• Restorative Dentistry and Endodontics
• /
• 제29권5호
• /
• pp.439-445
• /
• 2004

Continuous Wave 가압법으로 근관충전시 플러거 삽입 깊이에 따른 근관실러의 치근단 정출을 평가하고자 직선형의 단근관 및 15번 크기의 치근단공을 가지는 발거된 40개의 치아에서 0.06 경사도 40번 크기가 되게 니켈-티타늄 전동화일인 $ProFile^{\circledR}$로 근관을 형성하고 플러거 삽입깊이를 근단 3, 5 또는 7 mm로 하여 System $B^{TM}$를 이용한 Continuous Wave 가압법 및 측방가압법으로 근관을 충전하였다. 치근단으로 정출된 근관실러의 무게를 측정하여 일원변량분석법과 Duncan's Multiple Range Test로 통계분석하였다. 플러거 삽입깊이 3 mm 또는 5 mm의 Continuous Wave 가압 충전군은 삽입깊이 7 mm 가압충전 군 및 측방가압 충전군에 비해 유의하게 많은 근관실러의 치근단 정출을 나타내었다 (p < 0.05). 그러나 플러거 삽입깊이 3 mm군과 5 mm군 사이 및 플러거 삽입깊이 7 mm Continuous Wave 가압군과 측방가압 군 사이에는 유의한 차이가 나타나지 않았다 (p > 0.05). 본 연구의 결과로 보아 Continuous Wave 가압법으로 근관충전시에는 플러거 삽입깊이가 깊을수록 근관실러의 치근단 정출이 많음을 알 수 있다.

• International Journal of Naval Architecture and Ocean Engineering
• /
• 제7권6호
• /
• pp.1056-1063
• /
• 2015

Waves can be expressed in terms of a spectrum; that is, the energy density distribution of a representative wave can be determined using statistical analysis. The JONSWAP, PM and BM spectra have been widely used for the specific target wave data set during storms. In this case, the extracted wave data are usually discontinuous and independent and cover a very short period of the total data-recording period. Previous studies on the continuous wave spectrum have focused on wave deformation in shallow water conditions and cannot be generalized for deep water conditions. In this study, the Generalized Extreme Value (GEV) function is proposed as a more-optimal function for the fitting of the continuous wave spectral shape based on long-term monitored point wave data in deep waters. The GEV function was found to be able to accurately reproduce the wave spectral shape, except for discontinuous waves of greater than 4 m in height.

• Journal of Positioning, Navigation, and Timing
• /
• 제1권1호
• /
• pp.15-21
• /
• 2012

For a GNSS receiver's robustness against RFI and the high accuracy of navigation solution in GNSS, interference source detection and mitigation are needed. In this paper, an adaptive lattice IIR notch filter is employed to track single-tone continuous wave and swept continuous wave interference signals, and an interference detection method is proposed. Furthermore, this paper presents interference source characterization algorithm using multiple ground stations' interference detection results. The measurement of the signal powers from each ground station is used to build weighting factors to estimate the type of the interference. The performance of interference detection algorithm is simulated for scenarios of GPS signal in the presence of single-tone continuous wave interference and swept continuous wave interference.

• 한국광학회지
• /
• 제14권3호
• /
• pp.338-342
• /
• 2003

최근 활발하게 연구되고 있는 광섬유 센서에 사용되는 광펄스신호가 광섬유에 입력될 때 발생할 수 있는 stimulated Brillouin scattering현상에 대하여 연구하였다. 펄스광원의 평균 광세기가 연속광원의 광세기와 같으면 SBS현상도 같아진다는 것을 알 수 있었다. 연구결과를 통해 연속광원을 이용한 SBS측정 결과를 이용하여 광펄스신호가 입력되었을 때 SBS 현상을 예측할 수 있다.

• 한국정보통신학회:학술대회논문집
• /
• 한국정보통신학회 2016년도 추계학술대회
• /
• pp.700-702
• /
• 2016

나로우주센터에서는 우주발사체의 비행임무 초기구간 동안에 발사체의 거리 및 속도정보를 획득하기 위해서 광학추적장비에 거리측정 도플러 레이더를 탑재하여 운용하고 있다. 본 논문은 광학추적장비의 MFCW(Multi Frequency Continuous Wave)방식과 FMCW(Frequency Modulation Continuous Wave)방식 도플러 레이더 구성과 거리측정 방법을 기술하였다.

• 대한정형도수물리치료학회지
• /
• 제13권2호
• /
• pp.1-11
• /
• 2007

Purpose: The purpose of this study was to determine the effect of continuous wave ultrasound and pulsed wave ultrasound that influence changes in pain and range of motion when applied to patients with temporomandibular joint disability. Methods: The subjects of the study were 40 selected patients who had been diagnosed with temporomandibular joint movement restriction and had endured pain for more than two weeks. These patients had visited K orthopedic surgery in Deagu measured from October 1, 2004 to March 31, 2005. The subjects were divided into two groups with 20 patients each. The one group was applied to continuous wave ultrasound and the other group was applied to pulsed wave ultrasound at a dosage of 1.5 W/$cm^2$ for a duration of 5 minutes and eight times for two weeks. The pain perception degree were measured by using Visual Analogue Scale(VAS) and the range of motion was measured by using a rule for each group. Results: The results obtained were as follows The change in the pain perception degree were statistically significant in both group(p<0.05) ; however, the continuous wave ultrasound group showed more difference in the average decrease in the pain perception degree than did the pulsed wave ultrasound group. Both groups showed significant results regarding changed in the range of motion(p<0.05) ; Comparing the difference in the average of the range of motion between the two groups, came back from normal the range of motion of temporomandibular joint at the both groups. Conclusion : Based on the results of this study, we found that both groups showed decreased pain and increased the range of motion, but the continuous wave ultrasound method had a higher therapy effect pain and the range of motion than the pulsed wave ultrasound method to patients with temporomandibular joint disability. With such finding, we expect that according to ultrasound therapy applicant method can be helped usable accurately to patients with variety symptoms temporomandibular joint disability.

• 한국정밀공학회:학술대회논문집
• /
• 한국정밀공학회 2009년도 춘계학술대회 논문집
• /
• pp.437-438
• /
• 2009

• 한국지구과학회지
• /
• 제28권7호
• /
• pp.903-913
• /
• 2007

천부지반에서 레일리파의 군속도와 위상속도 분산곡선을 역산하여 S파 속도구조를 구하는 방법을 비교하였다. 위상속도를 구하기 위해서 ${\tau}-p$ stacking 방법을 이용하였고, 군속도를 구하기 위해서 두 가지 방법, multiple filtering technique(MFT) continuous wavelet transform(CWT) 방법을 사용하였다. 고차모드가 존재하는 경우, 위상속도에서 기본모드와 고차모드를 분리하기가 용이하지 않았고, 군속도에서는 continuous wavelet transform 방법이 multiple filtering technique보다 효과적이었다. S파 속도 역산 결과, 위상속도와 군속도의 기본 모드만 역산할 경우, 신뢰구간의 깊이가 아주 얕았다. Continuous wavelet transform으로 구한 기본 모드와 1차 모드를 동시 역산할 경우, 신뢰구간의 깊이가 2배 이상 증가함을 알 수 있었다. 이는 1차 모드의 에너지가 더 깊은 층을 통과함으로 깊은 층에 대한 5파 속도 정보를 지니고 있기 때문으로 보인다. 위의 방법을 서해안 동호항의 조간대에 적용하여, continuous wavelet transform으로 구한 군속도의 기본 모드와 1차 모드를 동시 역산하여 S파 속도구조를 구하고, 해당 지역의 시추조사 결과와 비교하였다.

• Restorative Dentistry and Endodontics
• /
• 제24권3호
• /
• pp.490-494
• /
• 1999

The aim of this in vitro study was to investigate the coronal leakage of obligate anaerobes into root canals obturated with two different techniques. 48 extracted human teeth with straight, single root canals were prepared with crown-down technique with Profile under copious irrigation until the master apical file was size 40. The teeth were divided randomly into experimental groups (40 teeth) and control groups (8 teeth). In the experimental groups, 20 teeth were obturated with lateral condensation and other 20 teeth were obturated with continuous wave technique with System B. Coronal leakage of two root canal filing technique was evaluated using anaerobic bacterial leakage model with Fusobacterium nucleatum(ATCC 25586) for 60 days. The results were as follows 1. The incidence of bacterial leakage of experimental groups was 65% in group 1 (lateral condensation) and 60% in group 2 (continuous wave technique with System B). This difference was not statistically significant (P>0.05). 2. There was no statistically significant difference(P>0.05) in leakage score between group 1 (lateral condensation) and group2 (continuous wave technique with System B).

• 한국소음진동공학회논문집
• /
• 제20권3호
• /
• pp.272-278
• /
• 2010

A method for damage detection in a plate structure is presented based on strain waves that are generated by impact or damage in the structure. Strain responses from continuous sensors, which are long ribbon-like sensors made from piezoceramic fibers or other materials, were used with a neural network technique to estimate the damage location. The continuous sensor uses only a small number of channels of data acquisition and can cover large areas of the structure. A grid type structural neural system composed of the continuous sensors was developed for effective damage localization in a plate structure. The ratios of maximum strains and arrival times of the maximum strains obtained from the continuous sensors were used as input data to a neural network. Simulated damage localizations on a plate were carried out and the identified damage locations agreed reasonably well with the exact damage locations.