• 대한기계학회논문집B
• /
• 제39권9호
• /
• pp.727-734
• /
• 2015

세계적으로 유가 상승에 따른 내연기관의 에너지 변환 효율을 높이고자 하는 연구가 활발히 진행되고 있다. 가솔린엔진에서 높은 열효율을 실현하기 위해서는 희박연소에 의한 비열비의 증가 및 단열화염온도의 저감에 의한 열효율 향상이 필수적이다. 직접분사식 가솔린 엔진은 연료를 직접 연소실에 공급하고 정밀한 연소제어를 통해 희박 연소가 가능하게 하지만 희박연소 한계의 확대와 안정된 희박연소제어가 요구된다. 희박연소 엔진에 대한 삼원촉매의 배출가스 저감특성은 높은 공기과잉률 및 낮은 배기가스 온도로 인해 매우 제한적이다. 이에 효과적인 삼원촉매의 개발을 위해 승용 차량용 엔진의 주요 연비시험 운전조건인 2000 rpm BMEP 2bar 조건에서 공기과잉률의 변화에 따른 배출가스 반응 및 생성 특성을 비교하였다. 희박연소 조건에서 $NO_2$가 생성되었으며, $NO_2$의 비율은 공기과잉률이 증가할수록 증가하고 $N_2O$는 감소하였다.

• 한국연소학회지
• /
• 제15권1호
• /
• pp.43-49
• /
• 2010

Co-combustion of syngas in an existing boiler can be one of the options for replacing conventional fossil fuel with alternative fuels such as waste and biomass. This study is aimed to investigate effects of syngas cocombustion on combustion characteristics and boiler efficiency. An experimental study was performed for a pilot-scale furnace with 4 oil burners. Tests were conducted with mixture-gas as a co-combustion fuel and heavy oil as a main fuel. The mixture-gas was composed of 15% CO, 7% $H_2$, 3% $CH_4$ and 75% $N_2$ for simulating syngas from air-blown gasification. And LHV of the mixture-gas was 890 kcal/$Nm^3$. Temperature distribution in the furnace and flue gas composition were measured for various heat replacement ratio by the mixture gas. Heat loss through the wall was also carried out through heat & mass balance calculation, in order to obtain informations related to boiler efficiency. Experimental results show that similar temperature distribution and flue gas composition can be obtained for the range of 0~20% heat replacement by syngas. NOx concentration is slightly decreased for higher heat replacement by the syngas because fuel NOx is decreased in the case. Meanwhile, heat loss is a bit decreased for higher heat replacement by the syngas, which implies that boiler efficiency can be a bit decreased when syngas co-combustion is applied to a boiler.

• 대한기계학회논문집
• /
• 제8권3호
• /
• pp.201-209
• /
• 1984

본 연구는 Kim과 Chiu가 사용한 연속체 관점에서 유도된 액체-기체상의 2상유 동모델(Two Phase Flow:TPF)을 이용하여 초기 집단연소수(group combustion number)의 크기, 즉 액적들의 초기 분포상태에 따른 연소상태를 예측 분류한다. 또한 이때 예 측된 대표적인 연소상태에서 형성되는 화염의 성질을 비교 검토한다.

• 한국수소및신에너지학회논문집
• /
• 제29권5호
• /
• pp.538-548
• /
• 2018

The thermo-acoustic instability in the combustion process of a gas turbine is caused by the interaction of the heat release mechanism and the pressure perturbation. These acoustic vibrations cause fatigue failure of the combustor and decrease the combustion efficiency. This study is to develop a segmented dynamic thermo-acoustic model to understand combustion instability of gas turbine. Therefore, this study required a dynamic analysis rather than static analysis, and developed a segmented model that can analyze the performance of the system over time using the Matlab/Simulink. The developed model can confirm the thermo-acoustic combustion instability and exhaust gas concentration in the combustion chamber according to the equivalent ratio change, and confirm the thermo-acoustic combustion instability for the inlet temperature and the load changes. As a result, segmented dynamic thermo-acoustic model has been developed to analyze combustion instability under the operating condition.

• 한국산학기술학회논문지
• /
• 제12권7호
• /
• pp.2945-2950
• /
• 2011

자동차의 연비개선을 위한 대책으로 연소 효율 증대를 위해서 흡입라인에 연소실의 와류를 형성시켜주는 장치를 모델링하였다. 와류발생장치가 장착되지 않은 것과 와류발생장치의 형태가 다른 모델들을 각각 장착하여 유동해석을 실시한다. 와류발생장치는 공기의 연소실 흡입 전에 설치되어 와류발생장치의 날개에 의해 흡입공기를 휘감으며 와류를 발생시키게 된다. 본 연구에서는 와류발생장치를 사용함으로써 흡입 공기의 유동과 흡입행정의 압력분포를 해석하여 와류발생장치의 효과를 조사할 수 있다.

• 한국연소학회:학술대회논문집
• /
• 한국연소학회 제26회 KOSCO SYMPOSIUM 논문집
• /
• pp.119-127
• /
• 2003

In this study we propose an unsteady I-dimensional model of bed combustion with multiple solid phases, which confers a phase on each solid material. This model can be applied to a variety of bed combustion cases of various configurations and ignition methods. It contains fuel combustion, gaseous reaction, heat transfers between each phase, and geometric changes of the solid particles. An iron ore sintering pot is selected for verifying the model validity and simulation results are compared with the limited experimental data set of various coke contents and air supply rates. They predict the experimental results well and show applicabilities to the various system of the fuel bed with various solid materials.

• 한국정밀공학회지
• /
• 제22권3호
• /
• pp.123-129
• /
• 2005

The unbalance of the power output, noise, and vibration is happened by the disproportionate pressure variation in the cylinder. For this reason, decrease of the pressure in the cylinder and increase of the residual gas effect on the engine performance. If the abnormal combustion is continued, the crack would be occurred in the engine block. And it could be broken down. For the normal combustion of the SI engine, it is important to supply the balanced mixture by each operating condition. In this study, it was tested the combustion characteristics in the cylinder according to the abnormal adjusting of intake & exhaust valve. This test is willing to set a basic data's analysis fur developing an automotive diagnosis system by analyzing the pressure in the cylinder, the output signal of MAP sensor, the exhaust gas, etc.

• 한국연소학회지
• /
• 제11권4호
• /
• pp.1-8
• /
• 2006

The model cavity scramjet engine experiments are carried out using T3 free-piston shock tunnel. Upstream hydrogen fuel is injected before the cavity with different injection pressure. OH planar laser-induced fluorescence is used to investigate the combustion zone and piezoelectric pressure transducers are used to define the pressure rise due to the combustion. Main combustion region is a mixing layer which is between air and fuel. Also high OH fluorescence signal is appeared in the shear layer above the cavity in high equivalence ratio. From the OH signal in the cavity, this fuel injection system can be a role as a flame-holder.

• 한국연소학회지
• /
• 제17권2호
• /
• pp.17-23
• /
• 2012

In this study, thermoacoustic analysis model was developed in order to predict both eigenfrequencies and initial growth rate of combustion instabilities for lean premixed gas turbine combustors. As a first step, a model combustor and nozzle were selected and analytical linear equations for thermoacoustic waves were derived for a given combustion system. Then, methods showing how the equations can be used for analysis of the combustion instability were suggested. It was found that the prediction results showed a good agreement with the measurements. However, there were some limitation in growth rate predictions, which were related with over-simplification of flame structure, acoustic boundary conditions, and temperature distribution in the combustor.

• 한국연소학회지
• /
• 제11권3호
• /
• pp.18-25
• /
• 2006

The present studying is aimed to establish the relationship between flame chemiluminescence$(OH^*,\;CH^*,\;C_2^*)$ intensities and combustion conditions such as $NO_x$ emission characteristics. Measurements are made for $OH^*,\;CH^*,\;C_2^*$ radicals in gas & light oil diffusion flames. At turbulent nonpremixed combustion mode, the equivalence ratio is varied. The optical emissions were measured by photomultiplier(PMT) using optical band pass filter and spectrometer system. The experimental results showed that the ratio of radicals and $NO_x$ emission characteristics have exponential correlations and equivalence ratio characteristics have linear correlations at this experimental conditions.