• Journal of the Korean Society of Visualization
• /
• v.9 no.2
• /
• pp.21-26
• /
• 2011

Hydrodynamic focusing technique to generate focused flow has been used for flow cytometry in microfluidic devices. However, devices with circular capillary tubes made of glass are not suitable for flow visualization or optical signal detection because the rays of light are distorted at the curved interface. We devised a new acrylic chamber assembled with a pulled micropipette and a rectangular microchannel made of glass. This new channel geometry enabled us to visualize the three-dimensional (3D) flow characteristics with confocal imaging technique. We analyzed the 3D hydrodynamic focusing in a circular capillary tube and a rectangular microchannel over a practical range of flow rates, viscosities and pressure drops.

• Journal of Industrial and Engineering Chemistry
• /
• v.68
• /
• pp.24-32
• /
• 2018

Nanocellulose was surface-functionalized toward the applications in enhanced oil recovery (EOR) as a green alternative. The focus of this paper is on the effect of this material based nanofluid (NF) on foam lamella stabilization through studying its bubble breakup dynamics and flow behaviors in constricted mircofluidic devices. The NF stabilized foam produced an improved flow resistance across the capillary largely due to the capillary trapped bubbles at the contraction. The "snap-off" caused the NF stabilized foam to produce finer textured bubbles, which can migrate readily forward to the deep porous media, as revealed by the pressure profiles.

• Geomechanics and Engineering
• /
• v.31 no.4
• /
• pp.385-393
• /
• 2022

Previous studies postulated insignificant capillary rise (h_c) effect above the water table (H_w) for unsaturated soils. In addition, these studies utilised dry unit weight above H_w. This paper, therefore, addresses the effect of these postulations on strength where the influence of h_c using a modified upper bound approach, Discontinuity Layout Optimization (UNSAT-DLO) for a simulated soil was predicted. Two different parametric studies to model passive earth pressure and bearing capacity problems are carried out to provide an insight into the effect of capillary rise on strength. Significant increase in strength, owing to unsaturated conditions, was obtained where the maximum increase was when suction slightly less or greater than the air entry suction. On the other hand, the results showed a negative effect of h_c. For example, up to 8.24% decrease in passive thrust (P_p) was obtained at H_w=0 m when h_c rose 1 m from 0 m. To put this into perspective, this was equivalent to a decrease of about 2° in 𝜙 at H_w=0 m and h_c =0 m in order to obtain the same result at h_c =1 m. For the bearing capacity problem, the effect was seen to be higher, up to 18.4% decrease in N_𝛾 was obtained when h_c rose from 0 m to 2.5 m at H_w =0 m. In addition, the results revealed a negative influence of assigning dry unit weight above H_w or h_c.. However, considerable increase in strength was obtained when unsaturated unit weight above h_c was assigned.

• Clinical and Experimental Pediatrics
• /
• v.45 no.4
• /
• pp.449-453
• /
• 2002

Purpose : Arterial blood gas analysis is frequently performed in neonatal intensive care unit (NICU) to evaluate ventilation and the metabolic state of critically ill infants. In occasions when umbilical arterial catheterization is not available, frequent arterial puncture is mandatory. This requires some technical skill and may occasionally have side effects. So we studied the validity of capillary blood gas analysis which can be performed conveniently compared with arterial blood. Methods : Twenty-four neonates admitted to NICU during April to Aug. 2001 were studied. They were more than two weeks old without indwelling arterial catheters. Thirty-six times, simultaneous arterial, and capillary blood gases were drawn by puncture and the pH, $pCO_2$ and $pO_2$ of each sample was measured. Blood pressure and body temperature was checked before sampling to rule out impaired peripheral circulation. Capillary blood was collected from warmed heels. Results : There was a strong correlation between capillary and arterial pH(r=0.91, P<0.05). The absolute value of the difference between arterial and capillary pH was less than 0.05. Also capillary $pCO_2$ showed correlation with arterial $pCO_2$(r=0.77, P<0.05). Despite a statistically significant correlation between capillary and arterial $pO_2$(r=0.68, P<0.05), the absolute value of the difference was more than 10 mmHg in 92% of cases. Conclusion : Capillary blood gases accurately reflected arterial pH and $pCO_2$ and showed a relative correlation with $pO_2$. Capillary blood gas analysis can be a useful alternative to arterial blood when continuation of the umbilical arterial catheter is no longer available.

• Proceedings of the Korean Society of Soil and Groundwater Environment Conference
• /
• 1999.04a
• /
• pp.4-5
• /
• 1999

• Journal of the Korean Ceramic Society
• /
• v.49 no.3
• /
• pp.231-235
• /
• 2012

Plasticity is the ability of clay to respond to pressure with a continuous and permanent change of shape in any direction without breaking apart, and hold that shape when released. In this work, the effect of water content and aging period on the plasticity of porcelain clay was evaluated using the capillary rheometer to measure the flow rate and the shear stress. The shear stress of porcelain clay was slightly increased with increasing the aging period, indicating that the plasticity of porcelain clay was influenced by an organic content. It was also observed that the water content in the porcelain clay had a great influence on the plasticity of porcelain clay. The shear stress with water content of 21 wt% was sharply increased with increasing shear rate, but the shear stresses with water contents of 24 and 27 wt% is gently incremented.

• Transactions of the Korean Society of Mechanical Engineers B
• /
• v.33 no.10
• /
• pp.778-782
• /
• 2009

Recently, we developed a simple thermopneumatic micropump having neither a membrane nor a valve. This micropump discharges liquid by a thermopneumatic pressure and refill by a capillary attraction. In case of the micropump driven by the capillary attraction, the flow characteristic depends mainly on the geometry of the micropump. In this paper, we investigated the influence of the geometry of the micropump on the performance of the micropump to illustrate the properness of the micropump shape. We analyzed the micropump characteristics of six types having different geometries by FVM simulation with a commercial CFD tool. Also we fabricated the micropumps with PDMS and glass by micromachining, and tested the performances. The simulation and the test results illustrate that the discharge volume and the discharge time depend on the chamber volume. The expansion angle of the inlet channel location has influence on the refill time, while the front air channel direction has influence on the backward flow loss.

• Agricultural and Biosystems Engineering
• /
• v.2 no.1
• /
• pp.31-36
• /
• 2001

Based on the viscous flow characteristics of gas through capillary tube, a simple and cheap gas mixing system was developed for controlling gas compositions in CA chambers. The gas flow rate through capillary tube had a linear relationship with pressure, (length)$^{-1}$ and (radius)$^4$ of capillary tube, which agreed well with Hagen-Poiseuille’s law. The relationship between flow rate and combined parameters was described as Q=0.000209724($\pi$ r$^4$P/$\mu$L) and the coefficient of determination was 0.9984. The developed system could control gas concentrations in CA chambers within $\pm$0.3% deviation compared to the preset concentrations. It was possible to predict the required time and required gas flow rate for exchanging the gs in CA chamber to a certain concentration of gas by using the mathematical model developed in this study.

• Elastomers and Composites
• /
• v.22 no.3
• /
• pp.213-218
• /
• 1987

In this study, the rheological properties of a partially valcanized black filled EPDM were investigated as a function of degree of crosslinks using capillary rheometer. In order to obtain the samples having various degree of crosslinks between 0 and 6 percent, the vulcanization kinetics was also studied by Monsanto rheometer. The results showed that the die swell ana the pressure drop at the capillary entrance and exit increase nearly linearly with the increase in degree of crosslinks. However, melt fracture occurred at a lower shear rate for the samples of higher degree of crosslinks. These results were discussed in terms of the melt elasticity produced at the entrance region of capillary by the partial vulcanization. It is also interesting to note that the fluctuation of die swell during the practical extrusion or calendering process in the factories can be caused by the partial vulcanization occurred during the process.

• Magazine of the Korean Society of Agricultural Engineers
• /
• v.33 no.2
• /
• pp.120-129
• /
• 1991

This study refers to temporal variation of physical properties of tilled soil under natural rainfalls. Field measurements of porosity, average hydraulic conductivity and average capillary pressure head on a tilled soil were conducted by soil sampler and air-entry permeameter respectively at regular intervals after tillage. Temporal variation of these physical properties were analysed by cumulative rainfall energy since tillage. Field experiment was conducted on a sandy loam soil at Suwon durging April~July in 1989. The followings are a summary of this study results ; 1. Average porosity just after tillage was 0.548cm$^3$/cm$^3$. As cumulative rainfall energy were increased in 0.1070, 0.1755, 0.3849 J/cm$^2$, average porosity were decreased in 0.506, 0.4]95, 0.468m$^3$/cm$^3$ respectively. 2. Average hydraulic conductivity just after tillage was 45.42cm/hr. As cumulative rainfall energy were increased in 0.1755, 0.2466, 0.2978, 0.3849J/cm$^2$ average hydraulic conductivity were decreased in 15.34, 13.47, 9.58, 8.65cm/hr respectively. 3. As average porosity were decreased in 0.548, 0.506, 0.495, 0.468cm$^3$/cm$^3$ average capillary pressure head were increased in 6.1, 6.7, 6.9, 7.4cm respectively. 4. It was found that temporal variation of porosity, average hydraulic conductivity on a tilled soil might be expressed as a function of cumulative rainfall energy and average capillary pressure head might be expressed as a function of porosity. 5. The results of this study may be helpful to predict infiltration into a tilled soil more accurately by considering Temporal variation of physical properties of soil.