• 대한치과보철학회지
• /
• 제28권1호
• /
• pp.137-163
• /
• 1990

The properties of a investment material can be described by the consistency at the slurry state, the setting time, the compressive strength and the thermal expansion during the casting. In this study the effect of the production parameters which are included the ratio of quartz and cristobalite, the content of binder, the water powder ratio and the content and concentration of additives on the Properties of the gypsum-bonded investments has been investigated with help of the consistency test, the vicat needle test, the compressive strength test, the thermal expansion test, x-ray diffraction and DTA thermal differential test. The experimental results showed that the constitution of a investment with W/P ratio of 0.34, 30% of gypsum, 0.8% aluminium sulfate, 2% magnesium sulfate, 0.6% sodium phosphate was adapted for the properties of the KDA Spec. No. 13 type I investment. The important experimental results are summarized as follows. 1. The consistency of the investment decreased with increasing amount of aluminium sulfate and decreasing amount of sodium phosphate. An addition of magnesium sulfate up to 2% an increase of the consistency was shown. But 3% magnesium sulfate in investment showed a decrease of the consistency. The consistency did not vary significantly with a variation of the content of gypsum and cristobalite and the W/P ratio. 2. Aluminium sulfate and the magnesium sulfate promoted the hardening and the aluminium phosphate delayed the hardening. The setting time increased with amount of gypsum. The effect of the matrix on the setting time was insignificant. With the W/P ratio of 0.34 the setting time was 14 min. 3. The compressive strength decreased with the amount of aluminium sulfate up to 0.25% and increased with the amount of aluminium sulfate greater than 3%. The compressive strength decreased as decreasing the amount of magnesium sulfate and gypsum and as increasing the W/P ratio. The effect of the refractory on the compressive strength was also not significant. With the W/P ratio of 0.34 the compressive strength was $34Kg/mm^2$. 4. The 1st thermal expansion was found at the temperature near and the steady state or the contraction stage was found at the temperature between $250^{\circ}C$ and $500^{\circ}C$. After this stage the 2nd thermal expansion took place at the temperature near $500^{\circ}C$. The amount of thermal expansion increased with decreasing the content of magnesium sulfate, aluminium sulfate and gypsum and the W/P ratio. And the amount of thermal expansion increased as the content of sodium phosphate and cristobalite. With the W/P ratio of 0.34 the amount of total expansion was 1.2%.

• 대한치과보철학회지
• /
• 제29권1호
• /
• pp.139-165
• /
• 1991

The properties of a investment material can be described by the consistency at the slurry state, the setting time, the compressive strength and the thermal expansion during the casting. In this study the effect of the production parameters which are included the ratio of quartz and cristobalite, the content of binder, the water powder ratio and the content and concentration of additives on the properties of the gypsum-bonded investments has been investigated with help of the consistency test, the vicat needle test, the compressive strength test, the thermal expansion test, x-ray diffraction and DTA thermal differential test. The experimental results showed that the constitution of a investment with W/P ratio of 0.34, 30% of gypsum, 0.8% aluminium sulfate, 2% magnesium sulfate, 0.6% sodium phosphate was adapted for the properties of the KDA Spec. No. 13 type I investment. The important experimental results are summarized as follows. 1. The consistency of the investment decreased with increasing amount of aluminium sulfate and decreasing amount of sodium phosphate. An addition of magnesium sulfate up to 2% an increase of the consistency was shown. But 3% magnesium sulfate in investment showed a decrease of consistency. The consistency did not vary significantly with a variation of the content of gypsum and cristobalite and the W/P ratio. 2. Aluminium sulfata and the magnesium sulfate promoted the hardening and the aluminium phoshpate delayed the hardening. The setting time increased with amount of gypsum. The effect of the matrix on the setting time was insignificant. With the W/P ratio of 0.34 the setting time was 14 min. 3. The compressive strength decreased with the amount of aluminium sulfate up to 0.25% and increased with the amount of aluminium sulfate greater than 3%. The compressive strength decreased as decreasing the amount of magnesium sulfate and gypsum and as increasing the W/P ratio. The effect fo the refractory on the compressive strength was also not significant. With the W/P ratio of 0.34 the compressive strength was $34Kg/mm^2$. 4. The 1st thermal expansion was found at the temperature near $250^{\circ}C$ and the steady state or the contraction stage was found at the temperature between $250^{\circ}C$ and $500^{\circ}C$. After this stage the 2nd thermal expansion took place at the temperature near $500^{\circ}C$. The amount of thermal expansion increased with decreasing the content of magnesium sulfate, aluminium sulfate and gypsum and the W/P ratio. And the amount of thermal expansion increased as the content of sodium phosphate ad cristobalite. With the W/P ratio of 0.34 the amount of total expansion was 1.2%.

• 대한수학교육학회지:수학교육학연구
• /
• 제24권3호
• /
• pp.375-385
• /
• 2014

이 연구는 학교수학의 모평균과 모비율의 신뢰구간의 추정을 비교하면서 두 추정간에 일관성이 확보되고 있는지에 대해 고찰하였다. 이 결과를 토대로, 이 연구에서는 표본평균과 표본비율을 동일한 방식으로 취급하는 것, 모평균과 모비율의 신뢰구간의 예를 구성할 때 모표준편차 대신에 표본표준편차의 관측값을 대입하는 절차를 동일하게 적용하는 것, 표본비율 $\hat{P}$와 그에 대한 관측값 $\hat{p}$을 구별하는 것과 같은 일관성 확보 방안을 제안하였다.

• 대한화장품학회지
• /
• 제24권3호
• /
• pp.129-133
• /
• 1998

We have studied a relationship between the pattern of complex modulus change versus internal phase volume ratio and the rheological consistency of concentrated W/O emulsions with Magnesium Sulfate in the range 0.0 to 0.5 wt% and with different oil polarities, respectively. The rheological consistency with time of concentrated W/O emulsion was checked using Fudoh Rheometer and the coalescence of deformed water droplets was examined using polarized light microscope(LEICA DMRP). To find the pattern of complex modulus change of the concentrated emulsions versus internal phase volume ratio, the effect of varying water phase volume fraction from 0.78 up to 0.85 on viscoelastic measurements was investigated using rotational rheometer (HAAKE Rheostress RS 50). The rheological consistency was mainly destroyed by the coalescence of the deformed water droplets. The greater the increase of complex modulus was, the less coalescence occurred and the more consistent the concentrated emulsions were. And the pattern of complex modulus increase versus volume ratio has been explained with the resistance to coalescence of the deformed interfacial film of water droplets in concentrated W/O emulsion.

• Investigative Magnetic Resonance Imaging
• /
• 제15권2호
• /
• pp.102-109
• /
• 2011

목적 : 수술 전 축내 뇌종양의 경도를 평가하는데 확산강조영상 및 현성확산계수영상과 고식적 MR 영상의 유용성을 알아보고자 하였다. 대상 및 방법: 축내 뇌종양으로 수술을 받은 23명의 환자를 대상으로 T1, T2, 확산강조영상 소견을 후향적으로 분석하였다. 다양한 MR영상에서의 신호강도와 수술에서 평가한 종양의 경도를 정량적, 정성적으로 비교 분석하였다. 수술소견에서 종양의 경도는 낭성, 젤리같은, 쉽게 부서지는, 부드러운, 단단한, 딱딱한 정도로 나눴다. 세 명의 환자에서는 낭성 부분과 고형성 부분이 함께 있어서 각각에 대해서 평가하였다. 결과: 종양이 단단할수록 현성확산계수와 T2강조영상에서의 신호강도의 비는 더 낮았다 (p = 0.002, p = 0.01). 종양의 경도와 현성확산계수가 가장 강한 선형상관관계를 보였다 (r = -0.586, p = 0.002). 정성적 분석에서는 단단할수록 T2강조영상에서 정성적 신호강도 등급이 낮았다 (p = 0.018). 그 외 다른 MR소견은 통계분석에서 종 양의 경도와 유의한 상관관계를 보이지 않았다. 결론: 축내 뇌종양의 현성확산계수, T2강조영상에서 신호강도의 비와 정성적 신호강도 등급은 종양의 경도와 상관관계가 있었고 이는 수술 전 전략 수립에 많은 도움이 될 것으로 생각된다.

• 한국콘크리트학회:학술대회논문집
• /
• 한국콘크리트학회 1992년도 봄 학술발표회 논문집
• /
• pp.1-6
• /
• 1992

The objective of this report is to investigate and analyze the influnce of the different base concrete in consistency for the good production of superplasticized concrete (SPC) on the basis of the experimental results. The principal conclusions are summarized as follows. 1. SPC exhibited only slight bleeding in both cases of low and medium consistency of the base concrete, compared to the conventional concrete, compared to the coventional concrete. 2. SPC lost slump and flow value at a much faster rate than the conventional concrete with an equivalent water/cement ratio and initial consistency. 3. The compressive strength of SPC was fount to be higher than that of base and conventional concrete, and the case of base concrete with medium consistency showed a little more incretment than low consistency

• Restorative Dentistry and Endodontics
• /
• 제22권1호
• /
• pp.156-169
• /
• 1997

This study was designed to evaluate the influences of evaporation of liquid of dental cements by drying during long term using. Zinc phosphate cement, polycarboxylate cement, and glass ionomer cement were used, and evaluated the properties as follows; consistency, setting time, film thickness, solubility, and compressive strength according to the ADA specification. The specimens of control group were made by mixing the newly opened liquid using the powder-liquid ratio recommended by the manufacturer, and the specimens of ES groups were made by mixing the 10% evaporated liquid by drying with the powder-liquid ratio recommeded by the manufacturer, and the specimens of EM group were made by mixing the 10% evaporated liquid with the powder-liquid ratio modified for standard consistency. The following conclusions were drawn ; 1. The viscosity of mixture of all kinds of cements were increased by the evaporation of liquid, especially the viscosity of glass ionomer cement were influenced significantly. 2. The amount of liquid should be increased to get a standard consistency at the using of evaporated liquid of cement, the most significant increase of liquid amount was required on Ketac-Cem. 3. The setting times were increased at both cases of mixing of evaporated liquid with powder - liquid ratio recommended by manufacturer or modifided through consistency test. 4. At an experimental group of mixing of the evaporated liquid with powder-liquid ratio recommended by manufacturer, solubility was decreased and film thickness was increased. 5. By the result of evaporation of cement liquid, the compressive strength of polycarboxylate cement was increased slightly and it of glass ionomer cement was increased, however, by the increase of amount of liquid to be possible to manipulate the compressive strength were decreased.

• 사상체질의학회지
• /
• 제18권2호
• /
• pp.96-112
• /
• 2006

1. Objectives This study focuses on the reliability of the Questionnaire about Sasang Constitution Classification for Mongolians 2. Methods Test-retest method and internal consistency method have been performed based on the absolutely diagnosed group of 87 cases who respond to the questionaries during the time interval of one yeat between July 2003 and July 2004 to verify the confidence level. 3. Results and Conclusions (1) In the test-retest for each question of the Questionnaire of Sasang Constitution Classification for Mongolians, the dependency ratio is 40% and the agreement ratio is 92%. Therefore, this questionnaire has credibility because it has question relations and high agreement ratio. (2) In the internal consistency method for the measure of the Questionnaire of Sasang Constitution Classification for Mongolians, the value of Cronbach alpha is mote than 0.60. As a result, this questionnaire has internal consistency for each question which explains each physical constitution and it has credibility (3) In the internal consistency method for the measure of the Questionnaire of Sasang Constitution Classification for Mongolians, the Pearson's correlation coefficient, r, falls between $+0.38\;{\sim}\;+0.54$ in each measure. Accordingly, this questionnaire has internal consistency between each physical constitution measure and it has credibility.

• Communications for Statistical Applications and Methods
• /
• 제9권3호
• /
• pp.629-637
• /
• 2002

Shapiro and Wilk(1972) developed a test for exponentiality with origin and scale unknown. The procedure consists of comparing the generalized least squares estimate of scale with the estimate of scale given by the sample variance. However the test based on the statistic is inconsistent Kim(2001a) proposed a modified Shapiro-Wilk's test statistic using the ratio of two asymptotically efficient estimators of scale. In this paper, we study the consistency of the proposed test.

• 대한안전경영과학회:학술대회논문집
• /
• 대한안전경영과학회 2006년도 추계공동학술대회
• /
• pp.427-435
• /
• 2006

We study on the consistency of AHP. It is research that extend of SAW methods by [1]. For tools that measure judgment of inconsistency eigenvector methods, we research consistency that introduced consistency ratio by Saaty. in general, the higher consistence of compare matrix the bigger error within matrix. In this paper, we use the AHP for the optimal decision making. By this method, we have optimal decision making numenical example which three models of any domestic motors companies.