• 한국연소학회:학술대회논문집
• /
• 한국연소학회 1999년도 제19회 KOSCO SYMPOSIUM 논문집
• /
• pp.11-20
• /
• 1999

Acoustic pressure response and NO formation of hydrogen-air diffusion flames at various pressures are numerically studied by employing counterflow diffusion flame as a model flame let in turbulent flames in combustion chambers. The numerical results show that extinction strain rate increases linearly with pressure and then decreases, and increases again at high pressures. Thus, flames are classified into three pressure regimes. Such non-monotonic behavior is caused by the change in chemical kinetic behavior as pressure rises. Acoustic pressure response in each regime is investigated based on the Rayleigh criterion. At low pressures, pressure-rise causes the increase in flame temperature and chain branching/recombination reaction rates, resulting in increased heat release. Therefore, amplification in pressure oscillation is predicted. Similar phenomena are predicted at high pressures. At moderate pressures, weak amplification is predicted. Emission index of NO shows similar behaviors as to the peak-temperature variation with pressure.

• 한국소음진동공학회:학술대회논문집
• /
• 한국소음진동공학회 2009년도 춘계학술대회 논문집
• /
• pp.551-556
• /
• 2009

Vehicle interior noise is the results of numerous sources of excitation. One source involving tire pavement interaction is the tire cavity resonance and the forcing it provides to the vehicle spindle. Using a simplified model for the tire acoustic cavity system only, we formulated finite element equation to predict the fundamental acoustic cavity resonant characteristics inside tire-wheel assembly of undeformed and deformed tire. Combining the finite element analysis with experimental verification, we explained the acoustic characteristics theoretically. Especially, we have shown that the difference between the first two resonant frequencies increases as the deformation of tire due to vertical load increases.

• 한국공작기계학회:학술대회논문집
• /
• 한국공작기계학회 2003년도 추계학술대회
• /
• pp.137-142
• /
• 2003

A fundamental study for developing a system of fault diagnosis of a pump is performed by using neural network. The acoustic signals were obtained and converted to frequency domain for normal products and artificially deformed products. The signals were obtained in various driving frequencies in order to obtain many types of data from a limited number of pumps. The acoustic data in frequency domain were managed to multiples of real driving frequency with the aim of easy comparison. The neural network model used in this study was 3-layer type composed of input, hidden, and output layer. The normalized amplitudes at the multiples of real driving frequency were chosen as units of input layer, Various sets of teach signals made from original data by eliminating some random cases were used in the training. The average errors were approximately proportional to the number of untaught data. The results showed neural network trained by acoustic signals can be used as a simple method far a detection of machine malfunction or fault diagnosis.

• 한국공작기계학회논문집
• /
• 제13권5호
• /
• pp.81-86
• /
• 2004

A fundamental study for developing a system of fault diagnosis of a pump is performed by using neural network. The acoustic signals were obtained and converted to frequency domain for normal products and artificially deformed products. The signals were obtained in various driving frequencies in order to obtain many types of data from a limited number of pumps. The acoustic data in frequency domain were managed to multiples of real driving frequency with the aim of easy comparison. The neural network model used in this study was 3-layer type composed of input, hidden, and output layer. The normalized amplitudes at the multiples of real driving frequency were chosen as units of input layer. Various sets of teach signals made from original data by eliminating some random cases were used in the training. The average errors were approximately proportional to the number of untaught data. The results showed neural network trained by acoustic signals can be used as a simple method for a detection of machine malfuction or fault diagnosis.

• 한국조경학회지
• /
• 제29권3호
• /
• pp.10-18
• /
• 2001

The purpose of this study is to research the influence of soundscape in the preference of landscape. Specifically, Standards types of communications are applied to the landscape such as artificial waterscapes and natural valley. The spatial image was analyzed by the variables of Kaplan´s information processing model. The level of visual preferences was measured by a type of acoustic information in landscape and media of communication, and these data were analyzed by multiple regression. The results of this study can be summarized as follows; The value of landscape preference was not different from all fluent of coherence, complexity, legibility ,mystery and preference utilized the communication media, but it was different by the type of acoustic information in landscape. These results clearly show the influence of sound affecting decisions of landscape preference. The factors determining the level of landscape preference were found to be coherence, complexity, legibility, mystery and dummy variables of acoustic information in landscape and media od communication. These variables amy be the major factors which must be considered on planning and designing as the functional basis for the quantitative analysis.

• 한국소음진동공학회:학술대회논문집
• /
• 한국소음진동공학회 2003년도 춘계학술대회논문집
• /
• pp.701-708
• /
• 2003

This paper presents an acoustic source localization technique on 2D cavity model in flow using a phased microphone way. Investigation was performed on cavity flows of open and closed types. The source distributions on 2D cavity flow were investigated in anechoic open-jet wind tunnel. The array of microphones was placed outside the flow to measure the far field acoustic signals. The optimum sensor placement was decided by varying the relative location of the microphones to improve the spatial resolution. Pressure transducers were flush-mounted on the cavity surface to measure the near-filed pressures. It is shown that the propagated far field acoustic pressures are closely correlated to the near-field pressures. It is also shown that their spectral contents are affected by the cavity parameter L/D.

• 대한전자공학회:학술대회논문집
• /
• 대한전자공학회 2004년도 ICEIC The International Conference on Electronics Informations and Communications
• /
• pp.110-113
• /
• 2004

Underwater acoustic(UWA) communication is one of the most difficult field because of several factors such as multipath propagation, high temporal and spatial variability of channel conditions. Therefore, it is important to model and analyze the characteristics of underwater acoustic channel such as multipath propagation, transmission loss, reverberation, and ambient noise. In this paper, UWA communication channel is modeled with a ray tracing method and applied to image transmission. Quadrature phase shift keying(QPSK) and multichannel decision feedback equalizer(DFE) are utilized as phase-coherent modulation method and equalization technique, respectively. The objective is to improve the performance of vertical sensor array than that of single sensor in the viewpoint of bit error rate(BER), constellation output, and received image quality.

• 대한전자공학회:학술대회논문집
• /
• 대한전자공학회 2002년도 ITC-CSCC -3
• /
• pp.1917-1919
• /
• 2002

An adaptive algorithm for the acoustic echo canceller is presented. This paper proposes a modified LMS algorithm for the adaptive filter and applys the algorithm to he acoustic echo canceller, An objective of the proposed algorithm is to reduce the hardware complexity. In order to est the performances, a model of the echo path is established, and a program is described. The impulse reponses of the echo path have the length of 125msec or ore, and then the FIR filter with 1000 taps is required. he results from simulations show that the acoustic echo canceller adopting the proposed algorithm achieves the ERLE of 25dB or more within 1sec. If an echo canceller is implemented with this algorithm, its computation quantity s reduced to two times less than the one that is implemented with the normal LMS algorithm, without the degradation of performances.

• 한국지반공학회:학술대회논문집
• /
• 한국지반공학회 2009년도 세계 도시지반공학 심포지엄
• /
• pp.1346-1353
• /
• 2009

In this study, a numerical study was carried out to simulate the expansion of ground borehole by pulse discharge technology using finite element analysis. Considering the mortar in the borehole as an acoustic medium and the surrounding soil as an elasto-plastic material, the strong shock wave developed by the pulse discharge was modeled using the underwater explosion model. The ground expansion was simulated based on a coupled acoustic-structural analysis with varying properties of mortar and soil, and the behavior between acoustic-structural interface.

• 유체기계공업학회:학술대회논문집
• /
• 유체기계공업학회 1999년도 유체기계 연구개발 발표회 논문집
• /
• pp.208-217
• /
• 1999

The present work describes the prediction method for the unsteady flow field and the acoustic pressure field of a ducted axial fan. The prediction method is comprised of time-marching free-wake method, acoustic analogy, and the Helmholtz-Kirchhoff BEM. The predicted sound signal of a rotor is similar to the experiment one. We assume that the rotor rotates with a constant angular velocity and the flow field around the rotor is incompressible and inviscid. Then, a time-marching free-wake method is used to model the fan and to calculate the flow field. The force of each element on the blade is calculated by the unsteady Bernoulli equation. Lowson's method is used to predict the acoustic source. The newly developed Helmholtz-Kirchhoff BEM for thin body is used to calculate the sound field of the ducted fan. The ducted fan with 6 blades is analysed and the sound field around the duct is calculated.