• Journal of Power Electronics
• /
• 제15권4호
• /
• pp.964-973
• /
• 2015

This paper presents a simple approach for the selective harmonic elimination (SHE) of multilevel inverter based on the transistor-clamped H-bridge (TCHB) family. The SHE modulation is derived from the sinusoidal voltage-angle equal criteria corresponding to the optimized switching angles. The switching angles are computed offline by solving transcendental non-linear equations characterizing the harmonic contents using the Newton-Raphson method to produce an optimum stepped output. Simulation and experimental tests are conducted for verification of the analytical solutions. An Altera DE2 field-programmable gate array (FPGA) board is used as the digital controller device in order to verify the proposed SHE modulation in real-time applications. An analysis of the voltage total harmonic distortion (THD) has been obtained for multiple output voltage cases. In terms of the THD, the results showed that the higher the number of output levels, the lower the THD due to an increase number of harmonic orders being eliminated.

• 한국분무공학회지
• /
• 제14권2호
• /
• pp.59-64
• /
• 2009

These experiments are close examination of spray characteristics that are continuous liquid jet and modulated liquid jet. The experiments were conducted using water, over a range of crossflow velocities from $42{\sim}l36\;m/s$, with modulation frequencies of $35.7{\sim}166.2\;Hz$. Between continuous crossflow jet and modulated cross-flow jet of penetration, breakup point, spray angle and macro spray shape are experimentally investigated with image analysis. In cross-flow field, main parameter of liquid jet for breakup was cross-flow stream rather than modulation effect. As oscillation of the periodic pressure that could make liquid jet moved up and down, the mixing efficiency was increased. Also, a bulk of liquid jet puff was detected at upper field of liquid surface. So, this phenomenon has a good advantage of mixing spray from concentration of center area to outer area. Because of modulation frequency, SMD inclination of the structured layer was evanescent. Cross-sectional characteristics of SMD at downstream area were non-structured distributions. Then cross-sectional characteristics of SMD size were about same tendency over a range that is effect of spray mixing. The tendency of volume flux value for various modulation frequency was same distribution. And volume flux was decreased when the modulation frequency increase.

• 한국정보통신학회논문지
• /
• 제5권2호
• /
• pp.289-296
• /
• 2001

본 논문에서는 뒤틀린 니매틱 액정디스플레이를 가변적인 위상마스크로 사용하여 기존의 2진 데이터 영상에 위상변조를 추가하는 방법을 제안한다 이를 위해 액정디스플레이의 위상변조특성을 이론 및 실험적으로 조사하였고, 입사빔 세기가 매우 커지면 위상변조 특성이 변하는 현상이 존재함을 실험적으로 보였다. 위상변조가 가미된 2진 데이터 영상의 저장특성을 실험적으로 조사하기 위해 여덟 장의 홀로그램을 각다중 을 사용해서 Dupont 사의 광폴리머의 한 지점에 기록하였다. 위상변조를 사용하여 Fourier 면 홀로그램을 기록할 경우, 기존의 진폭변조방식만 사용하는 경우에 비해 빔세기 균일도를 높일 수 있어서, 같은 조건에서 더 많은 홀로그램을 기록할 수 있음을 보였다.

• 대한기계학회:학술대회논문집
• /
• 대한기계학회 2000년도 춘계학술대회논문집A
• /
• pp.556-561
• /
• 2000

This paper deals with the control of an active bending actuator fur a catheter. The bending actuator with 40mm in length utilizes three zigzag SMA (shape memory alloy) springs which are equally located in the circumference between inner $({\phi}2.5 mm)$ and outer $({\phi}3.0mm)$ tube. It is purposed on realization of desired bending angle $(90^{\circ})$ and direction $(360^{\circ})$. It is also installed in front of the catheter and used to guide a path at extremely bent or branched blood vessel. The performance-analysis of the bending actuator are investigated fur the purpose of optimizing the control of the bending actuator. The analog joy stick is used to command a bending angle and direction for the fast and accurate response. According to the commands of the joy stick, tensile force of each SMA spring is computed and obtained by controlling the temperature of each SMA spring using PWM (pulse width modulation) of supplied electric power.

• 대한전기학회논문지
• /
• 제39권7호
• /
• pp.668-679
• /
• 1990

The fully digitalized inveter has some difficulties in implementation because of the limitation of available memory capacity and computation time. This paper describes a new PWM(Pulse Width Modulation) Inverter technique which linearizes switching angle characteristics of SHEPWM(Selected Harmonic Eliminatin Pulse Width Modulation) Inverter. Also the detailed description of the scheme along with the realization is presented. The simulation and experimental results show that the proposed schemes have the advantates such as good voltage waveforms and memory-saving.

• 전력전자학회논문지
• /
• 제13권1호
• /
• pp.22-32
• /
• 2008

본 논문에서는 전철 구동용 견인 전동기의 구동을 위한 과변조 영역에서의 NPC형 3-레벨 인버터의 출력전압 선형화 기법을 제안한다. 과변조 영역은 Modulation Index: MI에 따라서 2가지 모드로 나누었으며 과변조영역 I에서는 퓨리에 시리즈를 통한 기본파성분의 크기로 유도된 reference angle을 사용하였다. 과변조영역 II에서는 과변조영역 I과 같은 방법으로 holding angle을 구하여 사용하였다. 이 두 가지 과변조기법을 통하여 PWM 인버터 출력전압을 1펄스 모드까지 선형적으로 획득할 수 있다.

• Journal of Magnetics
• /
• 제5권4호
• /
• pp.135-138
• /
• 2000

In order to study the effect of the magnetic anisotropy on the giant magnetoresistance in a Co/Cu multilayered system, the angle dependent magnetoresistance (MR) was measured. The experimental results showed that the maximum MR ratio depends on the angle between the direction of the applied field and the easy axis. The angular modulation of the MR ratio can be explained by the alignments of the two 'effective' magnetization vectors that are bound to their own easy axes. Two maxima observed in MR loops at the second antiferromagnetic maximum are discussed in relation to the magnetic anisotropy, The simulated results under the assumption of the existence of two in-plane easy axes in the sample are compared with the experiments.

• 전자통신동향분석
• /
• 제34권2호
• /
• pp.10-18
• /
• 2019

Since the introduction of CRT(Cathode Ray Tube) in the 1950s, display technologies have been developed continuously. Flat panel displays such as PDP(Plasma Display Panel) and LCD(Liquid Crystal Display) were commercialized in the late 1990s, and OLED(Organic Light Emitting Diodes) and Micro-LED(Micro-Light Emitting Diodes) are now being developed and are becoming widespread. In the future, we expect to develop ultra-realistic, flexible, embedded sensor displays. Ultra-realistic display can be applied to AR/VR(Augmented Reality/Virtual Reality) devices and spatial light modulators for holography. The sensor-embedded display can be applied to robots; electronic skin; and security devices, including iris recognition sensors, fingerprint recognition sensors, and tactile sensors. AR/VR technology must be developed to meet technical requirements such as viewing angle, resolution, and refresh rate. Holography requires optical modulation technology that can significantly improve resolution, viewing angle, and modulation method to enable wide-view and high-quality hologram stereoscopic images. For electronic skin, stable mass production technology, large-area arrays, and system integration technologies should be developed.

• 한국자기학회:학술대회 개요집
• /
• 한국자기학회 2000년도 International Symposium on Magnetics The 2000 Fall Conference
• /
• pp.307-314
• /
• 2000

In order to study the effect of the magnetic anisotropy on the giant magnetoresistance (GMR), the angle dependent magnetoresistance (MR) was measured. The experimental results show that the maximum MR ratio depends on the angle between the direction of the applied field and that of the easy axis. The angular modulation of the MR ratio can be explained by the alignments of the two 'effective' magnetization vectors that are bound to their own easy axes. The typical property of MR loops at 2$\^$nd/ antiferromangtic maximum (AFM) such as two maxima was discussed in relation with the magnetic anisotropy (MA). The simulated results under an assumption of the two in-plane easy axes, which exist in the sample, were compared with the experiments.

• 한국통신학회논문지
• /
• 제21권3호
• /
• pp.737-746
• /
• 1996

In this paper, we present simulation result of quantization effects about a new Angular From Carrier Recovery Loop(AF CR loop) for PSK modulation technique. AF CR loop includes detected angle symbol and Multi Level hardimiter. In general, detected angle is used in dtermining symbol. Because detected angle is used to make an error signal of phase detector output, hardware implementation of AF CR loop is simpler than that of other loops. Before hardware implementation of AF CR loop, the result due to quantization effect should be investigated. In order to confirm quntization effect of AF CR loop, we evaluate performance of this loop by Monte-Carlosimulation method. Under both in the AWGN and Jake's fading noise channel environments, we confirmed the characteristics of AF CR loop in terms of RMS jitter due to quntization effect. Differential APSK modulation schemeis used in this paper. Especially, Jake's fading channel is used as a channel model and also AGC(Automatic Gain Control) is used in the overall process of performance evaluation. We obtained the resonable result of quantization effect about AF CR loop. With the result of performanceevaluation based on quantization effects, we can expect to operate AF CRloop under the fading channel environments reasonably well.