• Journal of Food Hygiene and Safety
• /
• v.35 no.4
• /
• pp.382-390
• /
• 2020

This study was carried out to evaluate the antimicrobial effect of red ginseng (Panax ginseng C.A. Meyer) against several foodborne pathogens including Staphylococcus aureus, Escherichia coli, Candida albicans and Aspergillus niger. The antimicrobial effect was determined by agar diffusion method using red ginseng extract, crude saponin and non-water-soluble fractions. Red ginseng extract showed antimicrobial effect against S. aureus, but not C. albicans or A. niger. The extract showed anti-bacterial activity at concentration above 30% against S. aureus, which cause both food poisoning and atophic dermatitis. Crude saponin showed antibacterial activity above 7.5% against the bacterium. However, the ginsenosides purified from crude saponin showed no antimicrobial activities at 100-200 ㎍/mL. To investigate the mode of growth inhibition, red ginseng extract and crude saponin were added to 0.85% NaCl solution containing S. aureus and then incubated at 35℃ for 12 h. The results showed that viable cells were rapidly reduced in above 10% concentration of red ginseng extract and above 2% of crude saponin, respectively. However, the crude saponin and red ginseng extract did not inhibit the bacterial cells completely at those same concentrations. On the other hand, whereas all non-water-soluble fractions showed inhibition zones above 10 mm against S. aureus, they showed no inhibition effects against E. coli, C. albicans or A. niger. The methanol fraction-1 (MF-1) showed the highest antibacterial activity against S. aureus, and the MIC (minimal inhibitory concentration) was 0.625 mg/mL. These results suggest that red ginseng extract, crude saponin and non-water-soluble fractions show selective antibacterial activity against S. aureus, and non-water-soluble fractions might be used as natural antibacterial agents.

• Journal of Environmental Health Sciences
• /
• v.46 no.3
• /
• pp.276-284
• /
• 2020

Objectives: This study was conducted to identify the effects of PM₁₀ and PM_2.5 on hospital visits in the Incheon area over the period of 2016-2018. Methods: We applied correlation analysis and Poisson regression to perform the analysis using cardiovascular disease and respiratory disease data from the National Health Insurance Service and the daily average PM₁₀ and PM_2.5 from the Korea Environment Corporation adjusting for time lag. Results: When the daily average PM₁₀ concentration increased by 10 ㎍/㎥, the number of cardiovascular disease patients were 1.002 times higher (95% CI [Confidence Interval]; 1.000-1004) in Ganghwa County. As the daily average PM_2.5 concentration increased by 10 ㎍/㎥, the number of cardiovascular disease patients were 1.012 times higher (95% CI; 1.008-1.016) in Ganghwa County. As the daily average PM₁₀ concentration increased by 10 ㎍/㎥, the respiratory disease patients were 1.003 times (95% CI; 1.002-1.004) higher in Gyeyang and Michuhol Counties. As the PM_2.5 concentration increased by 10 ㎍/㎥, the respiratory disease patients were 1.003 times higher (95% CI; 1.002-1.005) in Bupyeong County. Conclusions: In some parts of the Incheon area there was a correlation between the number of patients with respiratory and cardiovascular conditions and the concentration of PM₁₀ and PM_2.5.

• Environmental Engineering Research
• /
• v.11 no.3
• /
• pp.156-163
• /
• 2006

In this study, substrate removal characteristics were analyzed to reduce the cost of external carbon dosage at Sudokwon Landfill Site Management Corporation in Korea by utilizing oxygen uptake rate (OUR) and nitrate uptake rate (NUR) tests. To estimate and evaluate the substrate removal characteristics obtained by the batch tests, the lab-scale MLE process was operated. By-products of J Co. (sugar manufactory) and S Co. (fine chemical industry) were selected as the concerned carbon sources through a comparison of carbon and nitrogen contents. MeOH was tested as a control experiment. Until the steady state, the fraction of $RBDCOD_{OUR}$ concentration to COD concentration of J Co., S Co. by-products and MeOH increased and reached levels of 98%, 82%, and 100%, respectively. During the 20th operating day, the fraction of $RBDCOD_{NUR}$ concentration to COD concentration was 95%, 81%, and 83%, respectively. These fractions of $RBDCOD_{NUR}$ concentration to $RBDCOD_{OUR}$ concentration increased according to acclimation periods and reached levels of 99%, 97%, and 81%, respectively, on the 20th day. The results obtained from the lab-scale MLE process operation using the concerned carbon sources as external carbon were similar to that observed by OUR and NUR tests.

• Journal of Korean Society of Environmental Engineers
• /
• v.28 no.11
• /
• pp.1135-1140
• /
• 2006

Concentration and speciation of trihalomethanes(THMs) and haloacetic acids(HAAs) that can be created during chlorine disinfection as disinfection by-products(DBPs) in Korean water treatment plants(WTPs) were investigated. 4 WTPs that adopted conventional water treatment processes were chosen for investigation and each represented a typical WTP on the Han, Keum, Sumjin and Nakdong Rivers. The average concentration of THMs was 26.9 ppb, and the maximum and minimum concentrations were 47.6 ppb and 11.0 ppb respectively, while the average concentration of HAAs was 25.4 ppb, and the maximum and minimum concentrations were 57.1 ppb and 9.7 ppb respectively. DBPs concentration was lower in the winter than the summer. The major species of THMs was chloroform and its average percentage was 77%, and the second highest was bromodichloromethane(20%), while the concentration of bromoform was below detection limits. The sum of dichloroacetic acid(DCAA) and trichloroacetic acid(TCAA) was 97% of $HAA_5 $ on average base. But its percentage was 90% in the Han River WTP, especially it was the lowest during the winter. On the other hand, the concentration of DCAA was higher than TCAA except during the summer.

• Asian Journal of Atmospheric Environment
• /
• v.6 no.2
• /
• pp.111-117
• /
• 2012

To establish area specific control strategy for ambient ozone in the Seoul Metropolitan Area (SMA), the maximum ozone concentration in each local government district in the SMA were estimated by using the OZone Isopleth Plotting Package for Research (OZIPR) model. The modeling period was June 2000 and the emission inventory data used were from National Institute of Environmental Research (NIER). Except the islands of Incheon, whole Seoul and Incheon areas were volatile organic compounds (VOCs) limited, i.e., decreasing the oxides of nitrogen ($NO_X$) emission alone may increase the maximum ozone concentration upto certain point. In Gyeonggi, 12 areas were VOCs limited while 12 areas were in between VOCs limited and $NO_X$ limited, i.e., decreasing both $NO_X$ and VOCs emission may decrease the maximum ozone concentration. Majority of the estimated ozone values were lower than the measured values. The reason could be inaccuracy in emission inventories and/or transport from other areas. The same calculation was carried out for June 2004 and it was found that Seoul was still in the VOCs limited condition.

• Journal of Preventive Medicine and Public Health
• /
• v.21 no.1 s.23
• /
• pp.152-162
• /
• 1988

Benzene and toluene, which are widely used aromatic hydrocarbons in workplace, are recently proved to cause health hazards due to their toxic effects. This study investigated the influence of toluene on the urinary excretion of benzene metabolite by administering short term exposure limit(STEL) of these compounds(i.e., 13.8mg/kg of benzene and 108.8 mg/kg of toluene) intraperitoneally into Sprague-Dawley rats. After administration, urinary phenol concentration of rat was measured by gas chromatography for every three hours. Data were analyzed by non-parametric statistical methods using Kruskal-Wallis multi-sample test and Mann-Whitney U test. The following results were obtained : 1. Administration of STEL-benzene increased urinary phenol concentration in lats. 2. Urinary phenol concentration was increased logarithmically according to the dosage of benzene. 3. Excretion of phenol in urine was decreased when benzene and toluene were administered simultaneously compared with administering benzene alone. In summary, these results reveal that administration of STEL of toluene has antagonistic effect of urinary excretion of benzene metabolite in rats.

• Proceedings of the Korean Society of Near Infrared Spectroscopy Conference
• /
• 2001.06a
• /
• pp.1284-1284
• /
• 2001

The transesterification of molten ethylene/vinylacetate (EVA) copolymers by octanol as a reagent and sodium methoxide as a catalyst in an extruder has been monitored by on-line near infrared (NIR) spectroscopy. A total of 60 NIR spectra were acquired for 37 minutes with the last spectrum recorded 31 minutes after the addition of octanol and catalyst was stopped. The experimental spectra show strong baseline fluctuations which are corrected for by multiplicative scatter correction (MSC). The chemometric methods of orthogonal projection approach (OPA) and multivariate curve resolution (MCR) were used to resolve the spectra and to derive concentration profiles of the species. The detailed analysis reveals the absence of completely pure variables that leads to small errors in the calculation of pure spectra. The initial estimation of a concentration that is necessary as an input parameter for MCR also presents a non-trivial task. We obtained results that were not ideal but applicable for practical concentration control. They enable a fast monitoring of the process in real-time and resolve the spectra of the EVA copolymer and the ethylene/vinyl alcohol (EVAL) copolymer to be very close to the reference spectra. The chemometric methods used and the decomposed spectra are discussed in detail.

• Journal of the Korean Institute of Illuminating and Electrical Installation Engineers
• /
• v.29 no.3
• /
• pp.54-60
• /
• 2015

There are 5 purification plants with the adopted advanced water purification treatment process in Korea. Annual operating costs were 8,990 million won including purchase cost of oxygen and power usage charges. We need research to optimize, in the future, when considering the direction of domestic water treatment continues to adopt advanced water treatment process. In this paper, calculate the optimal operating costs by injected the oxygen gas, used power cost. approximately 25% of the operating costs can be reduced when injected the ozone gas is 1.0ppm than 2.0ppm, the necessary amount of oxygen is increased then power is lower. so operating costs are decided according to oxygen costs. On the other hand, high ozone concentration 2.0ppm, the necessary power is increased then amount of oxygen is lower. Therefore, in the case of G purification plant, the controlling factor of the input ozone concentration 2ppm, PID control operation by setting the concentration of over 10Wt% is efficient. The installed capacity is the more little the more better when considering on Ozone injection rate in the process of water treatment.

• Environmental Engineering Research
• /
• v.19 no.1
• /
• pp.59-66
• /
• 2014

The aim of this study was to assess the effect of pre-aeration on sludge solubilization and the behaviors of nitrogen, dissolved sulfide, sulfate, and siloxane. The results of this study showed that soluble chemical oxygen demand in sewage sludge could be increased through pre-aeration. The pre-aeration process resulted in a higher methane yield compared to the anaerobic condition (blank). The pre-aeration of sewage sludge, therefore, was shown to be an effective method for enhancing the digestibility of the sewage sludge. In addition, this result confirms that the pre-aeration of sewage sludge prior to its anaerobic digestion accelerates the growth of methanogenic bacteria. Removal rates for $NH_3$-N and T-N increased simultaneously during pre-aeration, indicating simultaneous nitrification and denitrification. The siloxane concentration in sewage sludge decreased by 40% after 96 hr of pre-aeration; in contrast, the sulfide concentration in sewage sludge did not change. Therefore, pre-aeration can be employed as an efficient treatment option to achieve higher methane yield and lower siloxane concentration in sewage sludge. In addition, reduction of nitrogen loading by pre-aeration can reduce operating costs to achieve better effluent water quality in wastewater treatment plant and benefit the anaerobic process by minimizing the toxic effect of ammonia.

• Journal of Environmental Science International
• /
• v.14 no.3
• /
• pp.351-358
• /
• 2005

The research in this paper was carried out to examine the BTEX(Benzene, Toluene, Ethylbenzene, Xylene) concentrations in Seongseo Industrial Complex. These compounds are the major constituents, more than $60\%$ in composition of total VOCs, mainly charging in ambient air. BTEX samples were collected from the 38 sites, 10 for the source points and 18 for the boundary sites, and were analyzed by canister-GC/MS. The mean concentrations of BTEX were 33 ppbv for benzene, 214 ppbv for toluene, 89 ppbv for ethyl benzene, 77 ppbv for xylene. Among the BTEX, toluene had the highest concentration in the source points and boundary sites. In the source points, BTEX concentration of incineration facility for hazardous wastewater appeared highly in the range of 220­350 ppbv. BTEX concentrations in source boundary sites appeared in the order of toluene>ethylbenzene>xylene>benzene. As a result of the correlation analysis, the concentration of the source points was related to those of the boundary sites. Correlation of ethylbenzene and xylene was presented to 0.7991(P<0.0 1),\;0.6329(P<0.05) as the correlation coefficient, respectively.