• Proceedings of the IEEK Conference
• /
• 2002.07a
• /
• pp.333-336
• /
• 2002

An alternative CMOS implementation of a multi-output four-terminal floating nullor (FTFN) with constant-g$_{m}$ rall-to-rail input stage is proposed. This presented circuit is based on the advantages of a complementary transconductance amplifier and class AB dual translinear cell circuit that comes up with wide bandwidth. The constant-g$_{m}$ characteristic is controlled by the maximum-current selection circuits, maintaining the smooth response over the change of input common mode voltage. The circuit performances are confirmed through HSPICE simulations. A current-mode multifunction filter is used to exhibit the potentiality of this proposed scheme.eme.

• Proceedings of the KSME Conference
• /
• 2004.11a
• /
• pp.1166-1171
• /
• 2004

The combustion instability acts as a serious obstacle for the lean premixed combustion of gas turbine and even causes the fatal damage to the combustor and whole system. In this experiment, the pressure fluctuation is highly related to the stabilizing position of flame and fuel injection location. The fuel injection location is connected with the convection time of the fresh mixture, which is important time scale to refresh the mixtures near the flame stabilization location. The flame is extremely unstable when the alternative stabilization occurs and bulk mode frequency (${\sim}10Hz$) of pressure fluctuation is observed in this condition. It was found that the convection time scale of the fresh reactant coincided with the time scale of the bulk mode fluctuation. Hence this phenomenon results from the local equivalence ratio change caused by the pressure fluctuation induced by thermo-acoustic effects.

• Journal of Power System Engineering
• /
• v.6 no.3
• /
• pp.11-16
• /
• 2002

This paper describes the power performance and emission characteristics of the high speed direct injection diesel engine (2.9 litter displacements) driven by soybean oil asknown a bio diesel fuel. The results were compared to diesel fuel with blending bio diesel fuels. The soybean bio diesel fuel was added in the diesel fuel in concentration varying from 25% to 75% volume rates. We measured the emissions according to ECE 13 mode and full load, fixedengine speed. When the 25% bio diesel fuel was used, NOx emission at the ECE 13 mode test slightly decreased compared with diesel base engine. Over engine speed of 2000 rpm, the level of unburned hydrocarbon(HC) and carbon monoxide(CO) were the same to the diesel engine. Smoke emission decreased asthe blending bio diesel fuel rate increased.

• Journal of Information Technology Services
• /
• v.19 no.3
• /
• pp.1-15
• /
• 2020

This study applies the Delphi method to design services with convergence characteristics in the financial sector. In designing a service robot for practical deployment that can support and replace bank teller, the opinions and judgments of various expert groups were extracted and a consensus process was made through feedback. A total of six dimensions and thirty service elements were derived over three rounds. Coefficient of Variation and content validity were used to verify the suitability and reliability of the selected service elements. As a result, the essential service element of robots was interaction with customers, followed by basic and professional financial services. Based on these service factors, we proposed two types of service models. support mode to assist employees during business hours and alternative mode on behalf of employees outside business hours. It is hoped that this study will use the Delphi technique in the design of IT convergence services.

• IEMEK Journal of Embedded Systems and Applications
• /
• v.2 no.1
• /
• pp.43-52
• /
• 2007

IEEE 802.15.4 specification which defines low-rate wireless personal area network(LR-WPAN) has application to home or building automation, remote control and sensing, intelligent management, environmental monitoring, and so on. Recently, it has been considered as an alternative technology to provide multimedia services such as automation via voice recognition, wireless headset and wireless camera for surveillance. In order to evaluate capability of voice traffic on the IEEE 802.15.4 LR-WPAN, we supposed two scenarios, voice traffic only and coexistence of voice and sensing traffic. For both cases we examined delay and packet loss rate in case of with and without acknowledgement, and various beacon period varying with beacon and superframe order values. In LR-WPAN with voice devices only, total 5 voice devices could be applicable and in the other case, i.e., coexisted cases of voice and sensor devices, a voice device was able to coexist with about 60 sensor devices.

• Korean Journal of Optics and Photonics
• /
• v.10 no.6
• /
• pp.524-526
• /
• 1999

It is observed that the mode spacing of an cxternal cavity semiconducror laser can be altered dramatically by the insertion of an intracavity etalon. 111e mode spacing is decreased as a function of etalon's reflectivity and this effect is quantitatively explained by an analysis of resonant modes. We abo show that this effect provides a precise and convenient alternative for determining the coating reflectivity of a high reflectivity etalon. talon.

• KIEE International Transaction on Electrical Machinery and Energy Conversion Systems
• /
• v.2B no.3
• /
• pp.100-108
• /
• 2002

A simple sustain driver employing an energy recovery function is proposed as a highly efficient driver of a plasma display panel. The proposed driver uses dual resonance in the sustaining mode operation: a main resonance between an inductor and an external capacitor to produce alternative pulses and a sub-resonance between an inductor and a panel to recover the energy consumption by the capacitive displacement current of the PDP. The operational principle and design procedure of the proposed circuit are presented with theoretical analysis. The operation of the proposed sustain driver is verified through simulation and experiments based on a 7.5-inch-diagonal panel with a 200 KHz operating frequency.

• Transactions of the Korean Society of Automotive Engineers
• /
• v.4 no.4
• /
• pp.140-146
• /
• 1996

A large portion(above 70%) fo the hydrocorbon and NOx emissions for a typical vehicle occur mainly before the conventional underbody catalyst reaches activation temperature. To meet the stringent regulation as EC stage 2, the emissions produced during this period must be reduced. One of alternative techniques is to place CCC(Close-Coupled Catalyst) near the exhaust manifold. In this study, the characteristics of CCC are observed through EEC mode.

• KSTLE International Journal
• /
• v.1 no.1
• /
• pp.29-33
• /
• 2000

In this study, a methodology is developed and confirmed to find the physical contact between the slider and disc due to the defects of disk during head seeking operation using acoustic emission (AE) signal. The head/disk contact was detected during random and standard seeks, whereas no contact was detected during track fellowing. During standard and random seeks, the torsion mode of slider excitation was observed at 680KHz. Therefore, it is thought that AE technique can be used as an alternative method of the glide test by monitoring existence of the torsional mode of the slider during seek operation or can be used to detect the spacing loss during seeking operation. By appropriately choosing the location of the sensor an order of magnitude increase in the sensitivity for RMS AE signal is observed. Therefore we can find take-off velocity clearly with high signal to noise ratio of AE signal.

• KIEE International Transactions on Electrophysics and Applications
• /
• v.3C no.5
• /
• pp.199-206
• /
• 2003

Numerical solutions to complex characteristic equations are quite often required to solve electromagnetic wave problems. In general, two traditional complex root search algorithms, the Newton-Raphson method and the Muller method, are used to produce such solutions. However, when utilizing these two methods, the choice of the initial iteration value is very sensitive, otherwise, the iteration can fail to converge into a solution. Thus, as an alternative approach, where the selection of the initial iteration value is more relaxed and the computation speed is high, Davidenko's method is used to determine accurate complex propagation constants for leaky circular symmetric modes in circular dielectric rod waveguides. Based on a precise determination of the complex propagation constants, the leaky mode characteristics of several lower-order circular symmetric modes are then numerically analyzed. In addition, no modification of the characteristic equation is required for the application of Davidenko's method.