• 대한기계학회:학술대회논문집
• /
• 대한기계학회 2003년도 춘계학술대회
• /
• pp.261-266
• /
• 2003

The growth behavior of the transverse crack, which was one of the most dangerous damages of rail defects, was investigated under mode I and mixed mode loading in rail steel. In the case of variable amplitude loading, the fatigue crack growth behavior was discussed using characteristic stress intensity factor ranges ${\Delta}_{rms}$. In addition, characteristic comparative stress intensity factor ranges ${\Delta}_{V,rms}$ was proposed to evaluate the quantitative effects of the variable amplitude under mixed mode loading. As a result, crack growth rate under variable amplitude loading was faster than that under constant amplitude loading.

• 대한음성학회지:말소리
• /
• 제66호
• /
• pp.1-20
• /
• 2008

The purpose of this study was to investigate the characteristics of fundamental frequency(F0) and amplitude distributions in persons with cerebral palsy(CP) in the reading task. Participants were divided into three groups: 6 persons with spastic CP, 6 persons with athetoid CP and 6 normal persons who are around 15-20 years old. On the results of this study, firstly, in F0 distributions, most of the spastic CPs tended to appear narrow distributions on the basis of mode, but most of the athetoid CPs were opposite, and both of the CP groups tended to distribute highly on lower and higher frequencies than mean and mode. On the other hand, normal persons had a tendency to appear narrow distributions on the basis of mode. Finally, in amplitude distributions, the spastic CPs showed a tendency that there are little differences between the distribution of mode and the others, and most of the athetoid CPs showed a tendency that the distributions of mode were higher than the others. In addition to, the normal persons had a tendency that the distributions of mode were remarkably higher than both of the CP groups.

• 천문학회보
• /
• 제38권2호
• /
• pp.89.2-89.2
• /
• 2013

Solar energetic transients, e.g., flares, CMEs, etc., release large amount of energy which is expected to excite acoustic waves (p-modes) by exerting mechanical impulse of the thermal expansion of the flare on the photosphere. We study the p-mode properties of flaring and dormant active regions (ARs) to find association between flare and p-mode parameters. We compute the magnetic and flare activity indices of ARs using the line-of-sight magnetograms and GOES X-ray fluxes, respectively. The p-mode parameters are computed from the ring-diagram analysis. We correct p-mode parameters for magnetic field, filling factors and foreshortening by multiple linear-regression analysis. Our analysis of several flaring and dormant ARs observed during the Carrington rotations 1980-2109, showed strong association of mode parameters with magnetic and flare activities. We find that the mode parameters are contaminated by the geometrical effect. Mode amplitude decreases with angular distance from the solar disc centre. The mode width increases with magnetic activity while amplitude showed opposite relation due to mode absorption by the sunspot. After correcting modes due to all geometrical effects, magnetic activity and filling factor, we find that the modes amplitude, and mode energy increases with flare energy while width shows opposite relation.

• 한국소음진동공학회:학술대회논문집
• /
• 한국소음진동공학회 2007년도 춘계학술대회논문집
• /
• pp.147-156
• /
• 2007

This study offers a design procedure of optimum cable damper for multi-mode vibration control with nonlinear damper and also investigate the relation between mode and amplitude dependency. The proposed multi-mode damping index, which is defined as a energy loss ratio of cable potential, is a main component of optimization problem of optimum nonlinear damper. In order to include the amplitude dependency of nonlinear damper, it is assumed to exist three kinds of multi-mode patterns such as ambient vibration, support excitation and rain-win induced vibration. The optimum damper exponent depends on amplitude patterns. In case of ambient vibration, optimum factor is less than 0.5. In case of support excitation or rain-wind induced vibration is between 0.5 and 1.0. In this study, the effects of cable sag and inclination angle are included in the asymptotic design equation of damped cable structures.

• 한국소음진동공학회논문집
• /
• 제17권9호
• /
• pp.785-796
• /
• 2007

This study offers a design procedure of optimum cable damper for multi-mode vibration control with nonlinear damper and also investigates the relation between mode and amplitude dependency. The proposed multi-mode damping index, which is defined as a potential energy loss ratio of cable vibration, is a main component of optimization problem of optimum nonlinear damper. In order to include the amplitude dependency of nonlinear damper, three types of multi-mode patterns such as ambient vibration, support excitation and rain-wind induced vibration are assumed. The optimum damper exponent depends on amplitude patterns. In case of ambient vibration, optimum factor is less than 0.5 and in case of support excitation or rain-wind induced vibration it is between 0.5 and 1.0.

• 제어로봇시스템학회논문지
• /
• 제20권5호
• /
• pp.563-569
• /
• 2014

This article focuses on a hemispherical resonator gyro driven by the Coriolis effect. A hemispherical shell, called a resonator, is maintained in the resonance state by amplitude control and phase locking control. Parametric excitation has been used to control the amplitude. For rate measurement mode or FTR mode, nodal points have been kept to an amplitude of zero. Angular rate measurement has been demonstrated by rotating a resonator. Frequency mismatch between two stiffness principal axes is a major cause of low performance: vibrating pattern drift and reduced control effectiveness. This mismatch has been reduced significantly by the addition of small mass. A negative spring effect, which lowers resonance frequencies, has been verified experimentally.

• 한국반도체및디스플레이장비학회:학술대회논문집
• /
• 한국반도체및디스플레이장비학회 2004년도 춘계학술대회 발표 논문집
• /
• pp.129-131
• /
• 2004

극자외선 리소그래피(EUV lithography) 기술은 50nm 이하의 선폭을 가지는 차세대 소자 제작에 있어서 선도적인 기술 중 하나이다. EUVL 에서 필수적인 요소중의 하나가 mirror 로 사용되는 blank mask 이다. Blank mask 에 있어서 가장 중요한 요소는 반사도이다. 이 blank mask 는 Si substrate 위에 반사를 위한 Mo/Si pair 가 40pair 이상 적층되어있다. Blank mask 는 매우 청결해야한다. 만약 결함이 있다면 blank mask 에는 치명적이다 결함은 blank mask 에 있어서 반사도를 떨어뜨리는 주 요소이기 때문이다. 그 결함에는 amplitude defect 과 phase defect 이 있다. FIB 에서는 amplitude defect 을 수정하는 것이 가능하다. 우리는 FIB 를 이용하여 mage mode, spot mode, bar rotation mode 를 사용하여 amplitude defect을 수정하였다. 그리고, 그 결과 효과적으로 amplitude defect을 수정하였다.

• Journal of electromagnetic engineering and science
• /
• 제3권2호
• /
• pp.140-146
• /
• 2003

In this paper, the design of a channel filter and its group-delay-and-amplitude equalizer is carried out for the Ka-band satellite transponder subsystem. The 8th order dual-mode filter is employed for high selectivity around the band-edges with an elliptic-integral function response and has an in-line configuration. The 2-pole, reflection-type, group-delay equalizer is designed and manufactured to reduce the group-delay and amplitude variation, which can be large for such a high order filter. It is noted that in both the filter and equalizer, adopting the dual-mode coupling mechanism leads to less mass and volume. Through measurement, the performance of the realized group-delay-equalized filter is shown to meet the equipment requirements and to be appropriate for the satellite input multiplexer.

• 한국정밀공학회지
• /
• 제21권6호
• /
• pp.109-116
• /
• 2004

In this study, when variable-amplitude load with various applying mode acts on the pre-crack tip, we examined how fatigue cracks behave. Hence aspects of the deformation caused by changing the applying mode of single overload and propagation behavior of fatigue crack were experimentally examined: What kinds of the deformation would be formed at pre-crack and its tip\ulcorner What aspects of the residual plastic deformation field would be formed in front of a crack\ulcorner How aspects of the plastic zone could be evaluated\ulcorner As applying mode of single overloading changes, the deformation caused by tensile and shear loading variously showed in each applying mode. The different aspects of deformation make influence on propagation behavior of cracks under constant-amplitude fatigue loading after overloading with various modes. We tried to examine the relationship between aspects of deformation and fatigue behavior by comparing the observed deformation at crack and crack propagation behavior obtained from fatigue tests.

• 수산해양기술연구
• /
• 제40권2호
• /
• pp.138-143
• /
• 2004

제주대학교 실습선 아라호에 정착된 능동형 횡동요 감쇠장치의 성능에 관해 연구하기 위하여 33$^{\circ}$00‘.44”N, 125$^{\circ}$59’.88 ”E 위치에서 선박을 정지한 후, 횡동요 감쇠장치를 정지 (Passive A.R.T), 작동 (Active A.R.T)을 했을 때 경사계에 의한 횡동요각 및 종동요각, 풍속계에 의한 풍속의 변화와 그리고 선박이 항해 중에 감쇠장치의 작동을 정지(Passive A.R.T), 작동(Active A.R.T) 했을 때 의 능동형 횡동요 감쇠장치의 성능을 분석한 결과에 대해 요약하면 다음과 같다. 1. 선박이 정지했을 때 횡동요 감쇠장치를 정지, 작동한 경우 횡동요각의 평균진폭 (Average Amplitude of Roll) 은 각각 8.30$^{\circ}$, 4.37$^{\circ}$, 횡동요각의 유의진폭(Significant Amplitude of Roll $_{{\pi}{1/3}}$)은 각각 10.10$^{\circ}$, 5.30$^{\circ}$으로 나타났다. 2. 선박이 항해 중 일 때에는 횡동요각의 평균진폭 (Average Amplitude of Roll)은 각각 5.01$^{\circ}$, 4.36$^{\circ}$, 횡동요각의 유의진폭 (Significant Amplitude of Roll$^{\circ}$) 은 각각 5.50$^{\circ}$, 5.10$^{\circ}$으로 각각 나타났다. 3. 횡동요 감쇠장치는 선박이 정치했을 때에는 47.5%, 선박이 운항 했을 때는 12.7% 정도의 감쇠 효율을 보여서 정지했을 때 그 효율이 높은 것으로 나타났다. 4. 횡동요 감쇠 장치는 종동요(Pitching)에 대해서는 거의 영향을 미치지 않았다.