• The Korean Journal of Physiology
• /
• v.20 no.2
• /
• pp.199-208
• /
• 1986

The effects of $Mg^{++}$ upon the spontaneous contraction activated by 1 IU/l oxytocin were studied in the isolated rat uterine muscle. Longitudinal muscle strips u·ere prepared from the rat uteri at the estrous stage. All experiments were performed in tris-buffered Tyrode solution which was aerated with 100% $O_2$ and kept at $35^{\circ}C$. The results obtained were as follows: 1) In the uterine strips contracting spontaneously, as $Mg^{++}$ concentration increased in the Tyrode solution the amplitude of peak tension decreased in all the experimental solutions containing the various concentrations of $Ca^{++}\;(0.5{\sim}4 mM)$. And the amplitude of peak tension increased in inverse proportion to the $[Mg^{++}]/[Ca^{++}]\; ratio$. It is suggested that the tension-lowering effect of $Mg^{++}$ would be developed through decreasing intracellular ionized free calcium ion concentration by uncertain mechanism. 2) The frequency of the uterine contraction activated by oxytocin increased as the $[Mg^{++}]/[Ca^{++}]\;ratio$ ratio increased up to 1/2, but the frequency decreased above this ratio. It is speculated that $Mg^{++}$ would influence the excitability control action of $Ca^{++}$.

• Proceedings of the Korean Geotechical Society Conference
• /
• 2002.03a
• /
• pp.423-430
• /
• 2002

A feasibility of a trial test method was evaluated analytically, in which the elastic modulus of a soil deposit was tried to estimate by analyzing dynamic signals measured during conducting the SPT. If there existed a reliable relationship between the impedance ratio of a rod to a soil and the amplitude ratio of a reflected to an incident wave signal at the tip of steel rod contacting the soil surface, it was expected that one could determine the impedance of soil, and then roughly estimate the elastic modulus from the impedance. For a simple rod-soil system, the existence of the relevant relationship was verified in this study by analyzing computed wave signals propagating up and down through the rod. On the basis of these results, thus, a potential of the test method to practical applications could be seen. However, apparent theoretical shortcomings possessed in this approach were also realized since the soil part had an unconfined contact area where contacted with the rod. Therefore, it was concluded that further studies needed to be conducted, in which the reliable theoretical relationship between the impedance and the amplitude ratio as well as the effective contacting soil area contributing to wave reflection should be justified.

• Proceedings of the Earthquake Engineering Society of Korea Conference
• /
• 2000.10a
• /
• pp.245-250
• /
• 2000

Recent building structures are superior in its ability but they are light and fiexible, and so have problems of vibration. In general, the serviceability of RC slabs was known to be good against vibration because of its hardness. However recent high-rise apartment slabs are mostly light and long, the serviceability about vibration problems of RC slabs was performed. Basic information and its influence on vibrations of RC slabs were revealed. Also, its serviceability against vibration was examined. Many tests were conducted on existing building located in Chung-Nam area. As a results, damping ratio, natural frequency, acceleration amplitude and displacement amplitude which were used to examine serviceability of the RC slabs were obtained. These results on the test building proved that its serviceability conditions were satified to meet the code against vibration.

• 한국전산유체공학회:학술대회논문집
• /
• 2001.05a
• /
• pp.134-143
• /
• 2001

Viscous solutions of supersonic jet impinging on a flat plate normal to the flow are simulated using three-dimensional Navier-Stokes solver. The jet impinging flow structure exhibits such complex nature as shock shell, plate shock and Mach disk depending on the flow parameters. Among others, the dominant parameters are the ratio of the nozzle exit pressure to the ambient pressure and the distance between the nozzle exit plane and the impinging plane. In the present study, the nozzle contour and the pressure ratio are held fixed, while the jet impinging distance is varied to illuminate the characteristics of the jet plume with the distance. As the plate is placed close to the nozzle at 3D high, the computed wall pressure at or near the jet center oscillates with large amplitude with respect to the mean value. Here D is the nozzle exit diameter. The amplitude of wall pressure fluctuations subsides as the distance increases, but the maximum pressure level at the plate is achieved when the distance is about 4D high. The frequency of the wall pressure is estimated at 6.0 kHz, 9.3 kHz, and 10.0 kHz as the impinging distance varies from 3D, 4D, to 6D, respectively.

• Journal of Communications and Networks
• /
• v.8 no.1
• /
• pp.1-7
• /
• 2006

Quadrature amplitude modulation-spread spectrum (QAM-SS) and code division multiplexing (CDM) are multi-level modulation schemes with high performance but they cause a large peak-average power ratio (PAPR). Therefore, this paper proposes a novel modulation scheme for high-rate transmission which follows a sequence of CDM-mapping-CDM not only to correct the above-mentioned problem but also offer a high flexibility in obtaining arbitrary multilevel modulation with very low implementation complexity and high performance.

• Journal of the Korean Institute of Telematics and Electronics
• /
• v.27 no.5
• /
• pp.808-815
• /
• 1990

This paper treats with the design method for the single loop oversampled Sigma-Delta A/D converter with one delay and the digital integrator. Such an integrator was kgenerated by means of the bilinear transform of the analog integrator. The frequency spectrums of the quantizer and the decimator output signal are evaluated by FFT respectively. With the performance evaluation system, the values of SNR are obtained versus the input sinusoidal signal amplitude, frequency, the oversampling ratio, the DC-input level, the loop gain and the limitting value of the integrator. As compared with existing results, values of SNR versus the input signal amplitude and the oversampling ratio for the suggested system are about 6dB higher then previously reported results respectively. Furthermore, this approach achieves an about 60dB input dynamic range.

• Journal of the Korea Institute of Military Science and Technology
• /
• v.9 no.4
• /
• pp.104-113
• /
• 2006

To identify aeroelastic characteristics of wings with double-folding mechanism, aeroelastic analyses are performed. There are four wing models which consist of one linear model and three nonlinear models. The nonlinear models have one or two freeplay nonlinearties. The describing function method is used to approximately examine nonlinear effects. The aeroelastic module in MSC/NASTRAN is used to study the aeroelastic characteristics of the considered wing models. The effects of the folding mechanism and amplitude ratio are examined. As the amplitude ratio increases, the flutter speeds approach to those of the wing model with only one nonlinearity. The numerical results show that the flutter speeds of the wings with double-folding mechanism can be lower or higher than those of the wing model with only one folding mechanism depending upon the direction of the second folding mechanism.

• Journal of the Korea Institute of Military Science and Technology
• /
• v.20 no.2
• /
• pp.272-278
• /
• 2017

In this paper, we consider a single-channel amplitude comparison monopulse system(SCACMS). The monopulse ratio curve(MR-C) of the SCACMS can be controlled by an amplitude difference between sum and different signal, a phase difference and the coefficient of the signal processor. We first propose the SCACMS with multiple variables, and then apply a genetic algorithm to optimize the multiple variables in terms of minimizing a root mean square error. The simulation results show that when three variables of the SCACMS are jointly optimized, the linear region of the MR-C can be extended approximately 187 % compared to that of two variables.

• Proceedings of the Korean Institute of Communication Sciences Conference
• /
• 1984.04a
• /
• pp.37-41
• /
• 1984

The error rate performance of amplitude phase keying system has been studied in the environment of cochannel interference and impulsive noise. We have derived the error probability equations of amplitude shift keying signal and phase shift keying signal, and combining the results, we have evaluated the circular APK signal which is the one of the several cases of APK arrays. Using the derived equations, the circular APK system has been evaluated in terms of carrier-to-noise power ratio(CNR), carrier-to-interferer power ratio(CIR), and impulsive index. The graphic results show us the best case and worst case of APK system, and good performance compared to the other systems in cochannel interference and impulsive noise.

• Journal of the Korea institute for structural maintenance and inspection
• /
• v.4 no.4
• /
• pp.225-230
• /
• 2000

Recent building structures are superior in its ability but they are light and flexible, and so have problems of vibration. In general, the serviceability of RC slabs was known to be good against vibration because of its hardness. However, recent high-rise apartment slabs are mostly light and long, the serviceability of RC slabs due to vibration could be a problem. In this paper, a basic investigation about vibration problems of RC slabs was performed. Basic information and its influence on vibrations of RC slabs were revealed. Also, its serviceability against vibration was examined. Many tests were conducted on existing building located in Chung-Nam area. As a results, damping ratio, natural frequency, acceleration amplitude and displacement amplitude which were used to examine serviceability of the RC slabs were obtained. These results on the test building proved that its serviceability conditions were satisfied to meet the code against vibration.