• Journal of IKEEE
• /
• v.17 no.1
• /
• pp.10-15
• /
• 2013

This paper, we analyzed that the measured data of the radiated power spectrum of electromagnetic waves of the normal spark ignition system and the spark ignition system with feed through type ceramic condenser. The results show that the strength of power spectrum radiated from the system with feed through type ceramic condenser is weaker than the normal system, and the density of power spectrum radiated from the system with feed through type ceramic condenser is smaller than the normal system. From these results, the feed through type ceramic condenser can reduce the electromagnetic waves radiating from the spark ignition system which is the spurious emission, and it can be concluded that the ignition coil of the spark ignition system generating high voltage pulse is equivalent to the radio frequency oscillator which is oscillating high frequency from a electronic point of view.

• Journal of the Korean Ceramic Society
• /
• v.36 no.9
• /
• pp.915-922
• /
• 1999

Microwave dielectric properties and far infrared reflectivity spectra of the (Zr0.8Sn0.2)TiO4 ceramics were inves-tigated with the various cooling rate. Dielectric constant was nearly same value while the unloaded Q value was largely affected by cooling rate. The Q.f of 42,140 at 7 GHz was obtained for the specimens with cooling rate of 1$^{\circ}C$/min. The effect of the cooling rate on the change of the ionic the electronic polarization and the intrinsic microwave loss of the specimens were investigated by the infrared reflectivity spectra from 50 to 4000cm-1 which were calculated by Kramers-Kroning analysis and the classical oscillator model. The relative tendency of microwave dielectric properties of the specimens calculated from the relfectivity data were in good agreement with the results by the post resonant method.

• Journal of the Korean Ceramic Society
• /
• v.34 no.7
• /
• pp.693-698
• /
• 1997

The refractive index and dispersion in the (100-x)(0.6CaO.0.4Al2O3).xSiO2(x=0~30) glasses were investigated. As the amount of SiO2 increased, the refractive index decreased. The change of refractive index was attributed to the change of the molar refraction rather than the molar volume. When the amount of SiO2 was smaller than 20 mol%, the average electronic transition energy gaps(E0) and the electronic oscillator strengths(Ed) were about 10.9($\pm$0.1) nd 18($\pm$0.5)eV, respectively. However E0 and Ed of the glass (CAS30) with 30 mol% SiO2 increased to 12.63 and 19.89eV, respectively. The similar results was observed in the variation of Abbe Number. Abbe number of the glass in the range of 0~20 mol% SiO2 was about 46 and that of CAS30 increased to 60. The zero-material dispersion wavelength({{{{ lambda }}0) of pure calcium aluminate glass was 1.8 ${\mu}{\textrm}{m}$. As the amount of SiO2 increased, the zero-material dispersion wavelength shifted to a shorter wavelength. {{{{ lambda }}0 of CAS30 was 1.5 ${\mu}{\textrm}{m}$, that is currently using for the optical telecommunication system.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2000.05b
• /
• pp.61-64
• /
• 2000

An ultrasonic linear motor was composed of a slider and a stator vibrator including piezoelectric material and elastic material. The ultrasonic linear motors mainly consist of an ultrasonic oscillator which generates elliptical oscillations. Elliptical oscillations are generated by synthesizing two degenerated modes. The design of a stator for an ultrasonic linear motor was optimized with respect to vibration mode and direction of vibratory displacement by employing the finite element method. Applying multilayer piezoelectric ceramics. we found larger elliptical oscillations. The motors were designed by varying the width of stator vibrator and the thickness. the length and the position of multilayer piezoelectric ceramics.

• Proceedings of the Korea Electromagnetic Engineering Society Conference
• /
• 2001.11a
• /
• pp.218-221
• /
• 2001

In this paper, High Q Inductor using negative resistance circuit and the ceramic inductor was designed and fabricated at 2GHz. It was Improved the inductor of Q=90 using a inductor with Q=30 added to negative resistance circuit at 2GHz. As a result, at the bias condition of 3V and 16mA, the output power and phase noise in the operation frequency 2.01GHz are 5dBm and -115.34dBc/Hz at 100kHz offset from carrier, respectively. Phase noise was improved -10dBc/Hz at 100kHz offset compared to only using ceremic inductor.

• Transactions on Electrical and Electronic Materials
• /
• v.1 no.3
• /
• pp.1-5
• /
• 2000

This paper presents a new sort of multilayer piezoelectric ceramic transformer for switching regulation power supplies. This piezoelectric transformer operate in the second thickness resonant vibration mode. Accordingly its resonant frequency is higher than 1 NHz, Because output power is low if input and output part of transformer are consisted of single layer, this research suggests a new method, which is consisted of both input and output part of transformer have 2-layered piezoelectric ceramics, The size of transformer is 20 mm in width and length, and 1.4 mm in thickness, respectively, To design a high efficient switching circuit of the transformer, internal circuit parameters were measured and then weve calculated a parameter of inductor nd capacitor to design a driving circuit, Weve used a MISFET and its driver circuit modified a calp oscillator circuit as the primary switching circuit.

• Journal of the Korean Ceramic Society
• /
• v.37 no.3
• /
• pp.256-262
• /
• 2000

The dielectric properties of complex perovskite ($Pb_{1-x}Ca_{x}$)($Fe_{0.5}Ta_{0.5}$)$O_{3}$ with >($0.5{\le}x{\ge}0.65$ were investigated at microwave frequencies. Dilectric constant decreased with increasing Ca content, and was directly proportional to the cube of average ionic ra야 of A-site. For the specimen of x=0.6 sintered at $1250^{\circ}C$ for 3 h in air, dielectric constant (k) of 63, QF of 11000 GHz, and the temperature coefficient of resonant frequency(TCF) of -14ppm/$^{\circ}C$ were obtained. As Ca content increased, TCF of the specimen negatively increased due to the reduction of the tolerance factor(t). Changes in intrinsic loss with varying Ca content was investigated by the infrared reflectivity spectra ranging 50 to 4000 $cm^{-1}$, which were calculated by the Kramers-Kronig analysis and classical oscillator model. The relative tendency of microwave dielectric properties of the ($Pb_{1-x}Ca_{x}$)($Fe_{0.5}Ta_{0.5}$)$O_{3}$ specimens calculated from the reflectivity data were in good agreement with the results by the post resonant method.

• Journal of the Korean Ceramic Society
• /
• v.43 no.3 s.286
• /
• pp.177-184
• /
• 2006

Dy $L_3$-edge XANES and EXAFS spectra of chalcogenide Ge-As-S glass doped with ca. 0.2 wt% dysprosium have been investigated along with some reference Dy-containing crystals. Amplitude of the white-line peak in XANES spectrum of the glass sample turns out to be stronger than that of other reference crystals, i.e., $DY_2S_3,\;Dy_2O_3\;and\;DyBr_3$. It has been verified from the Dy $L_3$-edge EXAFS spectra that a central Dy atom is surrounded by $6.7{\pm}0.5$ sulfur atoms in its first coordination shell in the Ge-As-S glass, which is relatively smaller than 7.5 of the $Dy_2S_3$ crystal. Averaged Dy-S inter-atomic-distance of the glass ($2.78{\pm}0.01{\AA}$) also turns out to be somewhat shorter than that of the $Dy_2S_3$ crystal ($2.82{\pm}0.01{\AA}$). Such nanostructural changes occurring at Dy atoms imply there being stronger covalency of Dy-S chemical bonds in the Ge-As-S glass than in the crystal counterpart. The enhanced covalency in the nanostructural environment of $Dy^{3+}$ ions inside the glass would then be responsible for optical characteristics of the $4f{\leftrightarrow}4f$ transitions of the dopants, i.e., increase of oscillator strengths and spontaneous radiative transition probabilities.

• Journal of the Institute of Electronics and Information Engineers
• /
• v.51 no.3
• /
• pp.45-54
• /
• 2014

In this paper, We have designed and fabricated 20 InP Gunn diodes using a current limiting epitaxial structure by MINT's optimized fabrication processes. We have also packaged the fabricated InP Gunn diodes using our optimized packaging method, and then designed and fabricated a W-band waveguide FTO to measure characteristics of the packaged InP Gunn diodes. The packaged InP Gunn diode have a ceramic ring, a Au plated stud and a lid, and a Maltese cross. The fabricated InP Gunn diodes have good RF characteristics such as high output powers (11.8~17 dBm) and limiting low currents (less than 400 mA) between 92.9 and 94.78 GHz.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.24 no.8
• /
• pp.632-635
• /
• 2011

Additions (ZnO, CuO) doped $0.98(Na_{0.5}K_{0.5})NbO_3-0.02Li(Sb_{0.17}Ta_{0.83})O_3$ (0.98NKN-0.02LST-x) lead free piezoelectric ceramics have been fabricated by ordinary sintering technique. The effects of additions doping on the dielectric, piezoelectric, and ferroelectric properties of the ceramics were mainly investigated. X-ray diffraction of the sample appeared orthorhombic phase. The specimen doped with additions exhibits enhanced electrical properties ($d_{33}$= 153 pC/N). These results indicate that the 0.98NKN-0.02LST-x ceramics is a promising candidate for lead-free piezoelectric ceramics for applications such as piezoelectric actuators, harmonic oscillator and so on.