• 유변학
• /
• 제10권4호
• /
• pp.227-233
• /
• 1998

잠재성 경화제인 N-benzylpyrazinium hexafluoroantimonate(BPH)를 Cycloaliphatic계 에폭시 (CAE)/DGEBA계 에폭시의 혼합물에 1 mol% 첨가 시킨 후 혼합 조성비에 따른 유변학적 특성과 경화 동력학에 대해 연구하였다. 잠재특성은 등온 DSC를 이용하여 각각 $150^{\circ}C$와 $50^{\circ}C$의 반응 온도에 대한시간의 함수로서 전화량을 구하여 측정하였다. 블렌드 시스템의 유변학적 특성은 레오미터를 사용한 등온 실험을 통하여 storage modulus (G'), loss modulus (G") 그리고 damping factor (tan$\delta$)를 구한 후 이들 데이터로부터 겔화 시간을 측정하였다. 겔화 시간과 경화 온도를 Arrenius equation에 적용시킨 결과 가교 활성화 에너지 ($E_c$)를 구할 수 있었으며 겔화 시간과 활성화 에너지 모두 DGEBA의 함량이 증가할수록 증가하였다. 경화 활성화 에너지 ($E_a$)를 동적 DSC를 이용하여 Kissinger method에 의해 구하였는데 활성화 에너지는 CAE의 함량이 증가할수록 감소함으로써 높은 반응성을 나타내었는데, 이는 짧은 반복 단위와 단순한 곁사슬기 그리고 반응 매질 내의 점도 등에 기인한다.기인한다.

• Journal of Microbiology and Biotechnology
• /
• 제15권3호
• /
• pp.587-594
• /
• 2005

The contribution of electrostriction of water molecules to the stabilization of the negatively charged tetrahedral transition state of a lipase-catalyzed reaction was examined by means of kinetic studies involving high-pressure and solvent dielectric constant. A good correlation was observed between the increased catalytic efficiency of lipase and the decreased solvent dielectric constant. When the dielectric constant of solvents was lowered by 5.00 units, the losses of activation energy and free energy of activation were 7.92 kJ/mol and 11.24 kJ/mol, respectively. The activation volume for $k_{cat}$ decreased significantly as the dielectric constant of solvent decreased, indicating that the degree of electrostriction of water molecules around the charged tetrahedral transition state has been enhanced. These observations demonstrate that the increase in the catalytic efficiency of the lipase reaction with decreasing dielectric constant resulted from the stabilization of electrostatic energy for the formation of an oxyanion hole, and that this stabilization was caused by the increase of electrostricted water around the charged tetrahedral transition state. Therefore, we conclude that the control of solvent dielectric constant can stabilize the tetrahedral transition state, thus lowering the activation energy.

• 자원리싸이클링
• /
• 제23권6호
• /
• pp.47-53
• /
• 2014

런던협약으로 인하여 하수 슬러지 및 유기성 폐기물의 해양투기가 전면 금지되어 이의 효과적인 처리 및 에너지 전환 기술에 대한 요구가 증대되고 있다. 하수 슬러지의 빠른 감량과 에너지화가 가능한 열적 에너지 전환 기술의 적용을 위해서는 하수 슬러지의 열분해 및 연소 특성에 대한 기본적인 kinetics 자료가 필수적이다. 본 연구에서는 열중량 분석기(thermogravimetric analyzer, thermobalance)를 이용하여 하수 슬러지의 열분해 및 연소 kinetics를 도출하였다. 열분해의 경우 총 세 단계의 반응이 일어나 각각에 대하여 subtraction method에 의하여 activation energy와 빈도 인자를 도출하였다. 촤 연소의 경우 반응 kinetics 해석은 기체-고체 화학반응의 세 가지 모델이 이용되었고 shrinking core model이 연소 특성을 가장 잘 나타내어 이 모델을 기준으로 activation energy와 빈도 인자를 도출하고 산소농도 영향을 살펴보았다.

• 대한전기학회논문지
• /
• 제38권3호
• /
• pp.193-200
• /
• 1989

The errors of activation energy calculated by the initial rise method from the characteristics of thermally stimulated current have been estimated and an equation for the correction of the error is proposed. The coefficients needed in the proposed equation are determined by the numerical method. It is shown that the activation energy calculated by the conventional initial rise method contains errors of 0.7-10% depending on the location of the data points of the interval on which the method is applied. However, the error can be reduced to less than 0.5% when corrected by using the proposed equation. It is finally concluded that the activation energy determined by the initial rise method can approach the true value by adapting the proposed error correction method which is effective and reliable.

• Advances in Energy Research
• /
• 제8권4호
• /
• pp.253-264
• /
• 2022

This paper deals with the effects of design (active area, current density, membrane conductivity) and operating parameters (temperature, relative humidity) on the performance of hydrogen-fuelled proton exchange membrane (PEM) fuel cell. The design parameter of a PEM fuel cell with the active area of the single cell considered in this study is 25 cm² (5 × 5). The operating voltage and current density of the fuel cell were 0.7 V and 0.5 A/cm² respectively. The variations of activation voltage, ohmic voltage, and concentration voltage with respect to current density are analyzed in detail. The membrane conductivity with variable relative humidity is also analyzed. The results show that the maximum activation overpotential of the fuel cell was 0.4358 V at 0.21 A/cm² due to slow reaction kinetics. The calculated ohmic and concentrated overpotential in the fuel cell was 0.01395 V at 0.76 A/cm² and 0.027 V at 1.46 A/cm² respectively.

• Nuclear Engineering and Technology
• /
• 제50권1호
• /
• pp.182-189
• /
• 2018

A neutron generation system was developed to induce fissile fission in a lead slowing down spectrometer (LSDS) system. The source neutron is one of the key factors for LSDS system work. The LSDS was developed to quantify the isotopic contents of fissile materials in spent nuclear fuel and recycled fuel. The source neutron is produced at a multilayered target by the (e,${\gamma}$)(${\gamma}$,n) reaction and slowed down at the lead medium. Activation analysis of the target materials is necessary to estimate the lifetime, durability, and safety of the target system. The CINDER90 code was used for the activation analysis, and it can involve three-dimensional geometry, position dependent neutron flux, and multigroup cross-section libraries. Several sensitivity calculations for a metal target with different geometries, materials, and coolants were done to achieve a high neutron generation rate and a low activation characteristic. Based on the results of the activation analysis, tantalum was chosen as a target material due to its better activation characteristics, and helium gas was suggested as a coolant. In addition, activation in a lead medium was performed. After a distance of 55 cm from the lead surface to the neutron incidence, the neutron intensity dramatically decreased; this result indicates very low activation.

• Nuclear Engineering and Technology
• /
• 제47권5호
• /
• pp.608-616
• /
• 2015

The migration of silver (Ag) in silicon carbide (SiC) and $^{110m}Ag$ through SiC of irradiated tristructural isotropic (TRISO) fuel has been studied for the past three to four decades. However, there is no satisfactory explanation for the transport mechanism of Ag in SiC. In this work, the diffusion coefficients of Ag measured and/or estimated in previous studies were reviewed, and then pre-exponential factors and activation energies from the previous experiments were evaluated using Arrhenius equation. The activation energy is $247.4kJ{\cdot}mol^{-1}$ from Ag paste experiments between two SiC layers produced using fluidized-bed chemical vapor deposition (FBCVD), $125.3kJ{\cdot}mol^{-1}$ from integral release experiments (annealing of irradiated TRISO fuel), $121.8kJ{\cdot}mol^{-1}$ from fractional Ag release during irradiation of TRISO fuel in high flux reactor (HFR), and $274.8kJ{\cdot}mol^{-1}$ from Ag ion implantation experiments, respectively. The activation energy from ion implantation experiments is greater than that from Ag paste, fractional release and integral release, and the activation energy from Ag paste experiments is approximately two times greater than that from integral release experiments and fractional Ag release during the irradiation of TRISO fuel in HFR. The pre-exponential factors are also very different depending on the experimental methods and estimation. From a comparison of the pre-exponential factors and activation energies, it can be analogized that the diffusion mechanism of Ag using ion implantation experiment is different from other experiments, such as a Ag paste experiment, integral release experiments, and heating experiments after irradiating TRISO fuel in HFR. However, the results of this work do not support the long held assumption that Ag release from FBCVD-SiC, used for the coating layer in TRISO fuel, is dominated by grain boundary diffusion. In order to understand in detail the transport mechanism of Ag through the coating layer, FBCVD-SiC in TRISO fuel, a microstructural change caused by neutron irradiation during operation has to be fully considered.

• Bulletin of the Korean Chemical Society
• /
• 제18권3호
• /
• pp.280-286
• /
• 1997

Potential energy function sets for some ion-exchanged A-type zeolites, K-A and Rb11Na1-A, were determined by introducing the X-ray crystal structures as constraints. The potential functions reproduced well the X-ray crystal structures of the monovalent ion-exchanged zeolites. The activation energies for the en- or de-capsulation of small molecules (H2, O2, N2, and CH4) and inert gases from the α-cage of model zeolites (Na-A, K-A, Rb11Na1-A, and Cs3Na9-A) were obtained by the molecular mechanical calculations. The calculated activation energies agreed well with experimental results.

• Transactions on Electrical and Electronic Materials
• /
• 제15권2호
• /
• pp.81-86
• /
• 2014

The process parameter in optimized KOH alkali activation of soft carbon series coke material in high purity was set with DOE experiments design. The activated carbon was produced by performing the activation process based on the set process parameters. The specific surface area was measured and pore size was analyzed by $N_2$ absorption method for the produced activated carbon. The surface functional group was analyzed by Boehm method and metal impurities were analyzed by XRF method. The specific surface area was increased over 2,000 $m^2/g$ as the mixing ratio of activation agent increased. The micro pores in $5{\sim}15{\AA}$ and surface functional group under 0.4 meq/g were obtained. The contents of the metal impurity in activated carbon which is the factor for reducing the electrochemical characteristics was reduced less than 100 ppm through the cleansing process optimization. The electrochemical characteristics of activated carbon in 38.5 F/g and 26.6 F/cc were checked through the impedance measuring with cyclic voltammetry scan rate in 50~300 mV/s and frequency in 10 mHz ~100 kHz. The activated carbon was made in the optimized activation process conditions of activation time in 40 minutes, mixing ratio of activation agent in 4.5 : 1.0 and heat treatment temperature over $650^{\circ}C$.

• 한국신재생에너지학회:학술대회논문집
• /
• 한국신재생에너지학회 2005년도 춘계학술대회
• /
• pp.223-226
• /
• 2005

For $CO_2-free$ hydrogen production and better utilization of the produced carbon, catalytic decomposition of methane over rubber-grade carbon blacks manufactured from coal tar was carried out. The catalytic activities of several domestic carbon blacks were compared. A pelletized carbon black exhibited considerably lower activity and activation energy than the fluffy( loose) carbon black of the same grade. This difference is considered due to the binder that was added during pelletization. For pelletized carbon blacks, a tendency was observed that the activity per unit mass of catalyst increased with the specific surface area of the carbon black. Another tendency was also observed that the activation energy increased with the primary particle size or decrease of the specific surface area.