• Journal of Sensor Science and Technology
• /
• v.20 no.6
• /
• pp.393-399
• /
• 2011

In this paper, we designed and fabricated the novel air flow sensor using air drag force, which can be applied to the low air flow detection. To measure the low air flow, we should enlarge the air drag force and the output signal at the given air flow. The paddle structure is applied to the device, and the device is vertically located against the air flow to magnify the air drag force. We also adapt the corrugation structure to improve the output signals on the given air velocity. The device structure is made up of the silicon nitride layer and the output signal is measured with the piezoresistive layer. The output signals from the corrugated device show the better measurement sensitivity and the response time than that of flat one. The repeated measurement also shows the stabilized signals.

• Korean Journal of Air-Conditioning and Refrigeration Engineering
• /
• v.16 no.12
• /
• pp.1227-1233
• /
• 2004

Air handling unit (AHU)'s air filter pressure difference is important for energy consumption and indoor air quality. Both energy Performance data and air filter differential pressure of AHU in real office buildings were monitored and analyzed to investigate quantitatively energy impact as dust buildup level on air filter grows. We also modeled and simulated CAV system using HVACSIM＋ program to examine the energy effect of dust buildup on filters. Through analysis of time series pressure drop data, the filter pressure difference rate has been increased due to cumulative supply air flow rate increase. As filter pressure drop increased to 1 inch water column, it is found that the supply air flow rate was decreased by 10%, the chilled water flow rate was increased by 5.9% and the pump energy consumption was increased to 5.9%.

• Journal of Advanced Navigation Technology
• /
• v.28 no.2
• /
• pp.250-253
• /
• 2024

This paper proposes a low-power waveform for a long-range air-to-air data link. In the case of an air-to-air data link, data communication is performed in the air and high Doppler shift may occur depending on the flight speed, so a waveform based on the non-coherent method is suitable. In addition, since it is mounted on an aircraft, it must have low power characteristics. This paper proposes a waveform that combines a modulation technique based on frequency modulation and pulse position modulation that can turn on/off the transmission signal. As a result of the performance analysis, it was shown that the performance was suitable for air-to-air operation while showing low power characteristics.

• Korean Journal of Air-Conditioning and Refrigeration Engineering
• /
• v.29 no.2
• /
• pp.63-67
• /
• 2017

The purpose of this study is to analyze the Age of Air and the Local Air-change Effectiveness of by field measurement. The indexes of Age of Air and Local Air-change Effectiveness are used to analyze the local ventilation effectiveness of multiple locations and are mainly evaluated using the computational fluid dynamics (CFD) method. In this study, measurement of the Local Air-change Effectiveness was based on ASHRAE 129. The performance of Local Air-change Effectiveness and the dependence of the outlet location on Local Air-change Effectiveness were analyzed. The results showed that a greater air-change rate (ACH) may not guarantee better local ventilation effectiveness.

• Journal of Information Technology Applications and Management
• /
• v.28 no.6
• /
• pp.87-95
• /
• 2021

Recently interest for air pollution is gradually increasing. However, according to the environmental assessment of air quality, the level of air pollution in the nation is quite serious, and air pollutants measuring facilities are also not enough. In this paper, a secure air pollutants sensor system based low power wireless communication is designed and implemented. The proposed system is composed of three parts: air pollutants measuring sensors module, LoRa-based data transmission module, and monitoring module. In the air pollutants measuring module, the MSP430 board with six big air pollutants measuring sensors are used. The air pollutants sensing data is transmitted to the control server in the monitoring system using LoRa transmission module. The received sensing data is stored in the database of the monitoring system, and visualized in real-time on the map of the sensor locations. The implemented air pollutant sensor system can be used for measuring the level of air quality conveniently in our daily lives.

• Korean Journal of Air-Conditioning and Refrigeration Engineering
• /
• v.21 no.7
• /
• pp.417-423
• /
• 2009

Air curtains are widely used for gates of shopping mall, warehouse, cold stores and refrigerated display cabinets. The purpose of the air curtain is to reduce the infiltration of outdoor air and heat loss from the air conditioning space to ambient air. Design data for the air curtain given by previous researchers do not mention the influence of wind speed. Thus, this paper presents a performance of single jet air curtain in heating space when the wind blows toward the opening space of the building. A numerical simulation is used to study the influence of various parameters on the efficiency of the downward-blowing air curtain device which is installed inside of the wall above the door. The performance of the air curtain is evaluated by sealing efficiency which provides the assessment of the energy savings. A new safety factor is also proposed for determination of air curtain jet velocity under the various wind conditions.

• Journal of Environmental Impact Assessment
• /
• v.16 no.4
• /
• pp.267-275
• /
• 2007

In this study, relationship between the air pollution of Siheung city and the relative contribution of automobiles to the city's pollution was evaluated for the first time. Then, new air pollution exposure index was developed through simulation. Using the newly developed index, two different urban development scenarios were compared to present a sustainable urban development plan to reduce air pollution from the land utilization point of view. According to the result of this simulation, air quality of the city was found to be affected significantly by human activities. More populated area showed worse level of air quality. Any development in the city resulted in more automobile activity and deterioration of air quality. This simulation result thus explains that a rapid increase of automobiles accompanied by the land development near local roadsides in the city is the major cause of air pollution in Siheung city. In this study, if urban activities are vigorous in an area with high air pollution, people are more likely to be exposed to air pollutant under the bad environmental conditions. On the other hand, if urban activities are less vigorous in an area with high pollution or if urban activities are vigorous in an area with less pollution, the environmental condition was positive. The APEI (Air Pollution Exposure Index) was developed based on these considerations. Scenarios 1 and 2 were compared and analyzed using APEI. In result, scenario 1 is the case in which land is developed and used in an environmentally favorable manner. From this study, it was proved that the impact of air pollution on human health can be minimized with proper land use. The result form the current study can be used as the basic information to solve problems from improper land utilization and air pollution (by road traffic). It also can be utilized to evaluate air pollution level according to land use and road characteristics and to help to choose the best location of land use to comply with the road function and status.

• THE INTERNATIONAL COMMERCE & LAW REVIEW
• /
• v.40
• /
• pp.97-144
• /
• 2008

The purpose of this paper is to review the text of national legislation relating to the carrier's liability in respect of the carriage of passengers, baggage and cargo by air in major states such as United Kingdom, Germany, France, Canada, Russia and China, and to compare the air carrier's liability under the national legislations of above states with them under the Warsaw System relating to the international carriage by air. Also this paper reviews the text of the draft legislation relating to the carrier's liability in respect of the carriage by air in Korea. The Warsaw Convention for the Unification of Certain Rules Relating to International Carriage was adopted in 1929. In 1999, the ICAO adopted the Montreal Convention for the Unification of Certain Rules for International Carriage by Air vastly modernizing the unification of private air law. The Montreal Convention replaced the instruments of the “Warsaw System”, and came into force on 4 November 2003. The Montreal Convention is not only an international convention. It has also exercised a considerable influence on national legislation. A the Convention, or certain of its principles, with the object of regulating their national air transport. The main feature of the liability regime of the air carrier under the Montreal Convention is the two-tier liability system for death or injury of the passenger with strict liability up to 100,000 SDR and presumptive liability with a reversed burden of proof without any limit above that threshold. The principles of the liability of the air carrier under the Montreal Convention have been adopted into national legislations by the United Kingdom, Germany, France, Canada, Russia and China. Now the Ministry of Justice of Korea is proceeding to make a new national legislation relating to the liability of the air carrier in respect of the carriage by air. The draft legislation of the Part VI the Carriage by Air of the Commercial Code of Korea has adopted the main principles of the liability of the air carrier under the Montreal Convention. In conclusion, the national legislation relating to the liability of the air carrier in Korea will contribute to settle efficiently the dispute on the carrier's liability in respect of the carriage of passengers, baggage and cargo by air.

• Proceedings of the Korean Society of Precision Engineering Conference
• /
• 2004.10a
• /
• pp.231-236
• /
• 2004

The area of flat glass panel displays such as LCD (Liquid crystal display) and PDP (Plasma display panel) has been increased more than 2 $\times$ 2 m$^2$ for productivity improvement. However, such a large panel area incurs large panel deflection during panel transfer using robots or AGV (Automated guided vehicle) systems. Therefore, electronic industries are making an effort to find an alternative transfer system for the large glass panels with small deflection. The air conveyor with porous pads is one plausible solution, but it becomes expensive because the large porous pads cost much and air consumption increases as the panel area increases. In this work, a simple air slit levitating conveyor was devised to lower the equipment cost and to reduce the air consumption of system. The air flow model between the LCD glass panel and conveyor was constructed and its validity was verified by experiments. To minimize the air consumption, the conveyor dimensions were optimized, and the air consumptions between the air conveyors with the air slit and that with the porous pad were compared.

• 한국전산유체공학회:학술대회논문집
• /
• 2010.05a
• /
• pp.263-270
• /
• 2010

In this study, an air cleaner is considered to improve comfort, safety, and health of automobile passengers. The performance and installation conditions of the air cleaner have been studied to investigate their effects on the air quality in the cabin room using numerical analysis. A five-passenger sedan and a seven-passenger minivan that have comparatively large indoor volume have been considered. The distributions of the local mean age and the volume averaged age of indoor air are calculated according to the variation of the placement and the air flow of the air cleaner. In addition, a decrease of contamination concentration, especially VOCs(volatile organic compounds), by the air cleaner is numerically analyzed with time-accurate unsteady calculation to quantify the effect of the air cleaner on the indoor air quality. As a result, the effective installation and operation conditions of the air cleaner for the automobile cabin room could be suggested.