• Journal of Korean Academy of Nursing
• /
• v.25 no.3
• /
• pp.441-456
• /
• 1995

This study was done to determine direct and in-direct nursing time in nursing units in hospital to ap-plied computer system and expect that those results contribute to measure efficiency of nursing practice and planning of nursing manpower. The design for study was a descriptive study. The study results are as follows. 1. Patients admitted to the Internal Medicine and General Surgery units were grouped into four. Group Ⅰ, 32.9% of the total patients, consisted patients whose condition was considered minor Group Ⅱ, 26.1%, was of those whose condition was considered moderate, Group Ⅲ, 41. 8%, moderate severe and Group Ⅳ, 29.2% the most severe. 2. Nursing intervention times by care type were as follows four minutes spent for suction eight minutes, for simple position change, ten minutes, for sheet change, seven minutes for a hot or cool compress, six minutes for dressing change, four minutes for Ⅰ.M. injection, six minutes for patient health education and five minutes for body temperature check. 3. Direct care time by patient group revealed the following : Group Ⅰ rquired 191.4 minutes, Group Ⅱ required 331.1 minutes, Group Ⅲ rquired 499.4 minutes, and Group Ⅳ rquired 1328.0 minutes. 4. The ratio of time for adequate nursing care and direct care time in the Internal Medicine and Goneral Surgery units was 67.4%-83.4% and 94.7%-99.3% in the Intensie Care Unit. 5. Average daily direct care time per patient was 5.5 hours in the Internal Medicine unit and 11.5 hours in the Intensive Care Unit. 6. Time spent in indirect care was 48.3 minutes for computer recording,34.8 minutes for giving and receiving patient information for shift duty, 28.0 minutes for eating and resting time, 26.6 minutes for transfering and identifying patients, 25.6 minutes for identifying Doctor's order, 23.9 minutes for recording vital signs. 7. Time spent in indirect care was 282.2 minutes by head nurses (charge nurses), 258.7 minutes by nurses and 261.6 minutes by nurse aids. 8. The average nurse's workload was 9.3 hours and daily indirect nursing time required 46.3%-50. 5% of above mentioned workload time. .9. The average daily indirect care time per patient was expected to be 57.7 minutes in the Internal Medicine unit and 3.3 hours in the Intensive Care Unit.

• Journal of Digital Convergence
• /
• v.11 no.10
• /
• pp.577-584
• /
• 2013

IGRT(Image Guided Radiation Therapy) in radiation therapy is a very useful technique in order to increase setup of patient and position reproducibility. Tomotherapy can increase accuracy of setup to take IGRT by MVCT, but it be for verified accuracy of Image guided, and MVCT occurs the exposure of patient. Through this study, IGRT accuracy of Tomotherapy is very accurate within 1.0mm. When MVCT using Tomotherapy phantom for QA, QC be taken, exposure dose is Fine(2mm Slice thickness) 3cGy, Normal(4mm Slice thickness) 1.5cGy, Corse(6mmSlice thickness) 1.0cGy. Measurement value of spatial resolution using AAPM CT performance phantom did't cause a big difference. As a result, ability of IGRT in Tomotherapy is very accurate. While obtaining image for IGRT, we should minimize expose range because patient's be exposed to radiation. We should make an effort to do accurate radiation therapy to minimize exposure of patient by selecting the appropriate thickness of MVCT depending on patient's body and treat area.

• Journal of the Institute of Electronics Engineers of Korea SC
• /
• v.48 no.4
• /
• pp.94-101
• /
• 2011

Various kinds of medical imaging devices have been studied to develop periapical radiography. However, there are some problems such as high x-ray exposure rate and pains for patients because of the problems caused by intra-oral sensor based radiography system. In this study, a new concept of periapical radiography, intra oral X-ray tube and detector system, is introduced to solve these problems. This system is made up of miniature X-ray tube based on subminiature thermal electron or cold electron, CMOS based detector, and a body including automatic position and system control devices. In order to confirm the possibility of proposed new concept to periapical radiography, miniature x-ray tube from XOFT corporation is used to develop new x-ray system, and the performance evaluation of this system is performed according to collimator. Also, dental images are compared after acquiring both images from existing system versus new concept of system. As a result, new concept of system showed excellent image. Thus, it is considered that new concept of system will have a significant effect on medical imaging technology.

• Archives of design research
• /
• v.19 no.2 s.64
• /
• pp.129-138
• /
• 2006

Design securing a dominant position currently in the global market has shown inherent culture of each country, i.d. national disposition. For instancess, there are Scandinavia emphasizing humanism, America adopting pragmatism, Germany reflecting the rational principle, Spain reflecting the daily an, Italian design being rationalism and impressionism. The members of society shall be under the control of the already formed social-cultural value and character. So culture shall restrict the internal manner of social behaviour and apply pressure to the action of main body. Also culture shall be under the control of social environment and each culture shall be materialized as per the disposition of the members of society. Now korean design has been attracted lots of interests and attention from global market because it is excellent in the aspect of application capability for new technology and also suggests the image of design produced through them. Now Korean design shall run side by side the application for formative element to be recognized by technical design as well as korean identity. So dear definition for national and cultural disposition shall be required to korean design education and design development. These prescribed efforts shall be a shortcut for globalization of korean design.

• Journal of Animal Science and Technology
• /
• v.47 no.1
• /
• pp.1-10
• /
• 2005

Intramuscular fat content(lMF) is considered as one of major economic traits in the pig breeding and industry. In general, high IMF results in better meat quality. Several approaches to detect quantitative trait 10ci( QTL) for IMF indicated a strong possibility of the existence of a QTL related to IMF between the microsatellite marker SW71 and SW1881 on SSC6q. Porcine FABP3 has been considered as a candidate gene affecting IMF due to its physiological roles and position on the pig genome. Two novel mutations, g.-114T> C and g.-158T>G were detected by duplicate sequencing of the porcine FABP3 promoter region. These two mutations were identified as absolute linkage disequilibrium. The g.-158T> G mutation was used for investigating relationships with growth and fat deposition traits. The GG genotype of the g.-158T> G polymorphism showed highly negative effects(P< 0.01) on body weights at 3 and 12 weeks of age, and a positive effect(P< 0.05) on IMF. However, backfat thickness(BF) and carcass fat(CF) content were not significantly associated with the genotype. The result indicates that the novel mutations, identified in this study, could be utilized as possible genetic markers to improve IMF, independent with BF.

• Journal of the Korea Institute of Information Security & Cryptology
• /
• v.27 no.6
• /
• pp.1405-1417
• /
• 2017

Researches that apply the acceleration signal due to user's gait measured at the wearable device to the authentication technology are being introduced recently. The gait acceleration signal based authentication technologies introduced so far have assumed that an attacker can obtain a user's gait acceleration signal only by attaching accelerometer directly to user's body. And the practical attack method for gait acceleration signal based authentication technology is mimic attack and it uses a person whose physical condition is similar to the victim or identifies the gait characteristics through the video of the gait of the victim. However, mimic attack is not effective and attack success rate is also very low, so it is not considered a serious threat. In this paper, we propose Video Gait attack as a new attack method for gait acceleration signal based authentication technology. It is possible to know the position of the wearable device from the user's gait video signal and generate a signal that is very similar to the accelerometer's signal using dynamic equation. We compare the user's gait acceleration signal and the signal that is calculated from video of user's gait and dynamic equation with experiment data collected from eight subjects.

• Archives of Plastic Surgery
• /
• v.34 no.2
• /
• pp.209-216
• /
• 2007

Purpose: The ischial area is by far the most common site of pressure sores found in wheel chair bound paraplegic patients, because greatest pressure is exerted from the body on this area in a sitting position. Even after a series of successful pressure sore treatments, the site is very prone to relapse by the simplest ordinary tasks of everyday life. Therefore, it is crucial to preserve the main pedicle during primary surgery. Various surgical procedures employed to treat pressure sores such as myocutaneous flap and perforator flap have been introduced. After introduction of ischial sore treatment using the inferior gluteal artery perforator (IGAP) has been made, the authors experienced favorable clinical results of patients who have undergone IGAP flap procedure in a three year time period. Methods: A total of 17 patients received IGAP flap surgery in our hospital from January 2003 to May 2006, among which 14 of them being males and 3 females. Surgery was performed on the same site again in 6(35%) patients who had originally relapsed after receiving the conventional method of pressure sore surgery. Patients' average age was 49.4(27-71) years old. Most of the patients were paraplegic(11 cases, 65%) and others were either quadriplegic(4 cases, 23%) or ambulatory(2 cases, 12%). Based on hospital records and clinical photographs, we have attempted to assess the feasibility and practicability of the IGAP flap procedure through comparative analysis of several parameters: size of defective area, treatment modalities, occurrence of relapses, complications, and postoperative treatments. Results: The average follow-up duration of 17 subjects was 25.4 months(5-42 months). All flaps survived without any necrosis. Six cases were relapsed cases from conventional surgical procedures. All of them healed well during our follow-up study. Postoperative complications such as wound dehiscence and fistula developed in some subjects, but all were well healed through secondary treatment. A total of 2 cases relapsed after surgery. Conclusion: The inferior gluteal artery perforator flap is an effective method that can be primarily applied in replacement to the conventional ischial pressure sore reconstructive surgery owing to its many advantages: ability to preserve peripheral muscle tissue, numerous possible flap designs, relatively good durability, and the low donor site morbidity rate.

• Journal of dental hygiene science
• /
• v.9 no.5
• /
• pp.531-538
• /
• 2009

This study examined the musculoskeletal symptom experience rate of some dental clinic workers and the factors influencing musculoskeletal symptoms according to their working environment and health habit. To that end, between March 9 and March 28, 2009, 200 workers at dental clinics in Chungcheong-do were surveyed using the self-administered questionnaire method. The data were analyzed using the SPSS WIN 12.0 program. The following conclusion was reached. 1. One-year musculoskeletal symptom experience rates of the subjects were categorized according to pans of the body: shoulders - 60.5%, lower limbs (legs, knees, and feet) - 57.0%, the lumbar region (back and waist) - 56.0%, the neck - 51.0% and the upper limbs (arms, wrists, and fingers) - 32.0%. 2. In general characteristics, a statistically significant difference was found according to gender, age, education, position, and oral health state. In working environments, a statistically significant difference was found according to work experience, the average daily number of patients handled, the average daily working hours, the posture for diagnosis, and satisfaction over work. In health habit, a statistically significant difference was found according to regular exercise, regular examination, and regular eating habit. 3. Factors influencing musculoskeletal symptoms were examined. As a result, influencing the musculoskeletal symptom experience were satisfaction over work among working environment characteristics, and regular exercise among health habit characteristics.

• Journal of Ocean Engineering and Technology
• /
• v.33 no.2
• /
• pp.168-177
• /
• 2019

KRISO (Korea Research Institute of Ship & Ocean Engineering) started a project to develop the core algorithms for autonomous intervention using an underwater robot in 2017. This paper introduces the development of the robot platform for the core algorithms, which is an ROV (Remotely Operated Vehicle) type with one 7-function manipulator. Before the detailed design of the robot platform, the 7E-MINI arm of the ECA Group was selected as the manipulator. It is an electrical type, with a weight of 51 kg in air (30 kg in water) and a full reach of 1.4 m. To design a platform with a small size and light weight to fit in a water tank, the medium-size manipulator was placed on the center of platform, and the structural analysis of the body frame was conducted by ABAQUS. The robot had an IMU (Inertial Measurement Unit), a DVL (Doppler Velocity Log), and a depth sensor for measuring the underwater position and attitude. To control the robot motion, eight thrusters were installed, four for vertical and the rest for horizontal motion. The operation system was composed of an on-board control station and operation S/W. The former included devices such as a 300 VDC power supplier, Fiber-Optic (F/O) to Ethernet communication converter, and main control PC. The latter was developed using an ROS (Robot Operation System) based on Linux. The basic performance of the manufactured robot platform was verified through a water tank test, where the robot was manually operated using a joystick, and the robot motion and attitude variation that resulted from the manipulator movement were closely observed.

• Korean Journal of Heritage: History & Science
• /
• v.43 no.3
• /
• pp.102-121
• /
• 2010

Three bronze bells excavated from the Hoeamsa temple site were investigated for their microstructures and chemical compositions in an effort to understand the technology applied in fabrication, which may represent the related industry established in the early Joseon period. The result shows that the bells were cast from alloys of approximately 85% copper-8% tin-7% lead. The chemical analysis for ten trace elements shows that they were all kept below 0.3 weight %, suggesting that the alloys were made of relatively well-refined copper, tin and lead. The presence of sulfur and iron indicates that chalcopyrite or chalcocite may have been used in the smelting of copper. Evidence has been found that the bells were cast by pouring the liquid metal from the top of the sand molds that were set up in an upright position. No additional treatments, thermal or mechanical, other than a little grinding were applied upon the completion of casting. After the shaping process, a balancing plate was attached to the top of the bell using a steel connection ring. The connection assembly was then fixed to the main body by using molten bronze as a solder. The surface inscription was found carved using different techniques. The differences in the order of strokes and the calligraphic style indicate that the carving was carried out by more than one master. In the absence of documentary evidence on past bronze technology, the present bronze bells with known chronology, provenance and the main agent of production, prove to be a rare and valuable archaeological material for the understanding of the related technology in use in the early Joseon period.