• 상하수도학회지
• /
• 제24권6호
• /
• pp.723-734
• /
• 2010

With a belief of high water quality production and less chemical usage, membrane technology including Microfiltration (MF), Ultrafiltration (UF), and Nanofiltration(NF) is being employed more and more in drinking water treatment process. However, due to higher energy consumption of UF and NF, MF is normally used for drinking water treatment especially in a plant of large scale. In this investigation, performance ofsand filtration and membrane filtration was compared regarding removal of various water quality parameters, such as TOC, DOC, KMnO4 consumption, THMFP, and HAAFP. Two lines of pilot plant have been operated, one of which line is a traditional advanced water treatment process which includes sedimentation, sand filtration, ozonation, and activated carbon, and the other line is an alternative treatment process which includes sedimentation with inclined plate, MF membrane, ozonation, and activated carbon. For the first about 4months of period, MF filtration showed similar or little bit higher performance than sand filtration. However, after about 4month later, sand filtration showed much higher performance in removing all parameters monitored in the investigation. It was found that sand filtration is a better option than MF filtration as far as microbial community is fully activated in sand filter bed.

• 대한기계학회논문집B
• /
• 제38권2호
• /
• pp.121-128
• /
• 2014

본 연구의 목적은 용융탄산염연료전지와 같은 고온연료전지에 동반하는 기계적 주변기기의 타당성을 검토할 수 있는 동적 시뮬레이션 모델을 개발하는 것이다. 연료전지를 운송수단과 같은 독립적인 동력기관에서 사용하기 위해서는 동반하는 기계적 주변기기를 최적화 및 소형화할 필요가 있다. 본 연구에서는 유입가스의 조성, 압력, 유량 및 스택의 온도에 따른 용융탄산염연료전지 내부의 화학반응의 동적 모델링을 구현하고 정상상태 시뮬레이션을 수행하여 실험결과와 비교 분석하였다. 또 연료전지의 전류밀도 제어에 따른 on/off 시뮬레이션을 수행하여 동적 시뮬레이션 모델의 타당성을 분석하였다.

• 한국환경과학회지
• /
• 제9권3호
• /
• pp.261-266
• /
• 2000

A kinetic study for nitrate removal by anion exchange resin was performed using continuous column reactors. Kinetic approach from the packed bed showed the reaction rate constant k$_1$ was 0.07~0.17 $\ell$/mgㆍhr and maximum exchange quantity q$_{o}$ was 27.75~31.81 mg/g. The results from the continuous column well agreed with that from the batch reactor. An economic analysis of the water treatment plant by anion exchange resin with a regenerating system was performed to design plant and process. Based on the treatment of 20 mg/$\ell$ nitrate-contained wastewater of 10,000 gallons per day to 2 mg/$\ell$, total capital cost and total annual cost are estimated to be 836 million wons and 211 million wons, respectively.y.

• KIEAE Journal
• /
• 제11권6호
• /
• pp.133-138
• /
• 2011

This paper presents energy self-sufficiency simulated in municipal wastewater treatment plants (WWTPs) by adopting solar energy production systems that were simulated by varying azimuth and super-hydrophilic coating on the surface of photovoltaic (PV). Relative to the national average energy consumption in WWTPs, the employment of 100 kW PV system was simulated to achieve 2.75% of energy self-sufficiency. The simulated results suggested that the installation of PVs toward South or Southwest would produce the highest energy self-sufficiency in WWTPs. When super-hydrophilic coating was employed in the conventional PV, 5% of additional solar energy production was achievable as compared to uncoated conventional PV. When 100 kW of PV system was installed in a future test-bed site, Kihyeung Respia WWTP located in Yongin, South Korea, the energy self-sufficiency by solar power was simulated to be 1.77%. The simulated solar power production by azimuth and super-hydrophilic coating will be useful reference for practitioners in designing the solar PV systems in the WWTPs.

• 한국환경복원기술학회지
• /
• 제15권2호
• /
• pp.117-125
• /
• 2012

The objective of this study was to investigate the possibility of planting seedlings for quarry rehabilitation. To achieve the objective, the experiment was designed for rehabilitation of quarry with planting seedlings and seeding types. Planting seedlings were categorized as target species, accompanied species and pioneer species. The study was conducted in limestone quarry (Lafarge Halla Cement Inc.) near the Baekdudaegan Mountains at Okke, Kangwon-do. The experimental planting bed was set in 2007 and field monitoring was carried out from 2007 to 2011. As the result of experiment, it was found that the early-phase pattern for surveyed species to establish was affected by the planting and seeding types. As years after planting and seeding, the percent of plant coverage also increased up to 90%. The methods of mixed planting and seeding were good for species diversity, but the growing of seedlings were affected by seeding plants. Accompanied species and pioneer species were superior to target species during first 2 years, but target species has gained predominance during last 2 years. The quality maintenance should be carried out annually to attain the goal of rehabilitation.

• 한국폐기물자원순환학회지
• /
• 제35권7호
• /
• pp.640-646
• /
• 2018

Biomass-fired power plants produce electricity and heat by burning biomass in a boiler. However, one of the most serious problems faced by these plants is severe corrosion. In biomass boilers, corrosion comes from burnt fuels containing alkali, chlorine, and other corrosive substances, causing boiler tube failures, leakages, and shorter lifetimes. To mitigate the problem, various approaches implying the use of additives have been proposed; for example, ammonium sulfate is added to convert the alkali chlorides (mainly KCl) into the less corrosive alkali sulfates. Among these approaches, the high temperature corrosion prevention technology based on ammonium sulfate has few power plants being applied to domestic power plants. This study presents the results obtained during the co-combustion of wood chips and waste in a circulating fluidized bed boiler. The aim was to investigate the characteristics of pollution load in domestic biomass power plants with ammonium sulfate injection. By injecting the ammonium sulfate, the KCl content decreased from 68.9 to 5 ppm and the NOx were reduced by 18.5 ppm, but $SO_2$ and HCl were increased by 93.3 and 68 ppm, respectively.

• The Plant Pathology Journal
• /
• 제38권5호
• /
• pp.472-481
• /
• 2022

Brown blotch disease, caused by Pseudomonas tolaasii, is one of the most serious diseases in mushroom cultivation, and its control remains an important issue. This study isolated and evaluated pathogen-specific bacteriophages for the biological control of the disease. In previous studies, 23 varieties of P. tolaasii were isolated from infected mushrooms with disease symptoms and classified into three subtypes, Ptα, Ptβ, and Ptγ, based on their 16S rRNA gene sequences analysis and pathogenic characters. In this study, 42 virulent bacteriophages were isolated against these pathogens and tested for their host range. Some phages could lyse more than two pathogens only within the corresponding subtype, and no phage exhibited a wide host range across different pathogen subtypes. To eliminate all pathogens of the Ptα, Ptβ, and Ptγ subtype, corresponding phages of one, six, and one strains were required, respectively. These phages were able to suppress the disease completely, as confirmed by the field-scale on-farm cultivation experiments. These results suggested that a cocktail of these eight phages is sufficient to control the disease induced by all 23 P. tolaasii pathogens. Additionally, the antibacterial effect of this phage cocktail persisted in the second cycle of mushroom growth on the cultivation bed.

• 에너지공학
• /
• 제22권2호
• /
• pp.96-104
• /
• 2013

석탄가스화 기술은 청정석탄에너지 기술 중에서 아주 중요한 대안으로 인식되고 있으며, 이에 전 세계적으로 차세대 석탄가스화기라고 할 수 있는 고효율 저비용 석탄가스화기를 개발하고 있다. 본 연구에서도 이러한 목적의 달성을 위하여 저비용으로 구현이 가능한 컴팩트 석탄가스화기를 개발하고 있으며, 다수개의 공급부로 이루어진 일체형 이중선회형 버너를 개발하였다. 개발된 버너의 가스화 운전조건을 확보하기 위하여 미분탄 분배기와 함께 기존의 석탄가스화기 몸체에 설치하여 가스화 실험을 수행하였다. 인도네시아산 아역청탄인 ABK 탄을 사용하여 1.5톤/일의 파일럿 규모로 $6.4{\sim}7.2kg/cm^2$, $1170{\sim}1300^{\circ}C$ 조건에서 운전을 수행하였다. 우선 성능평가보다는 안정적인 가스화기 운전조건을 확보하는데 중점을 두었다. 그 결과, 안정적인 운전조건에서 탄소전환율은 84.0%, 냉가스 효율 52.1%를 확보할 수 있었다.

• 한국산학기술학회논문지
• /
• 제16권11호
• /
• pp.7990-8000
• /
• 2015

식물공장은 환경적 조건을 조절하여 계절이나 장소에 관계없이 농산물을 일정하게 생산하는 식물재배 시스템이다. 식물공장에 있어서 내부의 열 유동은 식물공장의 중요한 변수이다. 본 논문에서는 다층 재배선반을 갖는 하이브리드 식물공장 내의 열유동 특성을 수치 시뮬레이션을 통해 연구하였다. 열 유동 특성의 수치해를 얻기 위해 유한체적법(Finite Volume Method)을 이용하였다. 수치해석 모델에 있어서는 저 레이놀드수(low Reynolds number) ${\kappa}-{\epsilon}$ 난류모델을 이용하였으며, 해석방법으로는 비압축성 점성유동 영역과 압력경계 조건을 사용하였다. 수치해석에 있어, 3종류의 유입 공기속도와 재배선반의 위치변화에 따른 식물공장 내의 열유동 특성을 상용 프로그램인 Solid Works Flow simulation을 사용하였다. 수치해석을 통한 결론은 다음과 같다. 첫째, 송풍기를 통한 식물공장 내의 유입 공기속도를 1.6 m/s로 하였을 때, Case 3의 재배선반 배치가 비교적 균일한 온도 분포를 나타내었고, LED광만을 사용한 Case 1의 배치는 시험베드(test bed) TB2와 TB3 영역의 낮은 온도분포로 인하여 서큘레이터 등을 통한 추가적인 온도 제어가 필요할 것으로 판단되었다. 둘째, 식물재배 LED 인공광(DYLED47)의 청색광과 적색광의 비율을 1:1로 100% 구동 시, 재배선반의 평균 온도가 약 $3^{\circ}C$ 증가하였다. 본 논문은 한국산학기술학회 논문지 심사용 투고요령입니다.

• 한국신재생에너지학회:학술대회논문집
• /
• 한국신재생에너지학회 2008년도 춘계학술대회 논문집
• /
• pp.475-478
• /
• 2008

The 3 ton/day-scale pilot plant consists of waste press, feed channel, fixed bed type gasification & melting furnace, quench scrubber, syngas refinery facility and flare stack. $H_2$/CO ratio of gasification syngas using the solid waste and sludge in the 3 ton/day gasifier showed about 1. Gasification melting furnace was operated $1,300{\sim}1,600^{\circ}C$. $H_2$/CO ration control system was obtained $H_2$/CO ratio 2 and 3.