• Journal of the Korean Institute of Telematics and Electronics S
• /
• v.35S no.6
• /
• pp.66-71
• /
• 1998

High spatial resolution ultrasonic imaging is necessary in several fields of investigation, in order to permit greater precision of clinical diagnosis in the dermatology, ophthalmology etc. We present a B-mode scan system using sector scanning probe of 20MHz center frequency. This developed system allow the high resolution image of 250${\mu}m$ in lateral and 80${\mu}m$ in axial, which of display the size of a $5mm {\times} 5mm$ image with 20 frames/sec. We have shown the images of various structural elements of the human skin and of the nail. We have compared the skin images obtained for each of the different age and we have shown in a general with the age, the atrophy of the skin thickness and the appearance of the abnormal hypoechogene band under epidermis (named SENEB : Sub Epidermal Non Echogene Band).

• Biomolecules & Therapeutics
• /
• v.21 no.6
• /
• pp.470-475
• /
• 2013

Ultraviolet (UV) radiation is a major environmental factor that leads to acute and chronic reactions in the human skin. UV exposure induces wrinkle formation, DNA damage, and generation of reactive oxygen species (ROS). Most mechanistic studies of skin physiology and pharmacology related with UV-irradiated skin have focused on proteins and their related gene expression or single-targeted small molecules. The present study identified and analyzed the alteration of skin metabolites following UVB irradiation and topical retinyl palmitate (RP, 5%) treatment in hairless mice using direct analysis in real time (DART) time-of-flight mass spectrometry (TOF-MS) with multivariate analysis. Under the negative ion mode, the DART ion source successfully ionized various fatty acids including palmitoleic and linolenic acid. From DART-TOF-MS fingerprints measured in positive mode, the prominent dehydrated ion peak (m/z: 369, M+H-$H_2O$) of cholesterol was characterized in all three groups. In positive mode, the discrimination among three groups was much clearer than that in negative mode by using multivariate analysis of orthogonal partial-least squares-discriminant analysis (OPLS-DA). DART-TOF-MS can ionize various small organic molecules in living tissues and is an efficient alternative analytical tool for acquiring full chemical fingerprints from living tissues without requiring sample preparation. DART-MS measurement of skin tissue with multivariate analysis proved to be a powerful method to discriminate between experimental groups and to find biomarkers for various experiment models in skin dermatological research.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.27 no.9
• /
• pp.872-875
• /
• 2016

In this paper, the turnstile junction-based Ortho-Mode Transducer(OMT) is designed and manufactured. It is usually well-known that turnstile junctions have symmetry structure of waveguide so the higher order modes, which occurs inside the waveguide, can be cancelled. Because of these symmetrical properties, the turnstile junction-based OMTs have merits like high transmission and low return loss characteristic in broadband and two different modes propagate orthogonally in common port resulting in the fully realization of double polarization. The designed OMT has the application of Radar Seeker and operates in W-band(94 GHz), the millimeter wave frequency. The average of return loss value of manufactured OMT is lower than -20 dB and it has bandwidth characteristic of over 500 MHz.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.11 no.2
• /
• pp.146-153
• /
• 1998

The optical near-field patterns, propagation loss and mode sizes of x-cut $Ti:LiNbO_3$ optical waveguide which was fabricated by Ti-diffusion varying with Ti strip thickness in wet oxygen atmosphere were discussed at optical wavelength 1550nm. As Ti thickness increased from $760{\AA}$, the insertion loss of waveguide was decreased. But at Ti thickness $1500{\AA}$, mode sizes are widely broadened. The Ti thickness of below $1100{\AA}$ and above $1500{\AA}$ showed negative effects to propagation loss and fiber coupling. The best Ti thickness for fabricating low propagation loss and good fiber coupling was inferred to be between $1100{\AA}-1500{\AA}$ in our conditions. And for Ti thickness $1150{\AA}$, its propagation loss, horizontal/vertical mode sizes were showed 1.61 dB/cm, $11.9/8.9{\mu}m$ for TM, 0.22 dB/cm, $12.0/9.1{\mu}m$ for TE respectively.

• Transactions of the Korean Society of Mechanical Engineers B
• /
• v.38 no.4
• /
• pp.329-335
• /
• 2014

This study aimed to understand the internal flow characteristics of a liquid droplet subject to periodic forced vibration. In order to predict the resonance frequency of a droplet, a high-speed camera and macro lens were used to capture internal flow characteristics of a droplet placed on a vibrating hydrophobic surface. Results showed that the droplet assumed a variety of shapes depending on the resonance mode of free droplet, particularly in modes 2, 4, 6, and 8. In addition, the induced internal vortex flow inside the droplet was also observed in each mode. Typically, the induced flow moved upwards along the axis of symmetry and downwards along the surface of the droplet, that is, from the apex to the contact line in modes 2 and 4, after which it broke into a smaller vortex. On the other hand, the large-scale vortex always remained steady in modes 6 and 8. The speed of the flow in mode 4 was always greater than that in mode 2, but those in modes 6 and 8 were similar.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.37 no.6B
• /
• pp.423-432
• /
• 2012

We design a control circuit that can switch input power between a rechargeable battery and a sensor communication device (mote) depending on the operating state of a solar cell as well as the active and sleep mode of a sensor MAC protocol. A mote that simply combines a solarcell and a rechargeable battery may die if there is not sunlight long. A battery is recharged if sunlight is sufficient and a device is in a sleep mode, and it supplies power if sunlight is low and the mote is in an active mode. A mote can switch its input power between solar cell and battery depending on the output level of a solar cell. During this switching, a mote may lose its state information due to the reset of a microprocessor by the transient power-off. A capacitor is used to cope with this phenomenon and also supplies power to a mote during a sleep mode. Experimental results show that the solar cell based mote operates in a very stable manner against the lack of sunlight long.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.25 no.1
• /
• pp.39-46
• /
• 2014

In this paper, to operate 2.4 GHz Inverted-L antenna with On-Board Broadband characteristics is proposed. The antenna was designed on the system board, the bandwidth by adjusting the reactance of the antenna that was formed common-mode and differential-mode on the antenna stubs has been improved. The system size is $80mm{\times}60mm$, the size of the antenna was limited to $30mm{\times}60mm$, the thickness of FR4 dielectric substrate is 0.8 mm, FR4 dielectric constant 4.4 is used. The experimental results, the bandwidth from 17.2 to 24.1 %, the gain is 3.01~4.71 dB, omni-directional radiation pattern characteristics were obtained. By a mobile terminal design applying the results of the paper, the handset's price competitiveness and production efficiency can be improved.

• Korean Journal of Optics and Photonics
• /
• v.18 no.6
• /
• pp.389-394
• /
• 2007

The characteristics of the single mode fiber hydrogen sensor have been investigated theoretically and experimentally. Palladium is adopted as a material for the transducer and a thin Ni film is used for the adhesion between the fiber end and the Pd film. It is shown that sensitivity and response time strongly depend on the thickness of Pd film. The single mode fiber sensor coated with 5 nm thick Ni adhesion layer and 10 nm thick Pd transducer layer showed 0.6 dB change of reflectivity and $3{\sim}5$ sec of response time as it absorbed 4% hydrogen gas.

• Korean Journal of Optics and Photonics
• /
• v.19 no.5
• /
• pp.343-348
• /
• 2008

This study was carried out to commercialize FTTH by developing a burst mode optical receiver for E-PON. The optical receiver was manufactured by minimizing the capacitance of a photodiode to improve sensitivity for meeting 10, 20 km OLT Rx standard of E-PON at the transmission speed of 1.25 Gb/s. When bit-error ratio is $10^{-12}$ and PRBS is $2^5-1$, sensitivity is -26 dBm, loud/soft ratio is 23 dB. Both preamble time and guard time were set to 102.4 ns (128 bit). After comparing a photodiode whose capacitance is 0.53 pF with another photodiode whose capacitance has been minimized to 0.26 pF, we could see that sensitivity improved to 0.7 dBm and so did bandwidth to 190 MHz of burst mode for the optical receiver manufactured by the photodiode whose capacitance is 0.26 pF.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.36 no.12A
• /
• pp.941-949
• /
• 2011

In a cooperative communication system with a source node and multiple relays equipping single antenna and a destination node equipping multiple antennas, the selective cooperative spatial multiplexing scheme can obtain spatial multiplexing gain and additional selection diversity gain. But it can degrade a bit error rate performance because some received symbols forwarded from particular relays may be lost by attenuation due to path-loss. We propose a relay and transmission mode selection scheme which selects minimum number of multiple relays having the channel capacity larger than a given data rate and transmission mode which switches spatial multiplexing and spatial diversity mode in cooperation phase to enhance the bit error rate performance. The proposed scheme achieves 1.5~2dB gain at the low SNR range compared with the conventional scheme by obtaining additional spatial diversity gain.