• Clinical and Experimental Reproductive Medicine
• /
• 제38권3호
• /
• pp.142-147
• /
• 2011

Objective: This study was performed to evaluate testicular sperm chromatin condensation using aniline blue-eosin (AB-E) staining and its effects on IVF-ET. Methods: Chromatin condensation was analyzed using AB-E staining in 27 cases of testicular sperm extraction. There were 19 cases of obstructive azoospermia (OA) and 8 cases of non-obstructive azoospermia (NOA) in IVF-ET. Mature sperm heads were stained red-pink whereas immature sperm heads were stained dark blue. The percentage of sperm chromatin condensation was calculated from the ratio of the number of red-pink sperm to the total number of sperm analyzed. Results: The overall percentages of chromatin condensation in OA and NOA were $31.1{\pm}11.2%$ and $26.3{\pm}14.4%$, respectively. The fertilization rate was significant higher in OA than NOA ($p$ <0.05); however, the rates of good embryos and clinical pregnancy did not show statistical differences. In OA and NOA, statistical differences were not observed in the rate of chromatin condensation, fertilization, good embryos, and clinical pregnancy between the pregnant group and non-pregnant group. Conclusion: Chromatin condensation is less stable than OA and showed a low fertilization rate in NOA. While there were no significant differences in chromatin condensation results between NOA and OA, we propose that a pattern of decreased chromatin condensation in NOA is one of the factors of low fertilization results requiring further study.

• 한국재료학회:학술대회논문집
• /
• 한국재료학회 2003년도 추계학술발표강연 및 논문개요집
• /
• pp.30-30
• /
• 2003

• 대한금속재료학회지
• /
• 제56권12호
• /
• pp.900-909
• /
• 2018

A $ZnO/TiO_2$ photocatalyst decorated with PbS quantum dots (QDs) was synthesized to achieve high photocatalytic efficiency for the decomposition of dye in aqueous media. A $TiO_2$ porous layer, as a precursor photocatalyst, was fabricated using micro-arc oxidation, and exhibited irregular porous cells with anatase and rutile crystalline structures. Then, a ZnO-deposited $TiO_2$ catalyst was fabricated using a zinc acetate solution, and PbS QDs were uniformly deposited on the surface of the $ZnO/TiO_2$ photocatalyst using the successive ionic layer adsorption and reaction (SILAR) technique. For the PbS $QDs/ZnO/TiO_2$ photocatalyst, ZnO and PbS nanoparticles are uniformly precipitated on the $TiO_2$ surface. However, the diameters of the PbS particles were very fine, and their shape and distribution were relatively more homogeneous compared to the ZnO particles on the $TiO_2$ surface. The PbS QDs on the $TiO_2$ surface can induce changes in band gap energy due to the quantum confinement effect. The effective band gap of the PbS QDs was calculated to be 1.43 eV. To evaluate their photocatalytic properties, Aniline blue decomposition tests were performed. The presence of ZnO and PbS nanoparticles on the $TiO_2$ catalysts enhanced photoactivity by improving the absorption of visible light. The PbS $QDs/ZnO/TiO_2$ heterojunction photocatalyst showed a higher Aniline blue decomposition rate and photocatalytic activity, due to the quantum size effect of the PbS nanoparticles, and the more efficient transport of charge carriers.

• 한국분말재료학회지
• /
• 제11권2호
• /
• pp.143-148
• /
• 2004

In the present study, $TiO_2$ imbedded composite powders have been successfully prepared from the (Cu. Zn)/$TiO_2$ composite salt solution. The composite (Cu, Zn)/$TiO_2$ powders were formed by drying the solution at 200~$600^{\circ}C$ in the hydrogen atmosphere. Photocatalytic characteristics was evaluated by detecting the decomposition ratio of aniline blue with UV-visible spectrophotometer(Shimazu Co., UV-1601). Phase analysis of (Cu, Zn)/$TiO_2$ composite powders was carried out by XRD and DSC, and powder size was measured with TEM. The mean particle size of composite powders was about 100mm. As the reduction temperature increases, a few zinc sulfide and oxide phases was formed and copper oxide phase was reduced. The decomposition ratio of aniline blue was about 80％ under the UV irradiation by the TiO$_2$ phase in the composite (Cu, Zn)/$TiO_2$ powders and similar decomposition ratio of 80％ was obtained at the UV lightless condition by virtue of Cu and Zn compounds.

• 한국미생물·생명공학회지
• /
• 제18권1호
• /
• pp.71-75
• /
• 1990

B.longum TK-100 및 L.acidophilus TK-2070으로 혼합배양한 culture로 제조한 요쿠르트는 냉장상태에서도 산생성이 되었느데 이는 B.longum TK-100에 의한 것보다는 대수기의 L.acidophilus TK-2070에 의하여 거의 생성되었다. B.longum TK-100은 편성 혐기조건 뿐만아니라 통성혐기조건에서도 생육이 좋은 것으로 나타냈다. 또한, B.longum과 L.acidophilus는 냉장보존 중인 요쿠르트 내에서도 생존도가 양호하므로 발효유의 제조, 개발에 혼합 starter로서의 이용이 가능하다고 하겠다. 한편 aniline bule 0.1가 함유된 RCAM plate상에 나타난 B.longum TK-100의 colony는 직경이 약 2mm의 광택있는 회배색의 중심에 청색을 나타내었고, L.acidophilus TK-2070의 coiny는 직경이 약 1mm 의 회배색을 나타내어 쉽게 분별할 수 있다.

• 대한임상독성학회지
• /
• 제8권1호
• /
• pp.1-6
• /
• 2010

Methylene blue is a very effective reducer of drug-induced methemoglobinemia. It has dose-dependent oxidation or reduction properties. In most cases, a dose of 1 to 2 mg/kg IV given over 5 minutes and immediately followed by a 15- to 30-mL fluid flush to minimize the local pain is both effective and relatively safe. The onset of action is quite rapid, and the effects are usually seen within 30 minutes. The dose may be repeated after 30 to 60 minutes and then every 2 to 4 hours as needed. The total dose should not exceed 7 mg/kg as a single dose or 15 mg/kg within 24 hours. Repeated treatment may be needed for treating compounds that have prolonged elimination or those compounds that undergo enterohepatic recirculation (e.g., dapsone). Methylene blue can cause dose-related toxicity. At high doses, methylene blue can also induce an acute hemolytic anemia and rebound methemoglobinemia. The reasons for treatment failure with methylene blue include ineffective GI decontamination, the existence of other forms of hemoglobin (e.g., sulfhemoglobin), a low or high dose of methylene blue and the toxicokinetics of some agents, such as aniline, benzocaine or dapsone.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 2005년도 하계학술대회 논문집 Vol.6
• /
• pp.473-474
• /
• 2005

Blue-emitting polymers containing carbazole units In main chains were synthesized by palladium catalyzed polycondensation of aniline with dibromo-substituted monomers such as 3,6-dibromocarbazole, N-(2-ethylhexyl)-3,6-dibromocarbazole, and bis[6-bromo-N-(2-ethylhexyl)-carbazole-3-yl], respectively. All synthesized polymers exhibited relatively good solubility in common organic solvents, considerable molecular weights and high resistance to thermal degradation. From UV-Vis absorption and photoluminescence (PL) spectra of these solution-processable polymers, $\lambda_{max,UV}$ were in the range of 290 ~ 340 nm and $\lambda_{max,PL}$ were in the blue emission range of 440 ~ 478 nm, The polymers had HOMO energy (-5.19 ~ -5.64 eV) and wide band gap energy (2,91 - 3.42 eV).

• 분석과학
• /
• 제14권1호
• /
• pp.15-20
• /
• 2001

광촉매 특성을 지닌 $TiO_2$ 피막을 인가 전압 180 V에서 양극산화법을 이용하여 제조하고, 산화조건에 따른 구조적 차이에 대하여 조사하였다. 황산 및 황산+과산화수소 용액의 경우 $TiO_2$의 구조가 rutile과 anatase형이 혼합된 형태를 지녔으나, 황산+인산 및 황산+인산+과산화수소 혼합용액의 경우에는 대부분 anatase형의 $TiO_2$가 제조되었음을 알 수 있었다. 양극산화법에 의해 제조된 $TiO_2$는 모두 광촉매 특성율을 나타냈으며, 아닐린 블루 분해 반응의 경우 모든 산화 조건에서 반응차수가 1로 나타났으며 속도상수값이 거의 유사함을 알 수 있었다.

• 한국재료학회지
• /
• 제11권1호
• /
• pp.61-66
• /
• 2001

양극산화법을 이용하여 광촉매 특성을 나타내는 $TiO_2$ 피막을 제조하고 염료의 분해반응을 통하여 광분해 효율을 조사하였다 양극산화법에 의해 제조된 산화피막은 모두 광촉매 분해특성이 있었으며 양극산화의 조건에 따라서 $TiO_2$ 피막의 성장거동과 피막 형태에 차이가 나타났다. 황산용액에서 양극산화된 $TiO_2$ 피막은 불규칙적 인 입자모양으로 anatase와 rutile이 혼합된 조직이었으며, 인산이 첨가된 혼합용액에서 형성된 $TiO_2$는 anatase로 셀 모양의 피막형태로 생성되었다. 광촉매 특성에 적합한 양극산화의 인가 전압은 180V인 것으로 나타났다.

• 공업화학
• /
• 제10권6호
• /
• pp.934-938
• /
• 1999

가공제의 종류에 따라 구분한 화학적 처리, 일반 효소 처리 및 바이오-테크 처리에 의해 제조된 나피를 이용하여 가공한 아닐린 유형의 유성혁, 크러스트혁과 도장혁의 물성을 조사하였다. 크러스트혁과 도장혁의 물성은 동일하게 나타난 반면 유성혁의 물성은 다른 경향을 보였다. 도장혁의 경우 세가지 처리 방법 모두 $1.2kg_f/mm^2$의 인장 강도, 30%의 신장률, $3.0kg_f/mm$의 인열 강도, $15kg_f$의 은면 균열 하중 및 2.5%의 크롬 함유량 이상을 나타내어 모두 한국산업규격의 물성을 만족하였다. 특히, 바이오-테크 처리시 다른 두 방법보다 혁의 물성이 뚜렷이 향상되었다. 이는 전자 현미경에 의한 혁의 표면 및 단면 검사와 영상 분석에 의한 모공 검사 결과로 잘 설명되어진다.