• Journal of Environmental Science International
• /
• v.5 no.2
• /
• pp.211-220
• /
• 1996

New thin-and diselena-crown ethers containing two suffer and selenium donor atoms have been prepared. And then, mercury ($Hg^{2+}$) ion-selective electrodes with PVC-plasticizer (STPB) based on some macrocycles as neutral carriers were also made. The electrochemical selectivities for various ions, and the effects for macrocycles, matrix of membranes, ratio of plasticizer to macrowcles, concentration and pH of test solution were investigated on the $Hg^{2+}$ ion-selective electrodes. The 1, 10-diselena-18-crown-6-PVC-STPB (sodium tetraphenylborate) exhibited good linear responses of ${28.2}\pm{0.6}$ decade-1 for $Hg^{2+}$ ion in the conientration ranges of $10^{-2}~10^{-6}$ M $Hg^{2+}$ ion. This electrode exhibited comparatively good selectivities for $Hg^{2+}$ ion in comparison with alkali and alkaline earth metal ions, some heavy metal ions and rare earth metal ion in the range of pH 2.5~6.0. In addition, this electrode was applied as a sensor in the titration of $Hg^{2+}$ ion with $1^-$ ion in water.

• Journal of the Korean Ceramic Society
• /
• v.36 no.7
• /
• pp.725-733
• /
• 1999

It is a fundamental experiment to use blast-furnace slag in solidification/stabilization process. The compressive strength and leaching test of Pb and Cr doped samples were evaluated and the effects of heavy-metal ions on the hydration of slag was investigated. Sodium silicates(5wt%) was added as alkali-activator and the effects of replacing a part of slag with flyash or gypsum was also discussed. Pb ion was solidified by encapsulation of matrix. In of slag${\pm}$gypsum binder microstructure was densified by accelerating to form AFt/AFm phase and compressive strength was improved resulting in reducing leaching amount of Pb ion. Cr ion was solidified by substituting with Al ion in aluminate product. Slag+fly ash binder improved compressive strength and decreased leaching amount of Cr ion.

• Bulletin of the Korean Chemical Society
• /
• v.22 no.4
• /
• pp.405-408
• /
• 2001

New lipophilic triesters of calix[4]arene and calix[4]quinone are investigated as sodium ion-selective ionophores in poly(vinyl chloride) membrane electrodes. For an ion selective electrode based on calix[4]arene triester I, the linear response is 1 ${\times}$10-3.5 to 1 ${\times}$ 10-1 M of Na+ concentrations. The selectivity coefficients for sodium ion over alkali metal and ammonium ions are determined. The detection limit (logaNa+ = -4.50) and the selectivity coefficient (logKNa+,K+pot = -1.86) are obtained for polymeric membrane electrode containing calix[4]arene triester I.

• Bulletin of the Korean Chemical Society
• /
• v.10 no.2
• /
• pp.155-158
• /
• 1989

The rates of complexation of the 18-C-6 (1,4,7,10,13,16-hexaoxacyclooctadecane) with $K^+,\;Ca^{2+},\;Sr^{2+},\;and\;Ba^{2+}$ in methanol solution have been determined at 25$^{\circ}C$ by a pressure-jump technique. The Eigen Winkler mechanism has been applied to interprete the kinetic data. The results suggest that the rate determining step of the complexation in methanol is the rearrangement of the ligand in the outer sphere ion-dipole pair to form a stable encapsulated complex of the metal ion by the crown ether.

• Bulletin of the Korean Chemical Society
• /
• v.26 no.6
• /
• pp.882-886
• /
• 2005

Copper(II) ion-selective PVC membrane electrode based on 2-mercaptobenzoxazole as a new ionophore and o-nitrophenyl octyl ether (o-NPOE) as plasticizer is proposed. This electrode revealed good selectivity for $Cu^{2+}$ over a wide variety of other metal ions. Effects of experimental parameters such as membrane composition, nature and amount of plasticizer, and concentration of internal solution on the potential response of $Cu^{2+}$ sensor were investigated. The electrode exhibits good response for $Cu^{2+}$ in a wide linear range of 5.0 ${\times}$ 10−.6-1.6 ${\times}$ $10^{-2}$ mol/L with a slope of 29.2 ${\pm}$ 2.0 mV/decade. The response time of the sensor is less than 10 s, and the detection limit is 2.0 ${\times}$ $10^{-6}$ mol/L. The electrode response was stable in pH range of 4-6. The lifetime of the electrode was about 2 months. The electrode revealed comparatively good selectivities with respect to many alkali, alkaline earth, and transition metal ions.

• Bulletin of the Korean Chemical Society
• /
• v.28 no.5
• /
• pp.816-820
• /
• 2007

Novel new red-light emitting perylene fluoroionophore N,N'-dipropyl-1,7-bis(calix[4]azacrown-5-crown-5)- 3,4,9,10-perylene tetracarboxy diimide (3) was prepared by reacting N,N'-dipropyl-1,7-dibromo-3,4,9,10- perylene tetracarboxy diimide (1) with calix[4]azacrown-5-crown-5. Also the alternating copolymer (4) with similar repeating unit was prepared reacting by calix[4]bisazacrown-5 with 1. Metal ion binding by 3 and 4 leads to a blue-shift of absorption band and emission spectra. When ionophoric characteristics were investigated by binding alkali, alkali earth metal and various metal ions, polymeric ionophores displayed large fluorescence decreasing effects with K+, Ag+ and Ba2+, which was rationalized by photo-induced charge transfer (PCT).

• Journal of Pharmaceutical Investigation
• /
• v.1 no.1
• /
• pp.101-108
• /
• 1971

The stability and toxicity test for p.p'-DDT, DDVP and dipterex that put to used sample in this study effects is follows A. about p.p'-DDT (1) In elevating the stability of p.p'-DDT, best stabilizing solvent was benzene. (2) The stability-agent has no difficulty as long as it not contain metal ion for instance $Z_n^{2+}$,$C_r^{3+}$,$Al^{3+}$,and $Fe^{2+or3+}$ but in case of contain $F_e^{3+}$, the combination of salicylaminoguanidine is best effective. (3) Using this product for water-suspension, We must use span 40 for stability agent and adding it at the same time. (4) We must use container which does not week alkali and metal ion but it is to preserved in tight light-resistant container. (5) The stopper of container is adapted with above-mentioned condition of container, but it is better not to use metal material. (6) This product needs opening ventilation more than 30 minutes after diffusion or spray and in the room we remove cause of remained poison by cleaning the bottom. B. about DDVP and Dipterex (1) Benzene or toluene in best solvent to preserve stability of DDVP and Dipterex. (2) Span 40 is superior for stability agent of this product and second is span 80. (3) The pH of solution is very stable in pH 5-6 and comparative stable in alkali more than p,p'-DDT. (4) Container is to preserved in tight, lightresistant container and especially be careful of outflow and inflow of water. (5) Because this product is centeral stimulant poison, we must pay attention to prevent cause of contact diadermic toxicity after use.

• Applied Chemistry for Engineering
• /
• v.3 no.2
• /
• pp.266-272
• /
• 1992

Azacrownoalkyl phenylphosphinic acids were synthesized and their competitive solvent extraction characteristics from water to chloroform layer were investigated. Phosphinic acids were synthesized in good yields by one step reaction of phenylphosphinate, aldehyde, and monoazacrown ether and then basic hydrolysis of the resulting phosphinate dsters. These complexing agents revealed a wide effective pH range in extraction of alkali metal ions from water to the organic phase and total metal ion loading at pH 11 was about 75%. The selectivity of the cation extraction was determined mainly by the cavity size of the azacrown ethers, showing $Na^+$ >> $K^+$ > $Rb^+$ > $Li^+$ > $Cs^+$ for the alkyl phenylphosphinic acid ${\underline{2}}$, containing monoaza-15-crown-5 and $K^+$ >> $Rb^+$ > $Na^+$ > $Cs^+$ > $Li^+$ for the alkyl phenylphosphinic acid, ${\underline{3}}$, containing monoaza-18-crown-6 moiety. Applicable pH range of these azacrown ether phosphinic acids in solvent extraction of alkali metal cations was wider than a crownether carboxylic acid with similar selectivity, showing considerable amount of metal ion loading in slightly acidic or neutral media.

• Bulletin of the Korean Chemical Society
• /
• v.29 no.2
• /
• pp.417-421
• /
• 2008

The efficient synthesis of four mesitylene-based receptors 1-4 and their potentiometric response characteristics to alkali metal, alkaline earth metal, and transition metal ions, under various pH conditions are outlined. Receptor 1-based electrode exhibited more sensitive response to Ag+ ion (49 mV/decade of range from 10-6 to 10-2 M) than the 2-based electrode (47 mV/decade of range from 3 ´ 10-5 to 10-2 M), while the 3- and 4-based ones revealed sub-Nernstian below 40 mV/pAg+. All electrodes showed substantial responses to Ag+ ion under acidic condition, but there was almost nil-response to other transition metal ions (Fe2+, Co2+, Zn2+, Ni2+, Pb2+, Cd2+, Cu2+ and Hg2+). The association constant of receptor 1 toward Ag+ ion, measured by 1H NMR titration, showed the largest value (200 M-1) among the tested receptors. The results were interpreted with semi empirically-modeled structures.

• Bulletin of the Korean Chemical Society
• /
• v.32 no.4
• /
• pp.1221-1227
• /
• 2011

Ethyl pyruvate (EP) is known as a scavenger of reactive oxygen species (ROS) in the body through its role in the donation of diketone groups to metals to form an EP-metal complex. In order to develop a method for the quantification of EP in biological media, a sensitive and specific, high-performance liquid chromatographyelectrospray ionization-mass spectrometry (HPLC-ESI/MS) method is used to determine the EP-alkali metal ion binding species. The analyte was separated on a ZORBOX SB-C8 ($3.5{\mu}m$, $30mm{\times}2.1mm$ I.D.) column and analyzed in selected ion monitoring (SIM) mode with a positive ESI interface using the m/z 255 $[2M + Na]^+$ ion. The method was validated over the concentration range of $0.5-60.0\;{\mu}g$/mL under 1/9 (v/v) of acetonitrile/methanol solvent system with flow rate 0.05 mL/min. The limit of quantification (LOQ) was $0.5{\mu}g$/mL.