• 한국전자파학회:학술대회논문집
• /
• 한국전자파학회 2003년도 종합학술발표회 논문집 Vol.13 No.1
• /
• pp.150-154
• /
• 2003

In this letter, a novel compact duplexer which consists of Tx and Rx Filter using microstrip line ${\lambda}/4$ resonators with a pair of tap-connected open-ended stepped impedance stubs is designed. The tapped open stubs not only work as K-inverters but also introduce attenuation poles, attenuation poles are located at upper and lower side of the passband by adjusting the open stub length and width. The result of measurement duplexer has been yielded better isolation and sharper skirt behavior than that with a conventional bandpass filter and similar to those of simulation results.

• 대한기계학회:학술대회논문집
• /
• 대한기계학회 2004년도 춘계학술대회
• /
• pp.25-30
• /
• 2004

In this paper, the compensation of interfacial scatter due to adhesive layer and adherend thickness ratio variation was applied to improve measuring precision by calculating ultrasonic attenuation coefficient in the Al/Epoxy dissimilar bonded components. The optimum condition of theoretical value and experimental measuring accuracy by the ultrasonic method in the Al/Epoxy dissimilar bonded components have been investigated. From the experimental results, we proposed a measurement method of the interfacial crack lengths by the ultrasonic attenuation coefficient and discussed it.

• 한국소음진동공학회:학술대회논문집
• /
• 한국소음진동공학회 2001년도 추계학술대회논문집 II
• /
• pp.1280-1286
• /
• 2001

This paper presents some advanced and supplemental methods to enhance the accuracy in case of calculating geometric divergence attenuation, attenuation by multiple screening structures, ground attenuation at unflat surfaces of sound during propagation outdoors by the methods specified in ISO 9613-2. Moreover, a calculation method for considering short-term wind effect, specified in ASJ Model-1998, is also introduced. To verify the accuracy of adopted methods, we have carried out highway traffic noise prediction and measurement at the twelve locations appearing representative road shapes and structures, such as flat, retained cut, elevated, barrier-constructed roads. From the results, we have confirmed the predicted results show good correspondence with the measured at direct, diffracted and reflected sound fields within 30m from the center of near side lane.

• Journal of electromagnetic engineering and science
• /
• 제19권1호
• /
• pp.56-63
• /
• 2019

Typical negative group delay circuits (NGDC) are analyzed in terms of signal attenuation, group delay, and bandwidth using S-parameters. By inverting these formulations, we derive and present the design equations (for NGD circuit elements) for a desired specification of the two among the three parameters. The proposed design method is validated through simulation examples for narrow- and wide-band pulse inputs in the time and frequency domains. Moreover, an NGDC composed of lumped elements is fabricated at 1 GHz for measurement. As a function of frequency, the circuit-/EM-simulated and measured group delays are in good agreement. The provided simple NGDC design equations may be useful for many applications that require compensations of some signal delays.

• Korean Journal of Radiology
• /
• 제22권1호
• /
• pp.86-96
• /
• 2021

CT is a diagnostic tool with many clinical applications. The CT voxel intensity is related to the magnitude of X-ray attenuation, which is not unique to a given material. Substances with different chemical compositions can be represented by similar voxel intensities, making the classification of different tissue types challenging. Compared to the conventional single-energy CT, spectral CT is an emerging technology offering superior material differentiation, which is achieved using the energy dependence of X-ray attenuation in any material. A specific form of spectral CT is dual-energy imaging, in which an additional X-ray attenuation measurement is obtained at a second X-ray energy. Dual-energy CT has been implemented in clinical settings with great success. This paper reviews the theoretical basis and practical implementation of spectral/dual-energy CT.

• 대한방사선기술학회지:방사선기술과학
• /
• 제21권2호
• /
• pp.5-10
• /
• 1998

In the mammography, X-ray beam quality is one of the most important factors. Using X-ray mammography unit model GE/CGR Senography 600T Senix H.F, Authors studied four subjects. 1. The aluminum attenuation rate in 30 kVp when used with or without compression plate. 2. HVLs at 5 different area of the X-ray field of $26{\sim}32kVp$. 3. HVLs to know the influence of corrected measurement or parallel measurement. 4. Film density with microdensitometer along and cross to the long axis of X-ray tube, in terms of the Heel effect in the X-ray field. The following results were obtained. 1. Beam quality of anode area was harder than cathode area. 2. The dose reduction rate of compression plate was approximately $65.5%{\sim}88.1%$ and the beam quality with compression plate was hardened up to 4kVp accordingly. 3. If the X-ray beam enters the attenuation plate obliquely, HVL was $2.6{\sim}2.9%$ harder than perpendicular to it. 4. Because of heel effect, the film density of cathode area is higher than anode area to film density of 0.5.

• 한국정보통신학회:학술대회논문집
• /
• 한국해양정보통신학회 2006년도 춘계종합학술대회
• /
• pp.1005-1008
• /
• 2006

본 논문은 2.4 GHz대역 블루투스 시스템 및 무선랜 시스템을 효과적으로 구축하기 위해 필요한 다양한 실내 전파환경 데이터의 제공을 목적으로 한다. 측정 방법으로는 안테나의 송수신 방사특성을 측정하는 장비를 옥내에 설치하고, 전파경로에 각종 재질의 구조물을 설치하여 방사특성을 측정한다. 두께 25cm의 일반 시멘트벽을 투과할 경우의 감쇄를 측정 한 결과, 도달거리 1m 에서 약 $1\sim3dB$정도의 감쇄가 생김을 알 수 있었다. 또한 철골벽의 경우 철골 구조와 수평한 편파를 사용할 경우에는 감쇄가 증가하지만, 수직한 편파를 사용할 경우 철곡의 영향이 거의 없음을 알 수 있다.

• 대한기계학회논문집B
• /
• 제20권7호
• /
• pp.2315-2325
• /
• 1996

A compression wave is attenuated or distorted as it propagates in a tube. The present study investigated the propagation characteristics of the compression waves which are generated by a train in a high-speed railway tunnel. A Total Variation Diminishing (TVD) difference scheme was applied to one-dimensional, unsteady viscous compressible flow. The numerical calculation involved the effects of wall friction, heat transfer and energy loss due to the friction heat in the boundary layer behind the propagating compression wave, and compared with the measurement results of a shock tube and a real tunnel. The present results show that attenuation of the compression wave in turbulent boundary layer is stronger than in laminar boundary layer, but nonlinear effect of the compression wave is greater in the laminar boundary layer. The energy loss due to the frictional heat had not influence on attenuation and distortion of the propagating compression waves.

• 한국통신학회논문지
• /
• 제23권4호
• /
• pp.1006-1015
• /
• 1998

20GHz 이상의 주파수대에서 대기중 감쇠에 있어서 고려해야 할 인자로는 대기분자, 강우, 강설, 안개 등이 있으며 이 중 가장 큰 영향은 강우에 의한 감쇠이다. 강우로 인한 감쇠는 강우강도에 의해서 그 감쇠정도가 결정되고, 강우강도는 공간적 시간적으로 변동이 매우 다양하다. 따라서 강우강도에 의한 시간적 공간적 데이터의 확보와 정확한 강우강도의 추정은 정확하고 신뢰성 있는 회선설계를 위하여 필수적이다. 본 연구에서는 제주도를 제외한 남한전역의 32개 측후소로부터 얻을 수 있는 최근 10여년 간의 디지털 강우강도 데이터를 확보하여 지역별 강우강도와 시간율의 관계를 경험적으로 분석하였으며, 강우강도의 분포를 추정하기 위한 여러 가지 방법론을 비교 분석하였고 한국실정에 맞는 방법론을 제시하였다.

• 한국항행학회논문지
• /
• 제22권5호
• /
• pp.415-419
• /
• 2018

본 논문은 정지궤도위성인 KorSat 5A($113^{\circ}E$)에서 송신하는 비콘 신호를 김포에 위치한 지상국에서 수신할 때의 C/N (carrier to noise ratio)을 예측하고 측정하였다. 지상국을 기준으로, ITU-R의 zone K 강우 감쇠와 국내 기상정보를 분석한 강우 감쇠를 비교하였다. ITU-R에서는 우리나라 강우 특성을 zone K로 일괄 분류하였으나, 2013년부터 2017년까지의 분당 누적 강우 데이터를 바탕으로 지상국 인접 3개 도시의 강우 강도 및 감쇠를 예측하였다. 강우 경로와 감쇠 대한 계산은 ITU-R 권고를 참고하였다. 2주간의 위성비콘 신호 C/N 측정을 통해 강우량에 따른 C/N의 변화를 확인하였으며, $A_{0.3}$일 때 예측된 임계 C/N은 12 dB, 실험기간 동안 집중된 강우에 따라 최대 8 dB까지 감소하는 것을 확인하였다.