• Korean Journal of Optics and Photonics
• /
• v.17 no.6
• /
• pp.544-547
• /
• 2006

A time-domain modeling approach is used to study characteristics of a widely tunable coupled-ring reflector (CRR) laser diode(LD). The CRR consists of a bus waveguide and two coupled ring resonators coupled to the bus without resorting to distributed Bragg grating structure. The tuning range can be a few tens of nanometers with a side mode suppression ratio exceeding 35dB through the adjustment of currents into the phase control sections in the rings. The CRR laser diode has long effective cavity length compared to conventional laser diodes. Accordingly, a broad additional resonance peak in the amplitude modulation characteristics is observed between 20 to 30 GHz, implying the extension of amplitude modulation bandwidth.

• The Korean Journal of Food And Nutrition
• /
• v.29 no.2
• /
• pp.290-299
• /
• 2016

This study was conducted to determine the association between dietary calcium intake and biomarkers related to lipid and glucose metabolism and inflammation in Korean patients with type 2 diabetes. Seventy-five subjects (41 males, 34 females) were recruited from a group of patients who had visited the department of endocrine medicine. Data on anthropometric characteristics, clinical indices such as hemoglobin A1c and C-reactive protein (CRP), and dietary nutrient intakes were collected. Subjects were divided into three groups on the basis of their calcium intake [< EAR (below estimated average requirement), EAR-RNI (between EAR and recommended nutrient intake), > RNI (above RNI)]. Average calcium intake of < EAR, EAR-RNI, > RNI groups were $462.7{\pm}18.7$, $649.7{\pm}12.8$, and $895.7{\pm}21.7mg$, respectively. Energy intake was not different among groups but intakes of protein, total and saturated fatty acids were significantly higher in > RNI group than < EAR group. Analysis of covariance revealed that HDL cholesterol level was significantly higher in EAR-RNI group, as compared to < EAR group after adjustment with confounders such as age, sex, BMI and energy intake (p < 0.05). Levels of CRP and homeostasis model assessment 2-insulin resistance (HOMA2-IR) were significantly lower in EAR-RNI group. Total cholesterol level was higher in EAR-RNI and > RNI groups, although within the normal range. Our results suggest that dietary calcium intake may influence the levels of HDL-cholesterol, CRP and HOMA2-IR and subsequently, help management/treatment of type 2 diabetes patients.

• Korean Journal of Food Science and Technology
• /
• v.21 no.2
• /
• pp.180-184
• /
• 1989

Clarification of the juice extracted from stored Fuji apples was studied with pectolytic enzyme and pH control, separately and in combinations. In the separated treatment, the clarity of the juice was increased with the treated enzyme amount. The juice adjusted pH to 3.5 with malic acid had the highest clarity in pH range from 3.5 to 5.0, but this juice was not acceptable because of high acidity. In combination of the two treatment, the clarity of the juice treated with the enzyme at pH 4.0 was higher than that of the juice without the enzyme, and the juice with ligh trasmittance of about 92% could be obtained at the pH by addition with one-third amount of enzyme which was used for clarification of the juice extracted from the fresh apples at harvesting season.

• Journal of the Korean Association of Geographic Information Studies
• /
• v.20 no.4
• /
• pp.15-23
• /
• 2017

The WGS conversion project of cadastral drawing (promoted by the Ministry of Land) is not able to reflect the cadastral registration due to subtle differences such as area and location. When converting the digital cadastral region to the world geodetic system, the boundary point coordinates must be changed to the legal coordinate units. However, there is a phenomenon that occurs in which the minute area changes do not coincide with the area registered in the cadastral registration when the coordinate unit is changed. In this study, we have developed a method to adjust many parcels collectively by applying a passive fine-tuning method used in cadastral resurvey project to solve these problems. Total 1, total 2+1, interval 1, interval 2+1, etc. were classified based on the number of parcels that need to be considered for the range of adjustment and the area condition. The analysis of the experimental area (after developing SW for comparison of each method) showed that the total 2+1 method is suitable for the location accuracy and the interval 2+1 method is suitable for the temporal efficiency.

• Korean Journal of Computational Design and Engineering
• /
• v.18 no.6
• /
• pp.385-398
• /
• 2013

Opening wedge high tibial osteotomy (OWHTO) is widely used to treat unicompartmental osteoarthritis of the knee caused by degenerative deformations of the anatomical axes of the leg. However, since it is difficult to accurately plan the surgical degrees of adjustment such as coronal correction angle and tibial posterior slope angle to align the axes before the actual procedure, a number of studies have proposed analytical models to solve this problem. While previous analytical models for OWHTO were limited to specific cases, this study proposes an analytical osteotomy model (AOM) and a surgical planning system (SPS) that are suitable for a wide range of tibial morphologies and tibia conditions. The validity and generality of the model were verified in a total of 60 OWHTO cases. Results of the test showed that, as predicted, surgical degrees are affected quite significantly by tibia shape and slope of the resected surface. Comparison of the required surgical degrees and the degrees estimated from virtual surgery simulations using AOM showed a very small average difference of $0.118^{\circ}$. SPS, based on AOM, allows the operating surgeon to easily calculate surgical parameters needed to treat a patient.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.37A no.9
• /
• pp.762-771
• /
• 2012

In this paper, we propose an adaptive power control scheme employing a self-optimization concept in femtocell systems, in order to improve system capacity, thereby reducing call-drop probability. In the proposed scheme, each femto base station(FBS) controls individual channel's transmission power base on two parameters; the neighboring cell's transmission power for each individual channel which is delivered from a femto-gateway and the received power strength from neighboring cells which is periodically measured by means of a spectrum sensing. Adaptive adjustment of individual channel's transmission power in accordance with femto mobile station(FMS) mobility features can also reduce undesirable handovers and evenly distribute traffic load over all femtocells. In addition, the manipulative control of channel's transmission power is able to keep the system coverage and the call-drop probability within an acceptable range, regardless of density of femtocells. Computer simulation shows that the proposed scheme outperforms existing schemes in terms of the system coverage and the call-drop probability.

• Smart Structures and Systems
• /
• v.7 no.1
• /
• pp.1-13
• /
• 2011

It has been shown in the literature that active adjustment of the intake area of a jet engine has potential to improve its fuel efficiency. This paper presents the design and control of a novel proof-of-concept active jet engine intake using Nickel-Titanium (Ni-Ti or Nitinol) shape memory alloy (SMA) wire actuators. The Nitinol SMA material is used in this research due to its advantages of high power-to-weight ratio and electrical resistive actuation. The Nitinol SMA material can be fabricated into a variety of shapes, such as strips, foils, rods and wires. In this paper, SMA wires are used due to its ability to generate a large strain: up to 6% for repeated operations. The proposed proof-of-concept engine intake employs overlapping leaves in a concentric configuration. Each leaf is mounted on a supporting bar than can rotate. The supporting bars are actuated by an SMA wire actuator in a ring configuration. Electrical resistive heating is used to actuate the SMA wire actuator and rotate the supporting bars. To enable feedback control, a laser range sensor is used to detect the movement of a leaf and therefore the radius of the intake area. Due to the hysteresis, an inherent nonlinear phenomenon associated with SMAs, a nonlinear robust controller is used to control the SMA actuators. The control design uses the sliding-mode approach and can compensate the nonlinearities associated with the SMA actuator. A proof-of-concept model is fabricated and its feedback control experiments show that the intake area can be precisely controlled using the SMA wire actuator and has the ability to reduce the area up to 25%. The experiments demonstrate the feasibility of engine intake area control using an SMA wire actuator under the proposed design.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.34 no.10A
• /
• pp.784-795
• /
• 2009

An accurate positioning estimation in the wireless sensor networks (WSN) is very important in which each sensor node is aware of neighbor conditions. The multi-hop positioning estimation technique is considered as one of the suitable techniques for the WSN with many low power devices. However geographical holes, where there is no sensor node, may severely decrease the positioning accuracy so that the positioning error can be beyond the tolerable range. Therefore in this paper, we analyze error factors of DV-hop and hole effect to obtain node's accurate position. The proposed methods include boundary node detection, distance level adjustment, and unreliable anchor elimination. The simulation results show that the proposed method can achieve higher positioning accuracy using the hole detection and enhanced distance calculation methods compared with the conventional DV-hop.

• Journal of Microbiology and Biotechnology
• /
• v.16 no.4
• /
• pp.597-604
• /
• 2006

In order to extend the shelf-life of packaged or coated foods, an antibacterial edible film containing 1.8% of BLS was developed from the defatted corn germ meal, which had been fermented with Bacillus subtilis under the optimum condition of pH 7.0-7.5 and $33^{\circ}C$ for 33 h. Water vapor permeability of the fermented film $(88.3mg/cm^2\;h)$ was higher than those of the normal corn germ films $(75.8mg/cm^2\;h)$. Protein solubility of the fermented film was also higher than ordinary corn germ film at the pH range of 3-10. The fermented corn germ film had higher tensile strength and lower % elongation (elongation rate) than the ordinary corn germ film. The antimicrobial activity of the film was more than 50% of the maximum activity after film production with heat treatment at $90^{\circ}C$ and pH adjustment to 9. When the corn germ protein film with bacteriocin-like substance was applied on the mashed sausage media containing E. coli, the bacterial growth inhibition was higher than the ordinary corn protein film.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• v.9 no.2
• /
• pp.869-872
• /
• 2005

This paper presents a new switchable dual mode VCO(Voltage-Controlled Oscillator). The VCO is efficient in dual mode operation and has self-bias adjustment based on the operation frequencies of 2.4 GHz and 5 GHz. The switching is done using MOS transistors and tuning is done using MOS varactors. It is implemented using TSMC 0.18${\mu}$m CMOS technology. It is powered by 1.8V supply. The measured results showed that the overall tuning range is approximately 13% at 5 GHz and 8% at 2.4 GHz. The measured phase noise is approximately -102 dBc/Hz at 1 MHz offset for 5 GHz and -89 dBc/Hz at 600kHz offset for 2.4 GHz. The VCO showed tail currents of 2mA in 5GHz mode and 2.5mA in 2.4GHz mode from a 1.8 V supply, respectively.