• Korea-Australia Rheology Journal
• /
• v.11 no.4
• /
• pp.293-304
• /
• 1999

Refinements of classical theories for entangled or crosslinked polymeric systems have led to incommensurable models for rubber networks and polymer melts, contrary to experimental evidence, which suggests a great deal of similarity. Uniaxial elongation and compression data of linear and branched polymer melts as well as of crosslinked rubbers were analyzed with respect to their nonlinear strain measure. This was found to be the result of two contributions: (1) affine orientation of network strands, and (2) isotropic strand extension. Network strand extension is caused by an increasing restriction of lateral movement of polymer chains due to deformation, and is modelled by a molecular stress function which in the tube concept of Doi and Edwards is the inverse of the relative tube diameter. Up to moderate strains, $f^2$ is found to be linear in the average stretch for melts as well as for rubbers, which corresponds to a constant tube volume. At large strains, rubbers show maximum extensibility, while melts show maximum molecular tension. This maximum value of the molecular stress function governs the ultimate magnitude of the strain-hardening effect of linear and long-chain branched polymer melts in extensional flows.

• Macromolecular Research
• /
• v.14 no.5
• /
• pp.539-544
• /
• 2006

2-Furancarboxaldehyde-2-pyridinylhydrazone (FPH) and 5-methyl-2-furancarboxaldehyde-2-pyridinylhydrazone (MFPH) were synthesized and used as tridentate ligands of copper (I) bromide for the atom transfer radical polymerization of methyl methacrylate (MMA) and styrene. The polymerization of methyl methacrylate achieved high conversion and yielded polymers with a good control of molecular weight and low polydispersity (PDI=1.33). Higher PDI were observed in the polymerization of styrene. Using 1-phenyl ethylbromide (PEBr) and ethyl 2-bromoisobutyrate (EBiB) as model compounds for the polymeric chain ends, the activation rate constants of the new catalytic systems were measured. These results were correlated with the polymerization results and compared with another catalytic system previously reported.

• Bulletin of the Korean Chemical Society
• /
• v.19 no.11
• /
• pp.1194-1198
• /
• 1998

The density and the viscosity of aqueous PEO solutions are observed with the several concentrations of PEO at 20 ℃. The effects of urea on them are also observed. The apparent and the partial specific volumes of PEO are calculated from the density data, which result that the polymer-polymer interaction is dominating in the binary aqueous PEO solutions, while the polymer-solvent interaction is dominating in the ternary aqueous urea-PEO solutions. It is explained by the urea induced breakage of the structured water originated from the hydrophobic interactions and the binding of the urea to the PEO chain. The concentration dependence of relative viscosity and the density dependence of fluidity is also discussed with the concept of the polymersolvent and the polymer-polymer interactions of aqueous urea-PEO solutions.

• Bulletin of the Korean Chemical Society
• /
• v.27 no.6
• /
• pp.869-874
• /
• 2006

We have carried out the Glaser oxidative coupling polymerizations of diethynyldiphenylsilane, diethynylmethylphenylsilane,diethynylmethyloctylsilane, and 1,2-diethynyl-1,1,2,2-tetramethyldisilane to afford polycarbosilanes containing diethynyl and organosilane groups in the main chain, such as poly(diethynyldiphenylsilane), poly(diethynylmethylphenylsilane), poly(diethynylmethyloctylsilane), and poly(1,2-diethynyl-1,1,2,2-tetramethyldisilane), respectively. These obtained materials are almost insoluble in common organic solvents such as $CHCl_3$ and THF probably due to the presence of a rigid rod diacetylene group along the polymer main chain. Therefore, the polymers were characterized using several spectroscopic methods in solid state. FTIR spectra of all the polymeric materials show that the characteristic $C \equiv C$ stretching frequencies appear at 2147-2154 $cm ^{-1}$, in particular. The polymers in the solid state exhibit that the strong maximum excitation peaks appear at 260-283 nm and the strong maximum fluorescence emission bands at 367-412 nm, especially. Thermogravimetric analysis of the materials shows that about 55-68% of the initial polymer weights remain at 400 ${^{\circ}C}$ in nitrogen.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2000.04a
• /
• pp.177-180
• /
• 2000

In this study, we investigated the pretilt angle generation and liquid crystal (LC) alignment by ultraviolet (UV) exposure during imidization of polyimide on the polymer with side chain. The generated pretilt angle of nematic (N) LC using in-situ photo-alignment method was smaller than that of the conventional UV photo-alignment method. Also, the generated pretilt angle of NLC tends to increase by annealing.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.11 no.6
• /
• pp.477-480
• /
• 1998

In this paper, we investigated the liquid crystal(LC) alignment and generation of pretilt angle by using photo-alignment techniques on two kinds of polyimide(PI) surface, It was found that the uniform alignment for nematic(N) LC is obtained in a cell with slanted UV light irradiation on PI surface without side chain. We successfully observed that the pretilt angle of NLC is generated about $3^{\circ}$ with an incident angle of 70 degree on the PI surface without side chain. It is considered that the pretilt angle generation in NLC is attributed to interaction between the LC molecules and the polymer surfaces.

• 한국정보디스플레이학회:학술대회논문집
• /
• 2008.10a
• /
• pp.324-326
• /
• 2008

Novel X-shaped molecules containing perfluoroalkyl alkanes as a side chain have been synthesized and characterized. The properties of mesophases were investigated by a combination of differential scanning calorimetry (DSC), polarizing optical microscopy (POM), X-ray diffractometry (XRD) and electro-optical measurements.

• 한국정보디스플레이학회:학술대회논문집
• /
• 2003.07a
• /
• pp.482-483
• /
• 2003

We have synthesized a new material of polyoxetane based liquid crystalline polymer/liquid crystal (LCP/LC) for flexible memory or dynamic mode device and characterized the electro-optics behavior of this system. The microscopic dynamic behavior of main chain, side chain, and the low molecular weight LC were characterized by X-ray scattering and time resolved FTIR..

• 한국정보디스플레이학회:학술대회논문집
• /
• 2005.07a
• /
• pp.433-435
• /
• 2005

We have studied the realigning behavior of liquid crystal molecules in liquid crystalline polymer/liquid crystal(LCP/LC) system when they are exposed to external stimulation such as bending and pressing. The birefringence of the LCP/LC in a flexible display device was measured as a function of bending or pressing deformation. The microscopic dynamic behavior of main chain, side chain, and the LC were characterized by FTIR and polarization optical microscopy. When the device is deformed in scattering memory state, liquid crystal(LC) director is found to align from randomly oriented domain state(scattering state) to homeotropic state.

• Macromolecular Research
• /
• v.8 no.6
• /
• pp.292-297
• /
• 2000

The theoretical synthesis of the isotactic and syndiotactic poly(methyl methacrylate) were carried out as a model for real polymerization reactions following the normal chain reaction processes by repeating the uniform localization of wave functions with inclusion of the interaction between the end group of the cluster and an attaching molecule by the elongation method, and then, the calculated value was compared with the usual PM$_3$ calculation. The results revealed that a reaction of cluster with monomer molecules has made it possible to calculate the electronic structure and total energy of polymer with nearly infinite length and a matrix of constant dimension. The isotactic poly(methyl methacrylate) is more stable than syndiotactic one. The same tendency have been found between the experimentally measured properties and a calculated total energy to explain the chain motion in isotatic and syndiotactic poly(methyl methacrylate).