• Journal of Astronomy and Space Sciences
• /
• 제26권1호
• /
• pp.47-58
• /
• 2009

In this study, a Hardware-In-the-Loop (HIL) simulator using thrusters is developed to validate the spacecraft attitude system. To control the attitude of the simulator, eight cold gas thrusters are aligned with roll, pitch and yaw axis. Also linear actuators are applied to the HIL simulator for automatic mass balancing to compensate the center of mass offset from the center of rotation. The HIL simulator consists of an embedded computer (Onboard PC) for simulator system control, a wireless adapter for wireless network, a rate gyro sensor to measure 3-axis attitude of the simulator, an inclinometer to measure horizontal attitude, and a battery set to supply power for the simulator independently. For the performance test of the HIL simulator, a bang-bang controller and Pulse-Width Pulse-Frequency (PWPF) modulator are evaluated successfully. The maneuver of 68 deg. in yaw axis is tested for the comparison of the both controllers. The settling time of the bang -bang controller is faster than that of the PWPF modulator by six seconds in the experiment. The required fuel of the PWPF modulator is used as much as 51% of bang-bang controller in the experiment. Overall, the HIL simulator is appropriately developed to validate the control algorithms using thrusters.

• 제어로봇시스템학회논문지
• /
• 제16권9호
• /
• pp.905-912
• /
• 2010

Modern version of advanced supersonic fighter have ATCS (Automatic Thrust Control System) to maximum flight safety, fuel efficiency and mission capability the integrated advanced autopilot system such as TFS (Terrain Following System), GCAS (Ground Collision Avoidance System) and AARS (Automatic Attitude Recovery System) and etc. This paper addresses the design and verification of ATCS based on advanced supersonic trainer in HILS (Hardware In the Loop Simulator) with minimum hardware modification to reduce of development cost and maintain of system reliability. The function of ATCS is consisted of target speed hold mode in UA (Up and Away) and angle of attack hold mode in PA (Power Approach). The real-time pilot evaluation reveals that pilot workload is minimized in cruise and approach flight stage by ATCS.

• 한국항공운항학회지
• /
• 제21권4호
• /
• pp.34-40
• /
• 2013

Attitude command response type required for enhanced handling qualities of helicopter can be implemented by mechanical automatic flight control system with SAS actuators which have limited authorities. However, the early saturation of SAS actuator hinders the helicopter from following the attitude command for large stick command. Auto-trim controller can delay SAS actuator's saturation by utilizing trim actuators and allows the attitude command response type for larger stick command. This paper describes the control law for limited authority system of helicopter with auto-trim. Limited authority system is applied to BO-105 linear dynamic model and simulation is performed along with handling quality analysis.

• 제어로봇시스템학회논문지
• /
• 제17권7호
• /
• pp.704-713
• /
• 2011

For many years, many pilots lost their lives and aircrafts due to GLOC(Gravity-induced Loss Of Consciousness). Due to the emergence of high-gravity maneuvering aircraft such as the F-16, F-15 and T-50, the automatic GLOC detection and recovery systems are necessary to increase the aircraft safeties even when the pilot loses his consciousness due to high-G maneuvering. This paper addresses the design of GLOC detection, warning and recovery algorithm based on a model of supersonic jet trainer. The system is solely controlled by the pilot's control input (i.e., control stick force) and aircraft status such as attitude, airspeed, altitude and so forth. And, moreover, it does not depend upon any pilot physiological condition. The test evaluation results show that the developed system supports the recovery of an aircraft from the unusual aircraft attitude and improves the aircraft safeties even when the pilot loses his consciousness due to high-G maneuvering.

• 한국항공운항학회지
• /
• 제13권3호
• /
• pp.9-21
• /
• 2005

The stable motion has been judged by mathematical modeling of the conditions that a rocket flies flexibly to take an active part in atmosphere. In this paper, the rocket conditions consist of the air speed, thrust and automatic attitude control. Aerodynamic force, a critical trust and a critical air speed are determined by comparing mathematical knowledges with eigenfrequencies of vibration equation. And then rocket object model is designed. Parameters and eigenfrequencies are used in dimensionless forms for in general applications by eliminating restrictions such as dimension, weight and select of materials.

• 제어로봇시스템학회:학술대회논문집
• /
• 제어로봇시스템학회 2003년도 ICCAS
• /
• pp.519-524
• /
• 2003

In this report, a longitudinal adaptive flight control law is presented for the automatic landing system of a Japanese automatic landing flight experiment vehicle (ALFLEX). The longitudinal adaptive flight control law is designed to track an output of the vehicle to a guidance signal from the guidance portion of the automatic landing system. The proposed adaptive control law in the attitude control portion adjusts the controller gains continuously online as flight conditions change, in spite of the existence of unmodeled dynamics. The number of the controller gains to be adjusted is decreased to 1/2 from the previous studies. Computer simulation involving six-degree-of-freedom (DOF) nonlinear flight dynamics is performed to examine the effectiveness of the proposed adaptive control law. In order to verify the influence of the dispersion of the initial conditions, the Monte Carlo simulation is also applied. The initial conditions are more widely dispersed than the previous studies. As a result, except under the unsuitable initial conditions, the ALFLEX successfully landed on the runway.

• 제어로봇시스템학회:학술대회논문집
• /
• 제어로봇시스템학회 2004년도 ICCAS
• /
• pp.1386-1391
• /
• 2004

It is known that an aircraft with delta-wings which are attached to the body at a large angle like a kite or a hang glider has a measure of maneuverability and stability. Aircrafts of this kind can fly stably. Even if engine trouble occurs, it will not fall and might be able to land. In this paper, one of the conventional control methods, PID control, is applied to the aircraft with LQ local control block. This is based on an idea that the aircraft flies so stably that the automatic control system might be realized by a simple controller. The proposed PID controller consists of several sub-controllers which are constructed to each system neglecting the interference. In addition, the LQ control is involved as a local loop of the aileron and rudder control in order to increase stability of the attitude when circling. The effectiveness of the proposed method is shown through 3D computer simulations and experiments of the flight path control.

• 제어로봇시스템학회논문지
• /
• 제2권3호
• /
• pp.242-247
• /
• 1996

In this paper, an optimal coning compensation algorithm for strapdown system is proposed by minimizing the coning error. The proposed algorithm is derived as a generalized form in that it contains the class of the existing coning algorithms and allows the design of optimal algorithm for various combinations of gyro samples. It is shown the magnitude of resulting algorithm errors depends mainly on the total number of gyro samples including present and previous gyro samples. Based on the results, the proposed algorithm enables the algorithm designers to develop the effective coning compensation algorithm according to their attitude computation specifications with ease. In addition, the multirate method which can efficiently implement the algorithm is presented.

• 제어로봇시스템학회논문지
• /
• 제20권11호
• /
• pp.1103-1111
• /
• 2014

The results of control law design for a tilt-rotor unmanned aerial vehicle that has a nacelle mounted wing extension (WE) are presented in this paper. It consists of a control surface mixer, stability and control augmentation system (SCAS), hold mode for altitude / speed / heading, and a guidance mode for preprogram and point navigation which includes automatic take-off and landing. The conversion corridor and the control moments derivatives between the original tilt-rotor and its variant of the nacelle mounted WE were compared to show the effectiveness of the WE. The nacelle conversion of the original tilt-rotor starts when the airspeed is greater than 30 km/h but its WE variant starts at 0 km/h in order to reduce the drag caused by the high incidence angle of the WE. The stability margins of the inner loop are presented with the optimization approach. The outer loops for the hold mode are designed with trial and error methods with linear and nonlinear simulation. The main control parameter for altitude control of the helicopter mode is thrust command and it is transferred to the pitch attitude command in airplane mode. Otherwise, the control parameter for the speed of the helicopter mode is the pitch attitude command and it is transferred to the thrust command in airplane mode. Therefore the speed and altitude hold mode are coupled to each other and are engaged at the same time when an internal pilot engages any of the altitude or speed hold modes. The nonlinear simulation results of the guidance control for the preprogrammed mode and point navigation are also presented including automatic take-off and landing in order to prove the full control law.

• 대한조선학회논문집
• /
• 제33권2호
• /
• pp.36-43
• /
• 1996

현재 전 세계적으로 해상교통의 주역이 되리라고 생각되는 고속선에 대한 시험 연구를 수행하였다. 본 논문은 주행중 고속선에 가장 문제가 되는 파도중의 운항자세를 제어하는 시험을 수행한 결과이다. 선형은 카타마란 선형을 선택하였으며, 운항자세를 제어하기 위하여 선수와 선미부분에 제어판을 장치하였다. 자세제어 시스템으로는 제어판과 제어판 구동장치, 운동 계측장비로 되어있으며, 운동 계측장비로부터 데이타를 취득하고, 제어판 구동장치로 신호를 보내기 위하여 A/D, D/A보드를 각각 1장씩 사용하였다. 이 장비를 이용하여 규칙 정면파중의 고속선의 운항자세를 제어하는 시험을 수행하였으며, 실험결과로부터 자세제어 시스템이 작동하지 않을 때와 작동할 때의 차이를 비교하였다. 비교결과 종동요(Pitch)는 진폭이 많이 감소하였으나, 상하동요(Heave)는 많이 감소하지 않았다.