• Korean Journal of Materials Research
• /
• v.17 no.1
• /
• pp.1-5
• /
• 2007

GaN thin fan were grown by spin coated colloidal GaOOH precursor. Polycrystalline GaNs with crystalline size of $10{\sim}100nm$ were grown on $SiO_2$ substrate. The shape of crystallite above $900^{\circ}C$ had the hexagonal plate and column type. X-ray diffraction patterns for them correspond to those of the hexagonal wurtzite GaN. With increasing droplets. i.e, thickness of deposited layers, XRD intensity increased. PL (photoluminescence) spectrum consisted with an weak near band-edge emission at 3.45 eV and a broad donor-acceptor emission band at 3.32 eV. From the low temperature PL measurement on GaN grown at $800^{\circ}C$ that the shallow donor-acceptor recombination induced emission was more intense than the near band-edge excitonic emission.

• Proceedings of the Korea Electromagnetic Engineering Society Conference
• /
• 2001.11a
• /
• pp.257-261
• /
• 2001

This paper presents the implementation of wide-band RFIC amplifier operating from near 50MHz to 3GHz using Tachyonics SiGe HBT foundry. Voltage shunt feedback is used for the flat gain and the broad band impedance matching. Initial design parameters are calculated using the low frequency small signal analysis. Since the HBT model was not available at the design time, discrete tuning board was made for fine tuning in the low frequency range. Fabricated amplifier shows 12dB gain with 1dB fluctuation and PldB reaches 15dBm at 850MHz.

• Water for future
• /
• v.10 no.1
• /
• pp.101-117
• /
• 1977

The statatistical characteristics and spectra of sea waves at Mookho were analysed by several statistical methods. As the results, the following conclusions are obtained: 1. Values of surface elevation of sea wave are better fitted to Gram Charlier distribution than Gaussian distribution. This proves that sea waves have not only characters of irregularity but also non-linearity. 2. Distribution of maxima of surface elevation practically follows the distribution of Cartwright and Longuet-Higgins, also spectral width parameter is found to be increased with the increase of root mean square of surface elevation. 3. Sea wave may have spectrum of broad frequency band, however distributions of wave heights and periods follow the Rayleigh distribution which is derived from the assumption of narrow frequency band. 4. Ratios among mean wave heights from observed data show good agreements with theoretical values from Rayleigh distribution. 5. Spectral density and spectral width parameter increase with increase of wind velocity. And wave period at optimum band gas higher value than significant wave period by about 10 percent.

• Proceedings of the International Microelectronics And Packaging Society Conference
• /
• 2002.11a
• /
• pp.87-90
• /
• 2002

For the broad band wireless communications system, the composition of the millimeter wave system is needed. In other to commercialize that system, satisfaction of high frequency characteristic and low cost process is required. In this study, BPF which is very sensitive to the characteristic of fine line designed and fabricated using photoimageable thick film technology.

• The Bulletin of The Korean Astronomical Society
• /
• v.46 no.2
• /
• pp.80.2-80.2
• /
• 2021

Galactic young massive clusters are the ideal laboratories to study massive stellar evolution. Unfortunately, such objects are rare. Of particular interest are so-called Red Supergiant Clusters (RSGCs) that are currently only found toward the Scutum-Crux Galactic arm. Confirming their nature as RSGC is often not straight-fortward as distinguishing RSGs from AGB stars is still difficult even with high spectral resolution spectra. Here we report that broad band colors using 2MASS JHK and GAIA G band data can be useful in reducing the AGB contamination, thus providing selection criteria that effectively reveal the known RSGCs with negligible false positives. On the other hand, we suggest that RSGC4, one of the proposed RSGC candidates, may not be a cluster of RSGs as their colors are not compatible with our selection criteria. We discuss the nature of these stars together with our IGRINS spectroscopic observations. We also employ the same selection criteria to search for RSGC candidates in other parts of the plane, resulting in no prominent candidates.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.40 no.11
• /
• pp.93-98
• /
• 2003

In this paper, we designed a printed square loop antenna for operating of PCS and IMT2000 band. The proposed antenna has omni-directional radiation patterns with broad bandwidth, similar to the conventional antenna, to easy feed on composing single planar. We obtain an ideal impedance matching and increase bandwidth. An antenna bandwidth is about 150MHz(1.74∼l.89〔GHz〕) at 1$^{st}$ resonance frequency and 290MHz(1.95∼2.24GHz) at 2$^{nd}$ resonance frequency on VSWR(equation omitted)1.5, and then we can obtain not only 1.73∼l.87 〔GHz〕 PCS band but also 1.92∼2.17 (GHz) IMT2000 band. band.

• Journal of electromagnetic engineering and science
• /
• v.13 no.2
• /
• pp.93-103
• /
• 2013

This paper presented a novel approach for the design of a tunable dual-band bandpass filter (BPF) with independently tunable passband center frequencies and bandwidths. The newly proposed dual-band filter principally comprised two dual-mode single band filters using common input/output lines. Each single BPF was realized using a varactor-loaded transmission line resonator. To suppress the harmonics over a broad bandwidth, a defected ground structure was used at the input/output feeding lines. From the experimental results, it was found that the proposed filter exhibited the first passband center frequency tunable range from 1.48 to 1.8 GHz with a 3-dB fractional bandwidth (FBW) variation from 5.76% to 8.55%, while the second passband center's frequency tunable range was 2.40 to 2.88 GHz with a 3-dB FBW variation from 8.28% to 12.42%. The measured results of the proposed filters showed a rejection level of 19 dB up to more than 10 times the highest center frequency of the first passband.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.36 no.5A
• /
• pp.432-440
• /
• 2011

For the 4th generation mobile communication, LTE-advanced system needs the broad frequency band up to 100MHz for providing the data rate of maximum 1Gpbs. However, it is very difficult to secure the broad frequency band in the current frequency allocation situation. So, carrier aggregation was proposed as the solution, in which several fragmented frequency bands are used at the same time. Basically, multiple parallel receivers are required to get the information data from the different frequency bands but this conventional multi-chain receiver system is very inefficient. Therefore, in this paper, we like to study the single chain system that is able to receive the multi-band signals in a single receiver based on the time division multiplexing (TDM) reception method. This proposed TDM receiver efficiently manage to receive the multi-band signals in time domain and handle the baseband signals with one DSP board. However, the serious distortion could be generated by the sampling timing offset (STO) in the TDM-based system. Therefore, we like to analyze STO effects in the TDM-based system and propose a compensation method using estimated STO. Finally, it is shown by simulation that the proposed method is appropriate for the single chain receiver and show good compensation performance.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.18 no.10
• /
• pp.1107-1116
• /
• 2007

In this paper, a broadband open stubs band pass filters which can suppress the second harmonics using Z-transform technique, is designed, fabricated and characterized. The proposed broadband filters integrate the band stop filter with the FSCS structure and ${\lambda}_g/4$ open stub in order to suppress the second harmonics. Due to insertion of BSF at input and output terminal, the size of the filter was increased in the conventional filter, however, in the proposed structure, the position of inverter that connects the stubs can be integrated between those stubs, thereby decreasing the size. So, it can be fabricated in the size of $18.7{\times}16.9mm^2$ which is smaller size than conventional one. The measured results of the proposed filters have center frequency of a 5.8 GHz with bandwidth of 95 %, insertion loss of 0.6 dB, return loss of 14 dB. The simulation results are consistent with measurement results. The filter is designed far X-band satellite communication and ITS applications.

• Journal of the Microelectronics and Packaging Society
• /
• v.11 no.2 s.31
• /
• pp.43-47
• /
• 2004

A coupler or divider is a microwave passive component used for power coupling or dividing. Regarding the trend of current telecommunication systems monolithic integration of passive components is highly desirable. In this study by the LTCC(Low temperature co-fired ceramics) technology a 2012 size type dual band coupler with multi-layer structure was fabricated. To achieve the desired coupling values for both DCS and EGSM bands, broad side coupled patterns were used with multi-layer structure. Its characteristics such as coupling, insertion loss, isolation and directivity values were measured and compared with simulation results.