• 대한전기학회:학술대회논문집
• /
• 대한전기학회 1995년도 추계학술대회 논문집 학회본부
• /
• pp.264-267
• /
• 1995

In indirect vector control, if the value or the rotor tine constant used in slip calculation is different from the actual rotor time constant because of the temperature rising and flux saturation level, model flux angle and actual flux angle is different so that the transient and steady state response is degraded. In this paper, flux deviation angle is calculated by using actual torque and reference torque, and this flux deviation angle is summed to slip angle, therefore rotor flux angle is always accurate and indirect vector control is satisfied.

• International Journal of Air-Conditioning and Refrigeration
• /
• 제14권4호
• /
• pp.125-130
• /
• 2006

This study has been performed to investigate the thermal performance of variable conductance heat pipe (VCHP) with screen meshed wick. The active length of condenser section in a VCHP is varied by non-condensible gas, which controls the operating temperature, and the heat capacity of VCHP is controlled by the operating temperature. In this study, numerical analysis of the VCHP based on the diffusion model of non-condensible gas is done for the thermal control performance of VCHP. Water is used as a working fluid and nitrogen as a control non-condensible gas in the copper tube. As a result, the thermal conductance of VCHP has been compared with that of constant conductance heat pipe (CCHP) corresponding to the variation of operating temperature.

• 수산해양교육연구
• /
• 제29권3호
• /
• pp.702-710
• /
• 2017

Recently, in many reptiles (14 genera of turtles in five families), common characteristics of incubation temperatures are known to determine the sexes of hatchlings in many species of turtles, including the map turtles, painted turtles and snapping turtles, emys turtle, etc. According to many researcher's reports, in general, incubation at $25^{\circ}C$ (cooler temperatures) produces all or mostly males, however, incubation at $31^{\circ}C$ (higher temperatures) or higher produces all or mostly females. Exceptionally, even cooler temperature ($20^{\circ}C$) produce females, they produced all or mostly females. Accordingly, it is well-known that incubation temperature is the sex determining agent in these turtles. However, this paper presents study of the sex ratio and nest ecology in natural spawning nest: Observations on hatching sex ratios of eggs collected from natural nests of T. sinensis are similar to a previous report of the same genus Trionyx in the soft-shelled turtles. However, this genus (or species) showed some different phenomena to other kinds of turtles such as various kinds turtles mentioned above. After collection of naturally spawned eggs (17 eggs of T. sisnensis) on the natural nests, a laboratory experiment by the constant incubation temperatures was conducted with natural fluctuating soil temperatures in the natural nest with the soft-shelled turtle, T. sinensis. And also laboratory experiments were conducted using constant incubation temperatures of $25^{\circ}C$ (cooler temp.) and $30^{\circ}C$ (higher temp.) with the turtle, T. sinensis. Exceptionally, it was confirmed that the first and second incubation temperatures can't control sex-determination in the freshwater soft-shelled turtle, T. sinensis. The sex ratio approximated 1:1 (${\chi}^2=0.06$, P>0.05 (the Ist experiment). And the sex ratio approximated 1:1 independently of incubation temperature (${\chi}^2=0.33$, P>0.05 (the 2nd experiment). Consequently, temperature has no effect on sex determination in the genus Trionyx in a soft-shelled turtle.

• 대한전기학회논문지:전기기기및에너지변환시스템부문B
• /
• 제51권2호
• /
• pp.69-76
• /
• 2002

To obtain a high performance in a vector controlled induction motor, it is essential to know the instantaneous position of the rotor flux which depends on the rotor time constant. But the rotor time constant mainly varies due to the temperature rise in the motor winding, so real time compensating algorithm is necessary. This paper proposes that it uses short duration pulses added to the constant flux command current and then resultant torque command current produced by speed controller is utilized for the rotor resistance estimation. This method has advantage with a low computational requirement and does not require voltage sensors. The proposed method is proved by simulations and experimentals.

• Nuclear Engineering and Technology
• /
• 제56권5호
• /
• pp.1698-1711
• /
• 2024

Heat pipe cooled reactors have gained attention as a potential solution for nuclear power generation in space and deep sea applications because of their simple design, scalability, safety and reliability. However, under complex operating conditions, a control strategy for variable load operation is necessary. This paper presents a two-dimensional transient characteristics analysis program for a heat pipe cooled reactor and proposes a variable load control strategy using the recuperator bypass (CSURB). The program was verified against previous studies, and steady-state and step-load operating conditions were calculated. For normal operating condition, the predicted temperature distribution with constant heat pipe temperature boundary conditions agrees well with the literature, with a maximum temperature difference of 0.4 K. With the implementation of the control strategy using the recuperator bypass (CSURB) proposed in this paper, it becomes feasible to achieve variable load operation and return the system to a steady state solely through the self-regulation of the reactor, without the need to operate the control drum. The average temperature difference of the fuel does not exceed 1 % at the four power levels of 70 %,80 %, 90 % and 100 % Full power. The output power of the turbine can match the load change process, and the temperature difference between the inlet and outlet of the turbine increases as the power decreases.

• 한국의류학회지
• /
• 제36권1호
• /
• pp.1-11
• /
• 2012

This paper reports on a prototype cooling garment applying a cooling module. The cooling module was composed of a Peltier device, a cold sink, a heat sink and two fans. A constant box was used to evaluate the cooling effect of the module. Two cooling modules were attached on each side of the garment. The wear trial was conducted using 10 male subjects in an environmental chamber maintained at $30{\pm}0.5^{\circ}C$, $50{\pm}5%$RH. Subjective sensations of thermal, humidity, and comfort were surveyed. Statistical package SPSS12.0 was used for the t-test and the Wilcoxon signed-rank test. The results showed that most effective cooling module decreased the temperature of the constant temperature box by $-4.9^{\circ}C$. The micro-temperature of the cooling garment with a Peltier device was lower than the control garment during the exercise. In particular, the chest skin temperature was $1.5^{\circ}C$ lower with the cooling garment than the control. The maximum temperature difference was $-2.57^{\circ}C$ on the sides of the $1^{st}$ layer. Subjective thermal sensation from wear trials of the Peltier device attached garment was lower than the control garment. Subjects felt more comfortable with the cooling garment in almost all the periods.

• 대한기계학회논문집B
• /
• 제28권10호
• /
• pp.1172-1177
• /
• 2004

The emission control of automobile has been intensified as a part of the countermeasure to decrease air pollution in the world. As the cars with an alternative fuel starts to get into the spotlight, the cars with low emission has been introduced and exhaust gas regulation forced in this country. These days, LPG vehicles, which infrastructure of fuel was already built up, and CNG vehicles are recognized for alternative fuel cars in this country. In this study, the constant volume combustion chamber was manufactured and used for experiments to obtain the combustion characteristics of propane mixture. The combustion characteristics was analyzed, with the change of supply conditions of propane fuel. Inside the combustion chamber, the maximum temperature increase with the initial pressure is going up. The burning velocity also seems to have the same characteristic as the temperature. However, the heat flux do not change much according to the theoretical correct mixture but it changes with the various initial temperature of the combustion chamber.

• 제어로봇시스템학회:학술대회논문집
• /
• 제어로봇시스템학회 1997년도 한국자동제어학술회의논문집; 한국전력공사 서울연수원; 17-18 Oct. 1997
• /
• pp.305-308
• /
• 1997

The on-line calculation method is developed to obtain the temperature trajectory that brings the reactants to the desired state in batch styrene polymerization reactor. The temperature trajectory is obtained by applying the moments of the polymer concentration to the 2-step calculation method. The computer simulation is also carried out to verify the superiority of the on-line method to the off-line one. When a temperature disturbance of constant size is introduced, the off-line results shows considerable deviation from the target degree of polymerization. The on-line strategy set up a new trajectory to reach the desired state by using the current state of the reactor. Therefore, the on-line strategy deals with the changes of the system more adequately than the off-line strategy.

• E2M - 전기 전자와 첨단 소재
• /
• 제8권5호
• /
• pp.640-647
• /
• 1995

In this study, the BaTiO$\sub$3/ capacitor add to MnO$\sub$2/ like depressor and shifter were investigated for temperature or voltage compensation by structural and electrical analysis. The relative density of BCTM, generating poly crystall and formation of lattice defect, has a 90[%] over as the CaTiO$\sub$3/ come out to control grain size. The current density of BCTM2 increased non-ohmic in high-electric field but that BCTM3 and BCTM4 had a few changing. The BCTM3 and BCTM4 unformated grain boundary shown temperature compensation properties, so that the dielectric constant was low value. The curie point was near 140[.deg. C] in BCTM1 and BCTM4, but BCTM3 and BCTM4 not shown the curie point. It is found that the charging energy of BCTM4 was changed 6[%] according to rising temperature from room temperature to 417[K]. The formation of BaMnO$\sub$3/ was low dielectric constant to change frequency and temperature.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 1995년도 하계학술대회 논문집 C
• /
• pp.1102-1104
• /
• 1995

This study presents the results of an investigation on the electrical characteristics of $PVF_2$ film, to be regarded as the excellent piezo and pyroelectricity, using dielectric relaxation technique by the variation of temperature and frequency. As one of the results, we confirmed that crystal form with Infrared absorption and XRD was ${\alpha}$ type and its crystalline was 59[%]. Also, the results of observation conformed to Debye theory for frequency variation of relative permitivity and dielectric relaxation. Especially, we confirmed each constant values in comparision with equation related to diffusion behavior of ion, so we obtained that activation energy was computed 17.25[kcal/mole] from the relation curve with frequency and temperature.