• 한국안전학회지
• /
• 제15권3호
• /
• pp.83-87
• /
• 2000

Combustion characteristics of immobilized benzene and toluene in sands were studied. Experiments were performed by burning benzene and toluene immobilized on sands(particle size 0.1~0.5mm) to measure combustion rate and combustion temperature. The longer time from ignition to extinguishment was resulted from the larger particle size exhibited the higher mass burning rate. Of aromatic compounds tested the relative magnitude of facilitation of combustion was benzene and toluene. Combustion temperature of benzene and toluene without regard to the types of benzene and toluene was not increased with smaller sand. However, with larger sands, combustion temperature of benzene and toluene were increased by 50~$100^{\circ}C$ and the highest combustion temperature was obtained with larger sands.

• 청정기술
• /
• 제22권3호
• /
• pp.161-167
• /
• 2016

여러 가지 금속이온이 치환된 제올라이트에서 벤젠의 촉매연소 반응에 대해 연구하였다. 사용한 제올라이트 중 Y(4.8)형 제올라이트가 가장 높은 활성을 보여주었고, Y(4.8)형 제올라이트에 치환된 금속 이온 중 구리이온이 가장 높은 활성을 보여주었다. 촉매의 활성은 산소 TPD에 의해 얻어진 흡착산소의 양에 비례하였다. Cu/Y(4.8) 촉매에서 Cu 이온의 농도가 커질수록 반응활성이 증가하였다. 벤젠의 연소반응의 전환율은 반응물 중 벤젠의 농도보다는 산소 농도의 영향을 많이 받았다. 또한, 반응물에 첨가된 물은 촉매 활성을 감소시켰다.

• 공업화학
• /
• 제25권3호
• /
• pp.312-317
• /
• 2014

공침전법으로 제조된 CuO-$CeO_2$ 혼합산화물 촉매에서 벤젠의 촉매연소 반응에 대해 연구하였다. CuO-$CeO_2$ 혼합산화물 촉매들은 침전제 및 CuO 전구체를 달리하여 제조하였고, XRD, BET, XPS 및 $H_2-TPR$에 의해 특성분석을 하였다. 침전제의 종류에 상관없이 CuO 피크가 $2{\Theta}=35.5^{\circ}$와 $38.5^{\circ}$에서 뚜렷하게 나타났다. $NH_4OH$를 침전제로 사용하여 제조한 Cu/(Cu+Ce)의 몰비율이 0.35인 촉매가 가장 높은 활성을 보여주었다. 또한, 수소로 전처리하면 벤젠 연소반응의 활성이 증가하였고, $400^{\circ}C$에서 수소로 전처리한 촉매가 가장 높은 활성을 보여주었다.

• 한국안전학회지
• /
• 제24권5호
• /
• pp.28-33
• /
• 2009

The thermochemical parameters for safe handling, storage, transport, operation and process design of flammable substances are explosion limit, flash point, autoignition temperatures(AITs), minimum oxygen concentration(MOC), heat of combustion etc.. Also it is necessary to know explosion limit at high temperature and pressure. For the safe handling of benzene, lower explosion limit(LEL) at $25^{\circ}C$, the temperature dependence of the explosion limits and flash point were investigated. And the AITs for benzene were experimented. By using the literatures data, the lower and upper explosion limits of benzene recommended 1.3 vol% and 8.0 vol%, respectively. This study measured relationship between the AITs and the ignition delay times by using ASTM E659-78 apparatus for benzene, and the experimental AIT of benzene was $583^{\circ}C$. The new equations for predicting the temperature dependence of the explosion limits of benzene is proposed. The values calculated by the proposed equations were a good agreement with the literature data.

• 청정기술
• /
• 제18권3호
• /
• pp.259-264
• /
• 2012

페롭스카이트형 산화물을 능금산법으로 합성하여 TG/DTA, XRD, XPS, TEM 및 $H_2$-TPR 등에 의해 특성분석을 하였고, 벤젠의 연소반응에서의 활성을 조사하였다. 대부분의 촉매들은 페롭스카이트 결정구조를 잘 가지고 있었으며 15에서 70 nm의 크기를 나타내었다. $LaMnO_3$ 촉매가 가장 높은 활성을 보여주었고 $350^{\circ}C$에서 거의 100%의 전환율을 나타내었다. 반응활성을 증가시키기 위해 페롭스카이트 산화물의 A-와 B-위치에 다른 금속이온의 치환을 행하였다. $LaMnO_3$ 촉매의 A-위치에 Sr을 일부분 치환시키면 벤젠의 전환율이 증가하였다. 또한, B-위치에 Co 및 Cu 이온의 치환 역시 촉매 활성을 증가시켰고, $LaMn_{1-x}B_xO_3$ (B = Co, Fe, Cu)형 페롭스카이트에서 촉매활성은 Co > Cu > Fe의 순서로 감소하였다.

• 공업화학
• /
• 제24권5호
• /
• pp.507-512
• /
• 2013

페롭스카이트형 산화물을 마이크로파 공정으로 합성하여 XRD, XPS, BET 및 $H_2-TPR$ 등에 의해 특성분석을 하였고, 벤젠의 연소반응에서의 활성을 조사하였다. 대부분의 촉매들은 페롭스카이트 결정구조를 잘 가지고 있었으며 21 nm 에서 35 nm의 크기를 나타내었다. $LaMnO_3$ 촉매가 가장 높은 활성을 보여주었고 $250^{\circ}C$에서 거의 100%의 전환율을 나타내었으며, 마이크로파 공정으로 제조한 촉매가 기존의 졸-겔법으로 제조한 촉매에 비해 높은 활성을 보여주었다. 또한 소성온도가 증가함에 따라 연소반응의 활성이 증가하였다. 모든 촉매들의 산화환원 성질을 측정한 수소 승온환원 실험 결과는 벤젠의 연소반응의 순서와 잘 일치하였다.

• 한국대기환경학회지
• /
• 제11권2호
• /
• pp.131-136
• /
• 1995

The experiment for decomposing CFF-113 by a honeycomb catalyst was carried out in this study. Benzene and water were used as decomposing agents. The reaction of decomposition was from 600 .deg.C to 900.deg.C. Benzene was injected at 900.deg.C and then the catalyst was heated to 1100.deg.C by the heat of combustion of it. The electric power of the reactor was turned off when the combustion was started. The reaction temperature, however, was main trained and the decomposition of CFC-113 continued at that time. It was found that the highest decomposition efficiency was 80% at the ratio of benzene/CFC-113 of 20/1 in this experiment.

• 한국연소학회지
• /
• 제20권4호
• /
• pp.49-55
• /
• 2015

A short kinetic mechanism for premixed benzene/air flames was developed with a reduction method of Simulation Error Minimization Connectivity Method(SEM-CM). It consisted of 38 species and 336 elementary reactions. Flame speeds were calculated and compared with those from full mechanisms and experiments of other researchers. Flame temperature, the heat release rate, the concentration profiles of major species and radicals were also calculated with both mechanism. Those comparisons are in good agreement between the full mechanism and the short mechanism at high pressure condition. In numerical work the running time with the short mechanism was over 12 times faster than one with the full mechanism.

• 한국연소학회:학술대회논문집
• /
• 한국연소학회 2015년도 제51회 KOSCO SYMPOSIUM 초록집
• /
• pp.161-164
• /
• 2015

A short kinetic mechanism for premixed benzene/air flames was developed with a reduction method of Simulation Error Minimization Connectivity Method(SEM-CM). It consisted of 38 species and 336 elementary reactions. Flame speeds were calculated and compared with those from full mechanisms and experiments of other researcher. Those comparisons are in good agreement between the full mechanism and the short mechanism at high pressure condition. In numerical work the running time with the short mechanism was over 10 times faster than one with the full mechanism.

• 한국연소학회지
• /
• 제7권4호
• /
• pp.36-44
• /
• 2002

Carbon molecules with closed-cage structures are called fullerenes $(C_{60},\;C_{70})$, whose applications include super-conductors, sensors, catalysts, optical and electronic device, polymer composites, and biological and medical materials. The synthesis of fullerenes has been recently studied with low-pressure benzene/argon/oxygen flames. The formation of fullerene is known as molecular weight growth processes of PAHs (polycyclic aromatic hydrocarbon). This study presents results of PAHs and fullerene measurements performed in a low-pressure benzene/argon/oxygen normal co-flow laminar diffusion flame. Through the central tube of the burner, benzene vapors carried by argon are injected. The benzene vapors are made in a temperature-controlled bubbler. The burner is located in a chamber, equipped with a sampling system for direct collection of condensable species from the flame, and exhausted to a vacuum pump. Samples of the condensable are analyzed by HPLC (High Performance Liquid Chromatography) to determine the yields of PAHs and fullerene. Also, we computed mole fraction of fullerene and PAHs in a nearly sooting low pressure premixed, one-dimensional benzene/argon/oxygen flame (equivalence ratio ${\Phi}=2.4$, pressure=5.33kPa). The object of computation was to investigate the formation mechanism of fullerenes and PAHs. The computations were performed with CHEMKIN/PREMIX. As a result of this study, fullerenes were synthesized in a low pressure (20torr) $C_6H_6/Ar/O_2$ flames and the highest concentration of fullerene was detected just above the visible surface of a flame.