• Progress in Medical Physics
• /
• v.27 no.1
• /
• pp.37-45
• /
• 2016

In proton therapy, in vivo proton beam range verification is very important to deliver conformal dose to the target volume and minimize unnecessary dose to normal tissue. For this purpose, a multi-slit prompt-gamma camera module made of 24 scintillation detectors and 24-channel signal processing system is under development. In the present study, we have developed and tested a dual-mode signal processing system, which can operate in the energy calibration mode and the fast data acquisition mode, to process the signals from the 24 scintillation detectors. As a result of performance test, using the energy calibration mode, we were able to perform energy calibration for the 24 scintillation detectors at the same time and determine the discrimination levels for the detector channels. Further, using the fast data acquisition mode, we were able to measure a prompt-gamma distribution induced by a 45 MeV proton beam. The measured prompt gamma distribution was found similar to the proton dose distribution at the distal fall-off region, and the estimated beam range was $17.13{\pm}0.76mm$, which is close to the proton beam range of 16.15 mm measured by an EBT film.

• IEMEK Journal of Embedded Systems and Applications
• /
• v.7 no.6
• /
• pp.339-343
• /
• 2012

Security and monitoring system has many applications and commonly used for detection, warning, alarm, etc. As the networking technology advances, user requirements are getting higher. An intelligent and cooperative surveillance system is proposed to meet current user demands and improve the performance. This paper focuses on the implementation issue for the embedded intelligent surveillance system. To cover wide area cooperative function is implemented and connected by wireless sensor network technology. Also to improve the performance lots of sensors are employed into the surveillance system to reduce the error but improve the detection probability. The proposed surveillance system is composed of vision sensor (camera), mic array sensor, PIR sensor, etc. Between the sensors, data is transferred by IEEE 802.11s or Zigbee protocol. We deployed a private network for the sensors and multiple gateways for better data throughput. The developed system is targeted to the traffic accident detection and alarm. However, its application can be easily changed to others by just changing software algorithm in a DSP chip.

• Wind and Structures
• /
• v.21 no.1
• /
• pp.25-40
• /
• 2015

Oscillating motions of flexible cylinders are associated to some extent with the aerodynamic response of plants. Tandem motions of reeds with flexible stems in a colony are experimentally investigated using an array of flexible cylinders made of polydimethylsiloxane (PDMS). Consecutive images of flexible cylinders subjected to oncoming wind are recorded with a high-speed camera. To quantify oscillating motions, the average bending angle and displacement of flexible cylinders are evaluated using point-tracking method and spectral analysis. The tandem motions of flexible cylinders are closely related to the flow characteristics around the cylinders. Thus, the dynamic motions of a tandem arrangement of flexible cylinders are investigated with varying numbers of cylinders arranged in-line, numbers of cylinders in a group (behaving like a single body), and Reynolds numbers (Re). When the number of cylinders in a group increases, the damping effect caused by the support of downstream cylinders is pronounced. These results would be provide useful information on the tandem-arranged design of complex structures and energy harvesting devices.

• Proceedings of the Korea Committee for Ocean Resources and Engineering Conference
• /
• 2001.10a
• /
• pp.190-195
• /
• 2001

Flow patterns are very complex and interactive between cylinders. The patterns are turbulent and non-linear caused by various factors. In this paper, flow patterns and pressure gradient around vertical cylinders were investigated by experiment. Changing gaps between cylinders the flow patterns are measured at a fixed coming velocity. Flow patterns showed very complex and closely related to the coming velocity and cylinder space. The pressure gradient around the flow field is observed by twelve hole pitot tubes and manometer. The experiment has been conducted in circulating water channel with PIV system. That can visualize flow patterns. The laser beam was used to reflect the image from particles and recorded by CCD camera. The cylinders were spaced from ID to 5D with 0.5m/sec of incoming flow velocity. The experimental results using pitot tube showed in good agreement with results of precious by others study. The results can be applied in the understanding and design of multiple pile array structures.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.39A no.12
• /
• pp.699-707
• /
• 2014

Recently, the communication between LED array and camera, called Visual-MIMO, is under active research and we expect the maximization of application to the vehicle as well as smart-phone. In this paper, we improve the BER performance of Visual-MIMO system by using the brightness information of a received image. We also suggest the error correction method to minimize the error due to Inter-Symbol-Interference. The performance analysis according to the noise and distance variation will verify the validity of our proposed method including results through simulation and hardware experiment.

• Proceedings of the KSME Conference
• /
• 2003.04a
• /
• pp.1491-1498
• /
• 2003

Droplet evaporation can be used to transfer large amounts of energy since heat is transferred across a thin liquid film. Spreading the drop over a larger area can enhance this heat transfer. One method of accomplishing this is to dissolve gas into the liquid. When the drop strikes the surface, a gas bubble nucleates and can grow and merge within the liquid, resulting in an increase in the droplet diameter. In this study, time and space resolved heat transfer characteristics for a single droplet striking a heated surface were experimentally investigated. The local wall heat flux and temperature measurements were provided by a novel experimental technique in which 96 individually controlled heaters were used to map the heat transfer coefficient contour on the surface. A high-speed digital video camera was used to simultaneously record images of the drop from below. The measurements to date indicate that significantly smaller droplet evaporation times can be achieved. The splat diameter was observed to increase with time just after the initial transient dies out due to the growth of the bubble, in contrast to a monotonically decreasing splat diameter for the case of no bubbles. Bursting of the bubble corresponded to a sudden decrease in droplet heat transfer.

• Journal of the Institute of Electronics Engineers of Korea CI
• /
• v.40 no.2
• /
• pp.17-25
• /
• 2003

In this paper, a processor architecture is proposed based on the state space implementation technique for real time processing of 2-D discrete wavelet transform(DWT). It conducts 2-D DWT operations in consideration of row and column direction simultaneously, thus can reduce latency due to memory access for storing intermediate results. It is a VLSI architecture suitable for real time processing. The proposed architecture includes only four multipliers and four adders, and NK-N internal memory storage, where K denotes the length of filter. It has a small hardware complexity. Therefore it is very suitable architecture for real time, embedded applications such as web camera server. Since the processor is easily extended to array structure, it can be applied to various image processing applications.

• KSII Transactions on Internet and Information Systems (TIIS)
• /
• v.9 no.12
• /
• pp.5087-5102
• /
• 2015

Rapid popularization of smart cell phone equipped with camera has led to a number of new legal and criminal problems related to multimedia such as digital image, which makes cell phone source identification an important branch of digital image forensics. This paper proposes a classifier combination based source identification strategy for cell phone images. To identify the outlier cell phone models of the training sets in multi-class classifier, a one-class classifier is orderly used in the framework. Feature vectors including color filter array (CFA) interpolation coefficients estimation and multi-feature fusion is employed to verify the effectiveness of the classifier combination strategy. Experimental results demonstrate that for different feature sets, our method presents high accuracy of source identification both for the cell phone in the training sets and the outliers.

• Journal of information and communication convergence engineering
• /
• v.13 no.4
• /
• pp.275-279
• /
• 2015

There are several methods to record three dimensional (3D) information of objects such as lens array based integral imaging, synthetic aperture integral imaging (SAII), computer synthesized integral imaging (CSII), axially distributed image sensing (ADS), and axially distributed stereo image sensing (ADSS). ADSS method is capable of recording partially occluded 3D objects and reconstructing high-resolution slice plane images. In this paper, we present a computational method for depth extraction of partially occluded 3D objects using ADSS. In the proposed method, the high resolution elemental stereo image pairs are recorded by simply moving the stereo camera along the optical axis and the recorded elemental image pairs are used to reconstruct 3D slice images using the computational reconstruction algorithm. To extract depth information of partially occluded 3D object, we utilize the edge enhancement and simple block matching algorithm between two reconstructed slice image pair. To demonstrate the proposed method, we carry out the preliminary experiments and the results are presented.

• KSII Transactions on Internet and Information Systems (TIIS)
• /
• v.4 no.4
• /
• pp.633-654
• /
• 2010

High quality camera images, with good contrast and intensity, are needed to obtain the desired information. Images need to be enhanced when they are dark or bright. The histogram equalization technique, which flattens the density distribution of an image, has been widely used to enhance image contrast due to its effectiveness and simplicity. This technique, however, cannot be used to enhance images that are either too dark or too bright. In addition, it is difficult to perform histogram equalization in real-time using a general-purpose computer. This paper proposes a histogram equalization technique with AGC (Automatic Gain Control) to extend the image enhancement range. It is designed using VHDL (VHSIC Hardware Description Language) to enhance images in real-time. The system is implemented with an FPGA (Field Programmable Gate Array). An image processing system with this FPGA is implemented. The performance of this image processing system is measured.