• Journal of the Korean Geotechnical Society
• /
• v.15 no.2
• /
• pp.165-180
• /
• 1999

Static load tests were performed for open-ended piles, closed-ended piles, piles with grouted toe, and base-grouted piles by using calibration chamber. Then vertical bearing capacities determined from load tests were compared with each other. The stability of base-grouted pile during a simulated seaquake was investigated by changing the penetration depth. Also, static load tests and seaquake tests for 2-piles and 4-piles group were performed. The bearing capacity of the pile grouted inside the toe was 11.2~30.8% less than that of open-ended pile because of reduction of base resistance due to disturbance of base soil under pile toe. The bearing capacity of a base-grouted pile was 23.8~33.9% more than that of an open-ended pile and was similar to that of a closed-ended pile. The bearing capacity of base-grouted group pile was increased ; the bearing capacity of base-grouted 2-piles group increased 14.6~31.8% compared to that of open-ended 2-piles group, and that of base-grouted 4-piles group increased 15.3~22.4% compared to that of open-ended 4-piles group. During the simulated seaquake in deep sea, stability of base-grouted pile was found to be dependent on the pile penetration depth. During seaquake motion, single long base-grouted pile longer than 20m was stable and short base-grouted pile shorter than 12m failed. But relatively long base-grouted pile longer than 12m kept mobility state. Bearing capacity of base-grouted group pile with penetration depth less than 7m was degraded a little bit ; so, base-grouted group pile could maintain mobility condition.

• Progress in Medical Physics
• /
• v.5 no.2
• /
• pp.57-68
• /
• 1994

Purpose : The purposes are to discuss the reason to measure dose distributions of circular small fields for stereotactic radiosurgery based on medical linear accelerator, finding of beam axis, and considering points on dosimetry using home-made small water phantom, and to report dosimetric results of 10MV X-ray of Clinac-18, like as TMR, OAR and field size factor required for treatment planning. Method and material : Dose-response linearity and dose-rate dependence of a p-type silicon (Si) diode, of which size and sensitivity are proper for small field dosimetry, are determined by means of measurement. Two water tanks being same in shape and size, with internal dimension, 30${\times}$30${\times}$30cm$^3$ were home-made with acrylic plates and connected by a hose. One of them a used as a water phantom and the other as a device to control depth of the Si detector in the phantom. Two orthogonal dose profiles at a specified depth were used to determine beam axis. TMR's of 4 circular cones, 10, 20, 30 and 40mm at 100cm SAD were measured, and OAR's of them were measured at 4 depths, d$\sub$max/, 6, 10, 15cm at 100cm SCD. Field size factor (FSF) defined by the ratio of D$\sub$max/ of a given cone at SAD to MU were also measured. Result : The dose-response linearity of the Si detector was almost perfect. Its sensitivity decreased with increasing dose rate but stable for high dose rate like as 100MU/min and higher even though dose out of field could be a little bit overestimated because of low dose rate. Method determining beam axis by two orthogonal profiles was simple and gave 0.05mm accuracy. Adjustment of depth of the detector in a water phantom by insertion and remove of some acryl pates under an auxiliary water tank was also simple and accurate. TMR, OAR and FSF measured by Si detector were sufficiently accurate for application to treatment planning of linac-based stereotactic radiosurgery. OAR in field was nearly independent of depth. Conclusion : The Si detector was appropriate for dosimetry of small circular fields for linac-based stereotactic radiosurgery. The beam axis could be determined by two orthogonal dose profiles. The adjustment of depth of the detector in water was possible by addition or removal of some acryl plates under the auxiliary water tank and simple. TMR, OAR and FSF were accurate enough to apply to stereotactic radiosurgery planning. OAR data at one depth are sufficient for radiosurgery planning.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.8 no.3
• /
• pp.221-231
• /
• 1997

This paper presents an analysis of a hybrid direct-sequence/slow frequency hopped code division multiple access(DS/SFH-CDMA) system employing noncoherent M-ary frequency shift keying(MFSK) modulation in a multiple m-distribution fading environment. Multipath interfer- ence(MPI) and multiuser interference(MUI) is taken into accout and the spectral efficiency is calculated for uncoded as well as simple channel coding systems. The predetection multipath CCI canceller in conjunction with convolution coding is employed for improving the bit error rate(BER) performance. The BER of noncoherent hybrid system is obtained using a Gaussian interference approximation. From the results, we know that the error performance more deteriorates as the depth of fading becomes deeper. The DS part of the modulation combats the multipath interference, whereas the FH part is a predetection against large multiuser interference. It is shown that, for the con- sidered types of a channel coding, the use of a predetection coding is still essential for obtained a satisfactory bit error performance. The results show that the capacity of the DS/SFG-CDMA MFSK communication system increases in proportion to the length of PN code sequence in the presence of AWGN and MUI. In m-distribution fading environment the capacity increases in proportion to the fading index. The capacity is increased and error performance is improved when the CCI Canceller and Convolution code technique are adopted, respectively. From the results, it is known that the error performance of $4\times10^{-2}$ by adopting Canceller technique. Also convolutional coding technique is the improvement of error performance attains about $10^{-5}$ in code rate 1/2.

• Journal of the Korean Society for Nondestructive Testing
• /
• v.25 no.1
• /
• pp.15-19
• /
• 2005

Conventional eddy current testing has been used for the detection of the defect-like fatigue crack in the conductive materials, such as aluminum, which uses a sinusoidal signal with very narrow frequency bandwidth, Whereas, the pulsed eddy current method uses a pulse signal with a broad bandwidth. This can allow multi-frequency eddy current testing, and the penetration depth is greater than that of the conventional eddy current testing. In this work, a pulsed eddy current instrument was developed for evaluating the metal loss. The developed instrument was composed of the pulse generator generating the maximum square pulse voltage of 40V, an amplifier controlled up to 52dB, an A/D converter of 16 bit and the sampling frequency of 20 MHz, and an industrial personal computer operated by the Windows program. A pulsed eddy current probe was designed as a pancake type in which the sensing roil was located inside the driving roil. The output signals of the sensing roil increased rapidly wich the step pulse driving voltage かn off, and the latter part of the sensing coil output voltage decreased exponentially with time. The decrement value of the output signals increased as the thickness of the aluminum test piece increased.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.48 no.1
• /
• pp.16-24
• /
• 2011

The sound speed of seawater can be calculated by the empirical formula as a function of temperature, salinity and pressure. It is little affected by salinity because the average salinity is 34 psu and varies within a few psu seasonally and spatially in the ocean. Recently, low-salinity water of 24 psu flows into the western sea area of Jeju Island due to the flood of the Yangtze River in China during summer, affecting sound speed profile. In this paper, it was analyzed how environmental changes affected to the underwater communication - the sound speed of low-salinity water was calculated, and the communication channel was estimated by the simulated acoustic rays while the transmitting and receiving depth and the range were varied with and without the low-salinity layer. And The BER (Bit error rate) was calculated by BPSK(Binary phase shift key) modulation and the effects of the low-salinity water on the BER was investigated. The sound speed profile was changed to have positive slope by the low-salinity layer at the sub-surface up to 20 m of depth, forming acoustic wave propagation channel at the sub-surface resulting in the decrease of most of the BER Consequently, this paper suggests that it is important to consider changes of the ocean environment for correctly analyzing the underwater communication and the detection capability.

• The Journal of the Acoustical Society of Korea
• /
• v.32 no.2
• /
• pp.95-103
• /
• 2013

An underwater acoustic (UWA) communication in shallow water is strongly affected by the water surface and the seabed acoustical properties. Every reflected signal to receiver experiences a time-variant scattering in sea surface roughness and a grazing-angle-dependent reflection loss in bottom. Consequently, the performance of UWA communication systems is degraded, and high-speed digital communication is disrupted. If there is a dominant signal path such as a direct path, the received signal is modeled statistically as Rice fading but if not, it is modeled as Rayleigh fading. However, it has been known to be very difficult to reproduce the statistical estimation by real experimental evaluation in the sea. To give an insight for this scattering and grazing-angle-dependent bottom reflection loss effect in UWA communication, authors conduct experiments to quantify these effects. The image is transmitted using binary frequency shift keying (BFSK) modulation. The quality of the received image is shown to be affected by water surface scattering and grazing-angle-dependent bottom reflection loss. The analysis is based on the transmitter to receiver range and the receiver depth dependent image quality and bit error rate (BER). The results show that the received image quality is highly dependent on the transmitter-receiver range and receiver depth which characterizes the channel coherence bandwidth.

• Journal of Sericultural and Entomological Science
• /
• v.52 no.2
• /
• pp.117-122
• /
• 2014

On previous studies, we constructed a transgenic silkworm which produces the chimeric silk fused green fluorescent protein (EGFP), but the transgenic silkworm has decreased commercial feasible traits such as convenience of breeding and productivity of silk. In this study, we performed cross fertilization between green fluorescent silk transgenic silkworm and colored cocoon silkworm descents to make the transgenic the transgenic silkworm producing improved fluorescence cocoon. In the result, we found out a bit valuable cross fertilization manners ($female{\times}male$) in respect of silk productivity such as $T59B{\times}Jam26$, $Jam329{\times}T59W$, $T59W{\times}Jam329$, and $T59W{\times}Jam178$. The color-difference of offspring cocoons were measured according to different cross manners using by CIE Lab-based formulae with a X-rite VS450. In the result, the depth of green color of cocoons was a little high at cross manners as $Jam329{\times}T59W$, $T59W{\times}Jam178$. Meanwhile, the depth of yellow clolor of cocoons was remarkable at cross manners as $Jam178{\times}T59W$, $T59W{\times}Jam178$, respectively.

• Journal of Digital Convergence
• /
• v.14 no.10
• /
• pp.393-398
• /
• 2016

Stock information applications allow users to look up and find current stock information whenever and wherever. This study researched what kind of user experience the finance experts get when using these applications and what they suggest. The research was conducted through an in-depth interview of 8 finance experts, who worked minimum of three years, and used both Kakao Stock and JeungGwon Tong, the most used stock information applications, for a minimum duration of six months. The results show the user experience of Kakao Stock rated a bit higher than JeungGwon Tong. Since the objective of such applications are to show stock informations, the experts all rated the pleasurable and meaningful aspects rather low. They suggested, the developers should provide a more advanced and accurate information. They also suggested user interest recognized content be presented along with more convenient user interface to elevate usability. Hopefully, this study becomes a base to further study of user experience of various on and offline stock information services and they become a reference to develop a service with great user experience.

• Journal of Broadcast Engineering
• /
• v.20 no.2
• /
• pp.224-237
• /
• 2015

In this paper, we introduce the fast decoding method with the SIMD (Single Instruction Multiple Data) instructions for HEVC RExt (High Efficiency Video Coding Range Extensions). Several tools of HEVC RExt such as intra prediction, interpolation, inverse-quantization, inverse-transform, and clipping modules can be classified as the proper modules for applying the SIMD instructions. In consideration of bit-depth increasement of RExt, intra prediction, interpolation, inverse-quantization, inverse-transform, and clipping modules are accelerated by SSE (Streaming SIMD Extension) instructions. In addition, we propose effective implementations for interpolation filter, inverse-quantization, and clipping modules by utilizing a set of AVX2 (Advanced Vector eXtension 2) instructions that can use 256 bits register. The evaluation of the proposed methods were performed on the private HEVC RExt decoder developed based on HM 16.0. The experimental results show that the developed RExt decoder reduces 12% average decoding time, compared with the conventional sequential method.

• The Journal of Engineering Geology
• /
• v.2 no.1
• /
• pp.47-57
• /
• 1992

Geophysical methods applied to water seepage problem in earth-fill embankment attempt to detect and map the estimate of size and depth of the seepage path. Seepage zones generally produce lOW resistivity anomalies due to high saturation of water. Dipole-dipole resistivity surveying technique, which is actually a combined sounding-profiling procedure, was used to delineate the seepage path through this study. In this study, the finite difference methods to solve the electric potential distribution in 2 112 dimension, was adopted as the numerical scheme for the forward problem. Second order Marquart's method, one the iterative damped least square methods, was selected for the automatic inversion. The computer program was implemented in FORTRAN 77 for 1 6-bit personal computer. In this paper, we present a case history which illustrates the application of dipole-dipole resistivity method to the delineation of water flow in earth-fill structures. Also the automatic two-dimensional resistivity inversion was applied to a field data where the interpretive advantages of the program become evident.