• Bulletin of the Korean Chemical Society
• /
• 제28권12호
• /
• pp.2363-2368
• /
• 2007

A glassy carbon electrode (GCE) modified with phytic acid (PA) and single-walled carbon nanotubes (SWNTs) were investigated by voltammetric methods in buffer solution. The PA-SWNTs/GCE-modified electrode demonstrated substantial enhancements in electrochemical sensitivity and selectivity towards dopamine (DA) in the presence of L-ascorbic acid (AA). The PA-SWNTs films promoted the electron transfer reaction of DA, while the PA film, acting as a negatively charged linker, combined with the positively charged DA to induced DA accumulation in the film at pH under 7.4. However, the PA film restrained the electrochemical response of the negatively charged AA due to the electrostatic repulsion. The anodic peak potentials of DA and AA could be separated by electrochemical techniques, and the interferences from AA were effectively eliminated in the DA determination. Linear calibration plots were obtained in the DA concentration range of 0.1-10 μM and the detection limit of the DA oxidation current was determined to be 0.06 μM at a signal-to-noise ratio of 3. The results indicated that the modified electrode is used to determine DA without interference from AA.

• 한국초전도ㆍ저온공학회논문지
• /
• 제15권2호
• /
• pp.12-15
• /
• 2013

The pure and carbon (C)-doped $MgB_2$ thin films were fabricated on $Al_2O_3$ (0001) substrates at a temperature of $650^{\circ}C$ by using hot-filament-assisted hybrid physical-chemical vapor deposition technique. The $T_c$ value for pure $MgB_2$ film is 38.5 K, while it is between 30 and 35 K for carbon-doped $MgB_2$ films. Expansion in c-axis lattice parameter was observed with increase in carbon doping concentration which is in contrast to carbon-doped $MgB_2$ single crystals. Significant enhancement in the critical current density was obtained for C-doped $MgB_2$ films as compared to the undoped $MgB_2$ film. This enhancement is most probably due to the incorporation of C into $MgB_2$ and the high density of grain boundaries, both help in the pinning of vortices and result in improved superconducting performance.

• 한국정밀공학회:학술대회논문집
• /
• 한국정밀공학회 2010년도 춘계학술대회 논문집
• /
• pp.539-540
• /
• 2010

• 한국정밀공학회:학술대회논문집
• /
• 한국정밀공학회 2010년도 춘계학술대회 논문집
• /
• pp.495-496
• /
• 2010

• 한국정밀공학회:학술대회논문집
• /
• 한국정밀공학회 2007년도 춘계학술대회 논문집
• /
• pp.677-678
• /
• 2007

• Composites Research
• /
• 제29권4호
• /
• pp.156-160
• /
• 2016

유리상 탄소는 열적으로 안정하고, 화학적 반응성이 매우 낮으며, 다양한 크기로 제작이 가능하고, 전기적 저항 또한 낮아서 다양한 극한 환경에서 사용 가능하다. 이 논문에서는 전자빔 조사가 유리상 탄소 박막의 구조 변화에 미치는 영향과 그에 따른 열전효과 변화에 대해 연구하였다. 라만 분광 특성 분석을 바탕으로 유리상 탄소 박막에 전자빔 조사에 따라 결정화 또는 비정질화가 일어나는 것을 확인하였다. 또한, 이러한 결정변화가 유리상 탄소 박막의 자유전자 도핑 농도의 변화시키며 그에 따른 제백 상수나 전기적 전도도의 변화도 확인하였다. 전자빔 조사로 인하여 유리상 탄소의 열전파워 펙터가 최대 200%까지 향상되는 것을 보여 주었다.

• Applied Science and Convergence Technology
• /
• 제26권2호
• /
• pp.34-41
• /
• 2017

A 2.45 GHz microwave plasma with linear antenna has been prepared for hydrophobic and wear-resistible surface coating of carbon steel. Wear-resistible properties are required for the surface protection of cutting tools and achieved by depositing a hydrogenated amorphous carbon film on steel surface through linear microwave plasma source that has $TE_{10}-TEM$ waveguide. Compared to the existing RF plasma source driven by 13.56 MHz, linear microwave plasma source can easily generate high density plasma and provide faster deposition rate and wider process windows. In this study, $Ar/CH_4$ gas mixtures are used for hydrogenated amorphous carbon film deposition. When microwave power of 1000 W is applied, 40 cm long uniform $Ar/CH_4$ plasma could be obtained in gas pressure of 200~400 mTorr. The Vickers hardness measurement of hydrogenated amorphous carbon film on steel surface was evaluated. It was found the optimized deposition condition at $Ar:CH_4=25:25$ sccm, 300 mTorr with microwave power of 1000W and RF bias power of 100W. By deposition of hydrogenated amorphous carbon film, contact angle on steel surfaces increases from $43.9^{\circ}$ to $93.2^{\circ}$.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 2009년도 추계학술대회 논문집
• /
• pp.244-244
• /
• 2009

Carbon nanotubes (CNTs) have excellent electrical, chemical stability, mechanical and thermal properties. In this paper, networks of Multi-walled carbon nanotube (MWCNT) materials were investigated as transparent electrode. Sensor films were fabricated by air spray method using the multi-walled CNTs solution on glass substrates. The film that was sprayed with the MWCNT dispersion for 60 sec, was 300nm thick. And the electric resistivity and the light transmittance rate are $2{\times}10^2{\Omega}cm$ and 60%, respectively.

• 한국정보디스플레이학회:학술대회논문집
• /
• 한국정보디스플레이학회 2007년도 7th International Meeting on Information Display 제7권2호
• /
• pp.1245-1248
• /
• 2007

We propose new approaches to thin film transistor fabrication that use carbon nanotubes and semiconductor nanowires as active elements. These nanomaterials which are essentially studied in the context of the post CMOS era will certainly impact the active matrix display industry in the near future.

• 한국정보통신학회논문지
• /
• 제14권9호
• /
• pp.2065-2070
• /
• 2010

유기박막 반도체 소자에서 주로 보호막으로 사용되는 PMMA 코팅 박막의 특성에 대하여 FTIR 분석법을 이용하여 조사하였다. 희석된 PMMA 혼합액은 비율에 따라서 $SiO_2$ 박막의 표면을 친수성, 소수성 혹은 하이브리드 특성으로 변화시켰다. FTIR 분석에 의하여 탄소의 함량이 적은 샘플 7에서 화학적인 변화가 크게 일어나는 것을 확인하였다. 전자를 많이 포함한 소량의 탄소가 $SiO_2$ 박막의 분극성을 감소시키고 박막의 표면에너지를 감소시켜서 화학적으로 안정된 박막의 표면을 형성하여 누설전류가 감소되었다. FTIR 분석은 유기화합물 박막에서 일어나는 화학적 변화에 대하여 미세한 부분까지 측정할 수 있는 척도로서 유용한 분석 방법임을 확인하였다.