• 설비공학논문집
• /
• 제15권4호
• /
• pp.268-273
• /
• 2003

In the present study, the characteristics of upward bubble flow were experimentally investigated in a liquid bath. An electro-conductivity probe was used to measure local volume fraction and bubble frequency. Since the gas is concentrated at the near nozzle, the flow parameters are high near the nozzle. In general their axial and radial values tended to decrease with increasing distance. For visualization of flow characteristics, a Particle Image Velocimetry (P.I..V) and a thermo-vision camera were used in the present study. The experimental results show that heat transfer from bubble surface to water is largely completed within z=10mm from the nozzle, and then the temperature of bubble surface reaches that of water rapidly. Due to the centrifugal force, the flow was more developed near the wall than at bubble-water plume. Vortex flow in the bottom region was relatively weaker than that in the upper region.

• Macromolecular Research
• /
• 제8권3호
• /
• pp.116-119
• /
• 2000

The doping behaviors of water-soluble poly(3-thiopheneacetic acid) (P3TAA) and ie gel using I$_2$and concentrated HCIO$_4$aqueous solutions were investigated by UV-Visible absorption spectrometer. Electrical conductivity of tile doped polyhiophene gel was also studied. I$_2$-doping of water-soluble P3TAA gave rise to a new broad polaron peak at around 749 nm, which corresponds to localization of electron. It was found that doping ability of P3TAA gel was strikingly dependent on the concentration of HCIQ solution.

• Korean Membrane Journal
• /
• 제1권1호
• /
• pp.100-105
• /
• 1999

A novel system to thicken the concentrated colloidal solution from membrane water treat-ment processes was developed. A hollow-fiber microfilter(hydrophilic polyethylene nominal pore size 0.1 ${\mu}$m total surface area 0.42 m2) was installed in an acrylic housing that has an aeration port 5 cm below the membrane and a clarifier in the bottom. The concentrate was uniformly supplied from the top of the housing. Bacuum filtration caused downward flow of concentrate and as a result thickening interface. The addition of poly-aluminum chloride (PAC) resulted in rapid increase of trans-membrane pressure (TMP) and in no improvement of the filtered water turbidity and thickening process. Two types of con-centrate and concentrate turbidity had little effect on the increase of TMP and concentrate thickening. It was observed that for the same height of membrane housing membrane surface area to housing volume (A/V) ratio had significant effect on the increase of TMP. When the housing volume was increased ten times the increasing rate of TMP was three times faster as compared to the original housing. A hydraulic model successfully simulated the formation and sedimentation of thickening interface.

• International Journal of Air-Conditioning and Refrigeration
• /
• 제13권1호
• /
• pp.44-50
• /
• 2005

In the present study, the characteristics of upward bubble flow were experimentally investigated in a liquid bath. An electro-conductivity probe was used to measure local volume fraction and bubble frequency. Since the gas was concentrated at the near the nozzle, the flow parameters were high near the nozzle. In general their axial and radial values tended to decrease with increasing distance. For visualization of flow characteristics, a Particle Image Velocimetry (PIV) and a thermo-vision camera were used in the present study. The experimental results showed that heat transfer from bubble surface to water was largely completed within z = 10 mm from the nozzle, and then the temperature of bubble surface reached that of water rapidly. Due to the centrifugal force, the flow was more developed near the wall than at bubble-water plume. Vortex flow in the bottom region was relatively weaker than that in the upper region.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 2006년도 제37회 하계학술대회 논문집 전기설비
• /
• pp.23-24
• /
• 2006

Stator winding of hydro generator is gradually deteriorated by multi-stress and steady degradation of insulation results in insulation breakdown. The region where insulation breakdown occurs in stator winding is part where the multi-stress causes the defect of insulation material and electrical stress has been concentrated. Therefore, we judged locations of insulation breakdown to be varied according to various stress factors in service. In this paper, we drew the stator winding of hydro generators which has run for a long time and separated it into 3 parts(central part, end winding part, drawing part) according to the positions laid on the core. We performed electrical and thermal stress on these specimens for 1000 hrs under the same condition, measured the condition regularlyand analyzed the insulation status of each winding by performing partial discharge test. In addition, we analyzed the trend of partial discharge concerning specimens that caused the insulation breakdown during aging.

• 대한원격탐사학회지
• /
• 제3권1호
• /
• pp.11-23
• /
• 1987

본 연구는 LANDSAT MSS 및 TM 영상자료를 이용하여 낙동강 하천수가 유입, 확산되는 과정을 시간적, 공간적으로 추적조사하여, 이들이 해양환경에 미치는 영향을 구명하는데 중점을 두었다. 본 연구로부터 현탁물질량의 농도는 고분도와 같이 계절, 대.소조기, 창.낙조류, 강우량에 따라 큰 변동을 가져오며, 연안전선의 형성 및 분포에 대한 시간적, 공간적인 변동상태를 광역적으로 추적할 수 있었고 해안선, 퇴적형, 천해역의 해저지형 변동조사는 기존의 해도 및 육도를 최신화할 수 있는 정보로써 위성자료의 가치가 크다는 결론을 얻었다.

• Journal of information and communication convergence engineering
• /
• 제16권4호
• /
• pp.242-247
• /
• 2018

The data of K-Water waterworks is collected from various sensors and used as basic data for the operation and analysis of various devices. In this way, the importance of the sensor data is very high, but it contains misleading data due to the characteristics of the sensor in the external environment. However, the cleansing method for the missing data is concentrated on the prediction of the missing data, so the research on the detection and prediction method of the missing data is poor. This is a study to detect wrong data by converting collected data into quintiles and patterning them. It is confirmed that the accuracy of detecting false data intentionally generated from real data is higher than that of the conventional method in all cases. Future research we will prove the proposed system's efficiency and accuracy in various environments.

• 한국산학기술학회논문지
• /
• 제18권1호
• /
• pp.210-215
• /
• 2017

로터리 제진기의 rake에 대한 설계 및 구조강도 해석을 수행하였다. 수중부의 경우 물에 의해 발생되는 수중 마찰력 및 협착물에 발생되는 수중 마찰력 등을 계산하여 하중조건을 주었고, 수상부는 rake의 자중 $239kg_f$를 분포 하중으로 설정한 후 협착물의 위치에 따라 협착물 하중 $261kg_f$을 좌측, 중앙, 우측 집중하중으로 나누어서 해석하였다. 3가지 하중조건의 해석결과는 최대 등가응력이 모두 86MPa 이하이므로 3가지 하중조건 모두 소성변형이 발생하지 않고, 안전성이 있다고 판단되었다. 협착물의 무게와 물에 의한 마찰력에 따라 발생할 수 있는 하중에 대해 $1,000kg_f$, $1,300kg_f$, $1,500kg_f$ 3가지 하중으로 나누어서 해석하였다. $1,000kg_f$, $1,300kg_f$의 해석 결과의 경우 각각 143.6MPa, 186.6MPa의 등가응력이 발생하였고 소성변형이 발생하지 않아 안전성이 있는 반면에, $1,500kg_f$의 경우는 215.41MPa의 등가응력이 발생하였고 소성변형이 발생하고 안전성이 없다고 해석되었다. ANSYS를 활용한 로터리 제진기의 rake에 가해지는 하중에 대한 구조강도 해석의 결과는 기본설계의 지침이 될 수 있었으며, 이 시제품의 기능 및 성능시험을 통하여 유한요소해석의 결과를 신뢰할 수 있었다.

• 환경위생공학
• /
• 제21권4호
• /
• pp.29-38
• /
• 2006

This study included the development of analytical method for determining perchlorate in water sample. The analytical condition was referred in EPA 314.0 method which use ion chromatography and the concentrator column was replaced by the guard column. Concentrating 10mL raw or treated water sample on to AGl6 guard column made it possible to get the LOD(Limit of Detection) of $0.73\;{\mu}g/L$. The total run time was 11 minutes and during run time next sample could be concentrated on AGl6 guard column. Compared to the Concentration method which needed manual operation, the Direct Injection method could screen the many water samples. The LOD of the Direct Injection method was higher and the sensitivity was lower than that of the Concentration method. The RSDs(Relative Standard Deviations) were lower than 2.5 % for peak height and 0.7 % for retention time in pre-concentration methods. This method Showed good reproducibility and reliability and it was thought the deviations of recovery value could be reduced by considering column capacity and making water sample homogeneous. Matrix Elimination could be done using the pre-concentration method if perchlorate were in complex matrix of sample.

• 한국물환경학회지
• /
• 제27권4호
• /
• pp.433-437
• /
• 2011

The study is conducted to evaluate loading of organic matter as seasonal changes during non-storm period into Lake Paldang which is used to a major drinking water source. Samples were taken in Lake Paldang intake during non-storm period and were analyzed loading of organic matter. From the results of the survey, improving of the water quality showed remarkable tendency depending on the changing periods from summer to fall and from fall to winter. Dilution effect from the increase of base run-off caused by the concentrated rainfall in rainy season, the characteristics of Korea's climate seems to have to be the reason. On the other hand, deteriorating of the water quality showed tendency depending on the changing periods from winter to spring and from spring to summer. Increase of Cyanobacteria etc. is explained by seasonal effects which are a small amount of the rainfall in winter and spring and gradational increase of water temperature.