• Journal of the Korean Society of Marine Environment & Safety
• /
• v.25 no.3
• /
• pp.278-286
• /
• 2019

The Port of Pyeong Taek is located on the west coast, meaning that the difference between the rise and fall of tide is great (flood tide 1.8 to 2.9 knots, ebb tide 1.6 to 2.9 knots). Due to mainly N~NW'ly strong winds & high waves during winter, navigating as well as loading & discharging vessels must focus on cargo handling. The strong tidal and wind forces in the Port of Pyeong Taek can push an LNG carrier away from its berth, which will end up causing forced disconnection between the vessel's cargo line and shore-side loading arm. The primary consequence of this disconnection will be LNG leakage, which will lead to tremendous physical damage to the hull and shore-side equipment. In this study, the 125K LNG Moss Type ship docked at No. 1 Pier of the Pyeong Taek is observed, and the tension of the mooring line during cargo handling is calculated using a combination of wind and waves to determine effective mooring line and mooring line priority management. As a result if the wind direction is $90^{\circ}$ to the left and right of the bow, it was found that line monitoring should be performed bearing special attention to the Fore Spring Line, Fore Breast Line, and Aft Spring Line.

• Journal of Power System Engineering
• /
• v.8 no.4
• /
• pp.17-23
• /
• 2004

A delivery ship is used to handle the cargo with the crane to/from the ships. The ship is inclined in the direction of a cargo which is hung on a crane. In this case, a arc shaped rail should be in the equilibrium state to get good anti rolling performance. In this study, a device and control algorithm are developed to take accurate and quick equilibrium of the rail. The device is composed of a hinged immovable support and two screw jacks. And the control algorithm demands two controllers. One controller is designed such that the screw jack 1 and 2 follow the position reference signal generated by a tilt sensor. The other controller of two degree of freedom is designed to remove the synchronous error occurred between jack 1 and jack 2. The simulation results show that the desirable control performance is achieved.

• Journal of Power System Engineering
• /
• v.11 no.1
• /
• pp.134-139
• /
• 2007

A delivery ship is used to handle the cargo with the crane to/from the ships. The ship is inclined in the direction of a cargo which is hung on a crane. In this case, a arc shaped rail should be in the equilibrium state to get good anti-rolling performance. In this study, a device and control algorithm are developed to take accurate and quick equilibrium of the rail. The device is composed of a hinged immovable support, screw jack and damper. And the control system is based on I-PD control law to consider of control input saturation and overshoot. The controller is composed of integral controller of feedforward path and proportional-derivative controller of feedback path. The parameters of controller is designed to follow the reference signal and to remove overshoot. The simulation results show that the desirable control performance is achieved.

• Journal of Korea Port Economic Association
• /
• v.21 no.4
• /
• pp.121-139
• /
• 2005

The case, Papera Traders Co. Ltd. and Others v. Hyundai Merchant Marine Co. Ltd and Another(The Eurasian Dream), was occurred on July, 1998 when the ISM Code became mandatory under SOLAS and from that date it applied to oil tankers, chemical tankers, gas carriers, bulk carriers and cargo high-speed craft of 500 gross tonnage and above. On July 23, 1998, a fire started on the deck of pure car carrier Eurasian Dream while in port at Sharjah. The source of fuel was the stevedores action of pouring petrol or transferring fuel in some way - refueling or pouring into a carburettor. The fire eventually destroyed or damaged the vessels cargo of new and second-hand vehicles and rendered the vessel itself a constructive total loss. Justice Cresswell held that the fire that destroyed or damaged the cargo was due to the unseaworthiness of the vessel they have the burden of proving that the vessel was unseaworthy before and at the beginning of the voyage and that the loss or damage was caused by that unseaworthiness. This case was a dispute between dependent and claimant alleging that the carrier should provide "properly man, equip and supply the ship and keep the ship so manned" under Hague-Visby Rules. Although ISM code was not officially applied to the carriage by car carriers until July 2002, a rule based on the code had customarily been employed as a mean for international dispute resolution. Examining the above case closely, the purpose of this study is to explore the relation of ship management and obligation to exercise due diligence in making the vessel seaworthy.

• Proceedings of the Korea Committee for Ocean Resources and Engineering Conference
• /
• 2000.10a
• /
• pp.189-195
• /
• 2000

New concept of LNG-FPSO ship with moonpool and bilge step in bottom is considered and investigated in the point of motion reduction and sloshing phenomena of the cargo and operation tanks. The cargo capacity of the ship of which principle dimensions is L x B x D x t(design) =270.0 x 51.0 x 32.32 x 13.7(m) 16K at 98% loading condition. The two moonpools and rectangular step at bilge part are setted up specially for getting the effect of motion decrease. For the motion analysis, linearized three dimensional diffraction theory with the simplified boundary conditions is used. The six-degree of freedom coupled motion responses are calculated for the LNG-FPSO ship. Viscous effects on the roll motion responses of a vessel are taken into account in this calculation program using an empirical formula suggested by Ikeda, Himeno and Tanaka is used. The case study for the moonpool size had been carried out by theoretical estimation and experimental method. For the optimization of the moonpool size and effect of the step, 9 cases of its size and with and without step are considered. From the results of calculation and experiment, it can be concluded that this designed LNG-FPSO ship have possibility to carry out her missions in the rough sea as for the owner's demand waves condition. The motion responses, especially roll motion, for the designed LNG-FPSO ship are much lower than those of another drillship and shuttle tanker and limit criterions are satisfied. For the check of the cargo tank and operation tank sizes we have performed sloshing analysis in the irregular waves which focuses on the pressure distribution on the tank wall and the time history of pressure and free surface for No.2 and No5. tanks of LNG-FPSO with chamfers. Finally we got the tank size which has no resonance and no impact pressure in all filling in the bow quartering and beam sea.

• Journal of the Korean Society of Marine Environment & Safety
• /
• v.28 no.6
• /
• pp.1100-1109
• /
• 2022

Herein, a case study was conducted on the bilge pumping performance of a 24,000TEU class container ship with an overall length of 400m. Although the bilge system of the 24,000TEU class container ship was designed in accordance with the rule requirements of the Classification Society, the bilge system did not satisfy the 2 m/s requirements of SOLAS Reg.II-1/35-1 under the rated flow rate and maximum flow rate conditions of the bilge pump installed in the ship. In particular, assumptions were made that No.1 ~ No.4 cargo holds were flooded and filled entirely by sea water and the evaluation of bilge pumping performance had been performed for No.1 ~ No.4 cargo holds. According to the evaulation results of the, the mean water velocity at the main bilge pipe for No.2, No.3, and No.4 cargo holds did not meet the 2 m/s criterion. To resolve this problem, in this study, the branch bilge pipe in each cargo hold was changed from 150A to 200A and the mean water velocity at the main bilge pipe for No.2, No.3, and No.4 was calculated as 2.479m/s, 2.476m/s, and 2.459m/s, respectively.

• Journal of the Society of Naval Architects of Korea
• /
• v.44 no.3 s.153
• /
• pp.285-295
• /
• 2007

In order to ensure safety of small vessels, the amended Ship Safety Act will come into force on 4th. Nov. 2007. This study is performed to suggest the stability criteria of fishing vessels and cargo ships of 12m in length and over but less than 24m in length which will be new object of amended Ship Safety Act. We have analyze the dimensions of domestic small vessels and the casualty reports of capsizing accidents. According to the analyzed result, 58 ships that are in the range of the dimension are modeled and the stability calculation has been carried out. The Stability for the 58 ships has been analyzed by comparing the result that applied the selected standard in the national standard to the stability calculation. Based on the regression analysis of the model ship's allowable transverse metacentric-heights under several stability requirements, stability criteria for small fishing vessels and cargo ships are proposed.

• Special Issue of the Society of Naval Architects of Korea
• /
• 2007.09a
• /
• pp.26-31
• /
• 2007

After CSR is in effect, a matter of concern is how many to increase in terms of weight due to apply it to the ship and what difference it is comparing between existing rule and CSR rule. The concepts of CSR are to make the ship safer, more robust. and the design requirement clearer. Furthermore it pursues longer life of ship in fatigue strength. By reasons of those, most of requirements are stronger than before. Therefore many part of ship should be reinforced and the weight of ship can be increased. Under those circumstances, the builder should make an effort to define the CSR and to find the methods to manage well this situation. In this study, we performed 3D Cargo hold and Fine-mesh F.E analysis and deduced a conclusion and introduced new detail design.

• Journal of the Society of Naval Architects of Korea
• /
• v.46 no.3
• /
• pp.343-350
• /
• 2009

Recently ship safety regulations are being reinforced to improve maritime safety and to prevent maritime pollution by International Maritime Organization. It means that the regulation is becoming more proactive rather than reactive. In the mean time, design philosophy is also moving from rule based design to performance and simulation based design. In this paper, a study on practical application of the damage safety assessment system is carried out. The damage stability and the survivability of a cargo ship that was designed based on current regulation is investigated using performance based design tools in order to improve the safety of the design and verify the performance of the developed damage safety assessment system. To do this, damage scenarios is established and the characteristics and geometry the cargo ship is modeled. A new design alternative is proposed with small change in the internal arrangement based on safety evaluation results of the current design.

• Journal of the Korean Institute of Navigation
• /
• v.14 no.4
• /
• pp.1-15
• /
• 1990

With increasing ship's speed turnround and port time becomes a large percentage of total roundtrip time and this causes to accelerate the introduction of the various kind of modern handling equipment, the standardization of cargoes, and the improvement of the ship. However, it is still a drag on efficient operation of ship. Similarly, the turnround time at the container port is very important as a measure for the decision of the efficiency of port. To decrease operating coasts, the minimization of the time need to cargo handling at the ports of call must be achieved. Thus the optimization of the time need to cargo handling at the ports of call must be achieved. Thus the optimized Container Loading Plan is necessary, especially under the rapid speed of container operations. For the container loading plan, in this thesis, we use the hungarian method and the branch and bound method to get the initial disposition of both maximization of ship's GM and minimization of shift number to the obstructive container in a yard area. We apply the dynamic programming algorithm to get the final disposition for minimizing total turnroudn time and finally we analyzed the results to check whether the initial disposition is proper or not.