• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.14 no.11
• /
• pp.1143-1148
• /
• 2003

The distortion of picosecond pulses caused by dispersion as it propagates along microstripline and CPW(Coplanar waveguide) is investigated and measured using time domain measurement. Especially, this study presents that the distortion of these lines is analyzed and compared considering the relation between the dispersion effect and cut-off frequency(f$\_$TE/) of fundamental TE mode for the substrate of line. To verify theoretical results, several samples of 50 $\Omega$ lines are fabricated on the two kind of substrates with the different values of f$\_$TE/. The propagation characteristics of picosecond Gaussian pulse on thess lines are simply measured using VNA(Vector Network Analyzer) with the time-domain analysis function.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.21 no.12
• /
• pp.1371-1379
• /
• 2010

This paper presents an analysis of impulse dispersion for impulse radio ultra-wide band(IR-UWB) antenna. A set of antenna structure configurations are highlighted with verification based on the STFT(Short Time Fourier Transform) in 3.1~5.1 GHz: first, a taper-slotted antenna allowing the optimal impulse transmission, and second, 4 types of the omni-directional IR-UWB antenna using different feed structures(microstrip line, and CPW(Coplanar Waveguide)). The proposed STFT allows the analysis of the IR-UWB antenna's dispersion characteristic.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.33 no.9A
• /
• pp.934-940
• /
• 2008

In this paper, an antenna accessible to the Hepta-Band (GPS, DCS, PCS, UMTS, Wibro, Bluetooth and S-DMB) is designed and fabricated. To get broadband characteristics with small size, we propose a structure of Coplanar Waveguide-fed with Ground, which is based on a monopole antenna. Simulation is performed by adjusting the size of distance between a length of radiation patch and ground plane. The designed antenna satisfies the frequency bandwidth of 1.430Hz$\sim$2.9GHz(67.89%), the gain of $1.3{\sim}3.7dBi$ and an omni-directional radiation pattern at VSWR<2.

• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.39 no.4
• /
• pp.19-25
• /
• 2002

In this paper, to improve the characteristics of a transmission line on silicon substrate, we fabricated air-bridge interconnected CPW transmission line on a 10-${\mu}{\textrm}{m}$-thick oxidized porous silicon(OPS) substrate using surface micromachining. Air-bridge interconnected CPW of S-W-S = 30-80-30 ${\mu}{\textrm}{m}$has insertion loss of -0.25 ㏈ and return loss of -28.9 ㏈ at 4㎓ And return loss of CPW with stepped compensated air-bridge(S-W-S : 30-100-30 ${\mu}{\textrm}{m}$) is improved -0.98㏈ at 4㎓. The results indicate that the thick OPS provides an approach to incorporate high performance, low cost microwave and millimeter wave circuits in a high-resistivity silicon-based process.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.23 no.1
• /
• pp.21-28
• /
• 2012

In this paper, we propose a flexible zeroth-order resonant(ZOR) antenna. Its zero phase constant ensures that the antenna performance is independent of substrate deformation. A composite right/left-handed transmission line is designed based on coplanar waveguide technology to realize the zeroth-order resonance phenomenon. The CRLH is an implementation of metamaterial(left handed material) which is composed of shunt inductance and series capacitance. In order to yield additional circuital parameter, chip inductor and gap capacitor is added, respectively. The proposed ZOR antenna provides good performances: reasonable bandwidth(6.5 %) and peak gain(0.69~1.39 dBi). Simulated and measured results show that the antenna's resonant frequencies and radiation patterns are almost unchanged at different curvature diameters of 30, 50, 70 mm, as well as for a flat surface.

• Transactions on Electrical and Electronic Materials
• /
• v.16 no.3
• /
• pp.142-145
• /
• 2015

In this work, open stubs were fabricated on a polyether sulfone (PES) substrate, and their basic radio frequency (RF) characteristics were investigated for application to RF matching components of a flexible monolithic microwave integrated circuit (MMIC). According to the results, an open stub employing coplanar waveguide (OSCPW) on PES exhibited much lower loss than that on silicon substrate. The OSCPW with a length of $500{\mu}m$ on PES showed capacitance values of 0.031 ~ 0.044 pF from 0.5 to 50 GHz. For application to a relatively high-value capacitive matching, an open stub employing a fishbone-type transmission line (OSFTTL) was fabricated on PES, and its characteristics were investigated. The OSFTTL showed much higher capacitance values than the OSCPW due to the high effective permittivity value. Specifically, the OSFTTL on PES showed capacitance values of 0.066 ~ 0.24 pF from 0.5 to 50 GHz, which are higher than those for the open stub on silicon substrate. The above results indicate that the OSCPW and OSFTTL on PES can be effectively used for application to low/high-value capacitive matching components on microwave and millimeter wave flexible MMIC. To the best of the authors' knowledge, this work is the first report of the investigation of RF capacitive matching components on PES substrate.

• Journal of Navigation and Port Research
• /
• v.46 no.3
• /
• pp.179-190
• /
• 2022

In this study, we investigated the characteristic impedance and bandwidth of CPW3DCS (coplanar waveguide employing periodic 3D coupling structures), and examined its potential for the development of a marine radio communication FISoC (fully-integrated system on chip) semiconductor device. To extract bandwidth and characteristic impedance of the CPW3DC, we induced a measurement-based equation reflecting measured insertion loss, and compared the measured results of the propagation constant β and characteristic impedance with the measured ones. According to the results of the comparison, the calculated results show a good agreement with the measured ones. Concretely, the propagation constant β and characteristic impedance exhibited an maximum error of 3.9% and 6.4%, respectively. According to the results of this study, in a range of LT = 30 ~ 150 ㎛ for the length of periodic structures, the CPW3DC exhibited a passband characteristic of 121 GHz, and a very small dependency of characteristic impedance on frequency. We could realize a low impedance transmission line with a characteristic impedance lower than 20 Ω by using CPW3DCS with a line width of 20 ㎛, which was highly reduced, compared with a 3mm line width of conventional transmission line with the same impedance. The characteristic impedance was easily adjusted by changing LT. The above results indicate that the CPW3DC can be usefully used for the development of a wireless communication FISoC (fully-integrated system on chip) semiconductor device. This is the first report of a study on the bandwidth of the CPW3DC.

• Transactions on Electrical and Electronic Materials
• /
• v.13 no.5
• /
• pp.237-240
• /
• 2012

A conducting polymer, poly 3-hexylthiophene (P3HT) is characterized with the metal-insulator-semiconductor (MIS) measurement method and the high frequency planar circuit method. From the MIS measurement method, the relative dielectric constant of the P3HT film is estimated to be 4.4. For the high frequency planar circuit method, a coplanar waveguide is fabricated on the P3HT film. When applying +20 V to the CPW on P3HT film, the P3HT film is in accumulation mode and becomes lossy. The CPW on P3HT film is 1.5 dB lossier than the CPW on $SiO_2$ film without P3HT film at 50 GHz.

• Journal of information and communication convergence engineering
• /
• v.8 no.5
• /
• pp.489-492
• /
• 2010

This paper proposes the planar-type modified monopole antennas of loop structure. This antenna has an opened center of a conventional closed loop structure with an inside-folded terminal of the loop microstrip line. The size of the proposed antenna was minimized by folding the end of the loop. Also, the reactance value has been minimized by increasing capacitances between the coupled microstrip line. Therefore the proposed antenna has been compacted to about 20% from a conventional loop antenna and has increased its efficiency. The proposed antennas have an omni-directional pattern, the antenna gain was 3.67 [dBi] and the bandwidth was 900 MHz (2.6~3.56 GHz) with VSWR$\leq$2 from the simulated and the measured results. The frequency utilization coefficient was 29.9%. These properties could satisfy the S-DMB band.

• Journal of the Korean Institute of Telematics and Electronics
• /
• v.20 no.3
• /
• pp.40-44
• /
• 1983

A wide band quasi-log periodic microstrip antenna is designed using circular-disc microstrip patches as a basic radiator. The radiating elements are series-fed by a coplanar feeding network which consists of an open circuited feed line with a branch line connected to each radiating element. Experiment results show that the values of VSWR are less than 2.3 over the range of 2.72-3.43 GHz.