 mg/kg for PBI 60 and 0.01~0.02 mg/kg for PBI 30, respectively. Less than limit of the quantitation (LOQ) level (0.01 mg/kg) of cyantraniliprole was observed in radish samples. The residues in the plant samples were found as the levels less than maximum residue limit (MRL) for leafy and root vegetables. CONCLUSION(S): This study suggests PBI 30~60 days for rotational cultivation of lettuce, spinach and radish in greenhouse soil treated with cyantraniliprole at a yearly maximum application level.