• Journal of Advanced Navigation Technology
• /
• 제11권1호
• /
• pp.9-16
• /
• 2007

In this paper, the Bit Error Ratio (BER) performances of the D8PSK modulation schemes for VDL Mode-2 are analyzed according to the matched and unmatched cases of the channel filters. The carrier frequency and phase offset effects are analyzed with unmatched case. Generally in digital transmission techniques, the Root Raised Cosine filters which are used as channel filters are applied to both sides at transmitter and receiver in order to achieve no ISI, but in VDL Mode-2, the Raised Cosine Filter is used only in transmission section and the receiver section uses general low pass filter, therefore we could not achieve ISI reduction effects but can have better spectrum quality. From the simulation results, the error probability is increased slightly (1~2dB) with use of un-matched channel filter, we got the conclusions that carrier phase offset do not effect to bit error ratio, but the frequency offset effect is so serious. Finally, narrow band D8PSK modulation signals are generated by the use of Digital Up-Converter and then its features are compared with analog modulator.

• Journal of the Institute of Electronics and Information Engineers
• /
• 제51권8호
• /
• pp.148-155
• /
• 2014

In this research a signal processing system is designed for detecting the ultrasonic signal envelope using Xilinx's Zynq SoC(system on chip). As a design tool, Vivado IDE(integrated design environment) is used to hierarchically design the whole signal processing system. The proposed system consists of a Zynq-internal ADC, an FIR(finite impulse response) BPF(band pass filter), an absolute value calculator, an FIR LPF(lpw pass filter), and the Kalman filter. Under this configuration, two design schemes, HW design scheme with LPF as a final stage and HW/SW co-design scheme with a Kalman filter as a final stage, are compared in terms of the performance and efficiency. As a result, envelope detecting performances of the two schemes are proved to be almost same, but the HW/SW co-design is verified to be much more efficient than the HW design considering the much smaller time consumption during system design.

• Journal of the Korean Institute of Telematics and Electronics
• /
• 제18권4호
• /
• pp.1-11
• /
• 1981

This paper proposes a method of generalizing the clocking scheme in the Switched Capacitor Filter(SCF) design using Voltage Inverter Switches (VIS's). Parallel RC and RL elements, and parallel LC resonators can be implemented by the proposed clocking schemes Applying these new elements and the generalized clocking schemes to the SCF design, the total number of required operational amplifiers and capacitors can be reduced. Experimental results of a band- stop filter and a low-pass filter using a new type grounded VIS show good agreements with t he theoretical characteristics.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• 제18권7호
• /
• pp.748-756
• /
• 2007

In SIR filter, fringing capacitances and discontinuities yield a distorted frequency response from those expected by design formulas, especially in higher frequencies. In this paper, a procedure is presented in order to compensate for fringing capacitances and step impedance discontinuities by EM simulation for a 5th order SIR filter. This method propose the procedure of tuning the coupling and the length of individual resonator by EM simulation. For the filter composed by the tuned resonators, no further tuning is required. The procedure is experimentally justified by comparing the measured data of the fabricated filter with the simulation results.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• 제45권8호
• /
• pp.47-52
• /
• 2008

In order to enhance the rejection performance of the UWB bandpass filter based on the Composite Right- and Left-Handed Transmission-line(CRLH-TL) Metamaterial cell, we propose the lowpass filtering concept that fits into the design objectives : Keeping metamaterial property and miniaturization. So the bandpass filter itself is made far less than a quarter-wavelength and a pair of symmetric comprises lowpass filtering blocks are placed before and after the center CRLH filter which comprises tile interdigitated coupled lines and short-circuited stob. The design result will show the size of 'guided wavelength/8', the fractional bandwidth over 100%, the insertion loss much less than 1 dB, a flat Group-Delay and a good return loss performance, as expected.

• Journal of the Institute of Electronics Engineers of Korea SD
• /
• 제43권12호
• /
• pp.8-14
• /
• 2006

This paper proposed noise insensitive 4*4 mid frequency-OCT (MF-DCT) focus measure operator. Proposed operator enhanced low power 8*8 MDCT operator to have 4*4 rotationally same form for Gaussian noise. MF-DCT operator acting like band-pass filter suppresses both low-frequency signal useless for focus measure and high-frequency signal affected by impulsive noise. Also it is proved to be linear because it uses the energy of band-pass filtered signal as focus measure. Experimental result shows its superiority by comparing AUM with traditional operators.

• Journal of the Korean Institute of Telematics and Electronics
• /
• 제17권4호
• /
• pp.45-52
• /
• 1980

In order to eliminate the phase errors caused by the finite GB product of operational amplifiers, novel integnator circuits are proposed. These circuits are characterized by their positive phase error angles and integrator selectivity. The positive sign of the Q and of the circuits compensates the negative selectivity and phase error angles, inherent in the integrated operational amplifiers. Miller inverting intergrator of a biquad circuit realized by Thomas is replaced by the proposed circuit and the band-pass frequency response of the modified biquad network is experimentally analyzed. A considerable improvement is recognized to such extent that the center frequency of the band-pass filter is allowed to be shifted up to 20KHz, which has been infeasible with conventional biquad networks.

• Journal of Navigation and Port Research
• /
• 제26권1호
• /
• pp.127-136
• /
• 2002

This paper Presents a discussion on the design and realization for the Phase Sensitive Defector (PSD) circuitry of Flu$\chi$-gate Compass that gives direction information to the Directional Frequency Analysis and Recording (DIFAR) Sonobuoy in Air Anti-Submarine Warfare. PSD circuitry is realized with Twin-T RC networked active band-pass filter. Results of a performance test the PSD circuitry shows that the effectiveness of band-pass filtering of desired $2F_0$ second harmonic signal, which is Pro- portional to the direction of earth's magnetic field. This resulted in the extraction of direction information.

• Proceedings of the Korea Electromagnetic Engineering Society Conference
• /
• 한국전자파학회 2003년도 종합학술발표회 논문집 Vol.13 No.1
• /
• pp.219-223
• /
• 2003

This paper describes an estimation of DOA(Direction Of Arrival) measurement system using DBF receiver with linear array antenna. This DBF receiver is composed of resistive FET mixer using low IF mettled. A radio frequency(RF), a local oscillator(LO) and ail intermediate frequency(IF) considered in this research are 2.09 GHz, 2.08 GHz and 10 MHz, respectively. This receiver is composed of a band-pass filter, a low-pass filter, a DC bias circuit. DOA measurement system is consist of linear array antenna, DBF receiver, AD control box and computer in the anechoic chamber. Receiving antenna is 4-array monopole antenna and DBF receiver is 4-Ch resistive FET mixer without amplifier. DOA algorithm is implemented using MUSIC algorithm with high resolution. We show that the results of DOA is $-30^{\circ},\;0^{\circ}$ and $60^{\circ}$, respectively. And we know that DOA estimation error occur by antenna radiation pattern and fabrication error of antenna array.

• Journal of electromagnetic engineering and science
• /
• 제2권2호
• /
• pp.117-123
• /
• 2002

This paper describes the design for the resistive FET mixer with low If for the 4-Ch DBF(Digital Beam Forming) receiver This DBF receiver based on the direct conversion method is generally suitable for high-speed wireless mobile communications. A radio frequency(RF), a local oscillator(LO) and an intermediate frequency(If) considered in this research are 2.09 GHz, 2.08 CHz and 10 MHz, respectively. This mixer is composed of band pass filter, a low pass filter and a DC bias circuit. Super low noise HJ FET of NE3210S01 is considered in design. The RE input power, LO input power and Vcs are used -10 dBm, 6 dBm and -0.4 V, respectively. In the 4-Ch resistive FET mixer, the measured If and harmonic components of 10 MHe, 20 MHz and 2.087 CHz are about -19.2 dBm, -66 dBm and -48 dBm, respectively The If output power observed at each channel of 10 MHz is about -19.2 dBm and it is higher 28.8 dBm than the maximum harmonic component of 2.087 CHz. Each If output spectrum of the 4-Ch is observed almost same value and it shows a good agreement with the prediction.