• International Journal of Fuzzy Logic and Intelligent Systems
• /
• 제8권4호
• /
• pp.316-321
• /
• 2008

Advanced computer network technology enables computers to be connected in an open network environment. Despite the growing numbers of security threats to networks, most intrusion detection identifies security attacks mainly by detecting misuse using a set of rules based on past hacking patterns. This pattern matching has a high rate of false positives and can not detect new hacking patterns, which makes it vulnerable to previously unidentified attack patterns and variations in attack and increases false negatives. Intrusion detection and analysis technologies are thus required. This paper investigates the asymmetric costs of false errors to enhance the performances the detection systems. The proposed method utilizes the network model to consider the cost ratio of false errors. By comparing false positive errors with false negative errors, this scheme achieved better performance on the view point of both security and system performance objectives. The results of our empirical experiment show that the network model provides high accuracy in detection. In addition, the simulation results show that effectiveness of anomaly traffic detection is enhanced by considering the costs of false errors.

• Journal of Magnetics
• /
• 제21권2호
• /
• pp.173-178
• /
• 2016

Six-step commutation control widely used in brushless DC (BLDC) motor can be applied to consequent pole permanent magnet (CPPM) belt starter generator (BSG) with trapezoidal back electromotive force (EMF) in the starter state. However, rotor position detection with three Hall sensors in BLDC motor can hardly be employed in CPPM BSG due to asymmetric flux distribution in each pole side of CPPM BSG. This paper presents a low-cost rotor position detection method for CPPM BSG in which six Hall sensors are proposed to be used based on the analysis of flux distribution by 3D FEA. In the method, the six Hall sensors are divided into three groups and two signals in each group are combined through performing logic operations. In addition, offset angle between back EMF and the related Hall signal can be compensated by moving the Hall sensors. Experiments of a 2 kW CPPM BSG prototype have also been performed to verify the proposed method.

• Journal of Microbiology and Biotechnology
• /
• 제16권4호
• /
• pp.647-650
• /
• 2006

D-Psicose 3-epimerase (DPE) catalyzes the interconversion of D-fructose to D-psicose by epimerizing the carbon-3 position. The DPE from Agrobacterium tumefaciens was cloned and expressed in Escherichia coli. The expressed enzyme was purified by affinity chromatography on an IMAC, gel filtration chromatography on a Sephacryl S-300 HR, and anion-exchange chromatography on a RESOURCE Q. The molecular mass of the purified enzyme was estimated to be about 135 kDa by Superdex 200 gel filtration chromatography, corresponding to a homotetramer. The enzyme produced crystals suitable for X-ray diffraction to a $2.0{\AA}$ resolution at 100 K. The crystals were found to belong to the orthorhombic space group $P2_12_12_1$, with unit-cell parameters a=102.4, b=113.0, and $c=131.8{\AA}$. In addition, the calculated packing parameter $(V_m)$ was $2.79{\AA}^3/Da$, the solvent content was 55.92%, and an asymmetric unit consisted of four monomers.

• Journal of Power Electronics
• /
• 제17권6호
• /
• pp.1391-1401
• /
• 2017

In this paper, a secondary resonance half-bridge dc-dc converter with an inductive output filter is presented. The primary side of such a converter utilizes asymmetric pulse width modulation (APWM) to achieve zero-voltage switching (ZVS) of the switches, and clamps the voltage of the switch to the input voltage. In addition, zero current switching (ZCS) of the output diode is achieved by a half-wave rectifier circuit with a filter inductor and a resonant branch in the secondary side of the proposed converter. Thus, the switching losses and diode reverse-recovery losses are eliminated, and the performance of the converter can be improved. Furthermore, an inductive output filter exists in the converter reduce the output current ripple. The operational principle, performance analysis and design equation of this converter are given in this paper. The analysis results show that the output diode voltage stress is independent of the duty cycle, and that the voltage gain is almost linear, similar to that of the isolation Buck-type converter. Finally, a 200V~380V input, 24V/2A output experimental prototype is built to verify the theoretical analysis.

• 국제물리치료학회지
• /
• 제9권4호
• /
• pp.1576-1585
• /
• 2018

Regularly participating in physical activity is known to improve quality of life and body composition in elderly with stroke. However, comparatively less physical activity is performed by the stroke survivors. The factors related to inactivity in elderly female stroke survivors have not been elucidated. Therefore, this study aims to compare the quality of life factors and limb compositions between the active and inactive elderly female stroke survivors. Forty nine subjects between the ages of 65 to 75 years were selected from the KNHANES data between the years 2009 to 2011. In addition, 186 agematched healthy peers were also selected for limb composition comparisons. The subjects were groups based on walking days per week: walkers; 3 days or more, non-walkers; less than 3 days per week. BMI and waist circumference were within the obesity ranges for both the non-walkers and walkers. As results, the trend for greater fat (${\pm}10%$) and lean mass (${\pm}30%$) differences were observed for non-walker and walkers, respectively. Significantly greater reasons for function limitation by stroke and hypertension were reported with significantly greater self-care difficulty was shown by the walkers. In conclusion, elderly female stroke survivals may require customized motivation and continuous support to participate in physical activity regularly.

• 한국추진공학회:학술대회논문집
• /
• 한국추진공학회 2012년도 제38회 춘계학술대회논문집
• /
• pp.110-116
• /
• 2012

사각노즐을 갖는 측추력기의 유동 특성 분석과 성능 예측을 위해 3차원 수치해석을 수행하였다. RANS 기법을 이용하였으며 측추력기의 유량 조절 셔터가 회전하는 각도가 세 가지 경우에 대해 계산을 수행하였다. 셔터의 형상적인 특성으로 인한 내부의 재순환영역을 관찰하였고, 사각 노즐에서의 유동의 비대칭성을 확인하였다. 또한 셔터의 개폐 정도에 따라 노즐 내 유동의 비대칭성이 심화되어 추력이 편향되는 것을 관찰하였다. 셔터가 회전함에 따라 추력이 편향되는 정도와 추력 성능을 예측하고 이론적으로 계산한 추력 값과 비교하였다.

• 한국추진공학회지
• /
• 제17권2호
• /
• pp.63-70
• /
• 2013

사각 노즐을 갖는 측추력기의 유동 특성 분석을 위해 3차원 수치해석을 수행하였다. RANS 기법을 이용하였으며 측추력기의 유량 조절 셔터가 회전하는 각도는 두 가지의 경우에 대해 계산을 수행하였다. 셔터의 형상적인 특성으로 인한 내부의 재순환 영역을 관찰하였고, 사각 노즐에서의 유동의 비대칭성을 확인하였다. 또한 셔터의 개폐 정도에 따라 노즐 내 유동의 비대칭성이 심화되어 추력이 편향되는 것을 관찰하였다. 셔터가 회전함에 따라 추력이 편향되는 정도와 추력 성능을 예측하고 이론적으로 계산한 추력 값과 비교하였다.

• Journal of Power Electronics
• /
• 제19권1호
• /
• pp.119-133
• /
• 2019

Although the dual modulation wave method can solve the low-frequency neutral point potential (NPP) fluctuation problem for three-level neutral point clamped converters, it also increases the switching frequency and limits the zero-sequence voltage. That makes it harmful when dealing with the NPP drift problem if the converter suffers from a long dead time or asymmetric loads. By introducing two degrees of freedom (2-DOF), an NPP control based on a search optimization method can demonstrate its ability to cope with the above mentioned two types of NPP problems. However, the amount of calculations for obtaining an optimal 2-DOF is so large that the method cannot be applied to certain industrial applications with an inexpensive digital signal processor. In this paper, a novel optimal 2-DOF-based NPP control is proposed. The relationships between the NPP and the 2-DOF are analyzed and a method for directly determining the optimal 2-DOF is also discussed. Using a direct calculation method, the amount of calculations is significantly reduced. In addition, the proposed method is able to maintain the strongest control ability for the two types of NPP problems. Finally, some experimental results are given to confirm the validity and feasibility of the proposed method.

• 정보보호학회논문지
• /
• 제9권2호
• /
• pp.49-60
• /
• 1999

IC 카드의 하드웨어적인 제약으로 대부분의 IC 카드는 대칭키 알고리즘을 사용하고 있지만 IC 카드 하드웨어 제조 기술의 발전으로 앞으로는 보안성이 우수한 비대 칭키 알고리즘이 많이 사용될 것이다. 그리고 IC 카드의 가장 큰 제약적 중 하나는 메모리 용량의 한계이다. 따라서 보안상 안전하면서도 메모리를 적게 사용하는 IC 카드 운영체제의 구현을 중요한 문제이다. 그래서 본 논문에서는 다양한 종류의 키 알고리즘을 수용할 수 있는 키 파일 탐색 기법을 제안하였다. 또한 데이터 파일 헤더에 잠금 필드를 삽입하여 보안성을 향상시켰으며 메모리 사용량을 줄일 수 있도록 데이터 파일 헤더만을 이용한 파일 탐색 기법과 자유 공간 탐색 기법을 제안하였다. Because of the evolution of IC card hardware fabrication technologies IC card will be able to accept asymmetric key encryption algorithm in the future. One of the most restrictive points of IC card is memory capacity. Therefore it is an important problem to design a secure IC card operating system using memory in small. In this paper we proposed a key file search mechanism using a key length field inserted in a key file header structure. The key file search mechanism makes IC card execute any key-based encryption algorithm. In addition we proposed inserting a lock field in data file header structure. The lock field intensifies the security of a data file. Finally we proposed a data file search mechanism and free space search mechanism using only data file header. The file system using these mechanisms spends smaller memory than that using a file description table and record of unallocated space.

• Geomechanics and Engineering
• /
• 제32권4호
• /
• pp.453-462
• /
• 2023

Designing pile foundations subjected to the uplift forces such as buildings, oil platforms, and anchors is becoming increasingly concerned. In this paper, the conceptual design of a new type of driven piles called expanding pile is presented and assessed. Some grooves have been created in the shaft of the novel pile, and some moveable arms have been designed at the pile tip. At first, static analyses using the finite element method were performed to evaluate the effectiveness of the innovative pile on the axial bearing capacity. Then its effect on seismic behavior of moment frame is considered. Results show that the expanding arms were provided an ideal anchorage system because of the soil's noticeable locking-up effect increasing uplift bearing capacity. For example at the end of the static tensile loading procedure, displacement decrement up to 55 percent is observed. In addition, comparing the uplift bearing capacity of the usual and new pile with different lengths in sand and clay layers shows noticeable effect and sharp increase up to about two times especially in longer piles. Besides, a sensible reduction in the seismic response and the stresses in the beam-column connection between 23-36 percent are achieved that ensures better seismic behavior of the structures.