• Journal of the Korean Society for Aeronautical & Space Sciences
• /
• v.32 no.4
• /
• pp.67-72
• /
• 2004

A regenerative cooling system has been designed through empirical 1-D analysis for a liquid rocket engine of 30-ton-level thrust. The hot-gas-side wall temperature from 1-D analysis shows 100K difference compared to 3D CFD analysis. Two variations of design with same cooling performance are suggested for different maximum channel widths i.e., 4mm and 2mm. The coolant pressure drop of the latter design is higher by 20%. The maximum liner temperature is about 700K when TBC and the thermal resistance of carbon deposit are considered. So film cooling is recommended to increase the cooling capacity as the present cooling capacity is insufficient

• The Korean Journal of Ecology
• /
• v.10 no.4
• /
• pp.195-204
• /
• 1987

Pollen analysis of moor peat of Daeam Mountain revealed vegetational history around Daeam Mountain. The pollen stratigraphy might be zoned into three, Zone I, Zone II and Zone III for the past 2, 200 years. The time required for amount of the accumulated peat in the moor was estimated in terms of the balance of the accumulation and decay of organic carbon of the deposit peat. Zone I(770~2, 200 yr BP) had Pinus and Quercus as main elements. Gramineae decreased while Typhaceae, Cyperaceae and spores such as Polypodiaceae increased. Zone II(300~770 yr BP) showed warming trend which is suggested by high pollen concentrations of Quercus, Juglans, Carpinus, Ulmus and by a more diverse flora of deciduous borad-leaved trees than Zone I. Pinus decreased in this zone. It suggests that the overall environment became milder than Zones I and III. Zone III(earlier than 300 yt BP) was predominantly Quercu and Pinus with amount of nonarboreal species such as Artemisia, Gramineae and Chenopodiaceae, that was grown under dry conditions. It suggests that overall environment vecome humid by comparison with the present time and it is surmised the course of boggy ground formation by a retrogressive succession.

• YAKHAK HOEJI
• /
• v.31 no.3
• /
• pp.133-139
• /
• 1987

These studies were attempted to investigate the preventive effect of Ganoderma lucidum extract administered concurrently with glutathione on the liver damage induced by carbon tetrachloride ($CCl_4$) in rats. S-GOT and S-GPT activities of all the pre-treatment groups were significantly decreased, as compared with those of the control intoxicated by $CCl_4$. The concurrent administrations of Ganoderma lucidum extract with glutathione (100+100mg/kg, 200+100mg/kg, and 400+100mg/kg, respectively) were more effective than the individual administrations. i.e., Ganaderma lucidtcm extract (100, 200 and 400mg/kg, respectively) and glutathione (100, 200 and 400mg/kg, respectively). On the determination of lipid-peroxidation in liver, the concurrent administrations of Ganoderma lucidum extract with glutathione (100+100mg/kg, and 200+100mg/kg, respectively) significantly reduced the liver TBA values. Although hepatic cellular necrosis and fatty acid deposit were remarkably increased by $CCl_4$ intoxication, the concurrent administration of Ganoderma lucidum extract with glutathione (200+100mg/kg) reduced the pathological changes of parenchymal cell necrosis and fatty changes around centrilobalar area of the control. These findings indicate that the concurrent administrations of Ganoderma lucidum extract with glutathione showed better improvements than the individual administrations of them in all pathological aspects, in particular, against hepatitis and hepatic necrosis due to the cellular necrosis and fatty infiltration.

• Journal of the Korean Institute of Illuminating and Electrical Installation Engineers
• /
• v.25 no.11
• /
• pp.103-112
• /
• 2011

This paper is tried to analysis the optical emission spectroscopy related to the position of inductive load coil and flow rates of methane and oxygen in the RF inductive plasma process. According to the position of load coil, peak of $H_{\alpha}$, $H_{\beta}$, and CH were appeared strongly at the middle position of the coil and it decreased both direction. The electron temperature was approximately 0.9[eV] at that position. Emission intensities of $H_{\alpha}$, $H_{\beta}$, and CH increased linearly by increasing input power. In addition, intensities of $H_{\alpha}$ and $H_{\beta}$ increased by increasing the flow rate of oxygen. It might be ascribed that the oxygen species were bonded with $C_nH_m$ by suppressing the combination with hydrogen atoms. Consequently, the optimal position of the inductive coil is decided to the intermediate position between 4th and 5th turns, the wanted carbon thin-film is possible to deposit by controlling flow rates of methane and oxygen.

• Journal of Industrial and Engineering Chemistry
• /
• v.68
• /
• pp.196-208
• /
• 2018

The effect of channel-system of zeolite on methanol-to-DME reaction was studied. Results revealed that channels size and topology affect catalyst lifetime, type and location of coke precursors. FER and MFI showed the best resistance towards coke deposition, whilst fast deactivation was observed on MOR. Although the higher concentration and strength of acid sites, FER structure formed a lower coke amount, preferably located within the pores, while coke cluster deposited on the external surface of MOR. Analysis of acid sites distribution and strength was performed during deactivation-regeneration process. Coke location assessment was also supported by molecular simulations.

• Journal of the Korean Society of Propulsion Engineers
• /
• v.23 no.2
• /
• pp.46-52
• /
• 2019

This research was conducted to analyze the effects of temperature on coking characteristics of kerosene. The kerosene was heated to 600 K, 700 K, and 800 K, and the cooled samples were collected. The used copper tubes were replaced according to the temperature conditions. The liquid and copper specimens were analyzed by gas chromatography-mass spectrometry and scanning electron microscopy equipped with an energy dispersive x-ray spectrometer, respectively. The results of the analysis confirmed that a carbon deposit was formed from the coking of fuel on the inner surface of the copper specimen at a relatively high temperature (800 K) of the copper tube.

• Journal of the Institute of Electronics and Information Engineers
• /
• v.53 no.8
• /
• pp.76-82
• /
• 2016

In this paper, we evaluated shielding effectiveness (SE) of carbon nanotube (CNT) film using near field scanning (NFS) in near field analysis. We adopted CNT film with deposit carbon density of 5% and thickness of 1mm for evaluation of shielding characteristic. Using a test coupon analogized to an actual IC package, we measured SE according to measuring position and SE according to distances between the CNT film and the test coupon. As a result, the measured SE in the near field varied with frequency. Especially, the measured electric field SE in the center of the test coupon is better than that of the measured edge point of the test coupon where it is affected by fringing effect. The results show that the measured SE in the near field is affected not only by frequency but also by measurement environment such as position and height of the probe and height of shielding film. In conclusion, we should choose proper methods for SE measurement considering interference distance in the electronic control system because there is little correlation between the proposed evaluation method in the near field and ASTM D 4935-10.

• Applied Chemistry for Engineering
• /
• v.10 no.6
• /
• pp.843-847
• /
• 1999

In this research, C/SiC composites, i.e. activated carbon coated with SiC obtained from dichlorodimethylsilane(DDS) and hydrogen, have been made by chemical vapor infiltration(CVI) in a fluidized bed reactor. Activated carbons of sizes of 4~12, 12~20, and 20~40 mesh were used. After deposition the surface area, the amount and the shape of deposit of each sample were observed at different concentrations of reactant DDS, sizes of activated carbon, reaction pressures and reaction times. The experimental results showed that uniform deposition in the pores of sample was obtained at a lower concentration of DDS and a lower pressure. Additionally, from the observation that the pore diameter and the surface area have minimum values at a certain time of deposition, it was known that deposition occurred inside of the pore at first and then on the outside of particle. Small particles of SiC were deposited uniformly on the surface of activated carbon at lower DDS concentrations and lower reaction pressures. The results were confirmed by SEM, TGA, the pore size distribution analyzer and BET.

• Journal of Climate Change Research
• /
• v.6 no.4
• /
• pp.319-330
• /
• 2015

This study was carried out to predict the optimal growth site and estimate carbon stocks of Quercus acuta, evergreen broad-leaved trees in warm temperate zone according to climate change. The criterion for the optimal site prediction was created by quantification method with quantitative and qualitative data, collected from growth factors of stands and environmental factors of survey sites of 42 plots in Q. acuta by study relationship between growth of tree and site environmental factors. A program for the optimal site prediction was developed by using GIS engine tools. To prediction of the suitable growth site of Quercus acuta, developed program in this study applied to Wando in Jeollanam-do, distributing a various evergreen bread-leaved trees of warm temperate zone. In the results from analysis of the optimal site prediction on Q. acuta, the characteristics of the optimal site showed as follows; site environmental features of class I (the best site class for Q. acuta) was defined as 401 ~ 500 m of altitude, $21{\sim}25^{\circ}$ of slope with above hillside, residual of deposit convex of slope type with west of aspect. The area and carbon stocks of optimal site prediction by class for Q. acuta in classI showed 147.1 ha (2.5%), total 316.5 tC/ha, total $1,161tCO_2/ha/yr$ of class I, 2,703.5 ha (46.3%), total 5,817.4 tC/ha, total $21,331tCO_2/ha/yr$ of class II, 2,845.5 ha (48.6%), total 6,123.0 tC/ha, total $2,845.5tCO_2/ha/yr$ of class III and 153.7 ha (2.6%), total 330.7 tC/ha, total $1,213.7tCO_2/ha/yr$ of class IV.

• Applied Chemistry for Engineering
• /
• v.30 no.2
• /
• pp.212-218
• /
• 2019

To investigate the effect of the oxyfluorination of carbon nanotubes (OF-CNTs) on electroless Ni deposition and electromagnetic interference shielding efficiency (EMI SE), CNTs were treated with a mixture of oxygen and fluorine gases and sequentially deposited with nickel. These samples were then manufactured into thin films on a polyimide film to evaluate their EMI SE. The surface chemical property of OF-CNTs was investigated by X-ray photoelectron spectroscopy. From the results of thermogravimetric and scanning electron microscopic analyses, it was found that both the amount of deposited Ni and the surface morphology changed depending on oxyfluorination. Moreover, the Ni-deposited CNTs pretreated with $O_2:F_2=1:9vol%$ exhibited the maximum EMI SE as approximately 19.4 dB at 1 GHz. These results were attributed to the formation of oxygen and fluorine functional groups on the surface of CNTs due to the oxyfluorination, and the functional groups enabled to deposit a suitable amount of Ni and improve the dispersion in the deposited solution.