• Proceedings of the KSME Conference
• /
• 2007.05b
• /
• pp.2354-2359
• /
• 2007

Influence of changing combustor pressure on flame stabilization and emission index in the swirl-stabilized flame was investigated. The combustor pressure was controlled by suction fan at combustor exit. Pressure index ($P^{\ast}$=Pabs/Patm), where Pabs and Patm indicated the absolute pressure and atmosphere pressure, respectively, was controlled in the range of 0.7${\sim}$1.3 for each equivalence ratio conditions. The flammable limits of swirl flames were largely influenced by changing combustor pressure and they showed similar tendency with laminar flames. NOx emission index decreased with decreasing pressure index for overall equivalence ratio conditions. R.m.s. of pressure fluctuations is increased with decreasing combustor pressure. This flame fluctuation caused incomplete combustion, hence CO emission index increased. These oscillating flames were measured by simultaneous $CH^{\ast}$ chemiluminescence time-series visualization and pressure fluctuation measurement.

• Proceedings of the Korea Concrete Institute Conference
• /
• 2000.04a
• /
• pp.571-576
• /
• 2000

This paper summarized deformation properties of hydroelectric power concrete dam through the comparison between measured and analysed data. This is a part of the process to evaluate concrete dam safety, which has become a critical concern in the country. We analysed strain and angle deformation data by considering only the effect of atmosphere temperature to evaluate deformation properties of Gaisan hydroelectric power concrete dam. Analysis results are almost identical with measured data, and behavior of Gusian dam can be cleared up more reliably in case of acting the external loads (seismic, wind water pressure, etc.) except the influence of temperature.

• Journal of Korean Society for Atmospheric Environment
• /
• v.13 no.1
• /
• pp.1-7
• /
• 1997

Anion concentrations and distributions of airborne fine particles less than 2 $\mu$m in urban atmosphere were determined from Feb. 5 to 16, 1996. The sampling was carried out using 8 stages Hering's low pressure impactor (LPI, aerodynamic cutoff diameters are 0.05, 0.075, 0.11, 0.26, 0.50, 1.0, 2.0, and 4.0$\mu$m) on the top of a five-story building located at Kon-Kuk university in Seoul. Average concentrations if C $l^{[-10]}$ , N $O_3$$^{[-10]}$ and S $O_4$$^{2-}$ were 9.4, 8.4, and 14.5 $\mu\textrm{g}$/㎥, respectively. The distributions of these anion concentrations were bimodal types which showed two peaks in the range of 0.075~0.12 ${\mu}{\textrm}{m}$ and 0.5~1 ${\mu}{\textrm}{m}$ in aerodynamic diameter. These results were 2.5~4.7 times higher than anion concentrations collected by Anderson low volume air sampler.

• Journal of the Korean Ceramic Society
• /
• v.33 no.3
• /
• pp.259-268
• /
• 1996

In the present study the effect of the addition of Fe on the pressureless and hot press sintering behavior was studied under Ar atmosphere. Pressureless sintering was performed 1900~220$0^{\circ}C$ under. Ar atmosphere. The addition of 1 wt% Fe was increased effectively of the sintered density. However it was impossible to obtain high density higher than 90%,. Zr-Fe-B compound in liquid phase was observed from the EDS and WDS analysis. It was considered that sinterability was enhanced due to the mass transfer through Fe based liquid phase formed at the sintering temperature. Hot pressing was performed at 1600~1$700^{\circ}C$ under Ar atmos-phere for 1 hr. It was possible obtain 95% relative density of ZrB2 specimen which is higher density at pressure-less sintering. It could be thought that ZrB2 particles was rearranged through liquid phase by applied pressure during initial stage of sintering.

• Advances in Energy Research
• /
• v.8 no.4
• /
• pp.265-273
• /
• 2022

In this study, a product gas yield and carbon conversion were measured during the coal pyrolysis. The pyrolysis process occurred under two different atmospheres such as subcritical (45 bar, 10℃) and supercritical CO₂ condition (80 bar, 35℃). Under the same pressure (80 bar), the atmosphere temperature increased from 35℃ to 45℃ to further examine temperature effect on the pyrolysis at supercritical CO₂ condition. For all three cases, a power input supplied to heating wire placed below coal bed was controlled to make coal bed temperature constant. The phase change of CO₂ atmosphere and subsequent pyrolysis behaviors of coal bed were observed using high-resolution camcorder. The pressure and temperature in the reactor were controlled by a CO₂ pump and heater. Then, the coal bed was heated by wire heater to proceed the pyrolysis under supercritical CO₂ condition.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.19 no.6
• /
• pp.698-705
• /
• 2008

When electromagnetic waves propagate through atmosphere, waves are affected by various factors. Atmosphere normally consists of different molecular species, water vapours, rain, fog, snow and small suspended particles called aerosols. The distributions of atmosphere molecules, water vapours, rain rate, snowfall and aerosol are dependent on geometrical regions or environment. In order to predict propagation characteristics in atmospheric environment, statistical analysis of the relevant parameters such as temperature, humidity, atmospheric pressure, wind speed, areosol and rainfall is crucial. In this paper, we performed a long-term statistical analysis for the atmospheric parameters in domestic environments and analyzed the propagation characteristics through atmosphere based on that.

• Proceedings of the Korean Magnestics Society Conference
• /
• 1991.11a
• /
• pp.72-73
• /
• 1991

• Transactions of the Korean Society of Automotive Engineers
• /
• v.13 no.6
• /
• pp.7-12
• /
• 2005

In order to analyze the microscopic spray characteristics of free spray in ultra high pressure region, the droplets size and velocity of free spray injected under atmosphere condition were measured by PDPA. As injection pressure became ultra high pressure, the droplets size was decreased continuously due to the increase of mutual reaction between droplets and air. But the decreasing rate became moderate. The velocity was increased until 250 MPa, and then decreased over that of injection pressure. It was seemed that the droplet size was similar in range of $280\~350\;MPa$, but increased in 414 MPa, even though injection pressure was increased. The microscopic spray characteristics of free spray got worse in 414 MPa.

• Journal of IKEEE
• /
• v.23 no.3
• /
• pp.865-872
• /
• 2019

We developed a one-dimensional Ar fluid model running in DC-type applied voltage with a sine and a pulse waveform at the atmosphere pressure. We investigated the light emissions and efficiencies of ${\lambda}_{128nm}$, ${\lambda}_{727nm}$, ${\lambda}_{912nm}$ and ${\lambda}_{966nm}$ from the Ar excited particles. From the results, the light emission of ${\lambda}_{128nm}$ and ${\lambda}_{727nm}$ in the applied voltage with a sine waveform were almost two times as in DC voltage type. The shorter the switching time of applied voltage was, the more the light emissions of ${\lambda}_{128nm}$ and ${\lambda}_{727nm}$ were. We discussed the power consumption and Joule heating by charged particles.

• Bulletin of the Korean Chemical Society
• /
• v.35 no.5
• /
• pp.1465-1468
• /
• 2014

In this study, an intermediate temperature ionic conductor, $Ce_{0.95}Eu_{0.05}P_2O_7$, was prepared by solid state reaction. The variation of conductivities with the pressure $pH_2O$ or time were studied. The highest conductivity of $Ce_{0.95}Eu_{0.05}P_2O_7$ sample was observed in dry air atmosphere at $300^{\circ}C$ to be $1.1{\times}10^{-4}S{\cdot}cm^{-1}$ and in wet air atmosphere ($pH_2O=7.4{\times}10^3Pa$) at $100^{\circ}C$ to be $1.4{\times}10^{-3}S{\cdot}cm^{-1}$, respectively. The log ${\sigma}$ ~ log ($pO_2$) plot result indicated that $Ce_{0.95}Eu_{0.05}P_2O_7$ was almost a pure ionic conductor under high oxygen partial pressure and a mixed conductor of ion and electron under low oxygen partial pressure.