• Applied Chemistry for Engineering
• /
• v.27 no.4
• /
• pp.415-420
• /
• 2016

To enhance electrochemical performances of anode materials, the surface of coal tar pitch (CTP) was modified by incorporating heteroatoms through chemical treatment with phosphoric acid ($H_3PO_4$). The prepared anode materials with modified CTP was analyzed by XRD, FE-SEM and XPS. The electrochemical performances of modified CTP were investigated by constant current charge/discharge test, rate performance, cyclic voltammetry and impedance tests using the electrolyte of $LiPF_6$ dissolved in the mixed organic solvents (ethylene carbonate : dimethyl carbonate = 1 : 1 vol% + vinylene carbonate 3 wt%). The coin cell using modified CTP ($H_3PO_4/CTP$ = 3 : 100 in weight) has better initial capacity and initial efficiency (489 mAh/g, 82%) than those of other composition coin cells. Also, it was found that the capacity retention was 86% after 30 cycles and the rate capability was 87% at 2 C/0.1 C.

• KIPS Transactions on Computer and Communication Systems
• /
• v.9 no.4
• /
• pp.83-88
• /
• 2020

In Solar-powered wireless sensor networks(SP-WSN), the battery is periodically charged, so the best use of harvested energy is more important, rather than minimizing energy consumption. Meanwhile, as is well known, the reliability of communication between sensor nodes is very limited due to the resource-constraint of sensor nodes. In this paper, we propose an advanced FEC (forward error correction) scheme which can give SP-WSN more reliability for communication. Firstly, the proposed scheme uses energy modeling to calculate the amount of surplus energy which can be utilized for extra operations, and then determines the number of additional parity bits according to this amount of surplus energy. At the same time, link quality modeling calculates the optimal parity bits for error recovery in the current data communication environment. Finally, by considering these two parity sizes, it is possible to determine the optimal parity size that can maximize the data reliability without affecting the node black out. Performance verification was performed by comparing the amount of data collected at the sink and the number of outage nodes with other schemes.

• Journal of Environmental Health Sciences
• /
• v.41 no.6
• /
• pp.412-424
• /
• 2015

Objectives: An ultra dry air environment of nearly ${\leq}2%$ RH is often required in lithium battery factories. The objective of this study is to evaluate the subjective eye, pulmonary, nose, and skin symptoms of workers exposed to ultra-low relative humidity and thionyl chloride. Methods: We recruited 274 workers using a self-reported questionnaire in March 2014. Those who worked in ultra-low relative humidity and with thionyl chloride were identified and their prevalence of symptoms was compared with that of other workers. We excluded white collar workers, researchers and other workers who were exposed to various hazard factors, and finally included 164 workers. Results: There were significant differences in the rate of self-reported eye and skin symptoms between exposure group_1 and exposure group_2. Exposure group_2 experienced more frequent eye, and skin symptoms. Multinomial logistic regression analysis for experience of dry eye symptoms and skin symptoms in exposure group_2 showed that dry eye symptoms (odds ratio [OR], 6.33, 95% confidence interval [CI], 2.19-18.24, p<0.001), and itchiness (OR, 6.45, 95% CI, 1.94-21.43, p<0.01) were the significant variables. The complaints of workers experiencing ultra-low relative humidity and thionyl chloride were high compared with other workers. Conclusion: These findings suggest that exposure to ultra-low relative humidity and thionyl chloride may be associated with more frequent eye and skin symptoms than exposure to ultra-low relative humidity alone. The current precautions to protect workers from the adverse effects of ultra-low relative humidity and thionyl chloride appear to be insufficient, indicating that additional management plans to reduce symptoms should be considered.

• The Transactions of the Korean Institute of Power Electronics
• /
• v.4 no.5
• /
• pp.433-441
• /
• 1999

This paper presents a S-FES(Superconducting magnetic becuing Flywheel Energy Storage System) for the p purpose of replacing battery used to store the energy. Especially, the design elements of FES, such as the b beming, wheel mateηaI, and power converter, etc., are described. The design and manufacturing techniques of t the controllable IXlwer converter are proposed to generate the sinusoidal output current in the high speed operation and to get the const빠synchronous motor with halbach cuTay of high coesive I\d-Fe-B permanent magnet is used as the driver of F FES. The proposed S-FES system shows the stable rotation characteristics at high speed range about l 10,000[rpm]. To verify the validity of proposed system, the comparative study with the conventional ball b beming s~rstem is proceeded and it is well confirmed with the result of the lower friction losses of S-FES S system.

• Journal of the Institute of Electronics Engineers of Korea SC
• /
• v.43 no.5 s.311
• /
• pp.28-35
• /
• 2006

This paper presents a new 3.3-1 V synchronous buck DC/DC converter that employs CMOS operational transconductance amplifiers (OTAs) as circuit-building blocks. An error amplifier OTA in a PWM circuit is compensated for to improve temperature stability. The temperature coefficient of the transconductance gain of the compensated OTA is less than $150\;ppm/^{\circ}C\;over\;0-100^{\circ}C$. The HSPICE simulation results of the $0.3{\mu}m$ standard CMOS technology show that the efficiency of the proposed converter is as high as 80% in the load current range of 40-125 mA. These results show that the proposed converter is adequate for use in battery-operated systems.

• Journal of the Korean Electrochemical Society
• /
• v.5 no.1
• /
• pp.1-6
• /
• 2002

Silver doped vanadium pentoxides with a doping ratio Ag/V ranging from 0.03 to 0.11 were synthesized by sol-gel process, and $Li/Ag_xV_2O_5$ cell was investigated by the electrochemical methods. It appears to be amorphous layered material and entangled fibrous textures has been grown to form anisotropic corrugated fibrils. NMR measurements revealed that several different kinds of $Li^+$ ions exist in the lithium intercalated xerogel electrodes and the average cell potential was about 3.0V vs. $Li/Li^+$. The cell capacity of the silver doped $Ag_xV_2O_5$ xerogel cathodes was more than 359 mAh/g at discharge current 10mA/g and cycle efficiency $94\%$ was achieved.

• Proceedings of the Materials Research Society of Korea Conference
• /
• 2011.10a
• /
• pp.30.1-30.1
• /
• 2011

Silicon is one of useful materials in various industry such as semiconductor, solar cell, and secondary battery. The metallic silicon produces generally melting process for ingot type or chemical vapor deposition (CVD) for thin film type. However, these methods have disadvantages of high cost, complicated process, and consumption of much energy. Electrodeposition has been known as a powerful synthesis method for obtaining metallic species by relatively simple operation with current and voltage control. Unfortunately, the electrodeposition of the silicon is impossible in aqueous electrolyte solution due to its low oxidation-reduction equilibrium potential. Ionic liquids are simply defined as ionic melts with a melting point below $100^{\circ}C$. Characteristics of the ionic liquids are high ionic conductivities, low vapour pressures, chemical stability, and wide electrochemical windows. The ionic liquids enable the electrochemically active elements, such as silicon, titanium, and aluminum, to be reduced to their metallic states without vigorous hydrogen gas evolution. In this study, the electrodeposion of silicon has been investigated in ionic liquid of 1-butyl-3-methylpyrolidinium bis (trifluoromethylsulfonyl) imide ([bmpy]$Tf_2N$) saturated with $SiCl_4$ at room temperature. Also, the effect of electrode materials on the electrodeposition and morphological characteristics of the silicon electrodeposited were analyzed The silicon electrodeposited on gold substrate was composed of the metallic Si with single crystalline size between 100~200nm. The silicon content by XPS analysis was detected in 31.3 wt% and the others were oxygen, gold, and carbon. The oxygen was detected much in edge area of th electrode due to $SiO_2$ from a partial oxidation of the metallic Si.

• The KIPS Transactions:PartC
• /
• v.17C no.5
• /
• pp.433-440
• /
• 2010

Energy efficiency, low latency and scalability for wireless sensor networks are important requirements, especially, the wireless sensor network consist of a large number of sensor nodes should be minimized energy consumption of each node to extend network lifetime with limited battery power. An efficient algorithm and energy management technology for minimizing the energy consumption at each sensor node is also required to improve transfer rate. Thus, this paper propose no-overlap multi-pass protocol provides for sensor data transmission in the wireless sensor network environment. The proposed scheme should minimize network overhead through reduced a sensor data translation use to searched multi-path and added the multi-path in routing table. Proposed routing protocol may minimize the energy consumption at each node, thus prolong the lifetime of the sensor network regardless of where the sink node is located outside or inside the received signal strength range. To verify propriety proposed scheme constructs sensor networks adapt to current model using the real data and evaluate consumption of total energy.

• Journal of the Institute of Convergence Signal Processing
• /
• v.12 no.3
• /
• pp.204-211
• /
• 2011

Embedded systems require intensively complex and high power dissipating modules that have the capability of real-time high performance data processing, wide bandwidth communication, and low power consumption. However, the current battery technology has not been developed as much as meeting the requirements of portable embedded systems for long system lifetime. In this paper, new approach that operates with low energy consumption is proposed to overcome the situation while guaranteeing detection accuracy. The designed method associates a variety of detection algorithms hierarchically to detect events happening around the system. The Change for energy consumption characteristics is shown with change for probabilistic characteristics and those relationships are analytically explained from experiments. Furthermore, several techniques to consume low energy and achieve high detection accuracy are described, depending on the event static or dynamic characteristics.

• Journal of Gifted/Talented Education
• /
• v.11 no.1
• /
• pp.99-117
• /
• 2001

This study looked at the validity of assessments of academic giftedness in young children, details of assessment procedures and tasks related to them. It has shown that academic giftedness in young children can be reliably observed and reported by parents and teachers through similar characteristics to older gifted children. But for young preschool children since the potentiality rather than the current performance level is more important to detect and children's abilities are not fully differentiated, more systematic and comprehensive assessments are needed. Parents'and/or teachers' referrals, behavior checklists for the gifted, tests for creativity, short or group forms of standardized tests and finally individualized tests can be used as a comprehensive battery but these methods can be used stepwise for the sake of efficiency and economy. Especially the variability of performance in young children during the rapid developmental phase as well as their vulnerability by situational factors ask for the repeated assessments as regular bases. In this study different measures for gifted young children, specialists' qualification, and procedural guidance were reviewed and the necessity for various screening tools for different programs for the gifted was discussed. Finally it was emphasized that early assessment and following educational arrangement are needed for gifted young children for their optimal development.