• Journal of the Korean Institute of Telematics and Electronics A
• /
• v.33A no.11
• /
• pp.10-18
• /
• 1996

In this paper, performance of a hybrid direct-sequency/slow-frequency-hopped (DS/SFH) spread-spectrum (SS) system with coherent BPSK modulation is analyzed. The bit error probability is derived over a frequency=-selective rician fading channel in the presence of multiple tone jamming. The fading channel is modeled as the wide-sense stationary uncorrelated scattering (WSSUS) model. Numerical evaluations are presented for some combinations of system parameters. The performance of a hybrid DS/SFH SS system is shown to be inferior to that of a ure DS SS system at low jamming-to-signal power ratio (JSR). At high JSR, the performance of a pure DS SS system is shown to be the smae as the worst case performance of a hybrid DS/SFH SS system.

• Journal of the Korean Institute of Telematics and Electronics
• /
• v.25 no.5
• /
• pp.473-481
• /
• 1988

In this paper, we investigated bit error probabilities of GMSK, which is known to be one of promising modulation techniques for a digital mobile radio, under various mobile radio environments.: AWGN, slow Rayleigh fading channel, co-channel interference and adjacent channel interference. We employed an MSK-type receiver for a coherent detection and assumed degrading to both signals than adjacent channel interference. Especially, it is found that GMSK suffers more degradations than MSK from the co-channel interference. But with a high power adjacent channel interference, GMSK shows less bit error rate than MSK. The results confirm a higher spectrum efficiency of GMSK.

• The Bulletin of The Korean Astronomical Society
• /
• v.42 no.2
• /
• pp.54.1-54.1
• /
• 2017

Intrinsic alignments (IA), the coherent alignment of intrinsic galaxy orientations, can be a source of a systematic error of weak lensing surveys. The redshift evolution of IA also contains information about the physics of galaxy formation and evolution. We present the first measurement of IA at high redshift, z~1.4, using the spectroscopic catalog of blue star-forming galaxies of the FastSound redshift survey, with the galaxy shape information from the Canada-Hawaii-France telescope lensing survey. The IA signal is consistent with zero with power-law amplitudes fitted to the projected correlation functions for density-shape and shape-shape correlation components, $A_{\delta+}=-0.0040\pm 0.0754$ and $A_{++}=-0.0159\pm 0.0271$, respectively. These results are consistent with those obtained from blue galaxies at lower redshifts (e.g., $A_{\delta+}=0.0035_{-0.0389}^{+0.0387}$ and $A_{++}=0.0045_{-0.0168}^{+0.0166}$ at z=0.51 from the WiggleZ survey), suggesting no strong redshift evolution of IA. The upper limit of the constrained IA amplitude corresponds to a few percent contamination to the weak-lensing shear power spectrum, resulting in systematic uncertainties on the cosmological parameter estimations by $-0.035<\Delta \sigma_8<0.026$ and $-0.025<\Delta \Omega_{\mathrm m}<0.019$.

• Nuclear Engineering and Technology
• /
• v.55 no.6
• /
• pp.1999-2010
• /
• 2023

Undesirable flapping motion of discs can cause the failure of swing check valves in nuclear passive safety systems. Time-resolved particle image velocimetry (PIV) was employed to investigate the flow characteristics around a free-to-rotate plate and the motion response, with the Reynolds numbers, based on the hydraulic diameter of the channel, from 1.32 × 10⁴ to 3.95 × 10⁴. Appreciable flapping motion (±3.52°) appeared at the Reynolds number of 2.6 × 10⁴ with the frequency of 5.08 Hz. In the low-Reynolds-number case, the plate showed negligible flapping. In the high-Reynolds-number case, the deflection angle increased with reduced flapping amplitude. The torque from the fluid determined the flapping amplitude. In the low-Reynolds-number case, Karman vortices were absent. With increasing Reynolds numbers, Karman vortices developed behind the plate with larger deflection angles. Strong interaction between the wake flow from the leading and trailing edge of the plate was observed. Based on power spectrum density (PSD) analysis, the vortex shedding frequency coincided with the flapping frequency, and the amplitude was positively correlated to the strength of the vortices. Proper orthogonal decomposition (POD) modes evince that, in the case of appreciable motion, coherent structures exhibited a larger spatial scale, enhancing the magnitude of the external torque on the plate.

• Atmosphere
• /
• v.17 no.2
• /
• pp.115-123
• /
• 2007

The present study uses the GOES IR brightness temperature to examine the temporal and spatial variability of cloud activity over the region $25^{\circ}N-45^{\circ}N$, $105^{\circ}E-135^{\circ}E$ and analyzes the coherence of eastern Asian summer season rainfall in Weather Research and Forecast (WRF) model. Time-longitude diagram of the time period from June to July 2005 shows a signal of eastward propagation in the WRF model and convective index derived from GOES IR data. The rain streaks in time-latitude diagram reveal coherence during the experiment period. Diurnal and synoptic scales are evident in the power spectrum of the time series of convective index and WRF rainfall. The diurnal cycle of early morning rainfall in the WRF model agrees with GOES IR data in the Korean Peninsula, but the afternoon convection observed by satellite observation in China is not consistent with the WRF rainfall which is represented at the dawn. Although there are errors in strength and timing of convection, the model predicts a coherent tendency of rainfall occurrence during summer season.

• Proceedings of the Korean Society for Noise and Vibration Engineering Conference
• /
• 2007.11a
• /
• pp.291-296
• /
• 2007

This study presents the evaluation process for door module. Its objective evades the resonance generated at module plate due to the operation of window regulator motor. For this study, the design improvement process is composed of experimental methods having three steps. First step is modal analysis at door assembly status for acquisition of dynamic characteristics which are modal frequency and damping. Second step is a vibration experiment to get the test mode considered an efficiency of window regulator motor. Last step is a vibration measurement by the form of $6{\times}6$ array on module plate. A vibration measurement of 6x6 array form can be got to three analysis results which are a transfer path of vibration using cross correlation function, a vibration map using OA level and a contribution by frequency band using coherent output power spectrum on module plate. These results are applied to SDM(structural dynamic modification) for design improvement to get around the resonance on module plate by the excitation of window regulator motor.

• Proceedings of the Korean Society for Noise and Vibration Engineering Conference
• /
• 2002.11b
• /
• pp.312-316
• /
• 2002

Recently, mixers are being widely used in the water purification plant in order to increase the filtration efficiency. It has been found that a severe vibration was being felt on a upper structure of a mixer facility during steady state operation. The cause of the excessive vibration of the structure to which the mixer's shaft is supported has been evaluated through modal analysis on the shaft and vibration measurements during operation. The fundamental natural frequency of the mixer's shaft is found to be around 1.8 Hz and the main vibratory frequency around 30 Hz. It has been tuned out that the main vibratory frequency, 30 Hz is coincident with the fundamental holding frequency of the upper structure, and that the acceleration signal of the upper structure and the displacement signal of the mixer's shaft showed highly coherent to each other. Accordingly, it reveals that the main cause of the excessive vibration is due not to the mixer's vibration but to the natural frequency of the upper structure excited by flow turbulence.

• Transactions of the Korean Society for Noise and Vibration Engineering
• /
• v.17 no.11
• /
• pp.1093-1101
• /
• 2007

This study presents the design improvement process for door module. Its objective evades the resonance generated at module plate due to the operation of window regulator motor. For this study, the design improvement process is composed of experimental methods having three steps. First step is modal analysis at door assembly status for acquisition of dynamic characteristics which are modal frequency and damping. Second step is a vibration experiment to get the test mode considered an efficiency of window regulator motor. Last step is a vibration measurement by the form of $6{\times}6$ array on module plate. A vibration measurement of $6{\times}6$ array form can be got to three analysis results which are a transfer path of vibration using cross correlation function, a vibration map using OA level and a contribution by frequency band using coherent output power spectrum on module plate. These results are applied to SDM(structural dynamic modification) for design improvement to get around the resonance on module plate by the excitation of window regulator motor.

• Journal of Communications and Networks
• /
• v.2 no.1
• /
• pp.5-17
• /
• 2000

cdma2000 offers several enhancement as compared to TIA/EIA-95, although it remains fully compatible with TIA/EIA-95 systems and allows for a smooth migration from one to the other-Major new capability include:1)connectivity to GSM-MAP in addition to IP and IS-41 networks; 2) new layering with new LAC and MAC architectures for improved service multiplexing and QoS management and efficient use of radio resource ;3) new bands and band widths of operation in support of various operator need and constraints, as well as desire for a smooth and progressive migration to cdma 2000; and 4) flexible channel structure in support of multiple services with various QoS and variable transmission rates at up to 1 Mbps per channel and 2 Mbps per user. Given the phenomenal success of wireless services and desire for higher rate wireless services. improved spectrum efficiency was a major design goal in the elaboration of cdma2000. Major capacity enhancing features include; 1) turbo coding for data transmission: 2)fast forward link power control :3) forward link transmit diversity; 4) support of directive antenna transmission techniques; 5) coherent reverse link structure; and 6) enhanced access channel operation. As users increasingly rely on their cell phone at work and at home for voice and data exchange, the stand-by time and operation-time are essential parameters that can influence customer's satisfaction and service utilization. Another major goal of cdma2000 was therefore to enable manufacturers to further optimize power utilization in the terminal. Major battery life enhancing features include; 1) improved reverse link performance (i.e., reduced transmit power per information bit; 2) new common channel structure and operation ;3) quick paging channel operation; 4) reverse link gated transmission ; and 5) new MAC stated for efficient and ubiquitous idle time idle time operation. this article provides additional details on those enhancements. The intent is not to duplicate the detailed cdma2000 radio access network specification, but rather to provide some background on the new features of cdma2000 and on the qualitative improvements as compared to the TIA/EIA-95 based systems. The article is focused on the physical layer structure and associated procedures. It therefore does not cover the MAC, LAC, radio resource management [1], or any other signaling protocols in any detail. We assume some familiarity with the basic CDMA concepts used in TIA/EIA-95.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.37 no.8
• /
• pp.1-10
• /
• 2000

Performance analyses of hybrid DS-SFH spread-spectrum systems using coherent MSK and QPSK modulation techniques are considered over Rayleigh fading channel in the presence of multi-tone jamming. The BER equations for MSK and QPSK systems with non-diversity reception in the receiver are derived as the concept of average signal-to-noise power ratio E$\_$b//N$\_$0/ and jamming-to-signal power ratio JSR, and the performances is evaluated for various system parameters. The evaluation of performance is done between fading and nonfading system, and between MSK and QPSK system. Results show that the performances of two systems are similar in low JSR. However, MSK system outperforms QPSK system as JSR increases. Overall performances of two systems are a little improved as the DS spreading gain increases for the total spread-spectrum bandwidth fixed. The performance difference between fading system and nonfading system is similar in low E$\_$b//N$\_$0/, however, it becomes very largewith increase of E$\_$b//N$\_$0/..