• Transactions of the Korean Society of Mechanical Engineers
• /
• v.13 no.4
• /
• pp.789-798
• /
• 1989

A naphthalene sublimation technique based on the heat/mass transfer analogy is used to investigate the circumferential mass transfer from a circular cylinder in an approaching uniform shear flow. Experiments are performed in a wind tunnel (450*450m $m^{2}$ with a shear flow generator which is specially manufactured for generating variable shear rates(S). The effects of an approaching shear flow are correlated with mass transfer coefficients. It is found that the local mass transfer rate on a circular cylinder is characterized with the shear parameter $K^{d}$ defined as Sd/ $U^{c}$ , where d is the radius of cylinder and $U^{c}$ is the approaching velocity at the center of cylinder. The angle on the corresponding to minimum Sherwood number is approximately proportional to the shear parameter on an upper and down number is approximately proportional to the shear parameter on an upper and down circular cylinder (0< $K^{d}$ <0.132). Changes on the averaged mass transfer rate are not significant for small $K^{d}$ , which are slightly proportional to K$d^{2}$ but the local mass transfer rates are significantly changed with the approaching shear flow.

• Mass Spectrometry Letters
• /
• v.4 no.3
• /
• pp.55-58
• /
• 2013

Dioscin is a biologically active steroidal saponin with anticancer and hepatoprotective effects. A rapid, selective, and sensitive liquid chromatographic method with electrospray ionization tandem mass spectrometry was developed for the quantification of dioscin in rat plasma. Dioscin was extracted from rat plasma using ethyl acetate at acidic pH. The analytes were separated on a Halo C18 column using gradient elution of acetonitrile and 0.1% formic acid and detected by tandem mass spectrometry in selected reaction monitoring mode. The standard curve was linear ($r^2$ = 0.998) over the concentration range of 1-100 ng/mL. The lower limit of quantification was 1.0 ng/mL using 50 ${\mu}L$ of plasma sample. The coefficient of variation and relative error for intra- and inter-assay at four QC levels were 1.3 to 8.0% and -5.4 to 10.0%, respectively. This method was applied successfully to the pharmacokinetic study of dioscin after oral administration of dioscin at a dose of 29.2 mg/kg in male Sprague-Dawley rats.

• Bulletin of the Korean Chemical Society
• /
• v.32 no.5
• /
• pp.1559-1563
• /
• 2011

Thermal hydrogenation of phenylacetylene (PA, $C_8H_6$) to styrene ($C_8H_8$) on pre-$C_xH_y$- and C-covered Cu(111) single crystal substrates has been studied using temperature-programmed desorption (TPD) mass spectrometry. Chemisorbed PA with an acetylene group has been proved to be associated with hydrogen of pre-adsorbed $C_xH_y$ to form styrene (104 amu) on Cu surface. For the parent (PA) mass (102 amu) TPD profile, the TPD peaks at 360 K and 410 K are assigned to chemisorbed vertically aligned PA and flat-lying cross-bridged PA, respectively (J. Phys. Chem. C 2007, 111, 5101). The relative $I_{360K}/I_{410K}$ TPD ratio dramatically increases with increasing pre-adsorbed $C_xH_y$ before dosing PA, while the ratio does not increase for pre-C-covered surface. For PA on pre-$C_xH_y$-covered Cu(111) surface, styrene desorption is enhanced relative to the parent PA desorption, while styrene formation is dramatically quenched on pre-C-covered (lack of adsorbed hydrogen nearby) surface. It appears that only cross-bridged PA associates with adsorbed hydrogen to form styrene that promptly desorbs at 410 K, while vertically aligned PA is less likely to participate in forming styrene.

• Nutrition Research and Practice
• /
• v.16 no.3
• /
• pp.298-313
• /
• 2022

BACKGROUND/OBJECTIVES: The effectiveness of natural compounds in improving athletic ability has attracted attention in both sports and research. Gynostemma pentaphyllum (Thunb.) leaves are used to make traditional herbal medicines in Asia. The active components of G. pentaphyllum, dammarane saponins, or gypenosides, possess a range of biological activities. On the other hand, the anti-fatigue effects from G. pentaphyllum extract (GPE) and its effective compound, gypenoside L (GL), remain to be determined. MATERIALS/METHODS: This study examined the effects of GPE on fatigue and exercise performance in ICR mice. GPE was administered orally to mice for 6 weeks, with or without treadmill training. The biochemical analysis in serum, glycogen content, mRNA, and protein expressions of the liver and muscle were analyzed. RESULTS: The ExGPE (exercise with 300 mg/kg body weight/day of GPE) mice decreased the fat mass percentage significantly compared to the ExC mice, while the ExGPE showed the greatest lean mass percentage compared to the ExC group. The administration of GPE improved the exercise endurance and capacity in treadmill-trained mice, increased glucose and triglycerides, and decreased the serum creatine kinase and lactate levels after intensive exercise. The muscle glycogen levels were higher in the ExGPE group than the ExC group. GPE increased the level of mitochondrial biogenesis by enhancing the phosphorylation of peroxisome proliferator-activated receptor-γ coactivator-1α (PGC-1α) protein and the mRNA expression of nuclear respiratory factor 1, mitochondrial DNA, peroxisome proliferator-activated receptor-δ, superoxide dismutase 2, and by decreasing the lactate dehydrogenase B level in the soleus muscle (SOL). GPE also improved PGC-1α activation in the SOL significantly through AMPK/p38 phosphorylation. CONCLUSIONS: These results showed that GPE supplementation enhances exercise performance and has anti-fatigue activity. In addition, the underlying molecular mechanism was elucidated. Therefore, GPE is a promising candidate for developing functional foods and enhancing the exercise capacity and anti-fatigue activity.

• Natural Product Sciences
• /
• v.23 no.2
• /
• pp.84-91
• /
• 2017

This study proposes a sensitive and selective liquid chromatography-electrospray ionization tandem mass spectrometry method of efficiently assessing the quality of a traditional herbal medicine called Yeonggyechulgam-tang (YGCGT). The following compounds 1 - 11, namely, liquiritin apioside (1), liquiritin (2), liquiritigene (3), coumarin (4), cinnamic acid (5), cinnamaldehyde (6), glycyrrhizin (7), atractylenolide III (8), atractylenolide II (9), atractylenolide I (10), and pachymic acid (11) were separated on a UPLC BEH $C_{18}$ column ($2.1{\times}100mm$, $1.7{\mu}m$) at a column temperature of $45^{\circ}C$ eluted with a gradient condition of 0.1% (v/v) formic acid in distilled water and acetonitrile. The correlation coefficient of the calibration curve of the eleven constituents was ${\geq}0.9936$. The limits of detection and quantification of the compounds 1 - 11 were 0.06 - 4.73 ng/mL and 0.17-14.20 ng/mL, respectively. Using this analytical method, the compound 11 in lyophilized YGCGT decoction extract was not detected, while the compounds 1 - 10 were detected 0.13-166.43 mg/g.

• Analytical Science and Technology
• /
• v.21 no.6
• /
• pp.502-509
• /
• 2008

An ID LC/MS (isotope dilution liquid chromatography/mass spectrometry) was used as a primary method for the quantitative analysis of cholesterol in human serum. The separation of cholesterol was carried out by Thermo ODS hypersil $C^{18}$ column. The mobile phase was 100% methanol, and flow rate was $0.3m{\ell}/min$. Cholesterol and cholesterol-$3,4-13C_2$ were monitored at m/z 369.4 and 371.3, which correspond to $[M-H_2O+H]^+$ respectively. In order to verify the measurement method, NIST SRM 909b was analyzed. The results agreed well with certified values within uncertainty. The four kinds of serum certified reference material were prepared and certified. The repeatabilities of measurement were ranged from 0.1 to 0.8% (RSD), which were relatively good. The reproducibility between independent measurement run was below 0.24% (RSD). The expanded uncertainty was about 1.43% within the 95% confidence interval.

• Analytical Science and Technology
• /
• v.13 no.3
• /
• pp.385-393
• /
• 2000

A gas chromatography-mass spectrometric (GC/MS) procedure for the determination of amineptine (dihydro-10, 11-dibenzo[a, d] cycloheptenyl-5-amino-7-heptanoic acid) and its main metabolites in human urine was described. Amineptine has been known to be extensively metabolized by the ${\beta}$-oxidation of the heptanoic side chain with formation of pentanoic side chain metabolite ($C_5$-metabolite), and lactamizarion by internal dehydration of (${\beta}$-oxidized metabolite (${\delta}$-lactam). The detection of these compounds was based on acid hydrolysis, liquid-liquid extraction and trimethylsilylated derivatization of the carboxylic acid group. For the determination of amineptine and its metabolites in biological fluids, selected ions at the m/ 192, molecular ion and one of the characteristic ions were monitored by GC/MS. On the excretion study of amineptine in human urine, 70-90% of amineptine, ${\delta}$-lactam, and $C_5$-metabolite were found to be excreted within 4 hours and their excretion completed within 20 hours.

• Journal of Applied Biological Chemistry
• /
• v.44 no.4
• /
• pp.167-172
• /
• 2001

A cDNA fragment encoding the chloroplastic fructose-1, 6-bisphosphatase (FBPase) was cloned via PCR from the cDNA library of pea leaves. The cloned cDNA, about 1.05 kbp without signal sequence, was introduced into a pET-28a vector for expression in E. coli strain BL21(DE3)pLysS. The recombinant FBPase was purified through $Ni^+-NTA$ affinity chromatography and characterized. Molecular mass of the monomer was about 42,000. Enzymatic activity of the purified enzyme as the native pea chloroplastic FBPase was the highest at alkaline pH (pH 9.0). The recombinant enzyme was activated by a reducing agent DTT and was insensitive to AMP. The activation energy (Ea) and Arrehenius frequency factor were 42.67 kcal/mol and $2.65{\times}10^{14}/s$, respectively, slightly higher than those of the native enzyme. $K_M$ and $V_{max}$ were $99.98{\mu}M$ and $52.9{\mu}M/min$, respectively, which were comparable with the native enzyme.

• Journal of Korean Medicine for Obesity Research
• /
• v.17 no.2
• /
• pp.87-95
• /
• 2017

Objectives: This study was conducted to evaluate efficacy and safety of Punica granatum L. Actinidia chinensis Planch. mixed extract on body fat. Methods: Thirty women were recruited ($25kg/m^2{\leq}body$ mass index [BMI]${\leq}29.9kg/m^2$) ($19yr{\leq}age{\leq}38yr$) and randomized to receive Punica granatum L. Actinidia chinensis Planch. mixed extract or placebo for 8 weeks. During the test, they visited four times including screening. Body fat mass, body fat rate, anthropometric dimensions at waist and hip, waist-hip ratio, total cholesterol, triglyceride, low density lipoprotein-cholesterol (LDL-C), and high density lipoprotein-cholesterol (HDL-C) were measured at screening and 8 weeks after screening. Adverse reaction were also checked each visit. Results: There were no significant differences in all index. But when divide experimental group by BMI index, age, and compliance, less than BMI $27kg/m^2$ group decreased body weight, body fat mass and more than BMI $27kg/m^2$ group also decreased body weight, body fat mass and waist circumference. Less than age 30 years group showed decline of waist circumference, fat free rate and T-cholesterol and more than age 30 years group showed decline of fat free mass. Group with compliance more than 95% was decreased BMI, fat free mass, and hip circumference. Conclusions: There was no significant efficacy as compared with placebo group, but as divide experimental group according to BMI index, age, compliance, mixed extract might be effective to reduce obesity index.

• Journal of Powder Materials
• /
• v.21 no.4
• /
• pp.294-300
• /
• 2014

The connecting rod is one of the most important parts in automotive engines, transforming the reciprocal motion of a piston generated by internal combustion into the rotational motion of a crankshaft. Recent advances in high performance automobile engines demand corresponding technological breakthroughs in the materials for engine parts. In the present research, the powder metallurgy (P/M) process was used to replace conventional quenching and/or tempering processes for mass production and ultimately for more cost-efficient manufacturing of high strength connecting rods. The development of P/M alloy powder was undertaken not only to achieve the improvement in mechanical properties, but also to enhance the machinability of the P/M processed connecting rods. Specifically $MoS_2$ powders were added as lubricants to non-normalizing Fe-Cr-Mn-V-C alloy powder to improve the post-sintering machinability. The effects of $MoS_2$ addition on the microstructure, mechanical properties, and machining characteristics were investigated.