• Journal of Navigation and Port Research
• /
• v.28 no.5
• /
• pp.463-468
• /
• 2004

A lab-scale fundamental study to develop the solvent extraction process of ship wash wastewater containing TBT was carried out. For various solvents, including diesels for car and ship, bunker B, thinner, toluene, and ether, the extraction efficiencies of TBT from synthetic ship wash wastewater were compared The effect of extraction conditions, such as solvent amount, time and intensity of agitation, and pH, on the extraction efficiency of TBT was evaluated Diesel for ship showed better extraction efficiency of TBT than those of other tested solvents, and the proper amount of the extraction solvent for 1L of the wastewater was l0mL. When the agitation intensity was increased from 50rpm to 250rpm, the TBT remained in the wastewater after the extraction was decreased from around 120ppb to 2.8ppb. The remaining TBT in the wastewater was sharply decreased from 1hr of the extraction time, but was slightly increased again after 5hrs of the extraction time. The efficiency of TBT extraction was good in the weak acid range of pH, but was not significant as much as the others.

• Journal of the Korea Organic Resources Recycling Association
• /
• v.25 no.4
• /
• pp.41-50
• /
• 2017

The design of proper agitation system is requisite in biological waste treatment and energy generation plant, which is affected by viscosity, impeller types, and power consumption. In the present work, hydrogen fermentation of food waste was conducted at various operational pHs (4.5~6.5) and substrate concentrations (10~50 g Carbo. COD/L), and the viscosity of fermented broth was analyzed. The $H_2$ yield significantly varied from 0.51 to $1.77mol\;H_2/mol\;hexose_{added}$ depending on the pH value, where the highest performance was achieved at pH 5.5. The viscosity gradually dropped with shear rate increase, indicating a shear thinning property. With the disintegration of carbohydrate, the viscosity dropped after fermentation, but it did not change depending on the operational pH. At the same pH level, the $H_2$ yield was not affected much, ranging $1.40{\sim}1.86mol\;H_2/mol\;hexose_{added}$ at 10~50 g Carbo. COD/L. The zero viscosity and infinite viscosity of fermented broth increased with substrate concentrations, from 10.4 to $346.2mPa{\cdot}s$, and from 1.7 to $5.3mPa{\cdot}s$, respectively. There was little difference in the viscosity value of fermented broth at 10 and 20 g Carbo. COD/L. As a result of designing the agitation intensity based on the experimental results, it is expected that the agitation intensity can be reduced during hydrogen fermentation. The initial and final agitation intensity of 30 g Carbo. COD/L in hydrogen fermentation were 26.0 and 10.0 rpm, respectively. As fermentation went on, the viscosity gradually decreased, indicating that the power consumption for agitation of food waste can be reduced.

• Journal of Microbiology and Biotechnology
• /
• v.16 no.8
• /
• pp.1240-1247
• /
• 2006

The present study investigated the influence of the aeration rate and agitation intensity on the production of the mycelial biomass and antioxidative exopolysaccharide (EPS) in Ganoderma resinaceum. In submerged cultures with varying agitation speeds and aeration rates in a stirred-tank reactor, the maximum mycelial biomass and maximum EPS concentration were achieved at 50 rpm and 300 rpm, respectively. Under varying aeration rates, the highest amount of mycelial biomass (18.1 g/l) was accumulated at the lowest aeration rate (0.5 vvm) and the maximum EPS production (3.0 g/l) obtained at 1.0 vvm. A compositional analysis revealed that the five different EPSs were protein-bound heteropolysaccharides, consisting of 87.17-89.22% carbohydrates and 10.78-12.83% proteins. The culture conditions had a striking affect on the carbohydrate composition of the EPS, resulting in different antioxidative activities. All the EPSs showed strong scavenging activities against superoxide and 1, 1-diphenyl-2-picrylhydrazyl (DPPH) radicals, whereas no clear trend in antioxidative activity was observed against hydroxyl radicals and lipid peroxides. Although the precise reason for this difference is still unclear, the high glucose moiety of EPS is probably linked to its broad spectrum of antioxidative activity.

• Journal of the Korean GEO-environmental Society
• /
• v.15 no.8
• /
• pp.45-50
• /
• 2014

The microorganism decomposition experiment of sewage in the underground sewer has the limit of experiment condition and time. The way to reproduce the microorganism decomposition in the underground sewer was studied using batch reactor setting up the DO as a limiting condition. The DO concentration in the sewer is controlled by reaeration. It is possible to obtain correlation between flow condition and reaeration coefficient through the reproduction of reaeration phenomenon by controlling the flow condition in the sewer using this phenomenon. And it is possible to set the flow condition and agitation intensity (velocity gradient) that has the same reaeration coefficient using the correlation between the reaeration coefficient with the flow condition and reaeration coefficient with the agitation intensity. The circumstances in the sewer system was reproduced using batch reactor setting up the DO as a limiting condition from these results.

• Journal of environmental and Sanitary engineering
• /
• v.17 no.3
• /
• pp.21-30
• /
• 2002

This study was Performed to evaluate the effective solidification of Cd sludge using cement and power plant fly ash as cement admixture, to identify the leaching characteristics of the heavy metal Cd sludge solidified, and to develope proper KLT(Korean Leaching Test) of hazardous waste. KLT was compared with EPT(Extraction Procedure Toxicity) and TCLP(Toxicity Characteristics Leaching Procedure). Fly ash contents ranged from 0% to 30% of cement weight. The experimental results showed that the optimum amount of fly ash replaced was 10% to 15% and KLT was less appropriate than EPA and TCLP. Also the purpose of the study was to suggest the modification factors on the leaching test currently used, based on the above mentioned aspects. The effects of pH, leaching time, leaching for agitating intensity, and leaching solvent were investigated. As the result of test, the leaching potential was relatively high when the pH and agitation intensity of leaching solution were 5 and 150rpm, respectively. Leaching time of six hours was found to be sufficient and the use of acetic acid as a leaching solvent is more useful in landfill site particularly.

• Journal of environmental and Sanitary engineering
• /
• v.14 no.2
• /
• pp.40-45
• /
• 1999

This study deals with an investigation on low cost adsorbents locally available n dyeing wastewater treatment of color removal. Peat, bentonite, slag and fly ash were utilized for this study. Considering that low cost adsorbents contained in $SiO_2$, $Fe_2O_3$ and $Al_2O_3$ compositions, and coagulants were mainly used aluminate and ferrate in color removal. Color of dyeing wastewater was high removed in peat, berntonite and slag except for fly ash with passed time. It could be known that color removal of peat and slag were increased to pH 4, but was hardly changed with advancing to alkaline. Color intended to be high removed with increasing of agitation speed but to be almost slow after 150rpm. As a result on the experiment of Freundlich adsorption isotherms, adsorption intensity(l/n) appeared to be peat>fly ash>slag>bentonite and adsorption capacity(k) came out peat>bentonite>slag>fly ash. Therefore, if low cost adsorbents substituted for existing adsorbents, peat, bentonite and slag could look forward to an expected economical effect.

• Journal of environmental and Sanitary engineering
• /
• v.13 no.2
• /
• pp.76-81
• /
• 1998

The technology of removing phosphorous, considered as one of the most important control nutrients causing eutrophication in various water bodies, have been investigated by many researchers. In this study, casts which can be obtained from the vermicomposting of mixing sewage sludge and cow manure, were used as an adsorbent, and their effects of several physical/chemical factors on the efficiencies of phosphorous adsorption were examined by batch tests. Generally, it could be showed that the efficiencies of phosphorous adsorption were very influenced by cast dosage, temperature and agitation speed. If we reflected the adsorption capacity(k) and adsorption intensity(1/n) of Freundlich isotherm, we couldn't consider casts as a good adsorbent for removing phosphorous. But, because casts were relatively excellent in cation exchange, in point of waste recycling, we could know that they were capable of removing phosphorous. The SEM observation revealed that the evident variations were hardly seen, but particle sizes of cast were relatively bigger and showed forms of smaller plate than before.

• Nuclear Engineering and Technology
• /
• v.35 no.3
• /
• pp.191-205
• /
• 2003

Effects of the width and location of a flow disturbing circular plate, installed at a vertical tube surface, on nucleate pool boiling heat transfer of water at atmospheric pressure have been investigated experimentally. Through the tests, changes in the degree of intensity of liquid agitation have been analyzed. The plate changes the fluid flow around the tube as well as heat transfer coefficients on the tube surface. It is identified that the plate width changes the rate of the circulating flow whereas its location changes the growth of the active agitating flow. Moreover, the flow chugging was observed at the downside of the plate.

• KSBB Journal
• /
• v.4 no.3
• /
• pp.221-228
• /
• 1989

Celluose is an insoluble substrate, therefore, a proper mixing of the cellulose suspension is essential for an effective enzymatic hydrolysis. To study the effect of mixing motion of various enzyme reactors on enzymatic hydrolysis of cellulose, three distinct types of biroreator: vertical impeller type bioreator(VITB), horizontal paddle type bioreactor(HPTB), and tumbling drum type bioreactor(TDTB), were assembled and their performance was compared. The optimal agitation speed was 100rpm for VITB and HPTB, 200rpm for TDTB. The saccharification efficiency of each reactor was compared under the optimal agitation intensity. The highest degree of saccharification was achieved in the case of VITB, especially, at high cellulose concentration. The VITB seems to be the most suitable type of bioreactor that can maintain proper mixing pattern for effective enzyme reaction. In the view of energy consumption, the TDTB showed the lowest value: however, the energy consumption was rapidly increased at high concentration of celluose. To dertermine the most suitable type of bioreactor, the entire process, including substrate cost, substrate concentration, and feasibility of scale-up, needs to be evaluated.

• Journal of Korean Society on Water Environment
• /
• v.31 no.2
• /
• pp.94-102
• /
• 2015

Electro-coagulation experiments were conducted with aluminum (Al) or iron (Fe) electrode in order to determine the optimal electrode material and operation conditions for algae removal. Al electrode showed higher removal rate of algae than Fe electrode because Al flocs have positive surface charges which electrostatically attract algae species having negative surface charges. Removal rate of algae and total phosphorous (T-P) was increased as current density and electrode area increases. It was also found that initial pH with neutral range was optimum for T-P removal by electro-coagulation. Bench-scale continuous flow experiments consisted of electro-coagulation reactor, agitation tank and settling tank were conducted. In electro-coagulation reactor, a large fraction of Al flocs were distributed to scum layer, due to the gas bubbles generated by electrolysis reaction. In agitation tank, most of Al flocs were settled and the optimal mixing intensity was found to be 50 rpm to achieve good settleability. The removal rate of algae was about 90-95%. Additionally, the removal rate of the T-P and COD was observed to be $73.8{\pm}8.0%$ and $75.0{\pm}3.8%$, respectively. Meanwhile, the removal rate of total nitrogen (T-N) was relatively low at only 24%.