• Journal of the Korean Geotechnical Society
• /
• v.18 no.4
• /
• pp.339-347
• /
• 2002

An in-situ experiment was performed to evaluate the pullout resistance capacity of chains which is used as a reinforcement of reinforced earth wall. It was also considered that chain was combined with a bar or L-type steel angle by the transverse reinforcement member in the experiment. About 80 pullout tests were peformed with varying the lengths of chain(2.0m, 2.5m, and 3.0m), the combination of each transverse members(chain only, chain＋bar, or chain＋angle), and the vertical placement of reinforcements. In the case that uses a chain only and a chain combined with bar, the maximum displacement was about 150mm and load continuously increased to the ultimate tensile strength of chain, and then tension failure of chains occurred. But in the case of a chain combined with angle, the displacement decreased to about 100mm and so it was expected that this combination can constrain the displacement of chain. On the other hand, comparing the yielding pullout load measured in the field to that calculated by theoretical equation, it is shown that measured values are 1.2~3.0 times greater than those of calculated values according to the length of chain, normal vertical stress, and the combination of chain with transverse members. However, the difference in the increment of yielding pullout load between bar and angle is not clear but it appears almost the same increment. It is expected that chain can be safely used as reinforcements of reinforced earth wall, although a theoretical estimation of the pullout resistance capability of chain is too conservative.

• KDI Journal of Economic Policy
• /
• v.14 no.3
• /
• pp.23-48
• /
• 1992

The Korea's Consumer electronics industry has exhibited a spectacular growth in the last three decades, expanding into one of the most important industries in Korea in many respects. One interesting aspect of the industry is the dominant role played by the Big Three of the industry, Gumsung, Samsung, and Daewoo. Since 1984, the three companies have accounted for about 90% of the sales in key items such as color TV, VTRs, refrigerators, and washers. The Big Three not only dominated the manufacturing stage, but also the distribution stage of the industry through their networks of exclusive dealers that constitute the major part of the distribution market. In this study, we analyzed the effects of the exclusive dealing by the Big Three on the efficiency of the Korean economy. We find that exclusive dealing by the Big Three could seriously constrain competition in both the manufacturing and distribution stages of the industry. Exclusive dealing by the Big Three effectively forcecloses the market for most other manufacturers as well as deterring entry into the manufacturing stage by potential entrants. Further, it impedes the growth of distributors that achieve the economies of scale and scope and restricts competition by the Big Three. In contrast, we could find little evidence that exclusive dealing by the Big Three is pro-competitive or enhances welfare. As a remedy to this problem, we suggest that the Fair Trade Commission of Korea should regulate the exclusive dealing by the Big Three, thus opening the door for the growth of distributors that are not bound by an exclusive dealing relationship with any of the Big Three. Put differently, we urge the Korean Fair Trade Commission to apply the Article 23 (5) to the exclusive dealing by the Big Three. Article 23 (5) that states that unfair restrictive dealing is illegal has never been clarified by the FTC. We believe that our analysis could also serve as a basic for the clarification of the article in general.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.12 no.8
• /
• pp.3766-3776
• /
• 2011

The redevelopment project implementation difficulties and irregularities of the initial funding has been delayed in Busan. These financing and corruption in order to eradicate the composition of Urban & Residence Environment Improvement Fund. The province's major tax revisions improvement fund finances of City Planning Tax is due to the reduction is difficult to secure additional finances. This study tried to promote the activation of redevelopment in Busan by using Maintenance fund improvement of the institutional constrain As the results of this study, firstly, it is need to convert Metropolitan tax to some urban planning tax in local tax, some improvement fund to general rate among the Metropolitan tax. Secondly, we suggested to support of the practical measures for the operation and maintenance funds systematically, Urban & Residence Environment Improvement Fund the installation and operating ordinance's enactment, to establish a maintenance fund should be operational plan.

• Atmosphere
• /
• v.23 no.1
• /
• pp.93-102
• /
• 2013

Atmospheric transport pathway of an air mass is an important constraint controlling the chemical properties of the air mass observed at a designated location. Such information could be utilized for understanding observed temporal variabilities in atmospheric concentrations of long-lived chemical compounds, of which sinks and/or sources are related particularly with natural and/or anthropogenic processes in the surface, and as well as for performing inversions to constrain the fluxes of such compounds. The Lagrangian particle dispersion model FLEXPART provides a useful tool for estimating detailed particle dispersion during atmospheric transport, a significant improvement over traditional "single-line" trajectory models that have been widely used. However, those without a modeling background seeking to create simple back-trajectory maps may find it challenging to optimize FLEXPART for their needs. In this study, we explain how to set up, operate, and optimize FLEXPART for back-trajectory analysis, and also provide automatization programs based on the open-source R language. Discussions include setting up an "AVAILABLE" file (directory of input meteorological fields stored on the computer), creating C-shell scripts for initiating FLEXPART runs and storing the output in directories designated by date, as wells as processing the FLEXPART output to create figures for a back-trajectory "footprint" (potential emission sensitivity within the boundary layer). Step by step instructions are explained for an example case of calculating back trajectories derived for Anmyeon-do, Korea for January 2011. One application is also demonstrated in interpreting observed variabilities in atmospheric $CO_2$ concentration at Anmyeon-do during this period. Back-trajectory modeling information introduced in this study should facilitate the creation and automation of most common back-trajectory calculation needs in atmospheric research.

• Journal of Conservation Science
• /
• v.28 no.3
• /
• pp.185-192
• /
• 2012

Issues of chronology on archaeological remains or relics have been a storm-center of controversy when various archaeological researches have been done. Sometimes there is a limit for figuring out issues of chronology by archaeological research. In that case, the field of natural science is often needed to work out issues of chronology. Among various subjects in natural science, archaeomagnetism plays an important role in dating archaeological remains for baked earth bearing relics. In particular, archaeomagnetism is of use for sites where directly excavated dating proxy is unavailable. Terrestrial magnetism changes along with the passage of time and leaves trace by many kinds of residual magnetization which could be called fossil of terrestrial magnetism. Archaeomagnetic dating method is used to assign a date to the archaeological remains in which baked earth is found by measuring the changes of terrestrial magnetism through the thermal remanent magnetization retained in baked earth. This study aims to constrain the age of fire at Buinsa, Daege, Korea using 27 samples that were collected from a layer of baked earth. Buinsa is famous for the place where kept the first edition of Tripitaka Koreana, which was lost in fire at the second invasion of mongolia. In addition, there is a record that there was revolt around this region in A.D.1203. According to archaeomagnetic dating, ages of A.D.1150~1200 and A.D.1130~1210 were assigned for the two building sites in Buinsa, respectively. To this end, it can be concluded that the layer of baked earth on the two building sites in Buinsa recorded the vestige of fire caused by revolt.

• Journal of the Korean Geotechnical Society
• /
• v.19 no.6
• /
• pp.307-323
• /
• 2003

In this study the pilot test of C.G.S (Compaction Grouting System) as injection method by low slump mortar was performed and the results were analyzed in order to find out the application of this method to the soft ground and the effect of settlement restraint. The site for pilot test is adjacent to apartments supported by pile foundations. Sand drain method was performed previously as countermeasures against settlement, but settlement occurs continuously because this ground is very soft. Site investigations such as SPT, CPT and vane shear test were performed to determine the characteristics of ground improvement after the installation of C.G.S. Field measurements were performed on purpose to find out the displacement of ground during the installation of C.G.S. From the results of this study, C.G.S method can be optimized by the control of radius, space, depth, injection material and injection pressure. C.G.S improves soft ground with radial consolidation of adjacent soft ground. Considering that increase of N value to about 3, C.G.S can be considered as an effective method to increase the bearing capacity as well as constrain the settlement of soft ground. It is also expected to be economic and effective in the improvement of ground when it is used in applicable sites.

• Journal of the Korean earth science society
• /
• v.22 no.6
• /
• pp.512-527
• /
• 2001

Separated flows passed complex geometries are modeled by discrete vortex techniques. The flows are assumed to be rotational and inviscid, and a new techlnique is described to determine the stream functions for linear shear profiles. The geometries considered are the snow cornice and the backward-facing step, whose edges allow for the separation of the flow and reattachment downstream of the recirculation regions. A point vortex has been added to the flows in order to constrain the separation points to be located at the edges, while the conformal mappings have been modified in order to smooth the sharp edges and to let the separation points free to oscillate around the points of maximum curvature. Unsteadiness is imposed to the flow by perturbing the vortex location, either by displacing the vortex from the equilibrium, or by imposing a random perturbation with zero mean to the vortex in equilibrium. The trajectories of passive scalars continuously released upwind of the separation point and trapped by the recirculating bubble are numerically integrated, and concentration time series are calculated at fixed locations downwind of the reattachment points. This model proves to be capable of reproducing the trapping and intermittent release of scalars, in agreement with the simulation of the flow passed a snow cornice performed by a discrete multi-vortex model, as well as with direct numerical simulations of the flow passed a backward-facing step. The results of simulation indicate that for flows undergoing separation and reattachment the unsteadiness of the recirculating bubble is the main mechanism responsible for the intense large-scale concentration fluctuations downstream.

• Journal of the Korean earth science society
• /
• v.41 no.5
• /
• pp.478-489
• /
• 2020

This study presents an analysis of infrasonic signals from two accidental explosions in Gwangyang city, Jeonnam Province, Korea, on December 24, 2019, recorded at 12 infrasound stations located 151-435 km away. Infrasound propagation refracted at an altitude of ~40 km owing to higher stratospheric wind in the NNW direction, resulting in favorable detection at stations in that direction. However, tropospheric phases were observed at stations located in the NE and E directions from the explosion site because of the strong west wind jet formed at ~10 km. The transmission losses on the propagation path were calculated using the effective sound velocity structure and parabolic equation modeling. Based on the losses, the observed signal amplitudes were corrected, and overpressures were estimated at the reference distance. From the overpressures, the source energy was evaluated through the overpressure-explosive charge relationship. The two explosions were found to have energies equivalent to 14 and 65 kg TNT, respectively. At the first explosion, a flying fragment forced by an explosive shock wave was observed in the air. The energy causing the flying fragment was estimated to be equivalent to 49 kg or less of TNT, obtained from the relationship between the fragment motion and overpressure. Our infrasound propagation modeling is available to constrain the source energy for remote explosions. To enhance the confidence in energy estimations, further studies are required to reflect the uncertainty of the atmospheric structure models on the estimations and to verify the relationships by various ground truth explosions.

• Journal of Broadcast Engineering
• /
• v.17 no.5
• /
• pp.716-724
• /
• 2012

In this paper, we propose a fast decision method of maximum coding depth decision and reference frame selection in HEVC. To reduce computational complexity and encoding time of HEVC, two methods are proposed. In the first method, the maximum depth of each coding unit (CU) in a largest CU (LCU) is constrained by using the maximum coding depth used by adjacent LCUs based on the assumption that the spatial correlation is very high and rate-distortion (R-D) cost. And we constrain the number of reference pictures for prediction unit (PU) performing motion estimation by using the motion information of the upper depth PU. The proposed methods reduce computational complexity of the HEVC encoder by constraining the maximum coding depth and the reference frame. We could achieve about 39% computational complexity reduction with marginal bitrate increase of 1.2% in the comparison with HM6.1 HEVC reference software.

• The Journal of the Petrological Society of Korea
• /
• v.4 no.2
• /
• pp.144-152
• /
• 1995

The Jangsan Quartzite of the Joseon Supergroup and the foliated granite (so-called granitlc gneiss of presumed Precambrian age) of the Yeongnam massif are in direct contact at Cheondong-ri area, 6 km @SE of Danyang. sllthough it has been thought traditionally that the Jangsan Quartzite overlies unconformably the f&ted granite, it is difficult to interpret the contact as an unconformity smce the basal conglomerate in- the lower part of the Jangsan Quartzite does not have any clast of the foliated granite, Rather, recent structural studies of this area indlcate that the contact is a ductile shear zone. However, the sense and age of the shear movement are still problematic. Our mesoscopic and microscopic studies of &tre Cheondong-11 semi-brittle shear zone involving foliated cataclasite and phyllonite, which is a pa& of the Ogdong fault, indlcate a top-to-the northeast shearing, i.e., dextral strike slip. We also performed Pb-Pb dating for the age-unknown foliated granite, since the age of deformed granite ccarr emtrain the maximum age of deformation. The whole rock and feldspar Pb isotape data for the foliated granite and a micaceous xenolith define an isoc chron age of $2.16{\pm}0.15$ Ga ($2{\sigma}$;MSWD=4.4) which is interpreted as the emplacement age of the granite. This early Proterozoic age agrees with those of Precambrian igneous activity In the Yeongnam massif reported previously. The obtaiPrfid gge confirms the traditional idea about the age of the foliated granite and indicates that other methd(s) should be employed to constrain the age of the shear movement.