• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.20 no.1
• /
• pp.37-44
• /
• 2009

In this paper, a TRS band(Trunked Radio System: $806{\sim}866\;MHz$) array antenna has a good front-to-back ratio characteristics for the mobile communication base station is proposed. The proposed array antenna is composed of the $5{\times}3$ radiated elements which are the microstrip dipole antennas with the cavity-backed reflector. For the validity of the proposed antenna, the $5{\times}3$ array antenna is designed, fabricated, and its radiation characteristics are measured. As a result of measurements, the antenna gain is over 13.3 dBi and the front-to-back ratio is over 40 dB at the useable frequency band. We confirm that the designed antenna can be used as the mobile communication base station antenna with the excellent back lobe characteristics.

• Journal of the Institute of Electronics and Information Engineers
• /
• v.54 no.3
• /
• pp.10-14
• /
• 2017

A reverberation chamber is widely used in mobile handset measurements due to its faster and simpler measurement process compared to traditional anechoic chambers. We propose an ultra-wideband inverse conical antenna design suitable as a reference antenna in a reverberation chamber. Traditionally, multiple discone antennas are needed to cover more than 10:1 operation bandwidth of a reverberation chamber. The proposed inverse conical antenna offers wideband impedance matching bandwidth by virtue of the linear impedance transition along its oblique side. The antenna is feasible to mount on the conductive walls which can be utilized as a ground to improve the matching bandwidth, antenna gain and radiation patterns. The antenna geometry is optimized using a 3D electromagnetic simulation tool and fabricated using a 3D printer. The measured results show that the antenna reflection coefficient lower than -10dB and radiation efficiency more than 70% at the frequency range of 0.65~7 GHz.

• Journal of Institute of Control, Robotics and Systems
• /
• v.3 no.6
• /
• pp.602-612
• /
• 1997

With GPS carrier phase measurements from more than two antenna which attached to the vehicle, precise attitude can be easily obtained if the integer ambiguity included in carrier phase measurement is resolved. Recently some special products which use dual frequencies or has one receiver engine with multiple antenna are announced. But there are still strong requirements for the conventional single frequency off-the-shelf receiver. To meet these requirements, an efficient integer ambiguity resolution technique is indispensable. In this paper, a new technique to resolve integer imbiguity with single frequency receivers is proposed. The proposed method utilize the known baseline length as a constraint of independent elements of integer ambiguities. With this constraints, the size of search volume can be greatly reduced. Thus the true integer ambiguity can be easily determined with less computational burden and number of measurements. The proposed method is applied to real data to show its effectiveness.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.15 no.11
• /
• pp.1051-1061
• /
• 2004

In this Paper, a new antenna(VHMDA) characteristics of half-circular/elliptical disc-loaded planar antennas with horizontally top-loaded small disc is studied by simulation and measurements with additional resonant structure. The transfer function characteristics of Gaussian pulse from the designed UWB transmitter antenna has been investigated. The radiation pattern of the proposed antenna in azimuth is nearly omni-directional response, which is usulally required in conventional monopole antenna. In addition to that, the simulation and measured results show that the return loss characteristics of VHDMA covers considerably large bandwidth with small area. From the measured results of the circular and half-circular disc-loaded monopole antennas with small disc mounted on the top, it is found that the half disc-loaded monopole antenna with additional structure can be comparable to the circular disc-loaded monopole antenna in respect o( size and electrical performances. Surface wave and dielectric losses often caused by the printed antenna using high dielectric constant does not occur in metallic planar antenna with good impedance matching and without lossy matching unit. This structure implies that the performance of return loss is directly related with the radiation efficiency.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.20 no.11
• /
• pp.1194-1200
• /
• 2009

An internal antenna which has 1 cc volume was implemented on the FPCB(Flexible Printed Circuit Board) for the mobile phone. We increased antenna gain and efficiency by the applying of current direction concept on the antenna pattern for this small antenna. Short antenna length for the GSM band was compensated by the spiral inductor on the FPCB. For broadening bandwidth on GSM band, it's applied 2 spiral inductors. A conductor pattern for the DCS band was positioned perpendicular with the FPCB. Antenna was implemented on FPCB that is dielectric constant 4.4 and thickness 0.05 mm, and FPCB was attached on a carrier dimensioned $L{\times}W{\times}H=30{\times}7{\times}5\;mm$. Measurements showed that max. VSWR 2:1, efficiency 42.49~60.95 % and 47.95~73.21 %, average gain -3.72~-2.15 dBi and -3.19~-1.35 dBi on the GSM and DCS band, respectively. These results are good performances among the small antenna. And the radiation patterns are omnidirectional on the H-plane to both band.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.22 no.12
• /
• pp.1180-1183
• /
• 2011

In this paper, we present a design of AEM radome with frequency selective surface using unit-cell EM simulation method and verified the performance of AEM radome by the radiation pattern measurements of $16{\times}16$ array-antenna. Measured results under near-field condition showed a good agreement with the simulation and far-field measured ones. And there were no radiation pattern variation between antenna only and antenna with AEM radome. From these results, we verified that AEM radome with frequency selective surface can be a solution to reduce the RCS of conventional mast and radar.

• ETRI Journal
• /
• v.35 no.1
• /
• pp.51-57
• /
• 2013

In this paper, a small internal antenna for a mobile handset is presented using multiband, wideband, and high-isolation multiple-input multiple-output techniques. The proposed antenna consists of three planar inverted-F antennas (PIFAs) that operate in the global system for mobile communication (GSM900), the digital communication system (DCS), the personal communication system (PCS), the universal mobile telecommunication system (UMTS), and wireless local area network (WLAN) bands with a physical size of $40mm{\times}10mm{\times}10mm$. A resonator attached to the folded PIFA creates dual resonances, achieving a wide bandwidth of approximately 460 MHz, covering the DCS, PCS, and UMTS bands; a meander shorting line is used to improve impedance matching. Additionally, a modified neutralization link is embedded between diversity antennas to enhance isolation, which results in a 6-dB improvement in the isolation and less than 0.1 in the envelope correlation coefficient evaluated from the far-field radiation patterns. Simulation and measurements demonstrate very similar results for S-parameters and radiation patterns. Peak gains show 3.73 dBi, 3.77 dBi, 3.28 dBi, 2.15 dBi, and 5.86 dBi, and antenna efficiencies show 56.15%, 72.15%, 68.59%, 52.92%, and 82.93% for GSM900, DCS, PCS, UMTS, and WLAN bands, respectively.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.12 no.6
• /
• pp.983-993
• /
• 2001

This paper proposed a novel chip type ceramic dielectric antenna by using the advanced meander line technique that the radiational metals are formed on the face of ceramic dielectric(8$\times$4$\times$1.5 mm, alumina) and both faces of substrate(1.0 mm thickness, FR-4). The performance of the antenna model has a good agreements between measurements and computed results. Resultly, it has a 10 dB return-loss bandwidth(2.4∼2.4835 GHz) and 1.7 dBi measured radiation gain for Bluetooth application. The proposed antenna model can overcome the limited radiation of the small-sized antenna.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.13 no.9
• /
• pp.873-881
• /
• 2002

In this paper, the rectangular reflector antenna with 8-dipole array for PCS band (1,750 MHz ~ l,870 MHz) and IMT-2000 band(1,885 MHz ~ 2,200 MHz) is designed and the radiation characteristics are analyzed using the method of moments and HFSS(High Frequency Structure Simulator). To verify the analysis results, rectangular reflector antenna with 8-dipole array is fabricated and the calculated results are compared with the measured results. The measured results show good agreement with the calculated results. As a result of measurements, bandwidth(VSWR< 1.5) of 450 MHz is achieved at PCS and IMT-2000 band and gain is 16 dBi. The designed antenna can be used as the base station antenna for PCS/IMT-2000.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.12 no.5
• /
• pp.713-721
• /
• 2001

In this paper, parasitic patches gap-coupled microstrip antenna and stacked microstrip patch antenna combined with parallel coupled lines, which are a kind of wideband impedance matching network, are proposed to get the wider bandwidth. The iterative method using a distributed network is proposed to design the parallel coupled lines as a wideband impedance matching network. Measurements show that the proposed antennas provide wider bandwidths ~1.6 times and ~1.5 times those of conventional parasitic gap-coupled microstrip patch antenna and stacked microstrip patch antenna. In addition, measured radiation patterns show no serious variation of radiation patterns though the parallel coupled lines is added. The antenna gain is, however, lowered about 1 dB and 0.5 dB by the coupling loss in the parallel coupled lines.