• The Journal of Engineering Geology
• /
• v.14 no.4 s.41
• /
• pp.487-498
• /
• 2004

There is an increasing trend of construction works in mountainous areas by the urban development in Busan that is mainly composed of mountains. The study area, Hwangryeong Mt., is one of developing sites in the urban area, too. Landslides and cut-slope failures that occur large damages of human beings and the properties are influenced by soil characteristics as well as rock properties. This study analyzed geotechnical characteristics of soil dependent on geology at Hwangryeong Mt. where a large slope failure had been occurred in 1999. Geology of the study area is composed of the Cretaceous sedimentary rocks and volcanic rocks. Soil layer of the slopes can be grouped into sand mixed with clay and silt. The cohesion is plotted between $0.001\;and\;0.066kg/cm^2$. The friction angles are distributed in the ranges between $32^{\circ}\;and\;39^{\circ}$, meaning soil bearing a high friction angle. The permeability coefficients are plotted between $2.34\times10^{-4}cm/sec\;and\;2.58\times10^{-2}cm/sec$, indicating fine sand and loose silt with a medium grade of permeability. The sedimentary rocks area shows relatively higher permeability coefficients than those volcanic rocks area.

• Journal of the Korean Geographical Society
• /
• v.40 no.6 s.111
• /
• pp.716-729
• /
• 2005

In the Yeongpyeong River, one of the branches of Hantan River, there 4 fluvial terraces are identified. During the Quaternary, lava flow from Hantan River had gone 4.5km into upstream Part of the Yeongpyeong River and damed its entrance, and resultantly its lower basin had become a lava-damed paleolake. This study deals with fluvial terrace surface classification, stratigraphic analysis, deposits analysis, and OSL age dating in from Gungpyeongri to Seongdongri in lower reach of Yeongpyeong River, in order to identify Seomorphological Process of the terrace landforms relating to duration of lava-damed paleolake. Terrace surface T4, named Baekeuiri Formation, has been located under Jeongok lava layer to indicate pre-lava river bed. Terrace surfaces T3 and T2 are supposed to be formed during paleolake time, based on $3{\~}4m$ thick sand deposits including pebble and cobble layers, and clay and silt layers intersected with sand ones in nearly horizontal bedding. Terrace T1 is estimated to be formed as post-lake fluvial terrace after dissection of lava dam, based on the more fresh phase of deposits and very low height from present riverbed. The results of the OSL age dating for the T3 deposit layers indicate approximately $33{\~}40ka$, and still lake phase at that time.

• The Journal of Engineering Geology
• /
• v.31 no.4
• /
• pp.589-601
• /
• 2021

Artificial recharge technology is a method for solving problems such as groundwater level drop and ground subsidence caused by groundwater withdrawal. This study investigated the applicability of using the hydraulic conductivity of an aquifer to predict injection test results for aquifer restoration. Pumping and injection tests were performed under the same conditions as those for the artificial injection facility located in Icheon, Gyeonggi-do. The hydraulic conductivity of the aquifer, which plays a decisive role in restoring the groundwater level, was derived from the pumping test. A numerical model of a simplified on-site aquifer was constructed, and a transient analysis was applied with the same conditions as the pumping test. The correlation between the measured and the resulting model values is strong (R² = 0.78). The injection test was performed in a sedimentary layer composed of silt sand and clay sand. From the results of the injection test, an empirical formula was derived using Theim's formula, which is a common well analysis solution to determine the parameters of the aquifer from time-level data. The model values from the empirical formula have a high degree of correlation (R² = 0.99) with measured values. Under specific conditions, for areas where it is difficult to conduct an injection test, the formula from this study, which relies on the hydraulic conductivity of the aquifer determined through the pumping test, may be used to predict reliable injection rates for groundwater restoration.

• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.26 no.4C
• /
• pp.247-254
• /
• 2006

Online testing method is one of the numerical experiment methods using experimental information for a numerical analysis directly. The method has an advantage in that analysis can be conducted without using an idealized mechanical model, because mechanical properties are updated from element test for a numerical analysis in real time. The online testing method has mainly been used for the geotechnical seismic engineering, whose major target is sand. A testing method that may be applied to a consolidation problem has recently been developed and laboratory and field verifications have been tried. Although related research thus far has mainly used a method to update average reaction for a numerical analysis by positioning an element tests at the center of a consolidation layer, a weakness that accuracy of the analysis can be impaired as the thickness of the consolidation layer becomes more thicker has been pointed out regarding the method. To clarify the effectiveness and possible analysis scope of the online testing method in relation to the consolidation problem, we need to review the results by applying experiment conditions that may completely exclude such a factor. This research reviewed the results of the online consolidation test in terms of reproduction of the consolidation settlement and the dissipation of excess pore water pressure of a clay specimen by comparing the results of an online consolidation test and a separated-type consolidation test carried out under the same conditions. As a result, the online consolidation test reproduced the change of compressibility according effective stress of clay without a huge contradiction. In terms of the dissipation rate of excess pore water pressure, however, the online consolidation test was a little faster. In conclusion, experiment procedure needs to improve in a direction that hydraulic conductivity can be updated in real time so as to more precisely predict the dissipation of excess pore water pressure. Further research or improvement should be carried out with regard to the consolidation settlement after the end of the dissipation of excess pore water pressure.

• Journal of Aquaculture
• /
• v.8 no.2
• /
• pp.85-98
• /
• 1995

In Kunsan coastal areas, there are some plans to construct industrial zone and, it will affect physical and chemical parameters of marine environment of the area. As one of many environmental surveys on the aquacultural farm in Korean west coast, the survey on the bottom sediment characteristics of intertidal farm was conducted from May 1992 to April 1993. Dominant grain size was fine sand $(69-98\%)$ and the pH of sediment was ranged of $7.2\~9.1$. Especially the pH increased after embank was constructed. The water holding capacity was $11.1-28.1\%$ and showed high value in silt and clay area. The COD was 1.27 mg/g dry mud and increased after embank was constructed. The total organic matter content ranged of $0.84-8.11\%$ and the DO absorption was $0\~6.56 mg/g$ dry mud. The value of DO absorption showed low in winter and spring, but high in summer and fall. The total nitrogen and the sulfide were rang of $0\~402{\mu}g/g$ dry mud and $0\~122{\mu}g/g$ dry mud respectively. These values were high in summer and winter season, and higher in upper layer than that of lower layer in general.

• Journal of Korean Society of Environmental Engineers
• /
• v.28 no.5
• /
• pp.563-572
• /
• 2006

In order to propose optimum in-situ treatment for reducing phosphorous release from sediment of stationary lakes, a series of column tests were performed. The sediment used in experiment was very fine clay with a mean grain site $7.7{\phi}$ and high $C_{org}$ contents(2.4%). Phosphorous releases were evaluated in two ways : in lake water(with microbial effect) and in distilled water(without microbial effect). As in-situ capping material, sand and loess were used while Fe-Gypsum and $SiO_2$-Gypsum were used for in-situ chemical treatment. In case of lake water considering the effect of microorganism, phosphorous concentration rapidly decreased in the early stage of experiment but it was gradually increased after 10 days. Flux of phosphorous release for control was $3.0mg/m^2{\cdot}d$. Whereas, those for sand layer capping(5 cm) and loess layer capping(5 cm) were $2.5mg/m^2{\cdot}d\;and\;1.8mg/m^2{\cdot}d$, respectively because the latter two were not consolidated sufficiently. For Fe-gypsum and $SiO_2$-gypsum the fluxes were $1.4mg/m^2{\cdot}d$ which meant that reduction efficiency of phosphorous release was more than 40% higher than that of control. The case capping with complex layer was $1.0mg/m^2{\cdot}d$, which showed high reduction efficiency over 60%. The addition of gypsum($CaSO_4{\cdot}2H_2O$) into the sediment reduced release of Phosphorus from the sediments. Gypsum acted as a slow-releasing source of sulphate in sediment, which enhanced the activity of SRB(sulfate reducing bacteria) and improved the overall mineralization rate of organic matter.

• The Journal of Engineering Geology
• /
• v.15 no.2 s.42
• /
• pp.105-121
• /
• 2005

Most of the landslides triggered by intensive rainfall on natural slope occur serious damages of human beings and properties. There have been many landslides since 1991 in Gyeonggi province. The influential factors are rainfall, topography, geology and soil properties. There were 660 landslides occurred by intensive rainfall as much as 250mm at Yongin and Anseong area from Tuly 19th to luly 21st,1991 This study surveyed location, topography, geology, geometry of the landslide and rainfall at the area and analyzed occurrence characteristics of the landslides. Most of the landslides occurred on the soil layer above the bed rock. They showed changes of landslide types from translational slides at the head part to flow at the central part. The landslides have relatively small magnitude of which length is shorter than 50m. In order to identify characteristics of landslides dependent on soil conditions, geotechnical properties of soil were evaluated by laboratory tests using soil samples which were collected on slided area and not-slided area. Soil properties of the slided area show high percentage of coarse material such as gravel and sand. However, soil of the not-slided area is mainly composed of fine material such as silt and clay. Permeability coefficients of the slided area are higher than those of the not-slided area.

• Journal of the Korean GEO-environmental Society
• /
• v.10 no.3
• /
• pp.21-28
• /
• 2009

As the natural aggregates such as sand and clay are getting exhausted, the quantity of utilizing geosynthetics is being increased in the solid waste landfill. Especially, the waste landfills have been constructed at the gorge in the mountainous area and reclaimed land from the sea in the Korean Peninsula. Those areas are not favorable for construction of waste landfill in geotechnical engineering aspect. In this study, the frictional characteristics of geosynthetics that used in the waste landfill were estimated. Then, the studies of the behavior of geosynthetics and stability of LDCRS (Leachate Detection, Collection, and Removal System) of side slope were conducted in the waste landfill by means of the pilot test, and numerical analysis. Geocomposite which is combined type or separated type is influenced on the strain itself, and also implicated in the stress and strain of geomembrane at the lower layer. The strain on the combined type of geocomposite is about 50% smaller than that of the separated type at the side slope. The lateral displacement and settlement of top at the slope with the separated type are three times greater than that of the combined type. In the numerical analysis, discontinuous plans in between ground and geosynthetic, geosynthetic and geosynthetic, goesynthetic and waste have been modeled with the interface element. The results gave a good agreement with the field large-scale model test. The relative displacements of geosynthetics were also investigated and hence the interface modeling of liner system is appropriate for analysis of geosynthetics liner system in the waste landfill.

• Korean Journal of Fisheries and Aquatic Sciences
• /
• v.34 no.3
• /
• pp.245-253
• /
• 2001

To investigate the effects of hydromechanical and textural characteristics of sediment deposits on the cultivation of Manila clam, Ruditapes philippinarum surface and sub-surface core sediments were collected seasonally in Gomso tidal flat. Grain size distribution were analyzed to investigate the annual variation of sediment texture. In winter unimodal distribution of grain size with the peak at $5\phi$ is dominant However, during the summer sediment texture become a little bit coarser and grain size distribution shows the peaks at $4\~5 \phi$. Optimum sediment texture for the cultivation of manila clam, R. philippinarum was found to be sandy silt in which mean Brain size was between 4 and $5 \phi$ with the sand content less than $50\%$ and clay content of $5\~10\%$. Mechanical and hydrological characteristics of sediment deposits were also studied in the laboratory and the results were applied to the numerical simulation for the behavior of surface sediment subjected to the cyclic loading from sea-water level change. Results of numerical simulation illustrate that the permeability of sediment had to be maintained in the range of $10^{-11}\sim10^{-12}m^2$ to ensure the proper sedimentological environment for the cultivation of manila clam, R. philippinarum. The deposits of virtually impermeable mud layer, with the threshold thickness of 4 cm, would be very hazardous to clam habitat.

• Journal of Sericultural and Entomological Science
• /
• v.3
• /
• pp.37-43
• /
• 1963

This experimental work was carried out to know the best method in producing the root stock effectively. The major experimental work was carried out by using Kairyo-Nezumigaeshi, and the comparative works were carried out by using Ichi-Hei, Kairyo-Nezumigaeshi, Ro-Soh, Yongchon-Chuwoo and Suwon No. 4. Results obtained from the test are as follows. 1. The larger size of the branch burried, the better live ratio and the quality of the sapling was found, and there was no significant difference between the top part and bottom part of the branch from the point of view of the ratio, but it was found that the top part showed better live ratio and quality. Mean time there was no difference in live ratio between the two sprouts root-stock type and the three sprouts root-stock type. 2. When the live ratio and sapling quality was compared from the aspect of the new root development, the heavy and medium developed root type showed better result than the poor developed one. 3. For the ambushing depth test of the root-stock, the root-stock which was painted with paraffin on the top and exposed in the air was found to have best live ratio. Mean time, even though paraffin was not painted all the top of the root-stock, the one which was exposed the top of it or the one ambushed with thin soil layer, showed better live ratio than the one deep ambushed. 4. There was difference for the live ratio between the perpendicularly ambushed root-stock and the lied ambushed mot-stock, but the former method showed better sapling quality. 5. The soil nature did not show any difference for the live ratio between the sand loam and clay loam, but the former one showed better sapling quality. 6. There was no difference live ratio between the mulberry varieties, but Yongchon-Chuwoo showed best sapling quality. 7. The grafted sapling production cost was 2.30 won and cattage sapling cost was 1.61 won.