• Korean Chemical Engineering Research
• /
• v.56 no.5
• /
• pp.752-760
• /
• 2018

The lowering of temperature for combustion of diesel particulate matters (or diesel soot) is one of the important tasks in automotive industry that is searching for a way to meet up "high-fuel efficiency, low-emission" standard. In this study, it was discussed how the use of ozone over platinum-based catalyst promotes a low-temperature soot oxidation occurred at $150^{\circ}C$. The use of platinum catalyst did not increase oxidation rate largely but was very effective in improving the selectivity of carbon dioxide. The pre-oxidation of NO into $NO_2$ using ozone was rather crucial in improving the oxidation rate of soot at $150^{\circ}C$.

• International Journal of Safety
• /
• v.1 no.1
• /
• pp.58-61
• /
• 2002

A preparation method of cobalt supported alumina catalyst for a emergency escape mask cartridge has been studied. Catalysts were prepared by incipient wetness impregnation method using pre-shaped $\gamma$=alumina powders of 70-100 mesh. The catalyst was tested in a continuous-flow reactor system and characterized by elemental analysis, BET and TGA-DTA techniques. Cobalt shows higher activity than platinum or nickel for carbon monoxide oxidation at room temperature. Optimum loading amount of cobalt was 10 wt.% for CO oxidation and the reaction activity increases gradually with the increase of calcination temperature up to $450^{\circ}C.

• Bulletin of the Korean Chemical Society
• /
• v.35 no.7
• /
• pp.2029-2032
• /
• 2014

Magnetically nano-$CoFe_2O_4$ efficiently catalyzes oxidation of primary and secondary benzylic and aliphatic alcohols to give the corresponding carbonyl products in good yields. The reactions were carried out in an aqueous medium at room temperature in the presence of oxone (potassium hydrogen monopersulfate) as an oxidant. In addition, the catalysts could be reused up to 6 runs without significant loss of activities. Catalyst was characterized by SEM, XRD and IR.

• Journal of the Korean Chemical Society
• /
• v.12 no.3
• /
• pp.114-120
• /
• 1968

Fe-EDTA complex, which is easily formed when Fe salt and EDTA.2Na are mixed in the aqueous medium, is found to be a very effective catalyst in the dehydropolycondensation of aminophenols. In the dehydropolycondensation of aminophenols, the catalyst, Fe(Ⅲ)-EDTA complex (higher oxidation state) is reduced to less stable Fe(Ⅱ)-EDTA complex (lower oxidation state), and the latter is easily oxidized by air to the original higher oxidation state complex, therefore the catalytic action of Fe-EDTA complex is found to be recycled effectively. Under the catalytic action of the above mentioned complex, p-aminophenol is polymerized in the aqueous medium to form the oligomers of p-aminophenol, which the degree of polymerization to be 5 or more. The oligomers formed contain partly quinone nucleus as well as amino and hydroxyl groups. In this study, the effects of the solvents and characteristics of the oligomers are discussed. These types of polymerizations catalyzed by the metallic chelate compounds are considered to be very closely related to the reactions in the living matters.

• Bulletin of the Korean Chemical Society
• /
• v.9 no.2
• /
• pp.81-84
• /
• 1988

The CO oxidation was performed on $H_2$-reduced NiO-${\alpha}-Fe_2O_3$ in the temperature range 150-$250^{\circ}C$. The kinetic study and the conductivity measurements indicate the oxidation reaction follows Langmuir-Rideal type process that is uncommon in heterogeneous catalyst$^1$. No active site is found on the catalyst surface for CO adsorption, but an oxygen vacancy adsorbs an oxygen, and this step is rate initiation. The partial orders are half for $O_2$ and first for CO, respectively. Apparent activation energy for over-all reaction is 9.05 kcal/mol.

• Bulletin of the Korean Chemical Society
• /
• v.20 no.1
• /
• pp.49-52
• /
• 1999

Various metal oxides such as Fe2O3, FeO, TiO2, MnO2, MoO3, WO3 and ZnO have been used as a catalyst for Gif-KRICT type cyclohexane oxidation. In this reaction, the conversion of cyclohexane to cyclohexanone and cyclohexanol and the selectivity ratio of cyclohexanone to cyclohexanol were greatly affected by the acidity of metal oxides. When metal oxide has more acidic property, the reactivity on oxidation is increased and the formation of cyclohexanone is more favored. From this result, we proposed a new mechanism for the biomimetic Gif-KRICT oxidation system.

• Analytical Science and Technology
• /
• v.18 no.2
• /
• pp.120-129
• /
• 2005

Volatile organic compounds (VOCs) have been recognized as major contributor to air pollution. The catalytic oxidationis is one of the most important processes for VOCs destruction due to the possibility getting high efficiency at low temperature. In this study, monometallic Pt, Ir and bimetallic Pt-Ir were supported to $TiO_2$. In order to distribute metals uniformly, $H_2O-H_2$ treatment method was used. Xylene, toluene and MEK were used as reactants. The monometallic or bimetallic catalysts were prepared by the excess wetness impregnation method and characterized by XRD, XPS, and TEM analysis. Pt catalyst showed higher conversion than Ir catalyst and Pt-Ir bimetallic catalyst showed the highest conversion. The catalysts prepared by $H_2O-H_2$ treatment had better VOC's conversion than that of nothing treatment. In the VOCs oxidation, Pt-Ir bimetallic catalysts had multipoint active sites, so it improved the range of Pt metal state. Therefore, bimetallic catalysts showed higher conversion of VOCs than monometallic ones. $H_2O-H_2$ treatment effected an uniform distribution of Pt particles. In VOCs oxidation was found to follow first order reaetion kinetics. The activation energy of $H_2O-H_2$ treatment catalysts was lower than that of untreated ones. In this study, the a small amount of Ir was used with Pt to promote the oxidation conversion of VOCs.

• Clean Technology
• /
• v.23 no.2
• /
• pp.172-180
• /
• 2017

Thermodynamic evaluation indicates that nearly 100% conversion of elemental mercury to oxidized mercury can be attained by HCl of several tens of ppm level at the temperature window of SCR reaction. Cu-, Fe-, Mn-chloride loaded $V_2O_5-WO_3/TiO_2$ catalysts revealed good NO removal activity at the operating temperature window of SCR process. The catalysts with high desorption temperature indicating adsorption strength of $NH_3$ revealed higher NO removal activity. The HCl fed to the reaction gases promoted the oxidation of mercury. However, the activity for the oxidation of elemental mercury to oxidized mercury by HCl was suppressed by $NH_3$ inhibiting the adsorption of HCl to catalyst surface under SCR reaction condition containing $NH_3$ for NO removal. Metal chloride loaded $V_2O_5-WO_3/TiO_2$ catalysts showed much higher activity for mercury oxidation than $V_2O_5-WO_3/TiO_2$ catalyst without metal chloride under SCR reaction condition. This is primarily attributed to the participation of chloride in metal chloride on the catalyst surface promoting the oxidation of elemental mercury.

• Journal of the Korea Organic Resources Recycling Association
• /
• v.29 no.4
• /
• pp.47-54
• /
• 2021

In this study, the performance of a honeycomb-type hydrogen oxidation catalyst to remove hydrogen in a hydrogen economy society to secure leaking hydrogen. The Pd/TiO₂ catalyst was prepared based on a liquid phase reduction method that is not exposed to a heat source, and it was showed through H₂-chemisorption analysis that it existed as very small active particles of 2~4 nm. In addition, it was found that the metal dispersion decreased and the active particle size increased as the reduction reaction temperature increased. It was meant that the active metal particle size and the hydrogen oxidation performance were in a proportional correlation, so that it was consistent with the hydrogen oxidation performance reduction result. The prepared catalyst was coated on a support in the form of a honeycomb so that it could be applied to the hydrogen industrial process. When 20 wt% or more of the AS-40 binder was coated, oxidation performance of 90% or more was observed under low-concentration hydrogen conditions. It was showed through SEM analysis that long-term catalytic activity can be expected by enhancing the adhesion strength of the catalyst and preventing catalyst desorption. It is a basic research that can secure safety in a hydrogen society such as gasification, organic resource, and it can be utilized as a system that can respond to unexpected safety accidents in the future.

• Journal of Energy Engineering
• /
• v.7 no.1
• /
• pp.35-43
• /
• 1998

Electrodes using for the anode electrode of direct methanol fuel cell with Pt/C and Pt/Ru/C catalyst were prepared and characterized by SEM, TEM, thermal analysis and electrochemical analysis. The half cell tests were carried out with 1 M $H_2SO_4$ electrolyte and 1 M $CH_3OH$ in order to evaluate the electrode performance. The employed electrochemical methods were cyclic vol-tammetry and potentiodynamic polarization experiments. It was found that 20 w% polytetrafluoroethylene (PTFE) content in catalyst showed the best performance due to the best platinum utilization on PTFE-containing catalyst layer. It was found that Pt/Ru/C binary catalyst inhibited the poisoning of anode electrode showing improved performance compared to the Pt/C catalyst by the adsorption of oxygen containing species on the electrode surface at same time. The apparent activation energy for methanol oxidation on the Pt/Ru/C and Pt/C catalyst layer was 11.60 kJ/mol and 26.85 kJ/mol, respectively.