• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.31 no.10A
• /
• pp.952-959
• /
• 2006

In this paper, 2-D RAKE receiver simulator is made which beamforming technique is applied to in WCI)MA uplink basestation, and the performance is compared with that of 1-D RAKE receiver with varying the number of array elements, RAKE fingers and users. To model angular component of received signal and interfering signals due to multiple access, it is assumed that multiple users are located in the arbitrary direction of the same distance far from the basestation within a sector of the cell, and the channel simulator is made by using Geometry Based Single Bounce Elliptical Model(GBSBEM) suggested by Rappaport. BER performance is compared and analyzed with the various choise of the number of array elements, the number of RAKE fingers, the number of users and Eb/No. These results indicate that increasing the number of array elements eliminates efficiently multiple access interfering signals and improves dramatically BER performance.

• Journal of Positioning, Navigation, and Timing
• /
• v.6 no.2
• /
• pp.43-51
• /
• 2017

In this study, the effect of the steering vector model mismatch due to array uncertainties on the performance of array processing was analyzed through simulation, along with the alleviation of the model mismatch effect depending on array calibration. To increase the reliability of the simulation results, the actual steering vector of the array antenna obtained by electromagnetic simulation was used along with the Jahn's channel model, which is an experimental channel model. Based on the analysis of the power spectrum for each direction, beam pattern, and the signal-to-interference-plus-noise ratio of the beamformer output, the performance deterioration of array processing due to array uncertainties was examined, and the performance improvement of array processing through array calibration was also examined.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.20 no.1
• /
• pp.52-59
• /
• 2009

In modern radars, dynamic range requirements far severed due to high CNR(Clutter-to-Noise Ratio) environment operation scenario. ADC spurious signal restricted the required dynamic range. In this paper, receiver gain of active phased array radar dependent on ADC nonlinear characteristic was analyzed. Within limited scope of ADC SFDR which blocks required system dynamic range, ADC dynamic range reaches trade-off with ADC SNR loss. Comparing antenna stage output noise voltage to that of ADC input, receiver gain was mathematically analyzed. Finally the whole contents were explained from the application example.

• Journal of The Korean Astronomical Society
• /
• v.40 no.4
• /
• pp.133-135
• /
• 2007

A survey project of TRAO with the fifteen beam array receiver system is presented. A multibeam array receiver system has been purchased from FCRAO, and is being installed on TRAO 14m telescope. The target region of the survey is from ${\iota}=120^{\circ}{\sim}137^{\circ},\;b=-1^{\circ}{\sim}+ 1^{\circ}$, and velocity resolution would be 1 km/sec after smoothing from the original resolution of $0.64km\;s^{-1}$ in the transition of J = 1-0 of $^{13}CO$. The survey region is a part of the $^{12}CO$ Outer Galaxy Survey(OGS), and would be an extension of the Bell Laboratories $^{13}CO$ Galactic Plane Survey. By combining with the existing $^{12}CO$ database of the Outer Galaxy Survey, we will derive physical properties of identified molecular clouds and will conduct and statistical analysis of the Outer Galalxy molecular clouds. Reduction process and analysis methods will be introduced.

• Journal of Korea Multimedia Society
• /
• v.5 no.5
• /
• pp.582-589
• /
• 2002

In this paper, we propose a new method that combines antenna array, which employs any beamforming algorithm, and successive interference cancelling multiuser detector which improves the performance of the receiver and analyse its performance. Antenna away receivers can improve the performance by spatially discriminating among the users and reducing the multiple access interference. But the performance of the receivers degrades when the difference of the direction of arrival of the users are too small. Many interference cancelling multiuser detectors have been suggested for DS/CDMA systems which have low complexity for their performance. In this paper, we show how to mitigate such a degradation by combining successive interference cancelling multiuser detector.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.21 no.12
• /
• pp.1335-1342
• /
• 2010

This paper presents design and measurement result of S-band, $\bigcirc$ kW solid-state transmitter and receiver for active array radar system. Transmitter characteristics show 63 dB gain, 200 usec pulse width(max.), 10 % duty(max.) and 63 dB pulse to pulse stability. Receiver characteristics show 23 dB gain and 3.2 dB noise figure. Receiving mode for pulse network analyzer is used for pulse to pulse stability measurement. Measurement results satisfies all specification.

• Proceedings of the KSR Conference
• /
• 2005.11a
• /
• pp.412-417
• /
• 2005

To ensure the safety of the tunnelling without the loss of economy, the tunnel seismic profiling(TSP) method for the prediction ahead of tunnel face, begins to be used routinely in these days. TSP method does not interfere the tunnelling works while the horizontal drilling does, and its prediction length is longer than that of the drilling. Yet the most frequently adopted technique of TSP in Korea is the multi-shot and 2 receiver array using in-hole receivers, even though this array requires as many as 26 drill-holes for receiver installation and ballasting, which results in 3-6 hours of suspension in excavation work. In this paper, multi-receiver and lesser shot array using side-wall attached 3 component geophones is to be described to prove the efficiency in terms of the survey time as well as the reliability of the method by comparison of the predicted weak points and the face mapping results. The predictions mostly agreed with the real fractures or joint developed zones which have been confirmed during the excavation. It also has been found that TSP method can be effectively applied to perform draining ground water ahead of tunnel face by imaging the geologic discontinuities.

• Journal of electromagnetic engineering and science
• /
• v.6 no.2
• /
• pp.110-116
• /
• 2006

A reflective array type surface acoustic wave(SAW) dispersive delay line(DDL) with high time-bandwidth at the V/UHF-band is designed and fabricated for compressive receiver applications. This type of the SAW DDL has the properties of the relative bandwidth of 20 %, the time delay of 49.89 usec, the insertion loss of 38.5 dB and the side lobe rejection of 39 dB. In comparison with a commercial SAW DDL, the insertion loss, amplitude ripple and side lobe rejection are improved by $1.5dB{\pm}0.6dB$ and 4 dB respectively. Using the fabricated SAW DDL, the prototype of the compressive receiver is developed. It is composed of RF converter, fast tunable LO, chirp LO, A/D converter, signal processing unit and control unit. This prototype system shows a fine frequency resolution of below 30 kHz with high scan rate.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.23 no.10
• /
• pp.1188-1195
• /
• 2012

The trend for the development of radar is the active phased-array radar system. The trade-off between the processing speed and the number of the signal process board for the real time signal processing has to be optimized particularly in multichannel radar system. This paper introduces a transmission technique in order to transmit a large amount of received data from an Antenna Part to Signal Process Part. As a result, the number of the S/L board(COTS board) is reduced to one half, and the margin of the data transmission rate is about 2 times higher than the original method.

• The Journal of the Korea institute of electronic communication sciences
• /
• v.15 no.5
• /
• pp.849-856
• /
• 2020

The Angle-of-Arrival(AOA) information for an array antenna receiver is one of the important factors for estimating the location of specific signals and detecting signals efficiently, in various situations. The AOA estimator in the satellite environment can rapidly calculate the AOA information in the wide area, utilizing a planar (grid, circular) array antenna mounted on the satellite. Since the satellite receiver has the limitation of the array antenna size, the concentric circular (ring) array (CCA or CRA) antenna structure with comparatively small size but with multiple antenna elements is more efficient than the uniform circular array (UCA) structure, for the satellite environment. In this paper, we introduce a cascade AOA estimation algorithm based on CRA, consisting of CAPON and Beamspace MUSIC. In addition, we provide computer simulation examples for verifying the estimation performance of the cascade AOA estimation algorithm based on CRA and compare it to the case of UCA.