• 설비공학논문집
• /
• 제8권4호
• /
• pp.537-549
• /
• 1996

A numerical study of heat and mass transfer has been carried out for a frost formation process on a circular cylinder in a cross flow including the effect of buoyancy. Studies include cases of low and high Reynolds number flows. The effect of normal velocity at the surface which is produced due to mass transfer was included in the analysis as well as heat transfer contribution generated due to mass transfer. Variations of heat transfer and frost growth both in time and in the circumferential direction have been obtained for various buoyancy parameters. The effect of flow directions(identical or opposite directions to the gravity) has been studied to yield different frost growth. Our results have been compared with existing experimental data and are in good agreement. Buoyancy analyses for a high Reynolds number flow agree with full numerical solutions for the case of having the same flow direction as gravity. However, for the opposite direction case, the boundary layer analyses would not be applicable to predict frost growth except the region near the stagnation point.

• 한국연소학회:학술대회논문집
• /
• 한국연소학회 2015년도 제51회 KOSCO SYMPOSIUM 초록집
• /
• pp.83-86
• /
• 2015

The Laminar lifted methane jet flames diluted with helium and nitrogen in co-flow air have been investigated experimentally. The chemiluminescence intensities of $OH^{\ast}$ and $CH_2O^{\ast}$ radicals and the radius of curvature for tri-brachial flame were measured using an intensified charge coupled device (ICCD) camera, monochromator and digital video camera. The product of $OH^{\ast}$ and $CH_2O^{\ast}$ is used as a excellent proxy of heat release rate. These methane jet flames could be lifted in buoyancy and jet dominated regimes despite the Schmidt number less than unity. Lifted flames were stabilized due to buoyancy induced convection in buoyancy-dominated regime. It was confirmed that increased $OH^{\ast}$ and $CH_2O^{\ast}$ concentration caused an increase of edge flame speed via enhanced chemical reaction in buoyancy dominated regime. In jet momentum dominated regime lifted flames were observed even for nozzle exit velocities much higher than stoichiometric laminar flame speed. An increase in radius of curvature in addition to the increased $OH^{\ast}$ and $CH_2O^{\ast}$ concentration stabilizes such lifted flames.

• 디지털산업정보학회논문지
• /
• 제14권4호
• /
• pp.1-7
• /
• 2018

The floating sculptures in the form of ad-ballon commonly used ropes in order to hold on. Relatively air flow is much less indoor than outdoor. Users of buoyancy sculptures hope to be able to maintain their desired posture without being fixed. This study applied drone technology to buoyancy sculptures. The drones can be moved vertically and horizontally, and the posture can be maintained, so buoyancy sculptures are easy to apply. Therefore, we have studied the control system of buoyancy sculpture using drone technology. Also, a control system that can maintain the desired posture at a constant height was studied. The overall shape was a light fiber material and helium gas for zero buoyancy to support the sculpture. The system configuration was STM32F103CB from ARM. In addition, the gyro and acceleration, geomagnetic sensors and motors are composed of small and medium size BLDC motors. The scheduling of the control system in the configuration of the control device was carefully considered. Because the role of the whole component becomes very important. The communication between the components is divided into the sensor fusion and the interface communication with the whole controller. Each communication technology is designed to expand. This study was implemented to actively respond from the viewpoint of posture control using the drone technology.

• 대한기계학회논문집
• /
• 제14권3호
• /
• pp.725-733
• /
• 1990

본 연구에서는 Raju등의 연구의 확장으로 일정한 온도로 유지되는 경사진 평 판에 대하여 혼합대류 전 영역에 유효한 부력계수(.xi.)로서 (1+Gr$^{2}$$_{x}$cos.gamma./ Re$^{4}$$_{x}$)$_{-1}$를 적용하여 비상사 경계층 방정식을 유도하였다. 또한 적분 형 경계조건을 가진 편미분 경계층방정식을 유한차분법으로 Keller와 Cebeci의 Box scheme을 6차로 적용하여 수치해석하였다. 부력계수가 큰 영역에서 Mucoglu등의 해 석적 연구결과는 일정한 온도와 45˚의 경사를 유지하는 평판에 대한 Ramachandran의 실험적 연구결과와 약 10%정도 벗어난다. 이에 Ramachandran의 실험적 연구를 해석 적으로 재고찰하였다.하였다.

• 한국연소학회:학술대회논문집
• /
• 한국연소학회 2015년도 제51회 KOSCO SYMPOSIUM 초록집
• /
• pp.291-293
• /
• 2015

The experimental study on flow characteristic in various laminar coflow diffusion flame has been conducted with a particular focus on the buoyancy force exerted from gaseous hydrocarbon fuels. Methane ($CH_4$), Ethylene ($C_2H_4$) and n-Butane ($C_4H_{10}$) were used as fuels. Coflow burner and Schlieren technique were used to observe the fuel flow field near nozzle exit and flow characteristics in flames. The result showed that the vortices in n-Butane with density heavier than air were appeared near the nozzle exit with the strong negative buoyancy on the fuel stream. As Reynolds number increases by the control of velocity, the vortices were greater and the vortices tips were moved up from the nozzle exit. In addition, it can be found that the heated nozzle can affect to the flow fields of fuel stream near the nozzle exit.

• Nuclear Engineering and Technology
• /
• 제39권4호
• /
• pp.327-336
• /
• 2007

The influence of density differences on the mixing of the primary loop inventory and the Emergency Core Cooling (ECC) water in the downcomer of a Pressurised Water Reactor (PWR) was analyzed at the ROssendorf COolant Mixing (ROCOM) test facility. ROCOM is a 1:5 scaled model of a German PWR, and has been designed for coolant mixing studies. It is equipped with advanced instrumentation, which delivers high-resolution information for temperature or boron concentration fields. This paper presents a ROCOM experiment in which water with higher density was injected into a cold leg of the reactor model. Wire-mesh sensors measuring the tracer concentration were installed in the cold leg and upper and lower part of the downcomer. The experiment was run with 5% of the design flow rate in one loop and 10% density difference between the ECC and loop water especially for the validation of the Computational Fluid Dynamics (CFD) software ANSYS CFX. A mesh with two million control volumes was used for the calculations. The effects of turbulence on the mean flow were modelled with a Reynolds stress turbulence model. The results of the experiment and of the numerical calculations show that mixing is dominated by buoyancy effects: At higher mass flow rates (close to nominal conditions) the injected slug propagates in the circumferential direction around the core barrel. Buoyancy effects reduce this circumferential propagation. Therefore, density effects play an important role during natural convection with ECC injection in PWRs. ANSYS CFX was able to predict the observed flow patterns and mixing phenomena quite well.

• International Journal of Ocean Engineering and Technology Speciallssue:Selected Papers
• /
• 제6권1호
• /
• pp.15-21
• /
• 2003

A common feature in the three-dimensional numerical model experiments of coastal discharge with simplified model and idealized external forcings is investigated. The velocity fields due to the buoyancy and flaw flux, are spreaded radiately and the surface velocites are much greater than the homegeneous discharges. The coastal dischargd due to the Coriolis force and flaw flux are shaped a anticyclical gyre (clockwise) and determined the scale of the gyre in the coastal zone, respectively. The bottom topography restricts a outward extention of the coastal fronts and it accelerates a southward flow.

• 대한기계학회논문집
• /
• 제13권6호
• /
• pp.1321-1329
• /
• 1989

본 논문에서는 성층화된 용액ㅇ네 수평방향으로 온도구배가 가해지는 경우에 있어서 두 부력인자의 상대적 크기에 따라 나타나는 유동형태와 그에 따른 온도, 농도 분포 및 열전달특성을 수치적으로 연구하고자 한다.

• Nuclear Engineering and Technology
• /
• 제54권3호
• /
• pp.867-876
• /
• 2022

An experimental study has been conducted to investigate the heat transfer characteristics of supercritical carbon dioxide (sCO₂) uniformly heated in the horizontal circular smooth tube. The results illustrated that there was a significant difference in heat transfer between the top wall and bottom wall due to the buoyancy. Bulk flow acceleration cannot be negligible in the high heat flux region, which leads to heat transfer deterioration. A new heat transfer correlation is proposed, in which the buoyancy parameter and bulk flow acceleration have been taken into account. The new correlation and six classic correlations for sCO₂ are examined in horizontal tubes. The comparison indicates that the new correlation has a better performance for sCO₂ flowing through a horizontal heating tube under natural circulation conditions. For example, 94.9% of the calculated results using the new heat transfer correlation were within ±30% of the experimental results while only 87.9% of that using the Jackson correlation (the best of the six) were within the same error bands.

• Nuclear Engineering and Technology
• /
• 제15권1호
• /
• pp.50-56
• /
• 1983

Scram이 일어난 후 과도 기간 동안 LMFBR 출구공간에 있어서의 유동성층의 영향은 특별한 문제로 제기되고 있다. 이러한 경우에 난류 혼합에 미치는 부력 효과는 설계자에게 중요하다. 난류 유동 방정식에 부력 효과를 갖지 않는 기존 난류 모형의 부력효과를 더하기 위한 연구가 행해졌다. 개발된 부력 난류 유동의 물리적 모형은 SMAC 수치 해석 방법을 통하여 풀어졌다. 개발된 수치 해석 모형이 시험되어졌고, 실험자료와도 비교되었다. 결과는 난류에 대한 부력 효과가 출구공간에서 난류를 강하게 억압하며 성층의 안정도를 상당히 증가시켰다.