• 한국재료학회지
• /
• 제17권10호
• /
• pp.526-531
• /
• 2007

The sintering behavior and electrical property of $Ce_{0.8}Gd_{0.2}O_{1.9}$ ceramics were investigated with the iron oxide concentration ranging from 0 to 5 mol%. Both the sintered density and grain size were found to increase up to 2 mol% $Fe_2O_3$, and then to decrease with further additions. At a higher $Fe_2O_3$ content above 3 mol%, grain size decreased by a pinning effect induced by different shape grains. The electrical conductivity was also increased with increasing $Fe_2O_3$ content up to 2 mol%. Total conductivity of 2 mol% $Fe_2O_3-added$ specimen showed the maximum conductivity of $2{\times}10^{-2}{\Omega}{\cdot}cm^{-1}$ at $500^{\circ}C$. The addition of $Fe_2O_3$ was found to promote the sintering properties and electrical conductivities of $Gd_2O_3-dope\;CeO_2$.

• 대한환경공학회지
• /
• 제27권5호
• /
• pp.513-518
• /
• 2005

망간 산화물 촉매, 망간-세륨 산화물 촉매에서 톨루엔의 촉매 산화에 대하여 조사 하였다. XRD, TGA, 톨루엔-TPR 분석을 통해 촉매의 특성을 조사하였다. 톨루엔 산화반응에 있어서 망간 18.2 wt.% 세륨 10.0 wt.%이 적절한 비율인 것으로 나타났다. 그리고 세리아가 망간 산화물에서의 활성을 증진 시키는 것으로 보여진다. XRD결과 $MnO_2$가 황성 자리인 것으로 추측된다. TGA 톨루엔-TPR결과 세리아가 격자 산소의 이동성, 활성자리의 적절한 상화 상태, 저온에서의 환원능력 및 활성자리의 재산화 능력을 증진시키는 것으로 사료된다.

• 한국세라믹학회지
• /
• 제35권12호
• /
• pp.1294-1300
• /
• 1998

Yttria-stabilized zirconia ceramics with irregular grain shapes and curved grain boundaries was prepared by ceria doping. The amount of ceria doped into zirconia compacts by a dipping method were at range of 2 to 20 mol% Irregular grain shapes and curved grain boundaries were formed only inspecimens doped with more than 8mol% cerial. Ceria-doped specimens showed large grain size and low sintered density compared with pure yttria-stabilized zirconia which was due to the increase in the contents of stabilizer and cubic phase. The amount of doped ceria was larger on the surface than the inside regions and therefore mi-crostructure and phase on the surface were different from those in the inside regions. Transgranular frac-ture mode was observed ion ceria doped specimens due to irregular large grain sizes.

• 한국수소및신에너지학회논문집
• /
• 제23권6호
• /
• pp.640-646
• /
• 2012

The effect of Ce promotion over 1wt% $Pt/{\gamma}-Al_2O_3$ catalysts on the CO conversion and $CO_2$ selectivity was investigated in preferential CO oxidation (PrOx) to reduce the CO concentration less than 10 ppm in excess $H_2$ stream for polymer electrolyte membrane fuel cell (PEMFC). Ce-promoted 1wt% $Pt/{\gamma}-Al_2O_3$ catalysts were prepared by incipient wetness impregnation method and the loading amount of Pt was fixed at 1wt%. The content of Ce promoter which has excellent oxygen storage and transfer capability due to the redox property was adjusted from 0 to 1.5wt%. Ce-promoted 1wt% $Pt/{\gamma}-Al_2O_3$ catalysts exhibit high CO conversion and $CO_2$ selectivity at low temperatures below $150^{\circ}C$ due to the improvement of reducibility of surface PtOx species compared with the 1wt% $Pt/{\gamma}-Al_2O_3$ catalyst without Ce addition. When Ce content was more than 1wt%, the catalytic activity was decreased at over $160^{\circ}C$ in PrOx because of competitive $H_2$ oxidation. As a result, 0.5wt% Ce is optimal content not only to achieve high catalytic activity and good stability at low temperatures below $150^{\circ}C$ in the presence of $CO_2$ and $H_2O$ but also to minimize the $H_2$ oxidation at high temperatures.

• 한국세라믹학회지
• /
• 제32권1호
• /
• pp.95-105
• /
• 1995

Ceria(CeO2) stabilized zirconia(CeSZ) sol was synthesized with zirconium n-butoxide Zr(OC4H9)4 and cerium nitrate hexahydrate Ce(NO3)3.6H2O as precursors and ethylacetoacetate(EAcAc) as a chelating agent under atmosphere. CeSZ films were deposited on AISI 304 stainless steel using the prepared polymeric sol by dipcoating and the coating characteristics were investigated by XRD, ellipsometry, scratch test and SEM. The CeSZ film began to crystallize from amorphous to tetragonal phase at 40$0^{\circ}C$ and it was not converted into monoclinic phase up to 100$0^{\circ}C$ by the addition of 16mol% CeO2 as a stabilizer which could suppress phase transformation of zirconia. The CeSZ films were prepared by varying the EAcAc contents and the cncentration of CeSZ sol and measured the thickness and refractive index. From these results, it was found that the EAcAc contents and concentration of CeSZ coating sol evidently affect the densification of CeSZ film. The CeSZ film coated with 0.4M CeSZ sol and heat-treated at $600^{\circ}C$ for 10min had thickness of 50nm and 17% porosity. The CeSZ film on 304 stainless steel effectively acted as a protective layer against oxidation up to 80$0^{\circ}C$ and had superior corrosion resistance in 25% H2SO4 solution for 4.5 hrs.

• 한국재료학회지
• /
• 제25권3호
• /
• pp.144-148
• /
• 2015

Cubic mesocrystal $CeO_2$ was synthesized via a hydrothermal method with glutamic acid ($C_5H_9NO_4$) as a template. The XRD pattern of a calcined sample shows the face-centered cubic fluorite structure of ceria. Transmission electron microscopy (TEM) and the selected-area electron diffraction (SAED) pattern revealed that the submicron cubic mesocrystals were composed of many small crystals attached to each other with the same orientation. The UV-visible adsorption spectrum exhibited the red-shift phenomenon of mesocrystal $CeO_2$ compared to commercial $CeO_2$ particles; thus, the prepared materials show tremendous potential to degrade organic dyes under visible light illumination. With a concentration of a rhodamine B solution of 20 mg/L and a catalyst amount of 0.1 g/L, the reaction showed higher photocatalytic performance following irradiation with a xenon lamp (${\geq}380nm$). The decoloring rate can exceed 100% after 300 min.

• Korean Chemical Engineering Research
• /
• 제49권6호
• /
• pp.781-785
• /
• 2011

본 연구에서는 나노 크기의 세리아를 사마리움으로 일부 도핑(samaria-doped ceria(SDC))한 분말을 urea를 첨가제로 사용하여 수열합성법으로 합성하였으며 그 특성들을 XRD, FESEM, TEM 등을 통해 관찰하였다. 합성 시간 및 합성온도가 증가함에 따라 분말의 결정성 및 입도가 증가함을 확인하였다. 또한 이온전도도의 측정을 통해 합성된 SDC 파우더가 중 저온(600~$800^{\circ}C$) 부근에서 0.1 S/cm의 이온전도도를 보여 중 저온형 고체산화물 연료전지(IT-SOFC)의 고체 전해질에 적합함을 확인할 수 있었다. 합성된 SDC 분말은 중·저온 고체산화물 연료전지의 음극지지형 전해질로 사용하기 위해 전기영동 증착 방법을 이용하여 다공성 NiO-SDC 기판 위에 SDC 박막 증착을 시도하였다. 증착 용액은 acetone을 용매로 사용하고, 20V의 인가전압으로 10초간 증착한 결과 얇고 치밀하며 기공이 없는 SDC 박막이 형성되었음을 FESEM 분석을 통해 확인할 수 있었다.

• 한국전기전자재료학회논문지
• /
• 제19권2호
• /
• pp.145-152
• /
• 2006

The densification behavior and electrical conductivity of $Ce_{0.8}Gd_{0.2}O_{1.9}$ ceramics were investigated with the strontium gallate concentration ranging from 0 to $5\;mol\%$. Both the sintered density and grain size were found to increase rapidly up to $0.5\;mol\%$ $Sr_2Ga_2O_5$, and then to decrease with further addition. Dense $Ce_{0.8}Gd_{0.2}O_{1.9}$ ceramics with $97\%$ of the theoretical density could be obtained for $0.5\;mol\%$ $Sr_2Ga_2O_5$-added specimen sintered at $1250^{\circ}C$ for 5 h, whereas pure $Ce_{0.8}Gd_{0.2}O_{1.9}$ ceramics needed to be sintered at $1550^{\circ}C$ in order to obtain an equivalent theoretical density, Electrical conductivity was measured as a function of dopant content, over the temperature range of $350\;-\;600^{\circ}C$ in air. Total conductivity of $0.5\;mol\%$ $Sr_2Ga_2O_5$-added specimen showed the maximum conductivity of $2.37{\times}10^{-2}{{\Omega}-1}{\cdot}cm^{-1}$ at $500^{\circ}C$, The addition of strontium gallate was found to promote the sintering properties and electrical conductivities of $Gd_2O_3$-doped $CeO_2$.

• 공업화학
• /
• 제32권4호
• /
• pp.385-392
• /
• 2021

본 연구에서는 Co/CeO₂ 촉매 제조 시 코발트의 첨가 함량 및 세리아의 소성온도에 따른 물리·화학적 특성 및 일산화질소 산화 성능을 비교하였다. Co/CeO₂ 촉매의 구조적 특성은 XRD, BET 분석을 통하여 확인하였으며, 코발트 표면밀도에 따른 표면 결정 상태를 제안하였다. 또한, Raman, XPS 분석을 통하여 촉매의 산화가 및 산소 결합 상태를 확인하였으며, 일산화질소 산화 성능과의 관계를 제안하였다. H₂-TPR 분석을 통하여 촉매의 특성 변화에 따른 산소전달특성을 확인하였으며, 일산화질소 산화를 위한 촉매의 활성점(Co³⁺)을 제안하였다.

• 한국분말야금학회:학술대회논문집
• /
• 한국분말야금학회 2006년도 Extended Abstracts of 2006 POWDER METALLURGY World Congress Part 1
• /
• pp.416-417
• /
• 2006

Nanostructured ceria powder was synthesized by a thermochemical process and investigated its applicability for an oxygen gas sensor. An amorphous precursor powders prepared by spray drying a cerium-nitrate solution were transformed successfully into nanostructured ceria by heat-treatment in air atmosphere. The powders were a loose agglomerated structure with extremely fine $CeO_2$ particles about 15 nm in size, resulting in a very high specific surface area $(110\;m^2/g)$. The oxygen sensitivity and the response time $t_{90}$ measured at sintered sample at $1000^{\circ}C$ was about -0.25 and very short, i.e., $3{\sim}5$ seconds, respectively.