• Journal of the Korean Applied Science and Technology
• /
• v.16 no.2
• /
• pp.179-185
• /
• 1999

The effect of blowing agents and inner temperature on the machanical properties of the flexible polyurethane foams were investigated. In the study used that chemical blowing agents is $H_2O$ and support blowing agents. CFC-11, HCFC-114b, dichloromethane, n-penthane, iso-pentane, cyclopentane. The flexible polyurethane foams were foamed by the density of $0.015{\pm}0.002g/cm^3$ and $0.024{\pm}0.002g/cm^3$ which were used in mechanical properties measurements. Inner temperature was measure as long as the preparation of the flexible polyurethane foams of each blowing agents. The density, tensile strength, elongation, tear strength, compression strength and compression set were measured after 48 hours hardening. The result of the study was optimized dichloromethane and cyclopentane at the support blowing agents.

• KSBB Journal
• /
• v.11 no.6
• /
• pp.636-641
• /
• 1996

The production of extracellular mannitol by a new mannitol-producing bacterium, Leuconostoc sp. KY-002 was studied in shake flask cultures. The new isolate has a capability of utilizing fructose and sucrose for mannitol formation. Maximum mannitol production was obtained with fructose as the sole carbon source. Under the optimal culture conditions, within 70 hours of incubation, a final concentration of 26 g/L of mannitol from 50 g/L fructose was obtained with an indicated yield of 52% based on fructose consumed. However, higher concentrations of fructose ranging from 100 to 250 g/L could not effectively be transformed to mannitol due to a lack of osmotolerance. The strain produced no other polyols such as glycerol and sorbitol as by-products. Yeast extract was the best nitrogen source and high levels of inorganic phosphate up to 10 g/L promoted mannitol formation. Any mineral ions and salts did not play important role in both cell growth and mannitol production. Nicotinic acid enhanced mannitol production by 16%. The optimum culture temperature and initial pH were $35^{\circ}C$ and 6, respectively.

• Korean Journal of Materials Research
• /
• v.7 no.8
• /
• pp.654-659
• /
• 1997

HMDS[Si$_{2}$(CH$_{3}$)$_{6}$]단일 선구체를 이용하여 화학증착 방법으로 성장된 3C-SiC/Si(001) 이종접합박막의 특성을 XRD, 라만 스펙트럼 및 투과전자현미경(TEM)등을 이용하여 조사하였으며 시판되고 있는 상용 3C-SiC/Si 시편을 같은 방법으로 분석하여 특성을 비교검토하였다. $C_{3}$H$_{8}$-SiH$_{4}$-H$_{2}$혼합가스를 선구체로 이용하여 5$\mu\textrm{m}$두께로 성장된 상용 3C-SiC/Si 이종접합박막 시료의 XRD스펙트럼에서는 강한 3C-SiC(002)피크 만이 관찰되었으며, 라만 스펙트럼의 LO피크는 970nm$^{-1}$ 정도에서 강하게 나타났다. TEM 관찰 결과 다수의 전위, 쌍정, 적층결함 및 APB와 같은 결정결함들이 3C-SiC/Si 계면 근처에 집중적으로 분포되어 있었으며 성장된 박막은 단결정임을 확인할 수 있었다. 선구체로 HMDS를 사용하여 0.3$\mu\textrm{m}$ 및 2$\mu\textrm{m}$ 두께로 성장시킨 3C-SiC/Si 박막 시료의 XRD 스펙트럼은 다소 완만한 3C-SiC(002) 피크와 함께 3C-SiC(111)피크가 관찰되었으며, TEM으로 확인한 결과 소경각 결정립들이 약 5˚-10˚ 정도 방위차를 가지고 성장하여 기둥구조(columnar structure)를 이루고 있기 때문임을 알 수 있었다. 라만 스펙트럼 분석 결과 박막의 LO 피크가 967-969nm$^{-1}$정도로 다소 낮은 wavenumber쪽으로 이동되어 박막 내에 상당한 응력이 존재함을 확인할 수 있었다. 이와 같은 HMDS 3C-SiC박막의 특성은 성장 온도가 낮고 박막 성장용 가스로 사용한 HMDS 선구체에서 탄소가 과잉으로 공급되기 때문으로 제안되었다.다.

• Journal of the Korean Ceramic Society
• /
• v.34 no.12
• /
• pp.1227-1234
• /
• 1997

ZnO thin films were prepared by rf-magnetron sputter at various conditions. Crystallinity, microstructure, chemical composition, and optical composition, and optical properties of the films were investigated as functions of substrate temperature (R. T.-50$0^{\circ}C$) an sputter gas (O2/Ar=0-50%). ZnO thin films grown at 50$0^{\circ}C$ with sputter gas of pure argon as well as at R. T. with sputter gas of a mixture of argon & oxygen(O2/Ar=2%) exhibit a strong tendency of (002) preferred orientation, compared with a considerable random orientation at the other conditions. The thin films with (002) preferred orientation has a chemical stoichiometry of Zn/O-1.01, a band gap of 3.3eV, and a packing density of 98% respectively.

• Proceedings of the KIEE Conference
• /
• 2003.07c
• /
• pp.1577-1579
• /
• 2003

AlN thin films are prepared on Si (111) substrate by RF magnetron sputtering. Two-step deposition method is proposed to obtain AlN thin films with high c-axis (002)-TC value and low surface roughnesses. For all the deposited AlN films, the c-axis (002)-orientation, surface mophology, and roughness are characterized in terms of deposition conditions FEAR devices with Al/AlN/Mo/Si(111) configuration are also fabricated. From the frequency response characteristics, the return loss and electromechanical coupling contant($k_t{^2}$) are estimated.

• Journal of the Korean Crystal Growth and Crystal Technology
• /
• v.25 no.2
• /
• pp.45-50
• /
• 2015

Compositionally graded AlGaN epilayer was grown by HVPE (hydride vapor phase epitaxy) on (0001) c-plane sapphire substrate. During the growth of graded AlGaN epilayer, the temperatures of source and the growth zone were set at $950^{\circ}C$ and $1145^{\circ}C$, respectively. The growth rate of graded AlGaN epilayer was about 100 nm/hour. The changing of Al contentes was investigated by field emission scanning electron microscope (FE-SEM) and energy dispersive spectroscopy (EDS). From the result of atomic force microscope (AFM), the average of roughness in 2 inch substrate of graded AlGaN epilayer was a few nanometers scale. X-ray diffraction (XRD) with the result that the AlGaN (002) peak ($Al_{0.74}Ga_{0.26}N$) and AlN (002) peak were appeared. It seems that the graded AlGaN epilayer was successfully grown by the HVPE method. From these results, we expect to use of the graded AlGaN epilayer grown by HVPE for the application of electron and optical devices.

• Journal of the Korean Chemical Society
• /
• v.42 no.6
• /
• pp.638-645
• /
• 1998

By using the spray pyrolysis method, zinc oxide(ZnO) was produced from zinc acetate, the surface morphology of the prepared films was investigated by using scanning electron microscopy. The thickness of ZnO thin film was increased up to 460$^{\circ}C$ and it was 833 nm. The maximum wavelength of absorption was obtained at 365 nm, and the maximum peak of fluorescence at 475 nm and 505 nm. ZnO film have been characterized by XPS, XRD, and SEM. XRD results show that all the films are preferred orientation along the (002) plane which is depend on the substrate temperature. The optimal temperature to produce ZnO was determined at around 460$^{\circ}C$ from measurements of XPS, XRD and photocurrent. It was also shown that the homogeneous particles had the higher photocurrent.

• Journal of Korean Society of Coastal and Ocean Engineers
• /
• v.8 no.2
• /
• pp.185-192
• /
• 1996

In order to simulate the coastal dispersion effectively, hybrid concept of operator split Eulerian-lagrangian concentration model and random-walk particle tracking model are developed. Especially the random-walk model is adequate for region with steep slope of concentration. According to model tests, it agrees perfectly with analytical solution on around the source point for therefore. ▽C $\geq$ 0.005, meanwhile it shows poor results for ▽C$\leq$0.002. trial modeling for real situation therefore, random-walk model is applied for near field henceforth Eulerian-Lagrangian concentration model is adoped for whole domain so that overall performance and accuracy can be achieved by using developed hybrid model.

• Journal of the Korean Society of Food Science and Nutrition
• /
• v.46 no.10
• /
• pp.1216-1224
• /
• 2017

Acetic acid bacteria strains were isolated from commercial natural vinegar. Ten isolated strains were identified using 16S rRNA gene sequencing data after evaluating the ethanol- and sulfur-tolerance. Eight of the strains isolated were identified as Acetobacter pasteurianus. A. pasteurianus JAC002, JAC005, and JAC008 strains, which showed a high ethanol tolerance, were selected for making "Makgeolli seed-vinegar". Rice wine vinegars were manufactured with the selected strains through fermentation, and their physicochemical properties and antimicrobial activities were evaluated. A. pasteurianus JAC002 strain showed the highest oxidation ability to acetic acid from ethanol on the twentieth day of fermentation, resulting in 4.21% total acidity, 3,791.77 mg% acetic acid content, and 2,931.78 mg% ethanol consumption content. Rice wine vinegar manufactured with the A. pasteurianus JAC002 strain showed increased antimicrobial activities against Staphylococcus aureus (KACC1927) and Escherichia coli (KACC10115). As a result, A. pasteurianus JAC002 strain was found to be the most suitable strain for "Makgeolli seed-vinegar".

• Journal of Society of Preventive Korean Medicine
• /
• v.15 no.3
• /
• pp.163-178
• /
• 2011

Objective : This study is conducted to evaluate the efficiency of ethanol extracts of 4 mixed herbs(CP001 or CP002) on mouse model of atopic dermatitis induced by ovalbumin. Methods : Female BALB/c mice were internally sensitized with ovalbumin($20{\mu}g$) plus aluminum hydroxide hydrate(4mg) once per week. After 3 weeks, they were dermally challenged with patches containing ovalbumin ($100{\mu}g$) plus aluminum hydroxide hydrate(20mg) every other day for 3 weeks. After induction of atopic dermatitis, mice back skin were gently rubbed with CP001 or CP002(200mg/$m{\ell}$, $100{\mu}{\ell}$) for two weeks(every 2 days). Results : In CP001 or CP002 treated group, there was a remarkable reduction in infiltration of eosinophils on the skin areas and diminution of mast cells and total T cells in blood samples as compared with control group. Cutaneous expressions of interleukin-13, 17 were also decreased by CP001 or CP002. Moreover, blood immunoglobulin E level was decreased by drug administration while there was no decrease in OVA sensitization group. Conclusion : In summary, our result shows that herbal extracts(CP001 and CP002) could be potential candidates for the treatment of chronic atopic dermatitis.